UKUdaya Kumar

Udaya Kumar

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Udaya Kumar has a total of 11 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Return-Stroke Field Near the Air–Soil Interface With Realistic Soil

    by Rupam Pal, Udaya Kumar

    The return-stroke field generated by cloud-to-ground lightning is of primary concern in protection engineering. This field affects not only the electrical systems on and above the ground but also buried cables and other sensitive devices in the soil. In the literature, the field in the air due to return stroke has been thoroughly investigated. However, the assessment of the return-stroke field in the soil is relatively scarce. Measurement of the field in the soil is difficult to find, whereas most theoretical methods adopt oversimplified soil models and generalized return-stroke models, which do not consider any effect of soil parameters on current evolution. However, recent work has shown that soil's electrical parameters can significantly affect the return-stroke evolution. In light of this, it was deemed necessary to investigate the role of soil's electrical parameters on the return-stroke field, both in the air and the soil, with a realistic soil model, including soil ionization and frequency-dependent soil parameters. This work primarily focuses on the electric field produced by the return stroke within a radial distance of 500 m from the channel.


  • Open Access

    Modeling of Bi-Polar Leader Inception and Propagation from Flying Aircraft Prior to a Lightning Strike

    by Sayantan Das, Udaya Kumar

    Lightning is one of the major environmental threats to aircraft. The lightning strikes during flying are mostly attributed to aircraft-triggered lightning. The first step toward designing suitable protective measures against lightning is identifying the attachment locations. For this purpose, oversimplified approaches are currently employed, which do not represent the associated discharge phenomena. Therefore, in this work, a suitable model is developed for simulating the inception and propagation of bi-polar leader discharge from the aircraft. Modeling of leader discharges requires field computation around the aircraft, which is carried out employing the Surface Charge Simulation Method (SCSM) combined with sub-modeling, which ensures the best accuracy of field computations near nosecone, wingtips, etc. A DC10 aircraft model is considered for the simulation. Simulations are performed for different pairs of leader inception points on aircraft using the developed model. Subsequently, corresponding ambient fields required for stable bi-polar discharge from aircraft are determined. These values are in the range of measured ambient fields reported in the literature. In summary, the present work has come up with a suitable model for simulating the bi-polar leader inception and propagation from the flying aircraft. Using the same, a detailed quantitative description of the discharge phenomena from the aircraft is provided.


  • Phenomenon of Standing Waves on Uniform Single Layer Coils - Revisited and Extended

    by Ashiq Muhammed, Udaya Kumar, L. Satish

    Comprehensive knowledge of natural frequencies and shapes of corresponding standing waves are essential for gaining insight into the nature of response of coils to impulse excitation. Most previous analytical studies assumed standing wave shapes as sinusoidal, but circuit analysis and measurements suggest otherwise. Hence, this paper revisits the classical phenomenon to ascertain reasons for this discrepancy and thereafter extends it to analytically derive the exact mode shape of standing waves, for both open and short neutral conditions. The coil is modeled as distributed network of inductances and capacitances, while spatial variation of mutual inductance between turns is described by an exponential function. Initially, an elegant derivation of governing partial differential equation for surge distribution is presented, which is analytically solved by variable-separable method to yield the exact solution. Hyperbolic terms in solution neglected so far have been included. Exact shape of first few voltage standing waves gotten from analytical solution are compared with simulation results on 100-section ladder network and then measured on a large-sized single layer coil. Thus, even in a simple coil, shape of standing waves deviates considerably from being sinusoidal and this deviation depends on spatial variation of mutual inductance, capacitive coupling, and order of standing wave.


  • On Overcoming the Transverse Boundary Error of the SU/PG Scheme for Moving Conductor Problems

    by Sethupathy Subramanian, Udaya Kumar, Sujata Bhowmick

    Conductor moving in magnetic field is quite common in electrical equipment. The numerical simulation of such problem is vital in their design and analysis of electrical equipment. The Galerkin finite element method (GFEM) is a commonly employed simulation tool, nonetheless, due to its inherent numerical instability at higher velocities, the GFEM requires upwinding techniques to handle moving conductor problems. The streamline upwinding/Petrov–Galerkin (SU/PG) scheme is a widely acknowledged upwinding technique, despite its error peaking at the transverse boundary. This error at the transverse boundary is found to be leading to non-physical solutions. Several remedies have been suggested in the allied fluid dynamics literature, which employs non-linear, iterative techniques. The present work attempts to address this issue, by retaining the computational efficiency of the GFEM. By suitable analysis, it is shown that the source of the problem can be attributed to the Coulomb’s gauge. Therefore, to solve the problem, the Coulomb’s gauge is taken out from the formulation and the associated weak form is derived. The effectiveness of this technique is demonstrated with pertinent numerical results.


