Abdessami Soyed
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Abdessami Soyed has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Ameni Kadri
Electrical Engineering Department, University of Carthage, Tunisia
1 shared publication - Faouzi Bacha
Department of Electrical Engineering, National Higher Engineering School of Tunis (ENSIT), University of Tunis, Tunis, Tunisia
1 shared publication - Ismail Marouani
Affiliation Department of Electronics Engineering, Applied College, University of Ha’il, Ha’il, Saudi Arabia
1 shared publication - Mansoor Alturki
Department of Electrical Engineering, College of Engineering, University of Ha’il, Ha’il 55476, Saudi Arabia
1 shared publication - Othman Hasnaoui
University of Tunis, Electrical Engineering Department, ENSIT, Montfleury, Tunis, Tunisia
1 shared publication - Safa Slouma
Université de Carthage , Institut National des Sciences Appliquées et de Technologie , Tunis 1080 , Tunisia , ucar.rnu.tn
1 shared publication
Latest Publications
- Open Access
- 1 January 2026
- Published by Wiley in International Journal of Energy Research
- Vol. 2026 (1) , 9656791
An Enhanced Energy Management Strategy Based on Hybrid PI‐Sliding Mode Control Considering Frequency Separation Approach in a Photovoltaic‐Fuel Cell‐Battery System Intended for Residential Application
This study proposes an enhanced energy management system (EMS) for photovoltaic‐fuel cell‐battery (PV‐FC‐battery) hybrid systems, combining the strengths of the proportional‐integral (PI) regulator and sliding mode controller (SMC) based on a frequency separation strategy. SMC is robust to uncertainties and disturbances but can suffer from chattering. PI controllers are simple and effective for steady‐state performance but may lack robustness. Hence, by combining these two controllers, the hybrid system benefits from both robustness (SMC) and smooth tracking (PI). Existing EMS methods often struggle to balance the slow dynamics of FCs with the fast transients of PV and battery systems, leading to inefficiencies and accelerated degradation. To address this, the proposed approach, based on the infinite‐impulse response filter, decouples power dispatch into low frequency (LF; provided by FC) and high frequency (HF; managed by battery). This hybrid strategy ensures optimal power sharing, reduces FC stress, and improves system lifetime and performance. A supervisor algorithm is implemented, taking into consideration all system converters regulation to satisfy the load requirements and ensure power continuity, mitigating the DC bus vulnerability to voltage instability affected by fluctuations from both source sides and the load. An improved FC electrical model, including experimental FC test identification, is integrated in this algorithm. The FC model is carried out through an enhanced homemade FC test bench. The control algorithms are validated by simulation results using MATLAB‐Simulink. Experimentation is performed in an enhanced lab‐scale prototype under various operating modes and scenarios divided into time periods corresponding to specific load profile variations. Simulations and experimental validations demonstrate superior performance over conventional PI‐only and SMC‐only with 23% faster rise time response, 62.5% faster transient settling time, no overshoot, and 18% reduction in FC degradation. The key innovation lies in the unique integration of PI and SMC via frequency separation, offering a computationally efficient yet robust solution for hybrid renewable energy systems.
