RARaushan Aimagambetova

Raushan Aimagambetova

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Raushan Aimagambetova has a total of 32 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Study of the Stability of Parameters of Red-Range Semiconductor Laser Emitters for Fiber-Optic Sensors of Monitoring Systems

    by Raushan Z. Aimagambetova, Aliya D. Alkina, Ali D. Mekhtiyev, Ruslan A. Mekhtiyev, Rymkhan K. Azilkhanov

    The study is aimed at selecting low-cost semiconductor laser emitters for fiber-optic sensors of systems that monitor the technical condition of mine workings, open pits and monolithic building structures. One specimen of each of the three commercial red laser emitters used in visual fault locators, Guangyan, YJ-550C and KFL-11M, with a rated power of 50 mW and a rated wavelength of 630 nm, was investigated. The optical power was recorded every 10 min during 240 min of continuous operation after a one-hour warm-up. The optical frequency was measured by heterodyning with the iodine-stabilized He–Ne laser of the national primary standard of length of the Republic of Kazakhstan, with a Renishaw XL-80 laser as a reference. The optical power decreased by 13.4%, 6.9% and 11.9%. The standard deviation of the optical frequency was 2.15, 10.78 and 1.17 MHz against 0.029 MHz for the reference laser, and the Allan deviation at 0.25 s was 43 to 132 times worse. Abrupt beat-frequency jumps were observed for the Guangyan and KFL-11M emitters. Among the tested specimens, YJ-550C showed the highest power stability and is preferable for intensity-based quasi-distributed sensors provided that a reference channel is used, whereas use in interferometric schemes must be assessed against the optical path difference and the allowable error.

  • Development of a Stress Identification System in Reinforced Concrete Objects Based on Optical Fiber

    by Lalita Kirichenko, Ali Mekhtiyev, Raushan Aimagambetova, Alexey Urchenko

    This article describes a continuous monitoring system based on fibre optic sensors that can identify changes in optical characteristics caused by mechanical deformations in concrete structures. The principle of operation is based on analysing the pattern of the light spot at the fibre output, the shape and intensity of which change depending on the stress applied to the structure. A mathematical model linking the effective refractive index and deformation is presented. An experimental prototype with a multi-channel configuration and a closed loop has been assembled, providing distributed and highly sensitive monitoring. The experimental results confirm the system's ability to detect deformations, confirming its potential for use in the structural diagnostics of reinforced concrete elements.

  • Open Access

    Application of Deep Learning Algorithms to Increase the Accuracy of Control of Optical Parameters of Fiber-Optic Sensors

    by Raushan Z. Aimagambetova, Aigul N. Seraly, Ali D. Mekhtiyev, Aliya D. Alkina, Ruslan A. Mekhtiyev, Dinara T. Mukasheva

    The development of accurate, robust and adaptive methods for monitoring the optical parameters of fiber-optic sensors (FOS) is one of the priority tasks in the field of precision measurements, especially in the context of rapidly growing requirements for intelligent monitoring systems. This paper presents a comprehensive approach to the use of modern deep learning algorithms for analyzing and processing spectral data coming from FOS. The proposed solution is based on the use of convolutional neural networks (CNN) for the automatic extraction of informative features, as well as autoencoders for noise suppression and signal restoration. A hybrid architecture combining CNN and recurrent neural networks (RNN) was developed. The experiments conducted confirmed the effectiveness of the evaluated models. On the independent regression test set, the CNN-only model achieved a macro-averaged R2-based prediction score of 98.2% without added noise and 89.4% under high-noise conditions; on a separate temporal test sequence, the hybrid CNN + RNN model achieved 95.0% compared with 88.0% for CNN alone. The presented approach has high resistance to noise and the ability to scale to various types of FOS. At the conclusion, the prospects for the practical applications of the proposed system are discussed: the structural monitoring of buildings and structures and the automation of processes in industry and energy, with an emphasis on reliability, autonomy and integration with existing platforms.


  • Open Access

    Physical and mathematical model of optical-mechanical processes in an optical fiber during its deformation

    by B. B. Aubakirova, A. D. Mekhtiyev, А. Д. Алькина, R. Zh. Aimagambetova

    This article is devoted to the construction of unique and technically complex buildings and structures, which is associated with increased requirements in the words of for safety and technical and economic risks that require scientific and technical support for these objects. The basis is the well-known laws of geometric and wave optics, as well as the phenomenological theory in the words of the scientist of optical-electrical processes associated with the interaction of a light wave with an optical fiber.

  • Open Access

    Power supply via fiber-optical conductor for sensors of mine working monitoring system

    by Ali Mekhtiyev, Pavel Dunayev, Yelena Neshina, Aliya Alkina, Raushan Aimagambetova, Gabit Mukhambetov, Lalita Kirichenko, Ilyas Kazambayev

    The article describes a system of power transmission via fiber-optic cable, which allows the supply of power to sensors and other electronic devices of ultra-low power located in places of mining workings, for which the mandatory requirement is fire safety. The developed system will allow to replace the application of copper conductors. The result of this research is the developed laboratory bench that allows measuring the current and voltage parameters in the photodetector branch. The equivalent generator method has been used, as well as the known circuit laws with two dedicated nodes for an active two-terminal network. When analyzing the literature, the existing scientific achievements, and discoveries in the field of research, an own concept of research has been formed that is different from foreign analogs. During the experiment, the studies have been performed when the photodetector was in the short circuit, idle mode, and connected to a high-resistance load. Based on the results obtained, current-voltage characteristics (CVC) and histograms have been built using a radiation source (laser) with a power of 10 and 30 mW. The parameters and technical characteristics of the irradiated silicon crystal and the radiation source have been given. The obtained electrical power has been determined using the known laws of electrical engineering, including the Ohm law. To process the experimental data, there has been used quadratic interpolation of the function, the results of the root-mean-square approximation, and there has been carried out the regression analysis. Absolute and relative errors have been calculated. The Student coefficient has been determined with a confidence interval of 0.95. Based on the results of the study, the efficiency of the power transmission system has been determined


