Saker Saloum
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Saker Saloum has a total of 57 co-authors. Here are the top co-authors by number of shared publications:
B. Alkhaled
Atomic Energy Commission of Syria (AECS), Physics Department, P. O. Box 6091, Damascus, Syria
7 shared publicationsM. Naddaf
6 shared publicationsSamer Abou Shaker
Physics Department, Atomic Energy Commission, Damascus, Syria
5 shared publicationsS. A. Shaker
Physics Department, Atomic Energy Commission, Damascus, Syria
4 shared publicationsA. Obaid
Physics Department, Atomic Energy Commission, Damascus, Syria
3 shared publicationsB Alkhaled
United States Atomic Energy Commission
3 shared publications
Latest Publications
- 8 September 2026
- Published by Springer Nature in Optoelectronics Letters
- Vol. 22 (9) , 518-521
Effect of substrate pretreatment on HMDSN plasma deposited thin films properties
- 8 September 2026
- Published by Springer Nature in Optoelectronics Letters
- Vol. 22 (9) , 518-521
Effect of substrate pretreatment on HMDSN plasma deposited thin films properties
- 1 April 2026
- Published by AIP Publishing in Physics of Plasmas
- Vol. 33 (4)
Investigating the properties of argon-helium plasma mixture generated in the RF remote discharge system
This study aims to investigate experimentally the Ar-He glow-discharge mixture properties using both Langmuir probe and optical emission spectroscopy techniques, at different plasma operation conditions, namely, pressure, applied radio frequency (RF) power, and Helium fraction in the discharge. The plasma is excited in an RF hollow cathode remote discharge system. Different plasma characteristics are studied, such as the electron energy probability function (EEPF), electron density (ne), effective electron temperature (Teff), and atomic lines emission intensities. Findings indicate that the EEPFs exhibit a Druyvesteyn-like shape with depletion of high-energy electrons beyond 50% He fraction. In addition, it is revealed that ne has a maximum at 50% He fraction, which increases with the increase in both total pressure and applied RF power. Regarding Teff behaviors, it is found that it increases with the increase in total pressure, applied power and He fraction. Finally, it is shown that the evolutions of spectral line emission intensities are mainly affected by the applied RF power and partial pressures of argon and helium gases.
- 1 April 2026
- Published by AIP Publishing in Physics of Plasmas
- Vol. 33 (4)
Investigating the properties of argon-helium plasma mixture generated in the RF remote discharge system
This study aims to investigate experimentally the Ar-He glow-discharge mixture properties using both Langmuir probe and optical emission spectroscopy techniques, at different plasma operation conditions, namely, pressure, applied radio frequency (RF) power, and Helium fraction in the discharge. The plasma is excited in an RF hollow cathode remote discharge system. Different plasma characteristics are studied, such as the electron energy probability function (EEPF), electron density (ne), effective electron temperature (Teff), and atomic lines emission intensities. Findings indicate that the EEPFs exhibit a Druyvesteyn-like shape with depletion of high-energy electrons beyond 50% He fraction. In addition, it is revealed that ne has a maximum at 50% He fraction, which increases with the increase in both total pressure and applied RF power. Regarding Teff behaviors, it is found that it increases with the increase in total pressure, applied power and He fraction. Finally, it is shown that the evolutions of spectral line emission intensities are mainly affected by the applied RF power and partial pressures of argon and helium gases.