- 1 January 2026
- Published by Wiley in International Journal of Energy Research
- Vol. 2026 (1) , 9656791
Open AccessAn Enhanced Energy Management Strategy Based on Hybrid PI‐Sliding Mode Control Considering Frequency Separation Approach in a Photovoltaic‐Fuel Cell‐Battery System Intended for Residential Application
This study proposes an enhanced energy management system (EMS) for photovoltaic‐fuel cell‐battery (PV‐FC‐battery) hybrid systems, combining the strengths of the proportional‐integral (PI) regulator and sliding mode controller (SMC) based on a frequency separation strategy. SMC is robust to uncertainties and disturbances but can suffer from chattering. PI controllers are simple and effective for steady‐state performance but may lack robustness. Hence, by combining these two controllers, the hybrid system benefits from both robustness (SMC) and smooth tracking (PI). Existing EMS methods often struggle to balance the slow dynamics of FCs with the fast transients of PV and battery systems, leading to inefficiencies and accelerated degradation. To address this, the proposed approach, based on the infinite‐impulse response filter, decouples power dispatch into low frequency (LF; provided by FC) and high frequency (HF; managed by battery). This hybrid strategy ensures optimal power sharing, reduces FC stress, and improves system lifetime and performance. A supervisor algorithm is implemented, taking into consideration all system converters regulation to satisfy the load requirements and ensure power continuity, mitigating the DC bus vulnerability to voltage instability affected by fluctuations from both source sides and the load. An improved FC electrical model, including experimental FC test identification, is integrated in this algorithm. The FC model is carried out through an enhanced homemade FC test bench. The control algorithms are validated by simulation results using MATLAB‐Simulink. Experimentation is performed in an enhanced lab‐scale prototype under various operating modes and scenarios divided into time periods corresponding to specific load profile variations. Simulations and experimental validations demonstrate superior performance over conventional PI‐only and SMC‐only with 23% faster rise time response, 62.5% faster transient settling time, no overshoot, and 18% reduction in FC degradation. The key innovation lies in the unique integration of PI and SMC via frequency separation, offering a computationally efficient yet robust solution for hybrid renewable energy systems.
- 29 December 2021
- Published by Taylor & Francis in Cybernetics and Systems
- Vol. 53 (1) , 103-125
Direct Power and Voltage Oriented Control Strategies of Grid-Connected Wind Energy Conversion System Based on Permanent Magnet Synchronous Generator
This article deals with the control techniques of a low-voltage grid-connected to wind power conversion system based on a permanent magnet synchronous generator (PMSG) using an indirect matrix converter (IMC). Details of the proposed strategies for both the rectifier and inverter stages of the IMC are presented. Thus, a rectifier control strategy based on voltage-oriented control using space vector modulation is proposed. In addition, the control objective of the direct power control (DPC) inverter is the regulation of the active powers of the PMSG according to references established on the basis of the maximum power point tracker (MPPT) of the wind turbine, and also a good tracking of the output reactive power to its reference ensures unit power factor (UPF). A numerical simulation investigation is conducted to investigate the fast-dynamic performance of the proposed control systems during the wind speed variation. The obtained results in simulation are then complemented with tests in laboratory environment, the DPC control system is implemented on a dSpace DS1104 real time board. Selective experimental results are presented using a laboratory prototype of the wind energy conversion system to demonstrate the resulting improvements of the developed system. The results achieved have been clearly responded to the follow-up of references even under fluctuating wind conditions, and show promising relevance of the proposed method.
- 29 December 2021
- Published by Taylor & Francis in Cybernetics and Systems
- Vol. 53 (1) , 103-125
Direct Power and Voltage Oriented Control Strategies of Grid-Connected Wind Energy Conversion System Based on Permanent Magnet Synchronous Generator
This article deals with the control techniques of a low-voltage grid-connected to wind power conversion system based on a permanent magnet synchronous generator (PMSG) using an indirect matrix converter (IMC). Details of the proposed strategies for both the rectifier and inverter stages of the IMC are presented. Thus, a rectifier control strategy based on voltage-oriented control using space vector modulation is proposed. In addition, the control objective of the direct power control (DPC) inverter is the regulation of the active powers of the PMSG according to references established on the basis of the maximum power point tracker (MPPT) of the wind turbine, and also a good tracking of the output reactive power to its reference ensures unit power factor (UPF). A numerical simulation investigation is conducted to investigate the fast-dynamic performance of the proposed control systems during the wind speed variation. The obtained results in simulation are then complemented with tests in laboratory environment, the DPC control system is implemented on a dSpace DS1104 real time board. Selective experimental results are presented using a laboratory prototype of the wind energy conversion system to demonstrate the resulting improvements of the developed system. The results achieved have been clearly responded to the follow-up of references even under fluctuating wind conditions, and show promising relevance of the proposed method.