FKFatima Khitab

Fatima Khitab

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Fatima Khitab has a total of 53 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Green synthesis of nickel oxide nanoparticles using Calotropis procera leaf extract for visible-light photocatalytic degradation of RBV-5R dye

    by Aiman Imtiaz, Rabid Ullah, Shagufta Rasool, Naveed Ahmad, Abdulkarim Alansari, Farooq Ahmad, Fatima Khitab

    The increasing release of azo dyes into wastewater presents a significant environmental challenge due to their chemical stability, toxicity, and persistence in aquatic environments. In this study, nickel oxide nanoparticles were green-synthesized using Calotropis procera leaf extract and employed as photocatalysts for the degradation of RBV 5R dye, a model azo dye. The biosynthesized nanoparticles were characterized using SEM, XRD, FT-IR, and TGA, confirming their morphological, structural, and thermal properties. Photocatalytic degradation experiments were conducted under varying conditions to optimize the degradation efficiency, with results showing that mildly acidic conditions (pH 4) and 5 mM hydrogen peroxide yielded the highest degradation. The reaction kinetics followed a pseudo-second order kinetic (R2 = 0.9989), and the catalyst reusability was evaluated over five cycles, showing a slight decrease in efficiency from 99% to 93.5% by the fifth cycle, confirming good operational stability. This study demonstrates that Calotropis procera-mediated nickel oxide nanoparticles offer a cost-effective and environmentally sustainable solution for the photocatalytic degradation of toxic azo dyes, with significant potential for industrial wastewater treatment.

  • Titania-Based Sonocatalysts for Water Remediation: A Critical Evaluation of Mechanisms, Performance, and Its Niche among Advanced Oxidation Processes

    by Ki-Hyun Kim, Fatima Khitab, Hubdar Ali

    Growing industrial discharge of persistent organic pollutants threatens ecosystems and health, necessitating effective water remediation. Among advanced treatments, sonocatalysis shows promise but critically lacks rigorous benchmarks and a clear strategic...


  • Nickel-impregnated ZnO catalysts: a promising catalyst for efficient methylene blue dye degradation via photocatalysis and sonocatalysis

    by Masood Ahmad, Shagufta Rasool, Fatima Khitab, Naveed Ahmad, Farooq Ahmad, Amir Sada Khan, Nargis Jamila

    This research used the wet impregnation method to prepare visible light-induced nickel-impregnated zinc oxide (Ni/ZnO) photocatalysts. The synthesized catalysts were tested for methylene blue (MB) degradation in aqueous media. The photocatalyst’s structure, morphology, and composition were confirmed using EDX, SEM, and XRD analyses. The Ni/ZnO exhibited a high specific surface area of 192.88 m2/g and a mesoporous structure with an average pore size of 110.02 Å, as determined by BET analysis. The effect of different parameters such as the pH of the dye solution, catalyst dose, the concentration of dye, and the impact of oxidizing agent and radical scavenger on the photodegradation efficiency of catalyst for MB in aqueous media was investigated. The photocatalysis and sonophotocatalysis led to 75% and 98% degradation of 20 mg L−1 of MB in 60 min at pH 9 using 0.1 g L−1 of catalyst. The photocatalyst was found reactive upto five runs. The number of degraded molecules was 2.34E-06 mol and 3.06E-06 mol for photocatalysis and sonophotocatalysis, respectively. It was found that the degradation efficiency increased in the presence of H2O2 while decreasing with the increase of dye concentration and radical scavenger. The sonophotocatalytic degradation of methylene blue, demonstrating enhanced kinetics over photocatalysis alone, followed both pseudo-first-order and pseudo-second-order models. The photocatalysis reaction rate (r) was 7.82E-03 mmol g−1 min−1 with a quantum yield of 1.86E-06 mol/photon and a space–time yield of 1.86E-07 mol/photon/mg. In contrast, the reaction rate for sonophotocatalysis was 1.02E-02 mmol g−1 min−1 with a quantum yield of 2.43E-06 mol/photon and a space–time yield of 2.43E-07 mol/photon/mg. The results revealed that Ni/ZnO can be an effective catalyst for degrading toxic MB and MB like other dyes. Graphical Abstract


