TCT. J. B. Collins

T. J. B. Collins

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


T. J. B. Collins has a total of 208 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Hot-spot pressure evolution in inertial confinement fusion implosions

    by V. N. Goncharov, D. Cao, T. J. B. Collins, R. C. Shah, A. Shvydky

    Pressure in the central hot-spot region plays a key role in determining ignition conditions in inertial confinement fusion implosions. This paper investigates the evolution of hot-spot pressure during the deceleration phase. Mass ablation from the inner shell surface increases the hot-spot size, causing the pressure phs to rise faster with hot-spot convergence than predicted by the adiabatic scaling ∼Rhs−5, where Rhs is the hot-spot radius. In contrast, radiation cooling reduces phs. By analyzing the balance between radiation and mass ablation, we relate the maximum phs, relative to the adiabatic scaling, to the hot-spot properties. Beyond the well-established role of bringing most of the fuel mass into the hot spot, mass ablation increases the peak pressure by approximately 60% relative to rigid-piston compression to the same final volume, an effect that has not been included in previous studies. In addition, in hydrodynamically scaled designs, where pressure and temperature are held constant, the pressure reduction due to radiation losses changes with the size as eΠ, where Π∼Rhs0.8. Therefore, neglecting radiation losses when scaling inertial confinement fusion performance to larger systems can lead to overly optimistic projections.

  • Open Access

    Design options for achieving burning plasma and gain for next-generation laser direct-drive facilities

    by W. Trickey, D. Cao, J. A. Marozas, R. Shah, A. Shvydky, T. J. B. Collins, V. N. Goncharov

    The development of next-generation laser technology opens up the potential to build a direct-drive inertial confinement fusion facility that is capable of reaching burning plasma or ignition conditions at moderate laser energies in the hundreds of kilojoules. The addition of bandwidth to the laser source and the use of focal-spot zooming are predicted to significantly increase the ablative drive pressure, while a larger number of beam-ports (∼100) will keep irradiation nonuniformities below an acceptable limit. This study outlines target design options for reaching burning plasma and ignition using laser direct-drive (LDD). It is shown that such designs are predicted to robustly reach ignition at a laser drive energy of 250 kJ. Two-dimensional (2D) simulations are used to investigate the scaling of target performance vs power imbalance, mispointing and imprint. The simulations confirm that 250 kJ is sufficient to maintain gain above unity when perturbed with the amount of power imbalance, mispointing and laser imprint achievable in current direct-drive experiments on OMEGA.


  • Enhancements in Laser-Direct-Drive Nuclear Performance with Target Radius

    by C. A. Thomas, W. Theobald, J. P. Knauer, C. Stoeckl, M. J. Rosenberg, S. P. Regan, T. J. B. Collins, V. N. Goncharov, R. Betti, D. Froula, et al.

    Inertial confinement fusion is likely to require significant improvements in technology and design for large targets to implode at high driver energies. To assess the potential for benefits, we report on nuclear performance as a function of target radius R_{t} in direct-drive cryogenic implosions as performed on the OMEGA laser. The neutron yield and areal density are found to increase as R_{t}^{5.0±0.2} and R_{t}^{1.8±0.2}, respectively, and exhibit a much stronger dependence on target radius than previous studies have assumed. As this Letter demonstrates, these types of sensitivities should be expected when implosions are unstable, and have been degraded by a range of multidimensional effects in 3D. If the imperfections in a target and laser system are fixed in magnitude, it follows that larger implosions have higher relative quality, and approach criteria to ignite much more quickly than commonly appreciated.


  • Open Access

    Laser wavelength dependence of laser imprint

    by A. Pineau, A. Shvydky, R. C. Shah, T. J. B. Collins, D. Cao, J. Carrol-Nellenback, L. Ceurvorst, K. S. Anderson, W. Trickey, J. A. Marozas, et al.

