LLLu Liu

Lu Liu

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Lu Liu has a total of 10 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Improving the Scale Factor Thermal Stability of Resonant Fiber-Optic Gyroscopes by Tracking the Half-Wave Voltage of the Phase Modulator

    by Lu Liu, Shuang Liu, Hewei Wang, Junyi Hu, Binjie Li, Huilian Ma

    In this paper, a novel method for detecting and tracking the half-wave voltage of the phase modulator in a resonant fiber-optic gyroscope (RFOG) is proposed and demonstrated. A theoretical model is first developed to illustrate the effect of phase modulator half-wave voltage fluctuations on the stability of the RFOG scale factor. A novel method for detecting the half-wave voltage fluctuations is then proposed by applying an additional sawtooth modulation signal. Based on this, a double closed-loop RFOG system scheme employing a half-wave voltage servo loop is designed to simultaneously eliminate the sawtooth wave reset voltage error during the RFOG operation. The performance of the RFOG was tested under variable temperature conditions. The experimental results indicated that the reset voltage errors could be controlled within 1 mV, and the scale factor thermal stability was improved from 95.97 ppm/°C to 9.39 ppm/°C.


  • Improving the Performance of Broadband Source-Driven Resonant Fiber-Optic Gyroscopes

    by Shuang Liu, Junyi Hu, Yuxin Wang, Hewei Wang, Lu Liu, Huilian Ma

    The broadband source-driven resonant fiber-optic gyroscope (RFOG), as a new type of gyroscope, demonstrates impressive advantages in both detection sensitivity and long-term bias stability. To further improve the system performance, this paper investigates the factors affecting the detection sensitivity and long-term bias stability of the broadband source-driven RFOG. Two mathematical models are developed to analyze the relationship between the fiber-optic ring resonator (FRR) parameters and the detection sensitivity, as well as the error induced by imperfect modulation signals. The analysis shows that the detection sensitivity can be improved by optimizing the coupling coefficients of the FRR. Meanwhile, the bias error at the output of the gyroscope caused by imperfect modulation can be effectively suppressed by improving the harmonic suppression ratio of the modulation signal and compensating the phase difference between the first and second harmonics. Finally, after using the optimized FRR and suppressing the error due to imperfect modulation, the experimental results show that the bias stability is in the range of 1°/h to 450μ°/h for different cavity lengths.


  • Top Cited Papers

    Closed-Loop Resonant Fiber-Optic Gyroscope With a Broadband Light Source

    by Junyi Hu, Shuang Liu, Lu Liu, Huilian Ma

    The resonant fiber-optic gyroscope (RFOG) with a broadband light source has recently emerged as an attractive new type optical gyroscope. However, the use of a broadband source limits the linear dynamic range and worsens the scale factor accuracy. In this article, the closed-loop scheme of the broadband source-driven RFOG is proposed and demonstrated. First, a novel method called the period-stacking method is presented. Then the closed-loop mechanism of the broadband source system is revealed. Although the rotation-induced frequency difference is wavelength-dependent in the broadband source scheme, we are pleased to find that the frequency shift generated by the serrodyne modulation is wavelength-independent and can be used to compensate for the rotation information. Finally, a closed-loop broadband source-driven RFOG with a 100 m-long and 7.6 cm-diameter fiber-optic ring resonator is experimentally demonstrated. The measured result shows that the long-term bias stability of the closed-loop broadband source-driven RFOG is 0.0063 °/h over a test time of up to 500 minutes. The temperature dependence drops from 2.8 (°/h)/°C in the open-loop system to 0.54 (°/h)/°C. It is improved by a factor of 5.2. The open-loop linear detection range of ±50 °/s is improved to ±350 °/s. It is improved by a factor of 7. The open-loop scale factor nonlinearity of 8% is decreased to 0.0281% (281 ppm), which is improved by a factor of 285.


  • Evaluation and Measurement of the Lock-in Effect in Resonant Fiber Optic Gyroscopes

    by Lu Liu, Shuang Liu, Huilian Ma, Zhonghe Jin

    This paper makes a deep investigation of the lock-in behavior in a resonant fiber-optic gyroscope (RFOG). A theoretical model is first set up to reveal the mechanism of how the backscattering creates a lock-in phenomenon at the gyro output. After phase modulation, the RFOG has more than one lock-in zone. These lock-in zones are symmetrically distributed around zero rotation rate originating from the backscattering inside the resonator, but also being affected by the modulation parameters and feedback loops. Experimentally, we tested the lock-in phenomenon in a closed-loop RFOG. The main lock-in range is measured to be 30 °/h which agrees well with the theoretical result. Finally, we successfully demonstrated the elimination of the lock-in behavior by optimizing the modulation parameters in combination with the bandwidth of the feedback loop.


  • Evaluation and Suppression of the Effect of Laser Frequency Noise on Resonant Fiber Optic Gyroscope

    by Lu Liu, Hanzhao Li, Huilian Ma, Zhonghe Jin

    This article provides a novel method to analyze and calculate the effect of laser frequency noise on a resonant fiber optic gyroscope (RFOG). The output signal of the fiber ring resonator is expressed as the sum of various harmonic responses. It is found that the laser frequency noise at certain noise frequency would be demodulated together with the rotation-induced frequency signal, and thus deteriorating the gyro output stability. A theoretical model is then setup. The effect of laser frequency noise on the RFOG based on the separate modulation-demodulation technique is numerically evaluated and the effectiveness of the reciprocal modulation-demodulation technique is verified both theoretically and experimentally. The measured angular random walk of the reciprocal RFOG improves as the detected light power at the photodetector increases, which indicates that the measured angular random walk reaches the theoretical shot-noise limited sensitivity in the RFOG. The best value is 0.0021 °/√h when the light power arrived at the photodetector is 69 μW.