Tatiana Kunkel
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Tatiana Kunkel has a total of 29 co-authors. Here are the top co-authors by number of shared publications:
- Dmitrii Shuleiko
Faculty of Physics, Moscow State University, Moscow, Russia
3 shared publications - Pavel K. Kashkarov
Faculty of Physics, Moscow State University, Moscow, Russia
3 shared publications - Petr I. Lazarenko
National Research University of Electronic Technology, Moscow, Russia
3 shared publications - Sergey A. Kozyukhin
NS Kurnakova Institute of General and Inorganic Chemistry, Moscow, Russia, Russia
3 shared publications - Stanislav V. Zabotnov
Faculty of Physics, Moscow State University, Moscow, Russia
3 shared publications - Yuri Vorobyov
Ryazan State Radio Engineering University 1 Department of Micro and Nano Electronics Gagarin St. 59, Ryazan 390005
3 shared publications
Latest Publications
- 28 August 2025
- Published by American Vacuum Society in Journal of Vacuum Science & Technology A
- Vol. 43 (5)
Morphology transformation of Ge2Sb2Te5 films induced by ultrashort laser pulses
Surface modification of phase-change materials using femtosecond laser irradiation offers significant potential for diverse applications due to the broad tunability of the material’s physical properties. In this study, atomic force microscopy was employed to investigate the surface morphology of Ge2Sb2Te5 thin films modified by femtosecond laser pulses (wavelength: 1030 nm). The obtained topographic maps were analyzed using fluctuation analysis and average mutual information methods, enabling the evaluation of correlation characteristics and the degree of surface ordering. The results demonstrate that as the crystallinity of the thin-film samples increases, both the correlation length and the scaling exponent exhibit a corresponding rise.
- 28 August 2025
- Published by American Vacuum Society in Journal of Vacuum Science & Technology A
- Vol. 43 (5)
Morphology transformation of Ge2Sb2Te5 films induced by ultrashort laser pulses
Surface modification of phase-change materials using femtosecond laser irradiation offers significant potential for diverse applications due to the broad tunability of the material’s physical properties. In this study, atomic force microscopy was employed to investigate the surface morphology of Ge2Sb2Te5 thin films modified by femtosecond laser pulses (wavelength: 1030 nm). The obtained topographic maps were analyzed using fluctuation analysis and average mutual information methods, enabling the evaluation of correlation characteristics and the degree of surface ordering. The results demonstrate that as the crystallinity of the thin-film samples increases, both the correlation length and the scaling exponent exhibit a corresponding rise.
- Open Access
Hierarchical Surface Structures and Large-Area Nanoscale Gratings in As2S3 and As2Se3 Films Irradiated with Femtosecond Laser Pulses
Chalcogenide vitreous semiconductors (ChVSs) find application in rewritable optical memory storage and optically switchable infrared photonic devices due to the possibility of fast and reversible phase transitions, as well as high refractive index and transmission in the near- and mid-infrared spectral range. Formed on such materials, laser-induced periodic surface structures (LIPSSs), open wide prospects for increasing information storage capacity and create polarization-sensitive optical elements of infrared photonics. In the present work, a possibility to produce LIPSSs under femtosecond laser irradiation (pulse duration 300 fs, wavelength 515 nm, repetition rate up to 2 kHz, pulse energy ranged 0.03 to 0.5 μJ) is demonstrated on a large (up to 5 × 5 mm2) area of arsenic sulfide (As2S3) and arsenic selenide (As2Se3) ChVS films. Scanning electron and atomic force microscopy revealed that LIPSSs with various periods (170–490 nm) and orientations can coexist within the same irradiated region as a hierarchical structure, resulting from the interference of various plasmon polariton modes generated under intense photoexcitation of nonequilibrium carriers within the film. The depth of the structures varied from 30 to 100 nm. The periods and orientations of the formed LIPSSs were numerically simulated using the Sipe–Drude approach. A good agreement of the calculations with the experimental data was achieved.
Open AccessHierarchical Surface Structures and Large-Area Nanoscale Gratings in As2S3 and As2Se3 Films Irradiated with Femtosecond Laser Pulses
Chalcogenide vitreous semiconductors (ChVSs) find application in rewritable optical memory storage and optically switchable infrared photonic devices due to the possibility of fast and reversible phase transitions, as well as high refractive index and transmission in the near- and mid-infrared spectral range. Formed on such materials, laser-induced periodic surface structures (LIPSSs), open wide prospects for increasing information storage capacity and create polarization-sensitive optical elements of infrared photonics. In the present work, a possibility to produce LIPSSs under femtosecond laser irradiation (pulse duration 300 fs, wavelength 515 nm, repetition rate up to 2 kHz, pulse energy ranged 0.03 to 0.5 μJ) is demonstrated on a large (up to 5 × 5 mm2) area of arsenic sulfide (As2S3) and arsenic selenide (As2Se3) ChVS films. Scanning electron and atomic force microscopy revealed that LIPSSs with various periods (170–490 nm) and orientations can coexist within the same irradiated region as a hierarchical structure, resulting from the interference of various plasmon polariton modes generated under intense photoexcitation of nonequilibrium carriers within the film. The depth of the structures varied from 30 to 100 nm. The periods and orientations of the formed LIPSSs were numerically simulated using the Sipe–Drude approach. A good agreement of the calculations with the experimental data was achieved.
