Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Slađana Savić has a total of 40 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • JWPE 3-min Pitch 2025: "My Life in Water" - Part 2

    by Slađana Savić Jovanović, Olga El El Kik, Stefano Cairone, Samuel Navajas Valiente, Rajashree Yalamanchili, Sanaa Adlane, Nkeshe Khutso Ramogale, Toheeb Obidara, Hamid Boleydei, Xinyu Wang

    The JWPE 3-Minute Pitch - 'My Life in Water' is a global initiative that celebrates the outstanding research conducted by PhD students from any country working in the area of water processing and engineering. It aims at supporting dissemination and outreach training to develop capacity building for JWPE’s outcoming and emerging researchers. The challenge is for PhD students to encapsulate their research in a three-minute presentation, using language understandable to a non-specialist audience.

  • Open Access

    Holmium Metal Nanoparticle PbO2 Anode Formed by Electrodeposition for Efficient Removal of Insecticide Acetamiprid and Improved Oxygen Evolution Reaction

    by Milica Kaludjerović, Sladjana Savić, Danica Bajuk-Bogdanović, Aleksandar Jovanović, Lazar Rakočević, Goran Roglić, Jadranka Milikić, Dalibor Stanković

    This work examines the possibility of using a PbO2-based electrode doped with the rare-earth metal holmium in the field of oxygen evolution and the development of an efficient method for the degradation of acetamiprid. Acetamiprid is a widely used insecticide and, as such, it very often reaches waterways, where it can cause many problems for wildlife and the environment. X-ray powder diffraction analysis, Raman spectroscopy, and energy-dispersive X-ray spectroscopy results confirmed the structure of Ti/SnO2-Sb2O3/Ho-PbO2, while the morphology of its surface was investigated by scanning electron microscopy with energy-dispersive X-ray spectroscopy. Ti/SnO2-Sb2O3/Ho-PbO2 showed good OER activity in alkaline media with a Tafel slope of 138 mV dec−1. The Ti/SnO2-Sb2O3/Ho-PbO2 electrode shows very good efficiency in removing acetamiprid. By optimizing the degradation procedure, the following operating conditions were obtained: a current density of 20 mA cm−2, a pH value of the supporting electrolyte (sodium sulfate) of 2, and a concentration of the supporting electrolyte of 0.035 M. After optimization, the maximum efficiency of removing acetamiprid (10 mg L−1, 4.5 × 10−5 mol) from water was achieved, 96.8%, after only 90 min of treatment, which represents an efficiency of 1.125 mol cm−2 of the electrode. Additionally, it was shown that the degradation efficiency is strictly related to the concentration of the treated substance.


  • Open Access

    Samarium-Doped PbO2 Electrocatalysts for Environmental and Energy Applications: Theoretical Insight into the Mechanisms of Action Underlying Their Carbendazim Degradation and OER Properties

    by Milica Kaluđerović, Slađana Savić, Danica Bajuk-Bogdanović, Aleksandar Z. Jovanović, Lazar Rakočević, Filip Vlahović, Jadranka Milikić, Dalibor Stanković

    This study presents the fabrication of a samarium-doped Ti/Sb-SnO2/PbO2 electrode and investigates its applications in polluted water treatment and energy conversion. Physicochemical properties were characterized by scanning electron microscopy with energy-dispersive X-ray spectroscopy, X-ray powder diffraction analysis, and Raman spectroscopy. The Ti/Sb-SnO2/Sm-PbO2 electrode showed 2.5 times higher oxygen evolution potential activity than the Ti/Sb-SnO2/PbO2 electrode. Density Functional Theory was used to conduct first-principles calculations, and the obtained results indicated that Sm doping enhances the production of reactive oxygen species. The application of the Ti/Sb-SnO2/Sm-PbO2 electrode in carbendazim (CBZ) removal was investigated, since CBZ is a fungicide whose presence in the environment, including food, water, and soil, poses a threat. After 60 min of the treatment under optimized working parameters, the degradation rate of CBZ reached 94.2% in the presence of 7.2 g/L Na2SO4 with an applied current density of 10 mA/cm2 in an acidic medium (pH 4). Of the four investigated parameters, the current density had the most significant influence on the degradation process. At the same time, the initial pH value of the solution was shown to have the least impact on degradation efficiency. These results imply a potential use of the proposed treatment for CBZ removal from wastewater.


  • Degradation of fluoroquinolone antibiotic levofloxacin by UV-induced ferric ion photolysis in aqueous medium: The role of pH and chelation

    by Jelena Korać Jačić, Ivan Spasojević, Danica Bajuk-Bogdanović, Slađana Savić, Dragana Bartolić, Dragana Maglić, Milica Milenković


  • Open Access

    HPLC-DAD identification of compounds in corrosion inhibitor Salix alba bark extract and the hydrolate

    by Milica Zdravković, Slađana Savić, Vesna Grekulović, Dalibor Stanković

    The compounds present in Salix alba bark (SAB) extract and its hydrolate were identified using high-performance liquid chromatography with diode array detection (HPLC-DAD). SAB extract and its hydrolate were obtained by evaporating a macerate of dried, ground white willow bark and hot distilled water. A total of 19 standard polyphenolic compounds were used for the HPLC analysis. Results indicate that only 4-hydroxybenzoic acid (4-HBA) was detected in the SAB hydrolate. In contrast, both gallic acid and caffeic acid were present in the SAB extract. The presence of 4-HBA indicates the potential possibility of using SAB hydrolate as a starting component for the synthesis of parabens and other 4-HBA derivatives. Additionally, the identification of gallic and caffeic acids in the SAB extract further confirms the effect as a cathodic inhibitor of copper corrosion in chloride environments, because both acids are proven cathodic inhibitors of copper in different corrosion environments.