- 25 September 2025
- Published by Springer Nature in Optoelectronics Letters
- Vol. 21 (10) , 601-605
Plasma polymerized hexamethyldisilazane thin films in RF remote plasma system: effect of substrate distance from plasma source
- 25 September 2025
- Published by Springer Nature in Optoelectronics Letters
- Vol. 21 (10) , 601-605
Plasma polymerized hexamethyldisilazane thin films in RF remote plasma system: effect of substrate distance from plasma source
- 22 May 2023
- Published by Springer Nature in Optoelectronics Letters
- Vol. 19 (5) , 274-278
Effect of substrate bias on the properties of plasma deposited organosilicone (pp-HMDSN) thin films
- 22 May 2023
- Published by Springer Nature in Optoelectronics Letters
- Vol. 19 (5) , 274-278
Effect of substrate bias on the properties of plasma deposited organosilicone (pp-HMDSN) thin films
- 8 February 2023
- Published by Wiley in Surface and Interface Analysis
- Vol. 55 (5) , 357-363
Study of silicon surface micro‐roughness generated by SF 6 remote plasma etching
We investigate micro‐roughness of silicon surface in remote radiofrequency (RF) SF 6 plasma, for different etching durations. A linear behavior of etching rate is observed as a function of etching time. PL measurements at different temperatures indicate a visible (green and violet) and ultraviolet (UV) emissions. The evolution of surface roughness of Si substrates can be controlled depending on the etching duration. In response to the increase of the etching duration, the surface undergoes nanoscale roughening, ripple formation, and finally microscale roughening. Atomic force microscopy analysis was carried out to surface morphology.
- 8 February 2023
- Published by Wiley in Surface and Interface Analysis
- Vol. 55 (5) , 357-363
Study of silicon surface micro‐roughness generated by SF 6 remote plasma etching
We investigate micro‐roughness of silicon surface in remote radiofrequency (RF) SF 6 plasma, for different etching durations. A linear behavior of etching rate is observed as a function of etching time. PL measurements at different temperatures indicate a visible (green and violet) and ultraviolet (UV) emissions. The evolution of surface roughness of Si substrates can be controlled depending on the etching duration. In response to the increase of the etching duration, the surface undergoes nanoscale roughening, ripple formation, and finally microscale roughening. Atomic force microscopy analysis was carried out to surface morphology.
- 24 August 2022
- Published by Wiley in Surface and Interface Analysis
- Vol. 54 (12) , 1222-1230
Spectroscopic and electrical characterization of oxygen microwave discharge used for downstream plasma oxidation of Si
Actinometry optical emission spectroscopy (AOES), single cylindrical Langmuir, probe and electrostatic planar probe were used to characterize oxygen microwave plasma, at two distances from the plasma source ( Z 1 = 15 cm and Z 2 = 25 cm), using three values of applied microwave power (800, 1000, and 1400 W) at a constant pressure of 70 Pa, involving different parameters, which are electron density ( n e ), effective electron temperature ( T eff ), plasma potential ( V p ), floating potential ( V f ), positive ion flux ( Г i ), negative ion ratio ( α = n − / n e , n − is the negative ion density), and atomic oxygen density (AO: [O]). The electron density and the effective electron temperature were deduced from ( I ‐ V ) Langmuir probe characteristics. The atomic oxygen density was measured using actinometry method. Positive ion flux was evaluated from the positive ion saturation current ( I sat ) of the planar probe. The combination of both single Langmuir probe and the planar one enabled the calculation of electronegativity of the oxygen plasma. An application of this oxygen plasma is presented, which is the silicon surface oxidation. The formed SiO 2 layer has been characterized by both scanning electron microscopy (SEM) and atomic force microscopy (AFM) analysis.
- 24 August 2022
- Published by Wiley in Surface and Interface Analysis
- Vol. 54 (12) , 1222-1230
Spectroscopic and electrical characterization of oxygen microwave discharge used for downstream plasma oxidation of Si
Actinometry optical emission spectroscopy (AOES), single cylindrical Langmuir, probe and electrostatic planar probe were used to characterize oxygen microwave plasma, at two distances from the plasma source ( Z 1 = 15 cm and Z 2 = 25 cm), using three values of applied microwave power (800, 1000, and 1400 W) at a constant pressure of 70 Pa, involving different parameters, which are electron density ( n e ), effective electron temperature ( T eff ), plasma potential ( V p ), floating potential ( V f ), positive ion flux ( Г i ), negative ion ratio ( α = n − / n e , n − is the negative ion density), and atomic oxygen density (AO: [O]). The electron density and the effective electron temperature were deduced from ( I ‐ V ) Langmuir probe characteristics. The atomic oxygen density was measured using actinometry method. Positive ion flux was evaluated from the positive ion saturation current ( I sat ) of the planar probe. The combination of both single Langmuir probe and the planar one enabled the calculation of electronegativity of the oxygen plasma. An application of this oxygen plasma is presented, which is the silicon surface oxidation. The formed SiO 2 layer has been characterized by both scanning electron microscopy (SEM) and atomic force microscopy (AFM) analysis.
