Daniel Spencer
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Daniel Spencer has a total of 55 co-authors. Here are the top co-authors by number of shared publications:
- Hywel Morgan
School of Electronics and Computer Science, University of Southampton, Southampton, SO17 1BJ, UK
17 shared publications - Miguel Xavier
INL ‐ International Iberian Nanotechnology Laboratory Avenida Mestre José Veiga, s/n Braga 4715‐330 Portugal
3 shared publications - Richard O. C. Oreffo
Bone and Joint Research Group, Centre for Human Development, Stem Cells & Regeneration, Institute of Developmental Sciences, University of Southampton, Southampton, SO16 6YD, UK
3 shared publications - Carlos Honrado
International Iberian Nanotechnology Laboratory - INL, Braga, Portugal
2 shared publications - Federica Caselli
Department of Civil Engineering and Computer Science, University of Rome Tor Vergata, Rome, Italy
2 shared publications - Paolo Bisegna
Department of Civil Engineering and Computer Science, University of Rome Tor Vergata, Rome, Italy
2 shared publications
Latest Publications
- Open Access
- 4 June 2026
- Published by Royal Society of Chemistry (RSC) in The Analyst
- Vol. 151 (14) , 4115-4125
Rapid antimicrobial susceptibility testing directly from positive blood cultures
A smart centrifugation and selective lysis workflow enables rapid antimicrobial susceptibility testing directly from positive blood cultures within 3 h using impedance flow cytometry.
- 4 June 2026
- Published by Royal Society of Chemistry (RSC) in The Analyst
- Vol. 151 (14) , 4115-4125
Open AccessRapid antimicrobial susceptibility testing directly from positive blood cultures
A smart centrifugation and selective lysis workflow enables rapid antimicrobial susceptibility testing directly from positive blood cultures within 3 h using impedance flow cytometry.
- 5 July 2025
- Published by Elsevier in Journal of Infection
- Vol. 91 (2) , 106549
Rapid impedance-based Antimicrobial Susceptibility Testing (iFAST) of Enterobacterales in urinary tract infections
- 5 July 2025
- Published by Elsevier in Journal of Infection
- Vol. 91 (2) , 106549
Rapid impedance-based Antimicrobial Susceptibility Testing (iFAST) of Enterobacterales in urinary tract infections
- Open Access
- 30 April 2025
- Published by Royal Society of Chemistry (RSC) in Lab on a Chip
- Vol. 25 (12) , 2939-2948
Single-cell impedance spectroscopy of nucleated cells
A single-cell impedance spectroscopy with an extended frequency range (550 MHz) for nucleated cells was developed to discriminate changes in cell dielectric parameters.
- 30 April 2025
- Published by Royal Society of Chemistry (RSC) in Lab on a Chip
- Vol. 25 (12) , 2939-2948
Open AccessSingle-cell impedance spectroscopy of nucleated cells
A single-cell impedance spectroscopy with an extended frequency range (550 MHz) for nucleated cells was developed to discriminate changes in cell dielectric parameters.
- Open Access
- 23 October 2024
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 14 (46) , 34270-34278
A combined electro-optical deformability micro-cytometer
This paper describes a cytometer that measures the optical and electrical deformabilitiy of multiple single cells in a viscoelastic flow.
- 23 October 2024
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 14 (46) , 34270-34278
Open AccessA combined electro-optical deformability micro-cytometer
This paper describes a cytometer that measures the optical and electrical deformabilitiy of multiple single cells in a viscoelastic flow.
- Open Access
A Novel Wearable Sensor for Measuring Respiration Continuously and in Real Time
In this work, a flexible textile-based capacitive respiratory sensor, based on a capacitive sensor structure, that does not require direct skin contact is designed, optimised, and evaluated using both computational modelling and empirical measurements. In the computational study, the geometry of the sensor was examined. This analysis involved observing the capacitance and frequency variations using a cylindrical model that mimicked the human body. Four designs were selected which were then manufactured by screen printing multiple functional layers on top of a polyester/cotton fabric. The printed sensors were characterised to detect the performance against phantoms and impacts from artefacts, normally present whilst wearing the device. A sensor that has an electrode ratio of 1:3:1 (sensor, reflector, and ground) was shown to be the most sensitive design, as it exhibits the highest sensitivity of 6.2% frequency change when exposed to phantoms. To ensure the replicability of the sensors, several batches of identical sensors were developed and tested using the same physical parameters, which resulted in the same percentage frequency change. The sensor was further tested on volunteers, showing that the sensor measures respiration with 98.68% accuracy compared to manual breath counting.
