Younas Iqbal
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Younas Iqbal has a total of 35 co-authors. Here are the top co-authors by number of shared publications:
Asim Shahzad
2 shared publicationsMuhammad Adil
2 shared publications- Asim Shahzad
The College of Geography and Environmental Sciences, Henan University, Kaifeng, China
1 shared publication - Atiqa Zahra
Department of Botany, Mohi-ud-Din Islamic University, Nerian Sharif 12080, Azad Jammu and Kashmir, Pakistan
1 shared publication Chao Wang
Institute for Computational Materials Science, School of Physics and Electronics, Henan University, Kaifeng, People’s Republic of China
1 shared publication- Chao Wang
Henan Key Laboratory of High Efficiency Energy Conversion Science and Technology, Henan International Joint Laboratory of New Energy Materials and Devices, School of Physics and Electronics, Henan University, Kaifeng 475004, China
1 shared publication
Latest Publications
- Open Access
- 26 October 2026
- Published by Elsevier in Desalination and Water Treatment
- Vol. 328
Preparation of magnetic Co doped γ- Fe2O3nanoparticles used in the removal of tetracycline via adsorption coupled with an advanced oxidation process
- 26 October 2026
- Published by Elsevier in Desalination and Water Treatment
- Vol. 328
Open AccessPreparation of magnetic Co doped γ- Fe2O3nanoparticles used in the removal of tetracycline via adsorption coupled with an advanced oxidation process
- 18 August 2025
- Published by Springer Nature in Journal of Materials Engineering and Performance
- Vol. 35 (3) , 2466-2475
N-Type Mg3Sb2 (Bi, Te) Alloy Preparation and its Thermoelectric Performance Enhancement
- 18 August 2025
- Published by Springer Nature in Journal of Materials Engineering and Performance
- Vol. 35 (3) , 2466-2475
N-Type Mg3Sb2 (Bi, Te) Alloy Preparation and its Thermoelectric Performance Enhancement
- Open Access
- 11 July 2024
- Published by Elsevier in Ecotoxicology and Environmental Safety
- Vol. 282, 116698
Modern perspectives of heavy metals alleviation from oil contaminated soil: A review
- 11 July 2024
- Published by Elsevier in Ecotoxicology and Environmental Safety
- Vol. 282, 116698
Open AccessModern perspectives of heavy metals alleviation from oil contaminated soil: A review
- Open Access
Spatial Distribution and Risk Assessment of Heavy Metal(oid)s Contamination in Topsoil around a Lead and Zinc Smelter in Henan Province, Central China
A total of 137 farmland soil samples were collected around a lead/zinc smelter within 64 km2. The concentration, spatial distribution, and potential source of nine heavy metal(oid)s (As, Cd, Co, Cr, Cu, Ni, Pb, V, and Zn) in soils and their potential ecological risk were investigated in detail. The results showed that the average concentrations of Cd, Pb, Cr and Zn in these soils were higher than their background value in Henan Province, and the average content of Cd was 2.83 times of the risk screening values in the national standard of China (GB 15618-2018). According to the distribution of different heavy metal(oid)s in soils, Cd and Pb in soil decrease gradually with the increase of distance from the smelter to the surrounding area. This indicates that the Pb and Cd originate from smelters via airborne practices according to the typical air pollution diffusion model. The distribution of Zn, Cu, and As were similar to Cd and Pb. However, Ni, V, Cr, and Co were mainly affected by soil parent materials. The potential ecological risk of Cd was higher than those of other elements, and the risk grade of the other eight elements was mainly low. The polluted soils with significantly high and high potential ecological risk covered 93.84% of all the studied regions. This should be of serious concern to government. The results of a principal component analysis (PCA) and cluster analysis (CA) show that Pb, Cd, Zn, Cu, and As were the elements mainly stemmed from smelter and other types of plants, with a contribution rate of 60.08%, while Co, Cr, Ni, and V are mainly caused by nature, with a contribution rate of 26.26%.
Open AccessSpatial Distribution and Risk Assessment of Heavy Metal(oid)s Contamination in Topsoil around a Lead and Zinc Smelter in Henan Province, Central China
A total of 137 farmland soil samples were collected around a lead/zinc smelter within 64 km2. The concentration, spatial distribution, and potential source of nine heavy metal(oid)s (As, Cd, Co, Cr, Cu, Ni, Pb, V, and Zn) in soils and their potential ecological risk were investigated in detail. The results showed that the average concentrations of Cd, Pb, Cr and Zn in these soils were higher than their background value in Henan Province, and the average content of Cd was 2.83 times of the risk screening values in the national standard of China (GB 15618-2018). According to the distribution of different heavy metal(oid)s in soils, Cd and Pb in soil decrease gradually with the increase of distance from the smelter to the surrounding area. This indicates that the Pb and Cd originate from smelters via airborne practices according to the typical air pollution diffusion model. The distribution of Zn, Cu, and As were similar to Cd and Pb. However, Ni, V, Cr, and Co were mainly affected by soil parent materials. The potential ecological risk of Cd was higher than those of other elements, and the risk grade of the other eight elements was mainly low. The polluted soils with significantly high and high potential ecological risk covered 93.84% of all the studied regions. This should be of serious concern to government. The results of a principal component analysis (PCA) and cluster analysis (CA) show that Pb, Cd, Zn, Cu, and As were the elements mainly stemmed from smelter and other types of plants, with a contribution rate of 60.08%, while Co, Cr, Ni, and V are mainly caused by nature, with a contribution rate of 26.26%.
