AKAbbas Khodabakhshi

Abbas Khodabakhshi

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Abbas Khodabakhshi has a total of 52 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Risk assessment of heavy metals in brands of lipsticks commonly used in Shahrekord, Iran

    by Abbas Khodabakhshi, Farideh Bagherzadeh

    The desire for beauty and frequent use of cosmetics can expose humans to heavy metals, which can cause immune system disorders over time. We selected 5 common lipstick brands to determine the concentrations of cadmium (Cd), lead (Pb), and chromium (Cr). We prepared each sample by acid digestion, and then the concentration of the metals was measured using an atomic absorption spectrometer. The results showed that Pb, Cd, and Cr were present in all lipstick samples. However, their concentrations were lower than the Food and Drug Administration (FDA) standards. The maximum concentrations of Pb and Cd were 2.31 mg/kg (brand A) and 0.037 mg/kg (brand D), respectively. Health risk assessment of the examined metals showed that only Cr can pose non-carcinogenic (14.98) and carcinogenic (44.96E-04) risks to consumers. Despite the low concentration of heavy metals in our study, chronic use of lipstick can pose carcinogenic and non-carcinogenic risks due to the presence of Cr.


  • Open Access

    Removal of Natural Organic Matter (NOM) from Aqueous Solutions by Multi-Walled Carbon Nanotube Modification with Magnetic Fe3O4 Nanoparticles

    by Abbas Khodabakhshi, Ayoub Riahi Farssani, Morteza Sedehi, Mehraban Sadeghi

    Backgroundand Aim. Natural organic matter (NOM) has become one of the most serious environmental problems due to its persistence in aqueous solutions and the risk of carcinogenesis. In this study, the removal efficiencies of real and synthetic humic acid (HA) by multi-walled carbon nanotubes (MWCNTs) coated with iron oxide were evaluated. Materials and Methods. The MWCNs were synthesized and coated with iron oxide. In addition, the effects of pH, contact time, mixing speed, and adsorbent dose on the removal efficiency of NOM by MWCNTs-Fe3O4 were studied. Then, the removal efficiency of NOM from real samples was investigated at optimal conditions. The MWCNT-Fe3O4 was characterized by scanning electron microscopy (SEM) test and X-ray diffraction (XRD), respectively. Data analysis was performed using Minitab software based on the Taguchi method. Results. The results showed that MWCNTs were coated with Fe3O4. The SEM test shows particle (MWCNTs-Fe3O4) size in the range of 48–143 nm, and the particles have uniform spherical shapes. Enix software was used to identify the phase in this sample. The conditions including , mixing speed = 120 rpm, adsorbent dosage = 1.5 g·L−1, and contact time = 90 minutes were selected as optimal for NOM adsorption. The mean removal efficiencies of NOM in synthetic samples at 5, 10, and 20 mg·L−1 concentrations were 86.6%, 84.87%, and 95.41%, respectively. In addition, the mean removal efficiency of NOM in Choghakhor Wetland was 77%. Conclusion. Our findings demonstrated that the MWCNTs-Fe3O4 can be potentially used as an adsorbent for removing natural organic matter (HA) from aqueous solutions.


