Sukhyeong Youn
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Sukhyeong Youn has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
- Jiwon Chang
Yonsei University
3 shared publications - Aujin Hwang
Department of Electrical and Computer Engineering, Ajou University, Suwon 16499, South Korea
1 shared publication - Chan Ho Lee
School of Electronic Engineering, Soongsil University, Seoul, South Korea
1 shared publication Eunyeong Yang
Department of System Semiconductor Engineering, Yonsei University, Seoul 03722, South Korea
1 shared publication- Geonwook Yoo
Department of Intelligent Semiconductors, Soongsil University 1 , Seoul 06978
1 shared publication Han Beom Jeong
Department of Materials Science and Engineering, Korea Advanced Institute of Science and Technology (KAIST), Daejeon 34141, South Korea
1 shared publication
Latest Publications
- 15 September 2023
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 15 (38) , 45116-45127
Large-Scale Complementary Logic Circuit Enabled by Al2O3 Passivation-Induced Carrier Polarity Modulation in Tungsten Diselenide
Achieving effective polarity control of n- and p-type transistors based on two-dimensional (2D) materials is a critical challenge in the process of integrating transition metal dichalcogenides (TMDC) into complementary metal-oxide semiconductor (CMOS) logic circuits. Herein, we utilized a proficient and nondestructive method of electron-charge transfer to achieve a complete carrier polarity conversion from p-to n-type by depositing a thin layer of aluminum oxide (Al2O3) onto tungsten diselenide (WSe2). By utilizing the Al2O3 passivation layer, we observed precisely tuned n-type behavior in contrast to transistors fabricated on the as-grown WSe2 film without any passivation layer, which display prominent p-type behavior. The polarity-transformed n-type WSe2 transistor from the pristine p-type shows the maximum ON current of ∼0.1 μA accompanied by a high electron mobility of 7 cm2 V-1 s-1 at a drain voltage (VDS) of 1 V. We successfully showcased a homogeneous CMOS inverter utilizing 2D-TMDC which exhibits an impressive voltage gain of 7 at VDD = 5 V. Moreover, this effective polarity control approach was further expanded upon to successfully demonstrate a range of logic circuits such as AND, OR, NAND, NOR logic gates, and SRAM. The proposed methodology possesses significant promise for facilitating the advancement of high-density circuitry components utilizing 2D-TMDC.
- 15 September 2023
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 15 (38) , 45116-45127
Large-Scale Complementary Logic Circuit Enabled by Al2O3 Passivation-Induced Carrier Polarity Modulation in Tungsten Diselenide
Achieving effective polarity control of n- and p-type transistors based on two-dimensional (2D) materials is a critical challenge in the process of integrating transition metal dichalcogenides (TMDC) into complementary metal-oxide semiconductor (CMOS) logic circuits. Herein, we utilized a proficient and nondestructive method of electron-charge transfer to achieve a complete carrier polarity conversion from p-to n-type by depositing a thin layer of aluminum oxide (Al2O3) onto tungsten diselenide (WSe2). By utilizing the Al2O3 passivation layer, we observed precisely tuned n-type behavior in contrast to transistors fabricated on the as-grown WSe2 film without any passivation layer, which display prominent p-type behavior. The polarity-transformed n-type WSe2 transistor from the pristine p-type shows the maximum ON current of ∼0.1 μA accompanied by a high electron mobility of 7 cm2 V-1 s-1 at a drain voltage (VDS) of 1 V. We successfully showcased a homogeneous CMOS inverter utilizing 2D-TMDC which exhibits an impressive voltage gain of 7 at VDD = 5 V. Moreover, this effective polarity control approach was further expanded upon to successfully demonstrate a range of logic circuits such as AND, OR, NAND, NOR logic gates, and SRAM. The proposed methodology possesses significant promise for facilitating the advancement of high-density circuitry components utilizing 2D-TMDC.
- Open Access
- 10 March 2023
- Published by Wiley in Advanced Electronic Materials
- Vol. 9 (5)
Computational Analysis of Metal Contact on Bi2O2Se with Se Surface Vacancies
In this work, a theoretical study on the electronic properties of the metal/Bi2O2Se interface is presented through the density functional theory calculation. Particularly, the effects of Cr, Pd, Pt, Au, and Bi on monolayer, bilayer, and trilayer Bi2O2Se are explored. Naturally created Se vacancies on the Bi2O2Se surface are also considered by constructing two interface structures: the metal/Bi2O2Se with the Se vacancies remaining or filled with metals. For the metal/monolayer Bi2O2Se, it is observed that the Bi2O2Se layer is fully metallized since Bi2O2Se strongly interacts with the metal. Meanwhile, for the metal/bilayer and trilayer Bi2O2Se, the Bi2O2Se layers remain semiconducting except for the layer right next to metal. Among the considered metals, regardless of whether the Se vacancies are filled with metal or not, the semiconducting layers in bilayer and trilayer Bi2O2Se form Ohmic contact with Bi. It is also found that filling the Se vacancies with the metals heavier than Se increases the interface distance between metal and Bi2O2Se, and hence results in the weak Fermi level pinning effect.
- 10 March 2023
- Published by Wiley in Advanced Electronic Materials
- Vol. 9 (5)
Open AccessComputational Analysis of Metal Contact on Bi2O2Se with Se Surface Vacancies
In this work, a theoretical study on the electronic properties of the metal/Bi2O2Se interface is presented through the density functional theory calculation. Particularly, the effects of Cr, Pd, Pt, Au, and Bi on monolayer, bilayer, and trilayer Bi2O2Se are explored. Naturally created Se vacancies on the Bi2O2Se surface are also considered by constructing two interface structures: the metal/Bi2O2Se with the Se vacancies remaining or filled with metals. For the metal/monolayer Bi2O2Se, it is observed that the Bi2O2Se layer is fully metallized since Bi2O2Se strongly interacts with the metal. Meanwhile, for the metal/bilayer and trilayer Bi2O2Se, the Bi2O2Se layers remain semiconducting except for the layer right next to metal. Among the considered metals, regardless of whether the Se vacancies are filled with metal or not, the semiconducting layers in bilayer and trilayer Bi2O2Se form Ohmic contact with Bi. It is also found that filling the Se vacancies with the metals heavier than Se increases the interface distance between metal and Bi2O2Se, and hence results in the weak Fermi level pinning effect.
- Open Access
- 17 December 2021
- Published by American Association for the Advancement of Science (AAAS) in Science Advances
- Vol. 7 (51) , eabj2521
Visible and infrared dual-band imaging via Ge/MoS2van der Waals heterostructure
Ge/MoS2van der Waals heterostructure enables bias-dependent selective detection of visible and near infrared.
- 17 December 2021
- Published by American Association for the Advancement of Science (AAAS) in Science Advances
- Vol. 7 (51) , eabj2521
Open AccessVisible and infrared dual-band imaging via Ge/MoS2van der Waals heterostructure
Ge/MoS2van der Waals heterostructure enables bias-dependent selective detection of visible and near infrared.