  • Open Access

    Physical and Mathematical Models of Quantum Dielectric Relaxation in Electrical and Optoelectric Elements Based on Hydrogen-Bonded Crystals

    by Valeriy Kalytka, Ali Mekhtiyev, Yelena Neshina, Aliya Alkina, Raushan Aimagambetova, Gabit Mukhambetov, Aleksandr Bashirov, Dmitriy Afanasyev, Arkadiy Bilichenko, Dinara Zhumagulova, et al.

    The quantum statistical properties of the proton subsystem in hydrogen-bonded crystals (HBC) are investigated. Based on the non-stationary Liouville operator equation (taking into account a number of assumptions established in the experiment), a quantum kinetic equation is constructed for the ensemble of non-interacting protons (an ideal proton gas) moving in the crystal potential image perturbed by the external electric field. The balanced density matrix for the unperturbed proton subsystem is constructed using the quantum canonical Gibbs distribution, and the non-balanced density matrix is calculated from the solutions of the nonlinear quantum kinetic equation by methods in linear approximation of perturbation theory for the blocking electrode model. Full quantum mechanical averaging of the polarization operator makes it possible to study the theoretical frequency-temperature spectra of the complex dielectric permittivity (CDP) calculated using quantum relaxation parameters that differ significantly from their semiclassical counterparts. A scheme is presented for an analytical study of the dielectric loss tangent in the region of quantum nonlinear relaxation in HBC. The results obtained in the given paper are of scientific interest in developing the theoretical foundations of proton conduction processes in energy-independent memory elements (with anomalously high residual polarization) based on thin films of ferroelectric materials in the ultralow temperature range (1–10 K). The theoretical results obtained have a direct application to the study of the tunneling mechanisms of spontaneous polarization in ferroelectric HBC with a rectangular hysteresis loop, in particular in crystals of potassium dideutrophosphate (KDP), widely used in nonlinear optics and laser technology. The quantum properties of proton relaxation in HBC can be applied in the future to the study of solid-state electrolytes with high proton conductivity for hydrogen energy, capacitor technology (superionics, varicodes), and elements of MIS and MSM structures in the development of resonant tunnel diodes for microelectronics and computer technology.


  • Fiber-optic system for monitoring stability of quarry slopes

    by National Research Tomsk Polytechnic University, P. Sh. Madi, А. D. Аlkina, Karaganda Technical University named after Abylkas Saginov, A. V. Yurchenko, A. D. Mekhtiyev, S. Seifullin Kаzakh Agrotechnical University, R. Zh. Aimagambetova, Kazakhstan Institute of Standardization and Metrology

    This paper presents issues related to the development of a system for monitoring the displacement of the mountain range leading to the collapse of the sides of the quarry. The control system uses chiseled fiber-optic sensors. Fiberoptic sensors are based on Single Mode optical fibers. A laboratory sample of a point fiber-optic sensor based on a two-shoulder Mach-Zehnder interferometer using a Single Mode optical fiber for displacement control has been developed. The simulation stand of a laboratory sample of a fiber-optic sensor showed high measurement accuracy, linearity and can be used to control the stability of the sides of the quarry after the design has been improved. The experimental data obtained are processed using the Wolfram Alpha computer program. A hardware-software control complex has also been developed with a wide range of elements that allows you to adjust sensitivity and has machine learning elements.


  • Open Access

    Design of an information-measuring system for monitoring deformation and displacement of rock massif layers based on fiber-optic sensors

    by Vyacheslav Yugay, Ali Mekhtiyev, Yelena Neshina, Bakhytkul Aubakirova, Raushan Aimagambetova, Aigul Kozhas, Aliya Alkina, Madiyar Musagazhinov, Alexandr Kovtun

    This paper reports a study into designing an information-measuring system that could be used in coal mines that are dangerous in terms of the explosion of coal dust and methane gas. The results of reviewing technical advancements in the field of fiber-optic system development are given. To solve the set task, prototypes of a fiber-optic sensor of a new type and a hardware-software complex were constructed. The research aims to improve the safety of workers at coal enterprises. The result of the theoretical research has established that additional losses related to a micro bending should be taken into consideration while accounting for the effect of photoelasticity. The fundamental difference between the idea reported here and existing analogs is the development of a hardware-software complex capable of working with a single-mode optical fiber of great length with a significant noise level. The data processing unit is equipped with a television matrix and can analyze changes in the pixels of a light spot. The proposed system is quasi-distributed; it controls individual points within a rock massif. The designed hardware-software system provides high noise immunity of measuring channels when the external temperature changes. The research results helped develop an information-measuring system for monitoring the deformation and displacement of rock massif layers based on fiber-optic sensors, capable of operating in an explosive environment. The system makes it possible to control several layers located in the roof of the workings, while the fiber-optic sensor may contain two or three sensitive elements that are connected to different channels. With a sharp fluctuation in pressure and an increase in the displacement parameter, the system triggers a warning signal about the danger.