Tian-Tian Pi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Tian-Tian Pi has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
- Shi-Jin Ding
School of Microelectronics, Fudan University, Shanghai, China
2 shared publications - Wen-Jun Liu
Fudan University
2 shared publications David Wei Zhang
State Key Laboratory of ASIC and System, School of Microelectronics, Fudan University, Shanghai, China
1 shared publicationDongqi Xiao
State Key Laboratory of ASIC and System, School of Microelectronics, Fudan University, Shanghai, China
1 shared publication- Gang He
Anhui University
1 shared publication - Hong-Liang Lu
Fudan University
1 shared publication
Latest Publications
- 22 May 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 44 (7) , 1116-1119
Back-End of Line Compatible Hf0.5Zr0.5O2 With ZrO2 Seed Layer for Enhanced Ferroelectricity
In this letter, four ferroelectric (FE) capacitors with thickness dependent ZrO 2 seed layer (SL) were designed and fabricated at a low annealing temperature below 350 °C. By modulating the thickness of ZrO 2 SL, it is demonstrated that the FE capacitor with 1 nm ZrO 2 SL exhibits a superior remnant polarization (2 Pr ) of 44.1 μC/cm 2 under 3 MV/cm at 1 kHz and 2 Pr of 17.6 μC/cm 2 after 10 9 cycles at 3 MV/cm. It is found that the 1 nm ZrO 2 SL provides more growth sites for the Hf 0.5 Zr 0.5 O 2 (HZO) thin films, and enhances the ratio of the ferroelectric phases during crystallization, thereby leading to enhancement of its ferroelectricity and reliability. This work provides a robust solution to improve both ferroelectricity and endurance for future ferroelectric device compatible with back end of line (BEOL) process.
- 22 May 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 44 (7) , 1116-1119
Back-End of Line Compatible Hf0.5Zr0.5O2 With ZrO2 Seed Layer for Enhanced Ferroelectricity
In this letter, four ferroelectric (FE) capacitors with thickness dependent ZrO 2 seed layer (SL) were designed and fabricated at a low annealing temperature below 350 °C. By modulating the thickness of ZrO 2 SL, it is demonstrated that the FE capacitor with 1 nm ZrO 2 SL exhibits a superior remnant polarization (2 Pr ) of 44.1 μC/cm 2 under 3 MV/cm at 1 kHz and 2 Pr of 17.6 μC/cm 2 after 10 9 cycles at 3 MV/cm. It is found that the 1 nm ZrO 2 SL provides more growth sites for the Hf 0.5 Zr 0.5 O 2 (HZO) thin films, and enhances the ratio of the ferroelectric phases during crystallization, thereby leading to enhancement of its ferroelectricity and reliability. This work provides a robust solution to improve both ferroelectricity and endurance for future ferroelectric device compatible with back end of line (BEOL) process.
- 16 November 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 69 (1) , 156-159
High-Performance a-IGZO TFT Fabricated With Ultralow Thermal Budget via Microwave Annealing
In this work, we report high-performance amorphous indium gallium zinc oxide (a-IGZO) thin-film transistors (TFTs) with atomic layer deposited Al 2 O 3 dielectric processed at a minimal temperature of 189.6 °C via microwave annealing (MWA). The a-IGZO TFT with MWA exhibits an improvement of 57% in subthreshold swing (SS) compared with the unannealed device; meanwhile, it retains high field-effect mobility of up to 29.2 cm 2 /(V $\cdot $ s) and large switching ratio of >10 8 . Moreover, the SS of the device was further reduced through a two-step MWA treatment. It is believed that MWA treatment effectively reduces the density of trap states associated with oxygen vacancies, promotes the formation of lattice oxygen, and thus improves the quality of IGZO film. MWA with low thermal budget shows great potential in applications of the back-end of line (BEOL)-compatible oxide devices.
- 16 November 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 69 (1) , 156-159
High-Performance a-IGZO TFT Fabricated With Ultralow Thermal Budget via Microwave Annealing
In this work, we report high-performance amorphous indium gallium zinc oxide (a-IGZO) thin-film transistors (TFTs) with atomic layer deposited Al 2 O 3 dielectric processed at a minimal temperature of 189.6 °C via microwave annealing (MWA). The a-IGZO TFT with MWA exhibits an improvement of 57% in subthreshold swing (SS) compared with the unannealed device; meanwhile, it retains high field-effect mobility of up to 29.2 cm 2 /(V $\cdot $ s) and large switching ratio of >10 8 . Moreover, the SS of the device was further reduced through a two-step MWA treatment. It is believed that MWA treatment effectively reduces the density of trap states associated with oxygen vacancies, promotes the formation of lattice oxygen, and thus improves the quality of IGZO film. MWA with low thermal budget shows great potential in applications of the back-end of line (BEOL)-compatible oxide devices.