- Open Access
- 26 April 2023
- Published by IntechOpen
Perspective Chapter: Effect of Gold Seed Layer Annealing on the Surface Roughness and Nanostructure Growth
ZnO has gain a great attention in many applications due to its wide band gap. Orientation and alignment of ZnO nanorods are the key objectives of fundamental applied research. They may be produced by both physical and chemical methods, however the chemical method has the advantages of low temperature and pressure conditions. The electronic properties of ZnO nanorods are more superior then the thin films. Most of the applications of ZnO nanorods depends on the morphology, orientation and interspacing among them. Seed layer on the substrate has a key role in the morphology of ZnO nanorods. In this chapter the, orientation, alignment and a clear mechanism of ZnO nanorods production in hydrothermal method is presented. The experimental results deduced that the ZnO nanorods are produced in the precursor solution and move down to the substrate through 001 face stab between the successive grains generated through annealing of gold seed layer, and as a result an oriented and aligned array of the nanorods are formed on the substrate.
- 26 April 2023
- Published by IntechOpen
Open AccessPerspective Chapter: Effect of Gold Seed Layer Annealing on the Surface Roughness and Nanostructure Growth
ZnO has gain a great attention in many applications due to its wide band gap. Orientation and alignment of ZnO nanorods are the key objectives of fundamental applied research. They may be produced by both physical and chemical methods, however the chemical method has the advantages of low temperature and pressure conditions. The electronic properties of ZnO nanorods are more superior then the thin films. Most of the applications of ZnO nanorods depends on the morphology, orientation and interspacing among them. Seed layer on the substrate has a key role in the morphology of ZnO nanorods. In this chapter the, orientation, alignment and a clear mechanism of ZnO nanorods production in hydrothermal method is presented. The experimental results deduced that the ZnO nanorods are produced in the precursor solution and move down to the substrate through 001 face stab between the successive grains generated through annealing of gold seed layer, and as a result an oriented and aligned array of the nanorods are formed on the substrate.
- Open Access
- 1 December 2021
- Published by AIP Publishing in AIP Advances
- Vol. 11 (12) , 125006
Orientation and actual growth mechanism of ZnO nanorods through hydrothermal method on gold seed layer
In this study, the hydrothermal method was employed to synthesize an oriented ZnO nanorod array on an annealed gold seed layer coated on a glass substrate from different precursor concentrations. Zinc nitrate hexahydrate and hexamethylenetetramine were used as starting materials for ZnO nanorod growth. The effect of gold seed layer roughness on the orientation of ZnO nanorods is presented. The morphology of the nanorods shows that oriented ZnO nanorods were obtained after deposition on the annealed gold seed layer. Energy dispersive x-ray spectroscopy was used to identify the elemental composition and identify the elements present in the samples. The XRD pattern shows that the nanorods have a good crystalline structure, with dominant (002) peaks for all concentrations, which reflects that the c-axis of the elongated nanorods is oriented normal to the substrate. The proposed growth mechanism for the growth of ZnO nanorods is presented.
- 1 December 2021
- Published by AIP Publishing in AIP Advances
- Vol. 11 (12) , 125006
Open AccessOrientation and actual growth mechanism of ZnO nanorods through hydrothermal method on gold seed layer
In this study, the hydrothermal method was employed to synthesize an oriented ZnO nanorod array on an annealed gold seed layer coated on a glass substrate from different precursor concentrations. Zinc nitrate hexahydrate and hexamethylenetetramine were used as starting materials for ZnO nanorod growth. The effect of gold seed layer roughness on the orientation of ZnO nanorods is presented. The morphology of the nanorods shows that oriented ZnO nanorods were obtained after deposition on the annealed gold seed layer. Energy dispersive x-ray spectroscopy was used to identify the elemental composition and identify the elements present in the samples. The XRD pattern shows that the nanorods have a good crystalline structure, with dominant (002) peaks for all concentrations, which reflects that the c-axis of the elongated nanorods is oriented normal to the substrate. The proposed growth mechanism for the growth of ZnO nanorods is presented.