    In laser direct-drive inertial confinement fusion, laser imprint is one of the major causes of degradation in target performance through its seeding of hydrodynamic instabilities. Early experiments and simulations have shown that laser imprint could be mitigated with a longer laser wavelength because of its lower critical density and longer conduction zone. Building upon this work, we explore a scenario where the laser wavelength during the picket pulse differs from that of the main pulse in order to gain the benefit of reduced imprint, while avoiding losses in drive coupling efficiency or an increase in laser-plasma instabilities. A series of 2D radiation-hydrodynamic simulations, which test three different laser wavelengths for the picket pulse, has been performed, where the intensity of the picket pulse is adjusted in order to maintain the same implosion adiabat. A detailed analysis of the growth of the mass density modulations at the ablation front over a large range of mode numbers confirms that the laser imprint can be mitigated with a picket pulse operating at a longer wavelength than the main pulse because of the longer conduction zone and enhanced thermal smoothing. The amplitude of the ablation front modulations is found to be lower for all mode numbers, which reduces the seeding of the Rayleigh–Taylor instability without affecting the mode growth rates.


  • Open Access

    Correlating hot-electron preheat from the two-plasmon decay instability to ρR degradation for direct-drive implosions on OMEGA

    by D. Cao, W. Theobald, M. J. Rosenberg, L. Ceurvorst, D. Patel, A. R. Christopherson, C. Stoeckl, A. Lees, V. Gopalaswamy, R. Betti, et al.

    Focused experiments were performed with the goal of isolating the impact of hot-electron preheat on compression in deuterium–tritium (DT) layered, direct-drive implosions on OMEGA. Preheat from the hot-electrons generated by two-plasmon–decay (TPD) activity was varied through the incident laser intensity, with the total preheat energy deposited into unablated DT fuel being inferred using hard x-ray measurements. Results show a clear correlation between the inferred preheat levels and ρR degradation that is consistent with a derived, 1D preheat model. A fit to the results also provides an estimated range of ρR degradation from non-preheat sources for the adiabat ≈5implosions used in this study. A follow-up study using targets containing Si-doped (5.5%) CH ablators (CHSi) demonstrated results consistent with mid-Z dopants mitigating TPD activity by showing these targets had almost no ρR degradation as the laser intensity was increased up to levels previously considered damaging.


  • Open Access

    Flow visualization in high-energy-density laboratory plasmas

    by P. M. Nilson, J. Katz, M. Michalko, R. Raimondi, D. Guy, S. Klein, J. Schell, S. Zuhric, J. Robinson, C. Spindloe, et al.

    Flow visualization is often essential for evaluating high-energy-density (HED) laboratory plasmas, examining their dynamics, and assessing design strategies. However, imaging at fine phenomenological flow scales is a major challenge. Here, a zone-plate–based radiography system tailored for applications in HED physics is demonstrated. The burst-mode radiography system combines a dual-flash laser-generated x-ray source, a high-magnification zone plate optic, and a multiple frame hybrid complementary metal-oxide-semiconductor (hCMOS) sensor for image detection. Operating at a magnification of 42×, a pair of radiographs is measured in rapid succession, each time gated by a 4.75 keV flash of x rays lasting 100 ps. The system achieves a spatial resolution below 3 μm. The potential of this approach for applications in HED physics is exemplified by observing small-scale spike morphologies at a pusher-foam interface impacted by a strong, laser-driven blast wave.


  • Open Access

    Approaching hydro-equivalent ignition in laser direct-drive via target design optimization using novel statistical modeling

    by A. Lees, R. Betti, V. Gopalaswamy, J. P. Knauer, L. A. Ceurvorst, D. Patel, R. Ejaz, K. S. Anderson, K. A. Bauer, M. J. Bonino, et al.

    Laser direct-drive offers significant advantages in terms of target simplicity, improved energy coupling, and large fuel masses over indirect drive. However, performance degradations from hydrodynamic and laser-plasma instabilities seeded and driven by the direct illumination pose limitations on the parameter space available for achieving ignition. In this paper, new design improvements are identified to forge a path forward for a hydro-equivalent ignition demonstration. The first is related to a new formulation of the statistical model (SM) used to accurately predict target performance directly from input parameters such as laser pulse shape and target specifications. This new SM formulation provides direct guidance on target dimensions and laser beam-to-target radius to achieve the highest fusion yield on the OMEGA laser. The second improvement comes from cooling the deuterium–tritium (DT) ice layer below the triple point right before shot time leading to lower DT vapor densities and higher convergence. Guided by these design improvements, a Bayesian optimization algorithm was used to design an implosion that is predicted to closely approach a Lawson triple product that hydrodynamically scales to ignition if equivalent laser–target coupling is achieved at laser energies typical of the National Ignition Facility.