- 15 June 2021
- Published by Wiley in Surface and Interface Analysis
- Vol. 53 (9) , 754-761
Polymer surface modification using He/O 2 RF remote low‐pressure plasma
In this study, He/O 2 plasma mixture, induced in a radio frequency (RF) low‐pressure remote plasma system, has been characterized and employed for polymer surface modification. Actinometry optical emission spectroscopy (AOES) and Langmuir probe techniques were used to evaluate the plasma active species contributing to polymer surface modification. These active species involve the atomic oxygen [O] and the electrons ( n e ). Five different polymers (poly(methyl methacrylate) [PMMA], polytetrafluoroethylene [PTFE], polyethylene [PE], polyvinyl chloride [PVC], and polystyrene [PS]) were plasma treated and subsequently characterized for etching rate, surface morphology using atomic force microscopy (AFM) technique, and chemical elemental composition using X‐ray photoelectron spectroscopy (XPS) technique.
- 15 June 2021
- Published by Wiley in Surface and Interface Analysis
- Vol. 53 (9) , 754-761
Polymer surface modification using He/O 2 RF remote low‐pressure plasma
In this study, He/O 2 plasma mixture, induced in a radio frequency (RF) low‐pressure remote plasma system, has been characterized and employed for polymer surface modification. Actinometry optical emission spectroscopy (AOES) and Langmuir probe techniques were used to evaluate the plasma active species contributing to polymer surface modification. These active species involve the atomic oxygen [O] and the electrons ( n e ). Five different polymers (poly(methyl methacrylate) [PMMA], polytetrafluoroethylene [PTFE], polyethylene [PE], polyvinyl chloride [PVC], and polystyrene [PS]) were plasma treated and subsequently characterized for etching rate, surface morphology using atomic force microscopy (AFM) technique, and chemical elemental composition using X‐ray photoelectron spectroscopy (XPS) technique.
- 6 February 2021
- Published by Springer Nature in Silicon
- Vol. 14 (4) , 1767-1774
Characterization of Commercial P-MOSFETs for Using as a Gamma-Rays Dosimeter
- 6 February 2021
- Published by Springer Nature in Silicon
- Vol. 14 (4) , 1767-1774
Characterization of Commercial P-MOSFETs for Using as a Gamma-Rays Dosimeter
- 23 January 2020
- Published by Springer Nature in Silicon
- Vol. 12 (12) , 2957-2966
Hydrogenated Silicon Carbonitride Thin Film Nanostructuring Using SF6 Plasma: Structural and Optical Analysis
- 23 January 2020
- Published by Springer Nature in Silicon
- Vol. 12 (12) , 2957-2966
Hydrogenated Silicon Carbonitride Thin Film Nanostructuring Using SF6 Plasma: Structural and Optical Analysis
- 7 November 2019
- Published by Springer Nature in Silicon
- Vol. 12 (8) , 1839-1846
Effect of Atmospheric Ageing on the Properties of Organosilicon (Pp-HMDSO) Thin Films
- 7 November 2019
- Published by Springer Nature in Silicon
- Vol. 12 (8) , 1839-1846
Effect of Atmospheric Ageing on the Properties of Organosilicon (Pp-HMDSO) Thin Films