Dalyndha Aztatzi-Pluma
Dalyndha Aztatzi-Pluma has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Gerardo Vazquez-Guzman
Faculty of Science, Autonomous University of San Luis Potosi (UASLP), San Luis Potosi 78295, SLP, Mexico
4 shared publications - Panfilo Raymundo Martinez Rodriguez
School of Sciences, Universidad Autonoma de San Luis Potosi (UASLP), San Luis Potosi 78295, SLP, Mexico
4 shared publications - Christopher Jesus Rodriguez-Cortes
Faculty of Science, Autonomous University of San Luis Potosi (UASLP), San Luis Potosi 78295, SLP, Mexico
2 shared publications - Gerardo O. Perez-Bustos
Division of Electronics Engineering, Tecnologico Nacional de Mexico/ITS de Irapuato, Irapuato, Mexico
2 shared publications - Jose Miguel Sosa
Department of Electronics Engineering, ITS de Irapuato, Tecnologico Nacional de Mexico, Irapuato 36821, Gto, Mexico
2 shared publications - Belem Saldivar
Departamento de Control Automático, Centro de Investigacion y de Estudios Avanzados del Instituto Politecnico Nacional, Ciudad de México, México
1 shared publication
Latest Publications
- 9 January 2026
- Published by Springer Nature in Electrical Engineering
- Vol. 108 (2) , 80
A n-level CHB single-phase inverter for PV transformerless systems
- 9 January 2026
- Published by Springer Nature in Electrical Engineering
- Vol. 108 (2) , 80
A n-level CHB single-phase inverter for PV transformerless systems
- 3 September 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Latin America Transactions
- Vol. 23 (10) , 901-909
Design and validation of a hybrid MPPT algorithm for PVS using an interleaved boost converter
Photovoltaic systems must be highly efficient to transfer the electric power generated to the local loads or to the electrical grid. In partial-shading conditions there are multiple local maximum power points which are not evaluated by conventional MPPT methods producing low efficiency in the photovoltaic system. In this paper a hybrid Particle Swarm Optimization (PSO) based method is proposed. The proposed method allows to locate the global maximum power point enhancing the availability of the generated electrical power and reducing the convergence time compared to the conventional PSO algorithm. The proposed method is compared with classical MPPT algorithms like Hill Climbing (HC), perturb and observe (P and O), incremental conductance (IncCond) and the conventional particle swarm optimization (PSO) method. The comparison is performed by means of numerical simulations and implementing an experimental platform with real photovoltaic panels.
- 3 September 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Latin America Transactions
- Vol. 23 (10) , 901-909
Design and validation of a hybrid MPPT algorithm for PVS using an interleaved boost converter
Photovoltaic systems must be highly efficient to transfer the electric power generated to the local loads or to the electrical grid. In partial-shading conditions there are multiple local maximum power points which are not evaluated by conventional MPPT methods producing low efficiency in the photovoltaic system. In this paper a hybrid Particle Swarm Optimization (PSO) based method is proposed. The proposed method allows to locate the global maximum power point enhancing the availability of the generated electrical power and reducing the convergence time compared to the conventional PSO algorithm. The proposed method is compared with classical MPPT algorithms like Hill Climbing (HC), perturb and observe (P and O), incremental conductance (IncCond) and the conventional particle swarm optimization (PSO) method. The comparison is performed by means of numerical simulations and implementing an experimental platform with real photovoltaic panels.
- Open Access
Analysis and Improved Behavior of a Single-Phase Transformerless PV Inverter
Transformerless inverters have an important role in the electrical energy market. The high-efficiency and reliable inverter concept is one of the most widely used inverters in single-phase photovoltaic systems because of its high efficiency, low cost, and reduced leakage ground current. However, the leakage ground current behavior depends on the power and weather conditions, which can increase the parasitic capacitance value, thus producing an increase in the leakage ground current magnitude. In this paper, it is proposed to add a passive inductive–capacitive output filter to the inverter structure in order to reduce the dependency of the leakage ground current on the system power and weather conditions. The inductive–capacitive output filter is designed in such a way that it can provide a low impedance path for the leakage ground current, different from the ground path. The proposed system was evaluated both through simulations and experimentally in a 1 kW laboratory prototype.
Open AccessAnalysis and Improved Behavior of a Single-Phase Transformerless PV Inverter
Transformerless inverters have an important role in the electrical energy market. The high-efficiency and reliable inverter concept is one of the most widely used inverters in single-phase photovoltaic systems because of its high efficiency, low cost, and reduced leakage ground current. However, the leakage ground current behavior depends on the power and weather conditions, which can increase the parasitic capacitance value, thus producing an increase in the leakage ground current magnitude. In this paper, it is proposed to add a passive inductive–capacitive output filter to the inverter structure in order to reduce the dependency of the leakage ground current on the system power and weather conditions. The inductive–capacitive output filter is designed in such a way that it can provide a low impedance path for the leakage ground current, different from the ground path. The proposed system was evaluated both through simulations and experimentally in a 1 kW laboratory prototype.
- Open Access
- 28 December 2021
- Published by MDPI AG in Micromachines
- Vol. 13 (1) , 36
Hybrid PWM Techniques for a DCM-232 Three-Phase Transformerless Inverter with Reduced Leakage Ground Current
Pulse Width Modulation (PWM) strategies are crucial for controlling DC–AC power converters. In particular, transformerless inverters require specific PWM techniques to improve efficiency and to deal with leakage ground current issues. In this paper, three hybrid PWM methods are proposed for a DCM-232 three-phase topology. These methods are based on the concepts of carrier-based PWM and space vector modulation. Calculations of time intervals for active and null vectors are performed in a conventional way, and the resulting waveforms are compared with a carrier signal. The digital signals obtained are processed using Boolean functions, generating ten signals to control the DCM-232 three-phase inverter. The performance of the three proposed PWM methods is evaluated considering the reduction in leakage ground current and efficiency. The proposed modulation techniques have relevant performances complying with international standards, which make them suitable for transformerless three-phase photovoltaic (PV) inverter markets. To validate the proposed hybrid PWM strategies, numerical simulations and experimental tests were performed.
- 28 December 2021
- Published by MDPI AG in Micromachines
- Vol. 13 (1) , 36
Open AccessHybrid PWM Techniques for a DCM-232 Three-Phase Transformerless Inverter with Reduced Leakage Ground Current
Pulse Width Modulation (PWM) strategies are crucial for controlling DC–AC power converters. In particular, transformerless inverters require specific PWM techniques to improve efficiency and to deal with leakage ground current issues. In this paper, three hybrid PWM methods are proposed for a DCM-232 three-phase topology. These methods are based on the concepts of carrier-based PWM and space vector modulation. Calculations of time intervals for active and null vectors are performed in a conventional way, and the resulting waveforms are compared with a carrier signal. The digital signals obtained are processed using Boolean functions, generating ten signals to control the DCM-232 three-phase inverter. The performance of the three proposed PWM methods is evaluated considering the reduction in leakage ground current and efficiency. The proposed modulation techniques have relevant performances complying with international standards, which make them suitable for transformerless three-phase photovoltaic (PV) inverter markets. To validate the proposed hybrid PWM strategies, numerical simulations and experimental tests were performed.