  • Modeling of Return-Stroke Current Evolution Over a Realistic Ground

    by Rupam Pal, Udaya Kumar

    The return-stroke phase of the cloud-to-ground lightning flash is of primary concern for lightning-protection engineering. This also holds for buried cables and other sensitive devices in the soil. For evaluating the field in the soil, two approaches are employed: first, the quasi-static approach, in which a current source injects the stroke current into the soil; and second, a hybrid approach employing the “engineering model” for the channel-current evolution. In both the approches, the current injected into the soil is independent of the soil resistivity, which needs further scrutiny. The return-stroke model developed by Balaram Raysaha et al. (2011) self-consistently emulates the stroke-current evolution without any such assumptions and is, therefore, very suitable for a comprehensive assessment of the situation. However, the field-computation method employed by Balaram Raysaha et al. had to be changed to the domain-based finite-difference time-domain method for a realistic soil model. After this augmentation, the return-stroke model is employed to investigate the possible role of soil's electrical parameters on the return-stroke current evolution. It is found that for fast-rising currents of low amplitudes, the soil resistivity noticeably influences the current amplitude. Also, it is found that the soil dispersion leads to a significantly lower electric field in the soil.


  • On the Influence of Neighboring Conducting Objects on the Induced Currents in Simple Down Conductors Due to Nearby Lightning Strike

    by Vinoda Shivanand, Vishwanath Hegde, Udaya Kumar

    A lightning strike in the neighborhood can induce significant currents in tall down conductors. Though the magnitude of induced current in this case is much smaller than that encountered during a direct strike, the probability of occurrence and the frequency content is higher. In view of this, appropriate knowledge on the characteristics of such induced currents is relevant for the scrutiny of the recorded currents and in the evaluation of interference to the electrical and electronic system in the vicinity. Previously, a study was carried out on characteristics of induced currents assuming ideal conditions, that there were no influencing objects in the vicinity of the down conductor and channel. However, some influencing conducting bodies will always be present, such as trees, electricity and communication towers, buildings, and other elevated objects that can affect the induced currents in a down conductor. The present work is carried out to understand the influence of nearby conducting objects on the characteristics of induced currents due to a strike to ground in the vicinity of a tall down conductor. For the study, an electromagnetic model is employed to model the down conductor, channel, and neighboring conducting objects, and Numerical Electromagnetic Code-2 is used for numerical field computations. Neighboring objects of different heights, of different shapes, and at different locations are considered. It is found that the neighboring objects have significant influence on the magnitude and nature of induced currents in a down conductor when the height of the nearby conducting object is comparable to that of the down conductor.


  • Investigations on voltages and currents in the lightning protection system of the Indian satellite launch pad-I during a stroke interception

    by Udaya Kumar, Vishwanth Hegde, Pranavkumar B. Darji

    A reliable protection against direct lightning hit is very essential for satellite launch pads. In view of this, suitable protection systems are generally employed. The evaluation of efficacy of the lightning protection schemes among others requires an accurate knowledge of the consequential potential rise at the struck point and the current injected into soil at the earth termination. The present work has made a detailed effort to deduce these quantities for the lightning protection scheme of the Indian satellite launch pad-I. A reduced scale model of the system with a frequency domain approach is employed for the experimental study. For further validation of the experimental approach, numerical simulations using numerical electromagnetic code-2 are also carried out on schemes involving single tower. The study results on the protection system show that the present design is quite safe with regard to top potential rise. It is shown that by connecting ground wires to the tower, its base current and, hence, the soil potential rise can be reduced. An evaluation of an alternate design philosophy involving insulated mast scheme is also made. The potential rise in that design is quantified and the possibility of a flashover to supporting tower is briefly looked into. The supporting tower is shown to have significant induced currents.


  • Open Access

    Preliminary Studies on the Characteristics of the Induced Currents in Simple Down Conductors Due to a Nearby Lightning Strike

    by Udaya Kumar, Vishwanath Hegde, Vinoda Shivanand

    A lightning strike in a neighborhood can induce significant currents in tall down conductors. Although the magnitude of current in this case is much smaller than that encountered during a direct strike, the probability of occurrence and the frequency content is higher. In view of this, appropriate knowledge of the characteristics of such induced currents is relevant for the scrutinization of the recorded currents. Considering these, the present paper makes a preliminary investigation into the basic characteristics of lightning-induced currents in simple tall vertical down conductors. The electromagnetic model is employed for the study, and NEC-2 is employed for the numerical field computations. Laboratory experiments with reduced-scale electromagnetic model of the system are employed to validate the numerical approach. The influence of important parameters has been investigated and highly insightful results obtained. The induced current is found to depend on the maximum rate of rise of the stroke current and its velocity of propagation, the height of the down conductor, and the footing impedance. The channel inclination and the distance between the channel and the down conductor have significant influence on the magnitude of the induced current. It is found that the radius of the down conductor is not very influential. The induced current due to a stroke on a nearby conducting object of considerable height can have different overall features


  • Open Access

    Novel model for the simulation of lightningstepped leader

    by Udaya Kumar, G.R. Nagabhushana

    The stepped leader forms the first phase of the first stroke in any lightning flash. It is basically a stepwise elongating discharge in air, which carries significant charge. The charge distribution on the leader and its velocity of descent, determine the attractive radius in shielding efficiency calculations. Also, the conductivity and the charge distribution on the leader tip region govern the initial stages of the return stroke. Therefore, there is a need for determining these parameters accurately. In this regard, a self-consistent model for the stepped leader will be very useful. The authors present a new model for the stepped leader that does not assume basic quantities like leader charge, current and velocity, but derives them from the computer simulation.