SZShaoqi Zhou

Shaoqi Zhou

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Shaoqi Zhou has a total of 8 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Using DInSAR to inventory landslide geological disaster in Bijie, Guizhou, China

    by Chaoyong Shen, Shaoqi Zhou, Xuling Luo, Yu Zhang, Hui Liu

    Landslides are very complicated natural phenomena that create significant losses of life and assets throughout China. However, previous studies mainly focused on monitoring the development trend of known landslides in small areas, and few studies focused on the identification of new landslides. In addition, karst areas, where the vegetation is dense, the mountains are high, the slopes are steep, and the time incoherence is serious, have difficulty in tracking Differential Interferometric Synthetic Aperture Radar (DInSAR) landslides. Therefore, based on DInSAR technology, we use ALOS-2 PALSAR data to conduct continuous monitoring of existing hazards and identify new geological hazards in karst areas. The major results are as follows: 1) From June 11 to 6 August 2017, it was discovered that a hidden point of landslides occurred on the 420 m northwest mountain near the town of Zongling. It was determined that the landslide hidden point had been slipping for two consecutive years, with an average slip of 6.0 cm. From 4 September 2016 to 22 January 2017, undiscovered hidden points in the landslide account were found in Yinjiazhai. On 13 September 2016 and 22 November 2016, the discovered potential hazards in the landslide log book were the mountain hazards in southwestern Shiping village, and the deformation was 7.8 cm. 2) The DInSAR monitoring results from September to November 2016 showed that large deformations occurred in the landslide area of Shiping village. During a field visit, large cracks on the surface were found. The length of surface cracks in the southwest direction of Shiping village was 2.8 m. On 13 July 2017, Shiping collapsed as a result of the collapse of the mountainous area where the disaster occurred. The average slope of the landslide in the landslide area was approximately 65°, the height was 95 m, the length and width were 150 m and 25 m, respectively, and the thickness was 5 m. The method has shown great potential in precisely identifying some new geological hazards sites, as well as tracking and monitoring the potential hazards of geological disasters listed on the landslide account.


  • Open Access

    Analysis of the Influence of Forests on Landslides in the Bijie Area of Guizhou

    by Yu Zhang, Chaoyong Shen, Shaoqi Zhou, Xuling Luo

    Forests are an important part of the ecological environment, and changes in forests not only affect the ecological environment of the region but are also an important factor causing landslide disasters. In order to correctly evaluate the impact of forest cover on landslide susceptibility, in this paper, we build an evaluation model for the contribution of forests to the landslide susceptibility of different grades based on survey data for forest land change in Bijie City and landslide susceptibility data, and discuss the effects of forest land type, origin, age group, and dominant tree species on landslide susceptibility. We find that forests play a certain role in regulating landslide susceptibility: compared with woodland, the landslide protection ability of shrubland is stronger. Furthermore, natural forests have a greater inhibitory effect on landslides than artificial forests, and compared with young forest, mature forest and over-mature forest, middle-aged forest and near-mature forest have stronger landslide protection abilities. In addition, the dominant tree species in different regions have different impacts on landslides. Coniferous forests such as Chinese fir and Cryptomeria fortunei in Qixingguan and Dafang County have a low ability to prevent landslides. Moreover, the soft broad tree species found in Qianxi County, Zhijin County, Nayong County and Jinsha County are likely to cause landslides and deserve further research attention. Additionally, a greater focus should be placed on the landslide protection of walnut economic forests in Hezhang County and Weining County. Simultaneously, greater attention should be paid to the Cyclobalanopsis glauca tree species in Weining County because the area where this tree species is located is prone to landslides. Aiming at addressing the landslide susceptibility existing in different forests, we propose forest management strategies for the ecological prevention and control of landslides in Bijie City, which can be used as a reference for landslide susceptibility prevention and control.


  • Open Access

    Designing an Efficient Emergency Response Airborne Mapping System with Multiple Sensors

    by Chaoyong Shen, Zongjian Lin, Shaoqi Zhou, Xuling Luo, Yu Zhang

    Multisource remote sensing data have been extensively used in disaster and emergency response management. Different types of visual and measured data, such as high-resolution orthoimages, real-time videos, accurate digital elevation models, and three-dimensional landscape maps, can enable producing effective rescue plans and aid the efficient dispatching of rescuers after disasters. Generally, such data are acquired using unmanned aerial vehicles equipped with multiple sensors. For typical application scenarios, efficient and real-time access to data is more important in emergency response cases than in traditional application scenarios. In this study, an efficient emergency response airborne mapping system equipped with multiple sensors was designed. The system comprises groups of wide-angle cameras, a high-definition video camera, an infrared video camera, a LiDAR system, and a global navigation satellite system/inertial measurement unit. The wide-angle cameras had a visual field of 85°×105°, facilitating the efficient operation of the mapping system. Numerous calibrations were performed on the constructed mapping system. In particular, initial calibration and self-calibration were performed to determine the relative pose between different wide-angle cameras to fuse all the acquired images. The mapping system was then tested in an area with altitudes of 1000m1250m. The biases of the wide-angle cameras were small bias values (0.090m, 0.018m, and 0.046m in the x-, y-, and z-axes, respectively). Moreover, the root-mean-square error (RMSE) along the planer direction was smaller than that along the vertical direction (0.202 and 0.294m, respectively). The LiDAR system achieved smaller biases (0.117, 0.020, and 0.039m in the x-, y-, and z-axes, respectively) and a smaller RMSE in the vertical direction (0.192m) than the wide-angle cameras; however, RMSE of the LiDAR system along the planar direction (0.276m) was slightly larger. The proposed system shows potential for use in emergency response systems for efficiently acquiring data such as images and point clouds.