  • Open Access

    ATR-FTIR characterization of the white willow bark extract used as a copper corrosion inhibitor

    by Milica Zdravković, Slađana Savić, Vesna Grekulović, Dalibor Stanković, Iva Dimitrievska

    As proved inhibitor of copper corrosion in saline environment, the white willow bark (WWB) extract was characterized using the Attenuated Total Reflectance-Fourier Transform Infrared spectroscopy (ATR-FTIR) method. By identifying the bands typical for phenolic profile of WWB extract, the anti-corrodic properties of WWB were explained. The hydrogen-bonded O-H stretching vibrations present in WWB extract is attributed to the phenolic hydroxyl groups and alcoholic hydroxyl groups within glycosides. The C-H stretching vibrations typical for salicin and for glucoside part of salicin aromatic were also identified, as well as the C=C ring stretching vibrations and C-O stretching vibrations that can be attributed to phenolic and alcoholic groups. The presence of these functional groups confirms the presence of a protective film of the WWB extract on the copper surface, protecting the metal from the corrosive effect of chloride ions.

  • Influence of blackberry leaf extract on the copper corrosion behaviour in 0.5 M NaCl

    by Milica Zdravković, Vesna Grekulović, Jasmin Suljagić, Dalibor Stanković, Slađana Savić, Milan Radovanović, Uroš Stamenković


  • Open Access

    Differently Prepared PbO2/Graphitic Carbon Nitride Composites for Efficient Electrochemical Removal of Reactive Black 5 Dye

    by Aleksandar Marković, Slađana Savić, Andrej Kukuruzar, Zoltan Konya, Dragan Manojlović, Miloš Ognjanović, Dalibor M. Stanković

    In this paper, electrochemical degradation of Reactive Black 5 (RB5) textile azo dye was examined in regard to different synthesis procedures for making PbO2–graphitic carbon nitride (g-C3N4) electrode. The reaction of PbOH3- with ClO− in the presence of different surfactants, i.e., cetyltrimethylammonium bromide (CTAB) and tetrabutylammonium phosphate (TBAP), under conventional conditions, resulted in the formation of PbO2 with varying morphology. The obtained materials were combined with g-C3N4 for the preparation of the final composite materials, which were then characterized morphologically and electrochemically. After optimizing the degradation method, it was shown that an anode comprising a steel electrode coated with the composite of PbO2 synthesized using CTAB as template and g-C3N4, and using 0.15 M Na2SO4 as the supporting electrolyte, gave the best performance for RB5 dye removal from a 35 mg/L solution. The treatment duration was 60 min, applying a current of 0.17 A (electrode surface 4 cm2, current density of 42.5 mA/cm2), while the initial pH of the testing solution was 2. The reusability and longevity of the electrode surface (which showed no significant change in activity throughout the study) may suggest that this approach is a promising candidate for wastewater treatment and pollutant removal.


  • Open Access

    Microspherical Titanium-Phosphorus Double Oxide: Hierarchical Structure Development for Sensing Applications

    by Elena Korina, Anton Abramyan, Oleg Bol’shakov, Vyacheslav V. Avdin, Sladjana Savić, Dragan Manojlović, Vesna Stanković, Dalibor M. Stanković

    Stable, water-soluble titanium complexed with mandelic acid was used as a precursor for titanium phosphorus double oxide obtained in hydrothermal conditions in the presence of phosphoric acid. Surprisingly, hydrolysis of organic complexes provided a microstructured sphere with narrow size distribution, low aggregation and a small fraction of morphological irregularities. Obtained microspheres had a complex structure comprised of flakes, whose size could be manipulated with temperature conditions. Samples were found to be electrochemically active against sulcotrione, a well-recognized herbicide. Electrochemical sensors based on the synthesized microspheres were successfully adapted for natural water reservoir analysis and exhibited low levels of detection of 0.61 µM, limit of quantification of 1.86 µM, wide dynamic linear range from 2 to 200 µM, good selectivity, excellent reproducibility and in-time stability.


  • Open Access

    In-house-prepared carbon-based Fe-doped catalysts for electro-Fenton degradation of azo dyes

    by Slađana D. Savić, Goran M. Roglić, Vyacheslav V. Avdin, Dmitry A. Zherebtsov, Dalibor M. Stanković, Dragan D. Manojlović

    Compounds used in the fashion industry effect the water bodies in the vicinity of textile factories, resulting in the visible coloration of surface water. Fe-doped graphite-based in house prepared electrodes were used in the Fenton- -like degradation of Reactive Blue 52 (RB52). The electrodes consisting of high-density graphite in three granulation sizes and three levels of Fe content were characterized using scanning electron microscopy (SEM). The amount of Fe in the electrodes and H2O2 concentration in synthetic textile wastewater were optimized. Additionally, the size of graphite grains was varied to investigate whether it effects the degradation rate. Under only 10 min of electro-Fenton degradation, a system with 10 mmol dm-3 of H2O2 and an electrode made of 7 % of Fe and 70 ?m of granulation size of graphite, degraded over 75 % of RB52, and over 99 % after 40 min of treatment. The obtained results indicate that the proposed approach could be beneficial in the field of novel materials for environmental application and that in house prepared carbon could be an excellent replacement for commercially available supports.