GZGalyna Zozulya

Galyna Zozulya

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Galyna Zozulya has a total of 21 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Modification of copper foam with silver nanostructures by galvanic replacement

    by V. V. Skrypnychuk, Z. P. Lazurko, V. M. Hreb, G. I. Zozulya, E. A. Matsko, O. I. Kuntyi

    Silver nanostructures were deposited onto the surface of commercially available copper foam (Ag/Cufoam) using the galvanic replacement (GR) method. The regularities of the formation of silver deposits on the copper surface in solutions of hydrated Ag+ ions and [Ag(NH3)2]+ and [Ag(CN)2]– complexes were established. The complex-ion solutions promoted the formation of isle silver nanostructures and a porous film, where the solutions containing hydrated silver ions led to the formation of both isle and dendritic morphologies. During the GR process, the open-circuit potential (OCP) of the Ag/Cufoam shifted toward more positive values by approximately 0.1 V in Ag+ solutions and by 0.25–0.50 V in solutions of silver complexes. The OCP reached a stable value (approx.1 min) and could be considered one of the criteria indicating complete coverage of the foam surface with silver. The morphology of the deposited silver was found to be primarily governed by the precursor concentration and the duration of GR process. SEM revealed the distribution of silver nanostructures over the complex three-dimensional surface of the copper foam. Electrochemical studies of Ag/Cufoam as cathodes for the oxygen reduction reaction (і cathode = 10–20 mAxcm–2 at Е = –0.4 – –0.6 V) demonstrated their high electrocatalytic activity.

  • Open Access

    CO 2 Electroreduction on Silver and Silver‐Based Cathodes in Aqueous and Nonaqueous Solutions: A Review

    by Оrest Kuntyi, Oksana Dobrovetska, Galyna Zozulya

    The scientific literature on the electrochemical conversion of CO 2 on silver and silver‐based cathodes in aqueous solutions and nonaqueous media has been analyzed. It has been shown that the most problematic issues regarding cathodic reduction and, accordingly, utilization of this greenhouse gas into valuable products (CO, HCOOH, CH 4 , CH 3 OH, (COOH) 2 ) are the process speed and its selectivity. In this regard, we present the peculiarities of the electrocatalytic activity of the silver surface in comparison with other metals and the prospects of silver‐based cathodes in technological and economic perspectives. According to the publications of the last decade, special attention was paid to (1) silver cathodes with a highly developed surface, such as foam and nanoporous electrodes, (2) electrodes with AgNPs deposited on the substrate, and (3) binary silver‐containing cathodes. These types of cathodes can increase the rate of electrochemical conversion of CO 2 to CO by an order of magnitude or more, providing Faradaic efficiency of more than 90%. This is especially important given that carbon(II) oxide is currently the most cost‐effective product. One of the most promising and actively developing areas is the electrochemical conversion of CO 2 at a silver cathode in a nonaqueous medium, in particular in ionic liquids and organic aprotic solvents. In comparison with aqueous solutions, they exhibit an order of magnitude higher solubility of CO 2 , no cathodic hydrogen evolution, and significantly higher electrochemical stability. These advantages make it possible to carry out electrochemical conversion at high cathodic current values and ensure high selectivity for target products. It has been shown that the combination of a nonaqueous medium with silver‐containing cathodes increases both the productivity and selectivity of CO 2 reduction to CO and oxalate.


  • Synthesis of Silver Nanoparticles and Silver-Gold Binary System by Galvanic Replacement in an Ultrasonic Field

    by Galyna Zozulya, Оrest Kunty, Mariana Shepida, Vasyl Kordan

    The conditions for the synthesis of colloidal solutions of silver nanoparticles by galvanic replacement in an ultrasonic field and the AgAuNP binary system by galvanic replacement have been studied. It has been shown that colloidal solutions of stabilized nanoparticles with absorption maxima at 410 nm (AgNPs) and 540...560 nm (AgAuNPs) are formed in solutions of sodium polyacrylate and metal precursors of AgNO3 and H[AuCl4]. The synthesized AgAuNPs are spherical in shape and their size does not exceed 20 nm.


  • Influence of ultrasound on the deposition of Ag, Au, and Pd on the silicon surface by galvanic replacement in organic aprotic solutions

    by Mariana Shepida, Galyna Zozulya, Orest Kuntyi, Myron Holovchuk, Martyn Sozanskyi, Yuriy Sukhatskiy

    The deposition processes of nanosized particles of silver, palladium and gold on the silicon surface by galvanic replacement in fluoride-containing solutions of AgNO3 in DMF, Pd(NO3)2, and H[AuCl4] in DMSO in an ultrasonic field are studied. The influence of the ultrasonic field on the geometry of metal particles and the morphology of precipitate on the substrate is described. It is shown that ultrasonication of (1–10) mM AgNO3 solutions in DMF promotes the formation of nanostructured films on the silicon surface. The tendency to the nanofilms formation is also observed for gold. It was found that ultrasonication allows the deposition of gold on silicon by galvanic replacement in fluoride-free solutions of H[AuCl4]. An increase of the temperature of the solution causes the formation of dispersed precipitates on the silicon surface and an increase of the particles size.