Open AccessA Novel Wearable Sensor for Measuring Respiration Continuously and in Real Time
In this work, a flexible textile-based capacitive respiratory sensor, based on a capacitive sensor structure, that does not require direct skin contact is designed, optimised, and evaluated using both computational modelling and empirical measurements. In the computational study, the geometry of the sensor was examined. This analysis involved observing the capacitance and frequency variations using a cylindrical model that mimicked the human body. Four designs were selected which were then manufactured by screen printing multiple functional layers on top of a polyester/cotton fabric. The printed sensors were characterised to detect the performance against phantoms and impacts from artefacts, normally present whilst wearing the device. A sensor that has an electrode ratio of 1:3:1 (sensor, reflector, and ground) was shown to be the most sensitive design, as it exhibits the highest sensitivity of 6.2% frequency change when exposed to phantoms. To ensure the replicability of the sensors, several batches of identical sensors were developed and tested using the same physical parameters, which resulted in the same percentage frequency change. The sensor was further tested on volunteers, showing that the sensor measures respiration with 98.68% accuracy compared to manual breath counting.
- 24 March 2022
- Published by Royal Society of Chemistry (RSC) in Lab on a Chip
- Vol. 22 (9) , 1714-1722
Deciphering impedance cytometry signals with neural networks
A successful outcome of the coupling between microfluidics and AI: neural networks tackle the signal processing challenges of single-cell microfluidic impedance cytometry.
- 24 March 2022
- Published by Royal Society of Chemistry (RSC) in Lab on a Chip
- Vol. 22 (9) , 1714-1722
Deciphering impedance cytometry signals with neural networks
A successful outcome of the coupling between microfluidics and AI: neural networks tackle the signal processing challenges of single-cell microfluidic impedance cytometry.
- 4 February 2020
- Published by American Chemical Society (ACS) in ACS Sensors
- Vol. 5 (2) , 423-430
High-Speed Single-Cell Dielectric Spectroscopy
Single cell impedance cytometry is a label free analysis technique that is now widely used to measure the electrical properties of cell, and to differentiate different sub-populations. Current techniques are limited to measuring the impedance of a single cell at one or two simultaneous frequencies. Also there are no methods that extrapolate the intrinsic electrical properties of single cells. We demonstrate a new approach that uses multi-frequency impedance measurements to determine the complete intrinsic electrical properties of thousands of single cells at high throughput. The applicability of the method is demonstrated by measuring the properties of red blood cells and red cell ghosts, deriving the unique values of conductivity and permittivity of the membrane and cytoplasm for each individual cell.
- 4 February 2020
- Published by American Chemical Society (ACS) in ACS Sensors
- Vol. 5 (2) , 423-430
High-Speed Single-Cell Dielectric Spectroscopy
Single cell impedance cytometry is a label free analysis technique that is now widely used to measure the electrical properties of cell, and to differentiate different sub-populations. Current techniques are limited to measuring the impedance of a single cell at one or two simultaneous frequencies. Also there are no methods that extrapolate the intrinsic electrical properties of single cells. We demonstrate a new approach that uses multi-frequency impedance measurements to determine the complete intrinsic electrical properties of thousands of single cells at high throughput. The applicability of the method is demonstrated by measuring the properties of red blood cells and red cell ghosts, deriving the unique values of conductivity and permittivity of the membrane and cytoplasm for each individual cell.
- 9 January 2019
- Published by Royal Society of Chemistry (RSC) in Lab on a Chip
- Vol. 19 (3) , 513-523
Label-free enrichment of primary human skeletal progenitor cells using deterministic lateral displacement
Cell sorting using label-free microfluidic approaches offer significant promise for skeletal stem cell enrichment from human bone marrow.
- 9 January 2019
- Published by Royal Society of Chemistry (RSC) in Lab on a Chip
- Vol. 19 (3) , 513-523
Label-free enrichment of primary human skeletal progenitor cells using deterministic lateral displacement
Cell sorting using label-free microfluidic approaches offer significant promise for skeletal stem cell enrichment from human bone marrow.