  • Open Access

    Gum Arabic Magnetized Graphene Oxide Composite for the Removal of Fluorescent Dye Fluorescein from Aqueous Solutions: Equilibrium, Kinetic and Thermodynamic Studies

    by Anwar Ali, Fatima Khitab, Jasmin Shah, Muhammad Rasul Jan

    In recent years, due to industrialization water pollution is the major issue. The aim of the present work was the synthesis of solid Gum Arabic Magnetized Graphene Oxide (GA-MGO) and its application for the removal of fluorescent dye, fluorescein from aqueous samples. The characterization of the composite was carried out through FTIR, SEM, EDX, point of zero charge, and surface area. Various parameters optimization such as pH, shaking time, adsorbent dose, adsorbate concentration, temperature, and their influence on the removal of fluorescein using GA-MGO composite during the adsorption process was studied. The synthesized GA-MGO exhibited high adsorption efficiency of 94.18 % in 60 mins (pH 2, fluorescein 20 µg mL-1, 0.08 g L-1 of adsorbent). The synthesized GA-MGO composite has a high capacity to remove fluorescein molecules from aqueous solution at 25 °C. The kinetics of adsorption was investigated and it was found that adsorption followed pseudo-second-order kinetics with the regression coefficient R2 value of 0.962. The R2 value of Langmuir (0.985) and Freundlich (0.894) showed that the Langmuir adsorption isotherm fitted best to the adsorption process. Different thermodynamic parameters, Gibb’s free energy and Van’t Hoff equation reveals tht the proposed reaction is spontaneous and exothermic. Regeneration of adsorbent/ desorption of dye and application of composite to the sample of sewage and industrial effluents results in better adsorption. The finding reveals the feasibility of GA-MGO composite as potential precursor for the effective adsorption of fluorescent dyes due to its high surface area.

  • Open Access

    Modified Clinoptilolite for the Removal of Rhodamine B Dye from Wastewater

    by Syed Fawad Ali Shah, Fatima Khitab, Shagufta Rasool, Rozina Khattak, Tasmia, Hajera Gul, Riaz Muhammad, Muhammad Sufaid Khan, Munaza Naseem, Zane Vincevica-Gaile

    This study reveals the modification of the surface area of natural zeolite Clinoptilolite (CLN) by implementing the ion exchange method. The ammonium chloride cation exchange method was adopted and was followed by calcination at 450 °C for 5 h. This procedure helps to increase the surface area of CLN and also enhances its adsorption efficiency. The modifications of the CLN were confirmed by Fourier-transform infrared (FT-IR) spectroscopy and X-ray diffraction (XRD) analysis. The efficiency and adsorption capacity of the modified CLN were determined by the adsorption of a Rhodamine B (Rh B) dye from an aqueous medium. The comparative analysis of the adsorption efficiency of raw CLN and the modified CLN revealed an enhanced adsorption of Rh B by the modified CLN at pH = 10. For desorption, different solvents were used. The results showed good desorption in ethanol and methanol, and poor desorption in acidic (HCl) and basic (NaOH) solutions. The kinetic study of the adsorption of Rh B by the modified CLN helped us to conclude that the adsorption follows a pseudo-second-order kinetics. For the surface study and to understand the mechanism of adsorption, several isotherm models were applied to the adsorption data at equilibrium. The data showed consistency with the Freundlich adsorption isotherm confirming that the process took place at its heterogeneous surface. The experimentally calculated adsorption capacity of the modified CLN was 2.81 mg g−1, showing a comparable value to certain other common adsorbents. Therefore, the modified CLN may also be considered a cost-effective and promising adsorbent for the removal of Rh B dye from wastewater.


  • Open Access

    Ultrasound assisted photocatalytic degradation of isoproturon and triasulfuron herbicides using visible light driven impregnated zinc oxide catalysts