  • Open Access

    Evaluation of Pb (II) Removal by Tea Pulp Modified with Magnetite Nanoparticle

    by Morteza Mozaffari, Abbas Khodabakhshi, Amin Azizi

    Tea waste was used to successfully synthesize magnetic nanoparticles (TWMNPs). In this investigation, Pb (II) was eliminated by tea waste modified with magnetite nanoparticles (TWMNPs) was investigated. To prepare the TWMNPs, FeCl3.6H2O was dissolved in double distilled water (DDW) and 20g of pulp tea was added slowly and stirred, after 30min TWMNPs adsorbent were separated through an external magnetic field and washed three times with double distilled water (DDW) and ethanol then dried at 60°C. The FESEM test of TWMNPs shows the particle size in the range of 1520nm and spherical/cuboid-shaped crystal structure of Fe3O4 (magnetite). X-ray analysis showed that the main XRD diffraction peaks of TWMNPs are related to Fe3O4, HighScore plus XPert software was used to identify the phase in this sample. The specific surface area of the prepared magnetite nanoparticles was 25.2m2.g−1. The pore volume, maximum pore radius, and VSM of TWMNPs were 14.4cm3.g−1, 2.3nm, and 3.372.41, respectively. The effects of various parameters, such as contact time, pH, concentration, and adsorbent dosage, were studied. The experimental isotherm data were analyzed using the Langmuir and Freundlich models, and it was found that the removal process followed the Langmuir isotherm and the maximum adsorption capacity calculated by Langmuir fitting was 10.67mg.g−1. In addition, the adsorption kinetics followed the first-order kinetic model and the value of rate constant was found to be 14.04×10−2 min−1. The results showed that increasing the pH level led to a rise in the response level and Pb (II) removal. Also, the trend in Pb (II) removal and response level had an increase with increasing the initial concentration of Pb (II). Increasing contact time from 5 to 20minutes has a slight effect on Pb (II) removal. Considering the results, TWMNPs could lead to suitable results for the removal of Pb (II) from wastewater containing this metal. And the maximum adsorption capacity was found to be 10.67mg.g−1.


  • Open Access

    Equilibrium and Thermodynamic Studies on the Biosorption of Lead (II) by Living and Nonliving Biomass of Penicillium notatum

    by Abbas Khodabakhshi, Fazel Mohammadi-Moghadam, Kobra Shakeri, Sara Hemati

    This study aims to investigate the biosorption of Pb (II) by living and nonliving biomass of Penicillium notatum. Penicillium notatum PTCC 5074 was purchased from Iran Scientific-Industrial Research Organization in lyophilized form and after culturing in potato dextrose agar was propagated in Sabouraud dextrose broth medium. The highest adsorption by living and nonliving biomass (180.74 and 187.08mg/g per dry weight of biomass, respectively) was at the Pb (II) concentration of 228mg/L and ionic strength of 43mg/L in terms of Ca2+ and 1.2g/L biomass concentration. The optimum contact time and temperature in nonliving biomass were 37 hours and 32.5°C, respectively. Kinetic studies showed that Pb(II) adsorption in both cases follows a pseudo-second-order reaction. The adsorption process was consistent with the Langmuir model in the nonliving state, whereas the favourite models for the living state were Langmuir and Freundlich. Thermodynamic constants indicated that the adsorption process by nonliving and living biomass were exothermic and endothermic, respectively. The obtained results showed that Penicillium notatum in living and nonliving states is suitable for the development of an efficient and economic biosorbent for the removal of Pb (II) from aqueous environments.


  • Open Access

    Comparison of Paraquat Herbicide Removal from Aqueous Solutions using Nanoscale Zero-Valent Iron-Pumice/Diatomite Composites

    by Abbas Khodabakhshi, Fazel Mohammadi-Moghadam, Mohammad Mehdi Amin, Sara Hamati, Shakila Hayarian

    Paraquat is the most important herbicide of the bipyridyl group. The aim of the present study was to compare the removal of paraquat herbicide from aqueous solutions using nanoscale zero-valent iron-pumice/diatomite composites. In this study, nZVI was supported with diatomite and pumice. Scanning electron microscopy (SEM) analysis, X-ray diffraction spectroscopy (XRD), Fourier transform infrared spectrometry (FTIR), and specific surface area tests (BET) were used to evaluate the properties of nanoadsorbents. The residual concentration of paraquat in aqueous solution was detected by high-performance liquid chromatography (HPLC). Then, the effects of different variables including the pollutant concentration, contact time, temperature, adsorbents (D-nZVI and P-nZVI) dose, and pH, were investigated in a lab scale batch system. The results showed that the optimal pH for both processes was 3.74. In optimal conditions, the efficiencies of D-nZVI and P-nZVI were 92.76% and 85.28%, respectively. In addition, isotherm and adsorption kinetics studies indicated that P-nZVI follows the Langmuir and Freundlich isotherm models, and D-nZVI follows the Langmuir isotherm model, and both processes follow pseudo-second-order kinetics. The results indicated that the synthesized nanoparticles were suitable for removing paraquat from aqueous solutions. Both adsorbents were found to be very effective in removing similar compounds at ambient temperature in a short time.


