Marcos Paulo Gonçalves Pedroso
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Marcos Paulo Gonçalves Pedroso has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
Breno Mendonça
1 shared publication- Flávio Fernandes Barbosa Silva
Federal Institute of Education, Science and Technology Minas Gerais
1 shared publication - João Victor Oliveira Rodrigues
Federal Institute of Education, Science and Technology Minas Gerais
1 shared publication - Reginaldo Gonçalves Leão Junior
Basic Academic Division, Federal Institute of Minas Gerais (IFMG), Arcos 35600-306, MG, Brazil
1 shared publication
Latest Publications
- Open Access
- 14 November 2021
- Published by Research, Society and Development in Research, Society and Development
- Vol. 10 (15)
Performance evaluation of accelerometers ADXL345 and MPU6050 exposed to random vibrational input
The use of vibration monitors is a well-established practice in industrial maintenance, usually vibration sensors are positioned at specific points on the monitored machinery and data are continuously collected to feed a machine operating health control system. Nevertheless, the technology for obtaining the signal, its treatment and analysis is generally expensive, and the financial return is not evident, which justifies the development of low-cost alternatives technologies. In this work was performed an analysis of the responses of two Micro-Electro-Mechanical accelerometers, models ADXL345 and MPU6050, exposed to a low intensity random signal and standard operating frequency. The objective of the analysis was to verify the capacity of these devices to be used as mechanical vibration sensors for rotating machines. For this purpose, offset shift analyzes of the sensors due to the Earth's gravitational field were performed, as well as vibrational spectrum and rectification errors analysis under multiple conditions. The data pointed to a greater uniformity of the MPU6050 response, while several behavioral anomalies were seen in the ADXL345, when these sensors are exposed to the same mechanical signal. The qualitative and quantitative behavior of MPU6050 rectification error was consistent with reported in the literature. It was noted that the methodology used can profile the behavior of sensors, however, it is not sufficient to safely justify the inaccuracies, requiring that the tests be performed on a statistically representative number of sensors from different manufacturers and batches.
- 14 November 2021
- Published by Research, Society and Development in Research, Society and Development
- Vol. 10 (15)
Open AccessPerformance evaluation of accelerometers ADXL345 and MPU6050 exposed to random vibrational input
The use of vibration monitors is a well-established practice in industrial maintenance, usually vibration sensors are positioned at specific points on the monitored machinery and data are continuously collected to feed a machine operating health control system. Nevertheless, the technology for obtaining the signal, its treatment and analysis is generally expensive, and the financial return is not evident, which justifies the development of low-cost alternatives technologies. In this work was performed an analysis of the responses of two Micro-Electro-Mechanical accelerometers, models ADXL345 and MPU6050, exposed to a low intensity random signal and standard operating frequency. The objective of the analysis was to verify the capacity of these devices to be used as mechanical vibration sensors for rotating machines. For this purpose, offset shift analyzes of the sensors due to the Earth's gravitational field were performed, as well as vibrational spectrum and rectification errors analysis under multiple conditions. The data pointed to a greater uniformity of the MPU6050 response, while several behavioral anomalies were seen in the ADXL345, when these sensors are exposed to the same mechanical signal. The qualitative and quantitative behavior of MPU6050 rectification error was consistent with reported in the literature. It was noted that the methodology used can profile the behavior of sensors, however, it is not sufficient to safely justify the inaccuracies, requiring that the tests be performed on a statistically representative number of sensors from different manufacturers and batches.