  • Open Access

    Inference of three-dimensional hot-spot and shell morphology in inertial confinement fusion experiments using a convolutional neural network

    by K. M. Woo, J. Buck, K. Churnetski, R. Betti, C. A. Thomas, C. Stoeckl, P. V. Heuer, C. Kanan, P. B. Radha, J. Carroll-Nellenback, et al.

    The performance of inertial confinement fusion (ICF) implosions is sensitive to the three-dimensional (3D) morphology of the hot-spot and shell configurations. The ability to infer shell-mass uniformity and reconstruct 3D hot spots is crucial for quantifying the degradation of ignition criteria and improving symmetry in ICF implosion experiments. In this work, we present a deep-learning convolutional neural network (CNN) for reconstructing 3D hot-spot and shell structures for ICF capsules. The 3D geometry of the hot spot is reconstructed from x-ray images measured from multiple lines of sight on OMEGA. The shell configuration is inferred indirectly through machine learning using a convolutional neural network extensively trained on a simulation database. This simulation-dependent approach yields consistent agreement between reconstructed 3D shell densities and machine-learning optimized simulation results. This work demonstrates a CNN framework that successfully reconstructs 3D capsule structures from two-dimensional images in ICF implosions. Published by the American Physical Society 2025


  • Open Access

    An experimentally informed design process for future inertial confinement fusion facilities

    by R. K. Follett, A. Colaïtis, I. V. Igumenshchev, D. Cao, R. Nora, V. N. Goncharov, D. N. Polsin, R. Betti, J. P. Palastro, T. J. B. Collins, et al.

    The achievement of ignition in the laboratory has renewed interest in defining the requirements for a future high-gain inertial confinement fusion (ICF) facility. Our best chance of predicting future ICF performance is with 3-D radiation hydrodynamic simulations that have been benchmarked against experimental data, but their high computational cost is prohibitive for use in practical design studies. We introduce a hierarchical approach where 3-D simulations are tuned to match experimental measurements and used to train 3-D degradation models in 1-D simulations allowing for accurate predictions over the entire OMEGA direct-drive database. A genetic algorithm was used in combination with the trained 1-D simulations to search for optimal direct-drive implosion designs at driver energies ranging from 20 kJ to 10 MJ. As the fidelity of 3-D codes improves, this approach will provide a viable experimentally informed tool for defining the next ICF facility.


  • Open Access

    Progress toward hydro-equivalent ignition in OMEGA direct-drive DT-layered implosions

    by L. Ceurvorst, R. Betti, V. Gopalaswamy, A. Lees, J. P. Knauer, M. J. Rosenberg, D. Patel, R. Ejaz, C. A. Williams, K. M. Woo, et al.

    Considerable progress has been made in deuterium-tritium-layered implosion experiments on the OMEGA Laser System, bringing the prospects for thermonuclear ignition in direct-drive configurations with megajoule-class lasers closer to reality. Doing so has required navigating the balance between improved 1D performance and multidimensional stability. Using statistical modeling based on over 350 cryogenic implosions to identify various degradation mechanisms, and combined with multidimensional simulations and experimental techniques such as target offsets to combat residual flows, core conditions have repeatably been achieved that extrapolate to the burning-plasma state when scaled to 2.15 MJ of symmetric laser illumination. Using high implosion velocities (>450 km/s) and moderately high adiabats (∼5), these experiments produced record-high scaled Lawson parameters in direct drive equal to 89±2% of that required for ignition with expected yields of up to 1.5±0.2 MJ. To improve these results still further, focused physics studies are performed to improve physics understanding and identify routes to even greater performance. Recent studies include investigations into the impact of mounting features, laser imprint, reduced fuel temperatures, and greater on-target intensities through subscale experiments. This manuscript gives a summary of the cryogenic direct-drive program on the OMEGA laser, including routes taken to achieve the current best performance, the status of recent focused physics investigations, and future designs—such as target solutions to laser imprint and reducing vapor density to increase convergence—that are expected lead to the demonstration of hydro-equivalent ignition on OMEGA.