FWFang Wang

Fang Wang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Fang Wang has a total of 46 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Some basic principles of multi-phase flows modeling and simulations

    by N.N. Smirnov, E.I. Skryleva, E.V. Mikhalchenko, F. Wang

  • On the propagation mode evolution and detonability of diesel-fueled rotating detonation waves

    by Qun Li, Yuwen Wu, Yiqing Xia, Yufu Wang, Jianing Liu, Chuang Gao, Fang Wang, Chunsheng Weng

    Diesel-fueled rotating detonation combustors (RDCs) present a promising combustion technology for gas turbines widely used in marine and land-based power generation, benefiting from its high energy density and convenient storage. However, the propagation behavior, mode transition mechanisms, and detonability of diesel-fueled rotating detonation lack comprehensive investigations. Therefore, we developed a diesel-fueled experimental RDC system and conducted a series of tests by varying oxygen mass fraction and equivalence ratio. High-frequency pressure measurements and high-speed imaging were used to investigate the propagation modes of diesel-fueled rotating detonation waves (RDWs). Furthermore, theoretical calculations were performed to derive the critical initiation energy Ec. The influences of oxygen mass fraction and temperature on critical detonation energy were normalized, allowing for the prediction of the initiation temperature limits for RDW under pure air condition. The results characterized four distinct propagation modes: single-wave, two-wave co-rotating, dual-wave collision, and deflagration. Synchronized high-speed imaging and pressure measurements indicated that mode transitions were driven by local combustion. Theoretical analysis indicated that diesel possesses a longer induction zone length Δ and Ec than those of kerosene under identical conditions. The theoretical Ec values are inversely proportional to the experimentally measured RDW propagation frequencies for both fuels. By integrating the effects of oxygen mass fraction and temperature on Ec with experimental data, the initiation temperature limits for diesel–air rotating detonation is approximately 780 K. These findings illuminate the mode transition characteristics and detonability of diesel fuel, and provide a theoretical foundation for the application of diesel-fueled RDCs in land-based gas turbines.

  • Open Access

    The effect of transverse injection on combustion processes in a hydrogen–oxygen detonation combustor

    by Nikolay Smirnov, Elena Mikhalchenko, Lyuben Stamov, Evgeneniya Skryleva, Fang Wang

    The results of a numerical study of the effect of transverse injection on detonation combustion of hydrogen with oxygen in an annular chamber are presented. 10 types of feed with different compositions of the side supply (stoichiometric/rich mixture, O₂, N₂) at pressures of 5 and 15 atm are considered. Based on 3D simulations (Navier–Stokes equations, detailed kinetics, k-ω turbulence), the pressure, temperature, mixture inhomogeneity fields, and thrust characteristics are analyzed. The steady-state detonation is achieved in all cases; however, the detonation wave parameters depend on the mixture composition, injection strategy and injection pressure. The supply of N₂ or O₂ creates a near-wall cold zone, providing film cooling. The interaction of jets causes mixture stratification, secondary detonation waves, and pressure pulsations. Two scenarios are identified on fuel injection into the combustion chamber filled in with hot reaction products: secondary deflagration combustion and secondary detonation.

  • Roles of Acoustic Impedance and Acoustic Velocity Ratios on Semiconfined Detonation Propagation

    by Qiuyue Liu, Fang Wang, Fan Zhao, Chunsheng Weng, Qingjun Zhao

    A numerical study is conducted to reveal the roles of the acoustic impedance ratio Z and acoustic velocity ratio X on semiconfined cellular detonations propagating through a layer of reactant bounded by inert gas. A series of cases are simulated based on the control variate method in two initial conditions. The simulation results unveil significant differences in the roles of Z and X in the layered detonation propagation. As the Z increases (at [ ]), the layered detonation propagation regime remains in an oblique-shock-attached detonation structure whose shock wave angle generally remains the same while the interface angle slightly decreases, resulting in reduced detonation area expansion. However, as the X increases (at [ ]), the layered detonation propagation regime is more complicated, whose shock wave angle significantly increases and even becomes an overshooting detached shock to generate a compression effect on the detonation front. In cases with a high X of 3–4, the overshooting detached shock forms an inverse-Mach reflection or double-Mach reflection shock system, leading to a detonation area decrement and overdriven propagation. Furthermore, a semi-empirical prediction model for the detonation velocity deficit subject to both detonation area expansion and decrement is established in a unified manner and validated through existing experimental data. This study first clarifies the respective roles of two parameters and elucidates the underlying mechanisms, which further deepens the understanding of the layered detonation propagation.


  • Numerical research on the non-premixed two-phase kerosene/air ramjet rotating detonation engines with divergent isolators

    by Haoze Jiang, Wenkang Feng, Wenbo Cao, Fang Wang, Chunsheng Weng

    In this paper, the Eulerian–Lagrangian method was employed to simulate a non-premixed two-phase ramjet-rotating detonation engine with divergent isolators. The impact of the isolator lengths and inlet widths on the dynamics of the rotating detonation wave and the propagation of the upstream oblique shock wave is analyzed. The simulation results show that the upstream oblique shock wave can propagate upstream into the isolator, and there are two main propagation modes: penetration and suppression. The total pressure loss will occur when the flow passes through the upstream oblique shock wave. Generally, at the same isolator length, the smaller the inlet width, the greater the total pressure loss. In the case of the upstream oblique shock penetrating the isolator, the total pressure loss occurs before the isolator, which leads to the fact that the total pressure loss cannot be reflected in the result. In the short isolator, the Mach number will increase when reducing the isolator inlet width. This phenomenon will generate a normal shock in the divergent station. Therefore, the total pressure loss will increase after the divergent station, and the strength of the upstream oblique shock wave will be weakened, which is conducive to suppressing the upstream oblique shock wave. In the longer isolator, the upstream oblique shock wave can be suppressed. The propagation modes of the upstream oblique shock wave in the ramjet rotating detonation engine with divergent isolators can be predicted by the critical pressure ratio βcr3.


  • Open Access

    The role of isolators in two-phase kerosene/air rotating detonation engines

    by Wenbo Cao, Fang Wang, Chunsheng Weng, Huangwei Zhang


  • Layered detonation propagation subject to bilateral expansion: Role of the air layer height

    by Qiuyue Liu, Fang Wang, Chunsheng Weng, Bin Hu, Qingjun Zhao

    A two-dimensional numerical study was conducted to reveal the role of air layer height on cellular detonations propagating through a layer of vaporized kerosene/air reactant bounded by inert gas (upper side) and air (lower side). A series of cases with different reactive layer heights (h) and air layer heights (h2) are simulated and analyzed. The results indicate that the detonation propagation structures and ignition regimes at the interface between the reactive and air layers are significantly affected by h2. At h2 = 5.8λCJ (λCJ is theoretical cell width), the bottom oblique shock wave propagated as regular reflection structures, and the ignition regime relied on transverse detonations. As the h2 decreases below 2.9λCJ, the bottom oblique shock forms a Mach reflection structure with the bottom wall, and the detonation front ignition regimes can be divided into three types based on h2. The first ignition regime is also through transverse detonation (at h2 = 2.9λCJ). The second ignition regime is the collision between the reflected triple point, the downward triple point, and the Mach stem (at h2 = 0.72λCJ). However, at h2 = 1.45λCJ, in addition to the above two regimes, the ignition regime also relies on the collision between the downward transverse detonation and the Mach stem. Moreover, it was found that when the h/λ is larger than 5.6, layered detonation affected by bilateral expansion can propagate successfully, which is significantly closer to the rotating detonation experimental values compared with detonations subject to unilateral expansion.