  • Open Access

    CO2 Electroreduction in Organic Aprotic Solvents: A Mini Review

    by Оrest Kuntyi, Galyna Zozulya, Mariana Shepida

    An annual increase of CO2 concentrations in the atmosphere causes global environmental problems, addressed by systematic research to develop effective technologies for capturing and utilizing carbon dioxide. Electrochemical catalytic reduction is one of the effective directions of CO2 conversion into valuable chemicals and fuels. The electrochemical conversion of CO2 at catalytically active electrodes in aqueous solutions is the most studied. However, the problems of low selectivity for target products and hydrogen evolution are unresolved. Literature sources on CO2 reduction at catalytically active cathodes in nonaqueous mediums, particularly in organic aprotic solvents, are analyzed in this article. Two directions of cathodic reduction of CO2 are considerednonaqueous organic aprotic solvents and organic aprotic solvents containing water. The current interpretation of the cathodic conversion mechanism of carbon (IV) oxide into CO and organic products and the main factors influencing the rate of CO2 reduction, Faradaic efficiency of conversion products, and the ratio of direct cathodic reduction of CO2 are given. The influence of the nature of organic aprotic solvent is analyzed, including the topography of the catalytically active cathode, values of cathode potential, and temperature. Emphasis is placed on the role of water impurities in reducing CO2 electroreduction overpotentials and the formation of new CO2 conversion products, including formate and H2.


  • Open Access

    Porous Silicon Formation by Electrochemical Etching

    by Оrest Kuntyi, Galyna Zozulya, Mariana Shepida

    Porous silicon (PSi) is used as an effective material in biomedicine, sensors, solar cells, electrochemical energy, microelectronics, and nanotechnology. Considering the dependence of PSi functional properties on pore geometry and porous layer architecture, it is important to develop methods for controlled pore formation. After all, in the procession the method of obtaining PSi pore geometry and architecture of PSi functional properties of PSi, the decisive role belongs to the first participant. Among the most used methods, electrochemical etching is the most suitable for the controllability of the processes of nucleation and growth of pores since it can be controlled using the value of the current density, and the results are easily reproduced. This work analyses the literature on two types of electrochemical formation of PSi by anodic etching of (1) silicon surface and (2) silicon surface, modified with metal nanostructures. A modern explanation of the process of anodic dissolution of silicon with forming a porous surface in solutions containing HF is presented. The influence of such main factors on the process of anodic formation of PSi and its morphology is analyzed: the composition of the electrolyte and the role of each component in it; anode current density and methods of its supply (stationary, pulsed); duration; exposure to lighting; and temperature. Considerable attention is paid to the illustration of the role of alcohols and organic aprotic solvents on the formation of pore geometry. The influence of MNPs and metallic nanostructures on the process of localized metal-activated anodic etching of a semiconductor is analyzed.


  • Open Access

    “Green” Synthesis of Metallic Nanoparticles by Sonoelectrochemical and Sonogalvanic Replacement Methods

    by Оrest Kuntyi, Galyna Zozulya, Andriy Kytsya

    The main features of the green synthesis of metallic nanoparticles (MNPs) by the sonoelectrochemical methods are manufacturability, environmental friendliness, and the possibility of controlling the geometry of the forming particles. The electrochemical reduction technique allows efficiently designing the metal nanoparticles and provides the control of the content of components of bimetallic nanoparticles, as well as minimizing the number of precursors in working solutions. Due to the generation of turbulence, microjets, and shock waves, ultrasound increases mass transfer and formation of radicals in aqueous solutions and, accordingly, accelerates the processes of nucleation and growth of MNPs. Therefore, this hybrid method, which combines electrolysis and ultrasound, has attracted the interest of researchers in the last two decades as one of the most promising techniques. The present work presents a short analysis of the reference literature on sonoelectrochemical synthesis of metallic and bimetallic nanoparticles. The main factors influencing the geometry of nanoparticles and their size distribution are analyzed. The use of pulsed ultrasound and pulsed current supply during sonoelectrochemical synthesis is especially effective in designing MNPs. Emphasis is placed on the role of surfactants in the formation of MNPs and sacrificial anodes in providing the algorithm: anodic dissolution-electrochemical reduction of metal-nucleation and formation of МNPs. It is noted that ultrasound allows synthesizing the MNPs and M1M2NPs during the galvanic replacement, and an analogy of the formation of nanoparticles by sonogalvanic replacement and sonoelectrochemical method is shown.


  • Production of Cu/Ag Porous Bimetal by the Galvanic Replacement of Dezincified Brass

    by G. I. Zozulya, O. I. Kuntyi, I. P. Mertsalo, A. S. Mazur


  • Open Access

    Deposition of Gold Nanoparticles via Galvanic Replacement in DMSO and Their Influence on Formation of Silicon Nanostructures

    by Mariana Shepida, Orest Kuntyi, Stepan Nichkalo, Galyna Zozulya, Sergiy Korniy

    The process of gold nanoparticle (AuNP) precipitation on the silicon (Si) surface by galvanic replacement (GR) in dimethyl sulfoxide (DMSO) solution depending on the concentration of H[AuCl4], temperature, and duration was investigated. It is established that with an increase in the concentration of [AuCl4]− ions (from 2 to 8 mM H[AuCl4]), both the size of AuNPs and their surface coverage density are increased. It is demonstrated that an increase in temperature causes the size of AuNPs to increase from 40 to 80 nm at 40°C to 80–120 and 120–160 nm at 50 and 60°C, respectively. As the duration of the GR process increases, there is a tendency of the particle size growth. Under the studied deposition conditions, the organic aprotic solvent medium contributes to the formation of spherical AuNPs with 2D substrate filling. It is established that the AuNPs deposited on the silicon surface catalyze the process of metal-assisted chemical etching (MacEtch), which makes it possible to obtain Si nanostructures in the form of nanowire arrays.


  • Deposition of palladium nanoparticles on the silicon surface via galvanic replacement in DMSO

    by Mariana Shepida, Orest Kuntyi, Galyna Zozulya, Egor Kaniukov