  • Simultaneous monitoring of SARS-CoV-2, bacteria, and fungi in indoor air of hospital: a study on Hajar Hospital in Shahrekord, Iran

    by Sara Hemati, Gholam Reza Mobini, Mohsen Heidari, Fereidoun Rahmani, Akbar Soleymani Babadi, Marzieh Farhadkhani, Heshmatollah Nourmoradi, Ahmad Raeisi, Ali Ahmadi, Abbas Khodabakhshi, et al.

    The novel SARS-CoV-2 outbreak was declared as pandemic by the World Health Organization (WHO) on March 11, 2020. Understanding the airborne route of SARS-CoV-2 transmission is essential for infection prevention and control. In this study, a total of 107 indoor air samples (45 SARS-CoV-2, 62 bacteria, and fungi) were collected from different wards of the Hajar Hospital in Shahrekord, Iran. Simultaneously, bacterial and fungal samples were also collected from the ambient air of hospital yard. Overall, 6 positive air samples were detected in the infectious 1 and infectious 2 wards, intensive care unit (ICU), computed tomography (CT) scan, respiratory patients’ clinic, and personal protective equipment (PPE) room. Also, airborne bacteria and fungi were simultaneously detected in the various wards of the hospital with concentrations ranging from 14 to 106 CFU m−3 and 18 to 141 CFU m−3, respectively. The highest mean concentrations of bacteria and fungi were observed in respiratory patients’ clinics and ICU wards, respectively. Significant correlation (p < 0.05) was found between airborne bacterial concentration and the presence of SARS-CoV-2, while no significant correlation was found between fungi concentration and the virus presence. This study provided an additional evidence about the presence of SARS-CoV-2 in the indoor air of a hospital that admitted COVID-19 patients. Moreover, it was revealed that the monitoring of microbial quality of indoor air in such hospitals is very important, especially during the COVID-19 pandemic, for controlling the nosocomial infections.


  • Removal of Trichloroethylene by Clay Modified with Cationic Surfactant in Aqueous Solutions: Equilibrium, Kinetic, and Thermodynamic Study

    by Fazel Mohammadi‐Moghadam, Abbas Khodabakhshi, Marzieh Farhadkhani, Sara Hemati, Neda Masoudipour, Firoozeh Shahgholian, Heshmatollah Nourmoradi


  • Open Access

    Removal of mercury (II) from aqueous solutions by multiwalled carbon nanotubes coated with manganese oxide

    by Abbas Khodabakhshi, Hassan Asgarian

    Background and aims: Water pollution by heavy metals is one of the most important environmental problems. Among the heavy metals, mercury (Hg) is a very toxic metal and its high concentration can lead to impaired pulmonary and renal dysfunction. The aim of this study was to determine the amount of Hg removal by carbon nanotubes coated with manganese (Mn) oxide from aqueous solutions. Methods: In this study, multi-walled carbon nanotubes coated with Mn oxide were prepared and used to remove Hg from aqueous environments. In addition, the physical and structural characteristics of the nanotubes were determined by the X-ray diffraction (XRD). The impact of diverse variables was further investigated, including the initial concentration of Hg, the initial pH of the solution, contact time, mixing rate, as well as the amount of nano-composite and the impacts of confounders (nitrate and chloride). Finally, optimum conditions for each of these parameters were obtained by the Taguchi statistical method. Results: The XRD analysis showed that the nanotubes were properly coated with Mn oxide. Furthermore, the results demonstrated that under pH 7, the rate of mixing of 150 rpm, the contact time of 60 minutes, the amount of nano-composite of 60 mg, and the initial density of Hg 80 mg/L can be achieved by removing 95% Hg. Moreover, the confounder factors of nitrate and chloride reduced the amount of Hg removal by 4 and 5%, respectively. Conclusion: Based on the results, the nanotubes coated with Mn oxide can be used as easy and strong absorbents for the rapid absorption of Hg from drinking water and industrial wastewater.