- Open Access
- 17 October 2018
- Published by The Royal Society in Journal of The Royal Society Interface
- Vol. 15 (147) , 20180416
Dielectric characterization of Plasmodium falciparum -infected red blood cells using microfluidic impedance cytometry
Although malaria is the world's most life-threatening parasitic disease, there is no clear understanding of how certain biophysical properties of infected cells change during the malaria infection cycle. In this article, we use microfluidic impedance cytometry to measure the dielectric properties of Plasmodium falciparum -infected red blood cells ( i- RBCs) at specific time points during the infection cycle. Individual parasites were identified within i- RBCs using green fluorescent protein (GFP) emission. The dielectric properties of cell sub-populations were determined using the multi-shell model. Analysis showed that the membrane capacitance and cytoplasmic conductivity of i- RBCs increased along the infection time course, due to membrane alterations caused by parasite infection. The volume ratio occupied by the parasite was estimated to vary from less than 10% at earlier stages, to approximately 90% at later stages. This knowledge could be used to develop new label-free cell sorting techniques for sample pre-enrichment, improving diagnosis.
- 17 October 2018
- Published by The Royal Society in Journal of The Royal Society Interface
- Vol. 15 (147) , 20180416
Open AccessDielectric characterization of Plasmodium falciparum -infected red blood cells using microfluidic impedance cytometry
Although malaria is the world's most life-threatening parasitic disease, there is no clear understanding of how certain biophysical properties of infected cells change during the malaria infection cycle. In this article, we use microfluidic impedance cytometry to measure the dielectric properties of Plasmodium falciparum -infected red blood cells ( i- RBCs) at specific time points during the infection cycle. Individual parasites were identified within i- RBCs using green fluorescent protein (GFP) emission. The dielectric properties of cell sub-populations were determined using the multi-shell model. Analysis showed that the membrane capacitance and cytoplasmic conductivity of i- RBCs increased along the infection time course, due to membrane alterations caused by parasite infection. The volume ratio occupied by the parasite was estimated to vary from less than 10% at earlier stages, to approximately 90% at later stages. This knowledge could be used to develop new label-free cell sorting techniques for sample pre-enrichment, improving diagnosis.
- Open Access
- 23 August 2017
- Published by The Royal Society in Journal of The Royal Society Interface
- Vol. 14 (133) , 20170233
Size and dielectric properties of skeletal stem cells change critically after enrichment and expansion from human bone marrow: consequences for microfluidic cell sorting
The capacity of bone and cartilage to regenerate can be attributed to skeletal stem cells (SSCs) that reside within the bone marrow (BM). Given SSCs are rare and lack specific surface markers, antibody-based sorting has failed to deliver the cell purity required for clinical translation. Microfluidics offers new methods of isolating cells based on biophysical features including, but not limited to, size, electrical properties and stiffness. Here we report the characterization of the dielectric properties of unexpanded SSCs using single-cell microfluidic impedance cytometry (MIC). Unexpanded SSCs had a mean size of 9.0 µm; larger than the majority of BM cells. During expansion, often used to purify and increase the number of SSCs, cell size and membrane capacitance increased significantly, highlighting the importance of characterizing unaltered SSCs. In addition, MIC was used to track the osteogenic differentiation of SSCs and showed an increased membrane capacitance with differentiation. The electrical properties of primary SSCs were indistinct from other BM cells precluding its use as an isolation method. However, the current studies indicate that cell size in combination with another biophysical parameter, such as stiffness, could be used to design label-free devices for sorting SSCs with significant clinical impact.
- 23 August 2017
- Published by The Royal Society in Journal of The Royal Society Interface
- Vol. 14 (133) , 20170233
Open AccessSize and dielectric properties of skeletal stem cells change critically after enrichment and expansion from human bone marrow: consequences for microfluidic cell sorting
The capacity of bone and cartilage to regenerate can be attributed to skeletal stem cells (SSCs) that reside within the bone marrow (BM). Given SSCs are rare and lack specific surface markers, antibody-based sorting has failed to deliver the cell purity required for clinical translation. Microfluidics offers new methods of isolating cells based on biophysical features including, but not limited to, size, electrical properties and stiffness. Here we report the characterization of the dielectric properties of unexpanded SSCs using single-cell microfluidic impedance cytometry (MIC). Unexpanded SSCs had a mean size of 9.0 µm; larger than the majority of BM cells. During expansion, often used to purify and increase the number of SSCs, cell size and membrane capacitance increased significantly, highlighting the importance of characterizing unaltered SSCs. In addition, MIC was used to track the osteogenic differentiation of SSCs and showed an increased membrane capacitance with differentiation. The electrical properties of primary SSCs were indistinct from other BM cells precluding its use as an isolation method. However, the current studies indicate that cell size in combination with another biophysical parameter, such as stiffness, could be used to design label-free devices for sorting SSCs with significant clinical impact.