- Open Access
Artificial Anisotropy in Ge2Sb2Te5 Thin Films after Femtosecond Laser Irradiation
Ge2Sb2Te5 (GST225) looks to be a promising material for rewritable memory devices due to its relatively easy processing and high optical and electrophysical contrast for the crystalline and amorphous phases. In the present work, we combined the possibilities of crystallization and anisotropic structures fabrication using femtosecond laser treatment at the 1250 nm wavelength of 200 nm thin amorphous GST225 films on silicon oxide/silicon substrates. A raster treatment mode and photoexcited surface plasmon polariton generation allowed us to produce mutually orthogonal periodic structures, such as scanline tracks (the period is 120 ± 10 μm) and laser-induced gratings (the period is 1100 ± 50 nm), respectively. Alternating crystalline and amorphous phases at the irradiated surfaces were revealed according to Raman spectroscopy and optical microscopy studies for both types of structures. Such periodic modulation leads to artificial optical and electrophysical anisotropy. Reflectance spectra in the near infrared range differ for various polarizations of probing light, and this mainly results from the presence of laser-induced periodic surface structures. On the other hand, the scanline tracks cause strong conductivity anisotropy for dc measurements in the temperature range of 200–400 K. The obtained results are promising for designing new GST225-based memory devices in which anisotropy may promote increasing the information recording density.
Open AccessArtificial Anisotropy in Ge2Sb2Te5 Thin Films after Femtosecond Laser Irradiation
Ge2Sb2Te5 (GST225) looks to be a promising material for rewritable memory devices due to its relatively easy processing and high optical and electrophysical contrast for the crystalline and amorphous phases. In the present work, we combined the possibilities of crystallization and anisotropic structures fabrication using femtosecond laser treatment at the 1250 nm wavelength of 200 nm thin amorphous GST225 films on silicon oxide/silicon substrates. A raster treatment mode and photoexcited surface plasmon polariton generation allowed us to produce mutually orthogonal periodic structures, such as scanline tracks (the period is 120 ± 10 μm) and laser-induced gratings (the period is 1100 ± 50 nm), respectively. Alternating crystalline and amorphous phases at the irradiated surfaces were revealed according to Raman spectroscopy and optical microscopy studies for both types of structures. Such periodic modulation leads to artificial optical and electrophysical anisotropy. Reflectance spectra in the near infrared range differ for various polarizations of probing light, and this mainly results from the presence of laser-induced periodic surface structures. On the other hand, the scanline tracks cause strong conductivity anisotropy for dc measurements in the temperature range of 200–400 K. The obtained results are promising for designing new GST225-based memory devices in which anisotropy may promote increasing the information recording density.
- Open Access
Periodic Relief Fabrication and Reversible Phase Transitions in Amorphous Ge2Sb2Te5 Thin Films upon Multi-Pulse Femtosecond Irradiation
Ge2Sb2Te5 based devices attract the attention of researchers due to wide opportunities in designing phase change memory. Herein, we studied a possibility to fabricate periodic micro- and nanorelief at surfaces of Ge2Sb2Te5 thin films on silicon oxide/silicon substrates under multi-pulse femtosecond laser irradiation with the wavelength of 1250 nm. One-dimensional lattices with periods of 1250 ± 90 and 130 ± 30 nm were obtained depending on the number of acted laser pulses. Emergence of these structures can be explained by plasmon-polariton generation and laser-induced hydrodynamic instabilities, respectively. Additionally, formation of the lattices whose spatial period is close to the impacted laser wavelength can be modelled by considering the free carrier contribution under intensive photoexcitation. Raman spectroscopy revealed both crystallization and re-amorphization of the irradiated films. The obtained results show a possibility to fabricate rewritable all-dielectric data-storage devices based on Ge2Sb2Te5 with the periodic relief.
Open AccessPeriodic Relief Fabrication and Reversible Phase Transitions in Amorphous Ge2Sb2Te5 Thin Films upon Multi-Pulse Femtosecond Irradiation
Ge2Sb2Te5 based devices attract the attention of researchers due to wide opportunities in designing phase change memory. Herein, we studied a possibility to fabricate periodic micro- and nanorelief at surfaces of Ge2Sb2Te5 thin films on silicon oxide/silicon substrates under multi-pulse femtosecond laser irradiation with the wavelength of 1250 nm. One-dimensional lattices with periods of 1250 ± 90 and 130 ± 30 nm were obtained depending on the number of acted laser pulses. Emergence of these structures can be explained by plasmon-polariton generation and laser-induced hydrodynamic instabilities, respectively. Additionally, formation of the lattices whose spatial period is close to the impacted laser wavelength can be modelled by considering the free carrier contribution under intensive photoexcitation. Raman spectroscopy revealed both crystallization and re-amorphization of the irradiated films. The obtained results show a possibility to fabricate rewritable all-dielectric data-storage devices based on Ge2Sb2Te5 with the periodic relief.