    by Kashif Khan, Fatima Khitab, Jasmin Shah, Muhammad Rasul Jan

    Herbicides in wastewater are considered as a serious issue to environmental pollution. Different impregnated metal zinc oxide (Cu/ZnO and Ni/ZnO) as catalysts were prepared through wet impregnation method for the degradation of herbicides Isoproturon and triasulfuron. The prepared impregnated catalysts were characterized using scanning electron microscopy (SEM) and x-ray diffraction (XRD), energy dispersive x-ray (EDX) analysis, Fourier-transform infrared spectroscopyand surface area. The degradation of selected herbicides were investigated using combined effect of photocatalysis and sonication. The experimental parameters such as pH, irradiation time, photocatalyst dose, effect of oxidants, diverse ion effect, herbicide concentration and catalyst reusability have been optimized. The percent removal of isoproturon was found to be 99 and 98% at pH 7 and triasulfuron was 98% at pH 6 using Cu/ZnO and 99% at pH 7 using Ni/ZnO photocatalysts respectively. Graphical Abstract Graphical abstract of Ultrasound Assisted Photocatalytic Degradation of Isoproturon and Triasulfuron Herbicides


  • Open Access

    Superparamagnetic Zinc Ferrite Nanoparticles as Visible-Light Active Photocatalyst for Efficient Degradation of Selected Textile Dye in Water

    by Rabid Ullah, Fatima Khitab, Hajera Gul, Rozina Khattak, Junaid Ihsan, Mansoor Khan, Abbas Khan, Zane Vincevica-Gaile, Hani Amir Aouissi

    Photocatalysis is a promising technology for the degradation of recalcitrant organic pollutants in water. In this study, superparamagnetic zinc ferrite nanoparticles (ZnFe2O4) were synthesized and characterized using scanning electron microscopy, X-ray diffraction, energy dispersive X-ray and Fourier transform infrared spectroscopy. The synthesized nanoparticles (NPs) of ZnFe2O4 were observed to have a photosensitive nature and showed characteristic visible-light-induced activation that was used for the photocatalytic degradation of a textile dye, Remazol brilliant violet 5R (RBV-5R). The effect of different operational parameters such as pH, H2O2, catalyst dosage, concentration of RBV-5R and the reusability of ZnFe2O4 as well as scavengers were investigated under visible irradiation. The almost complete degradation (99.9%) of RBV-5R was observed at pH 10, 0.1 g of ZnFe2O4 and 6 mM of H2O2 in 30 min. The photocatalytic degradation of RBV-5R followed pseudo-first-order kinetics. The mineralization was calculated from total organic carbon (TOC) that was represented by 82% TOC removal in 30 min. The results revealed that visible-light-induced ZnFe2O4 photocatalysis may be a promising technology for the elimination of toxic organic dyes, such as RBV-5R, from water resources.


  • Open Access

    Dried Leaves Powder of Adiantum capillus-veneris as an Efficient Biosorbent for Hazardous Crystal Violet Dye from Water Resources

    by Salma Gul, Shehla Gul, Hajera Gul, Fatima Khitab, Rozina Khattak, Muhammad Sufaid Khan, Rizwan Ullah, Rooh Ullah, Zahida Wasil, Andrey E. Krauklis, et al.

    The dyeing industry uses many chemicals and dyes. After the dying process is completed, they release a significant amount of dyes in wastewater. The dyes’ color emissions are extremely poisonous and dangerous for aquatic and terrestrial life. Due to the toxic nature of dyes, the current study was carried out to evaluate whether it would be effective to employ an adsorption procedure with leaves from the Adiantum capillus-veneris plant as an adsorbent to remove commonly used textile dyes from an aqueous dye solution and wastewater. The effect of pH, concentration, time and the adsorbent dose on the adsorption process was studied in order to determine the maximum adsorption under ideal conditions. The selected pH was 3; the optimum concentration was 30 ppm with a contact time of 90 min and the optimized adsorbent dose was 60 mg. The absorbent under study showed excellent results when compared with commercial adsorbents i.e., animal charcoal and silica gel. The leaves of the Adiantum capillus-veneris plant revealed a maximum removal of 90.36 percent crystal violet dye (adsorption capacity (Qe) 9.05 mg/g) without any treatment to activate or alter the surface chemistry of the biosorbent. Its effectiveness was also tested with water gathered from several sources, including canal water, tap water, distilled water, and saline water, to determine whether it was practical. In both the canal and the tap water, the adsorbent displayed good removal efficiency. From the results of the current study, it can be inferred that the leaves of the Adiantum capillus-veneris plant are a reasonably priced biosorbent that can be used to remove toxic dyes from wastewater to protect water bodies from toxic pollution and can be used to treat industrial wastewater directly.