Hien Thi Doan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Hien Thi Doan has a total of 34 co-authors. Here are the top co-authors by number of shared publications:
- Han-Wen Liu
Department of Physics, National Central University, Taoyuan City 320317, Taiwan
4 shared publications - Hsin Chang
Department of Physics, National Central University, Taoyuan City 320317, Taiwan
4 shared publications - Yuan-Hann Chang
Institute of Physics, Academia Sinica, Taipei City 115201, Taiwan
4 shared publications - Yung-Fu Chen
National Central University
4 shared publications - Chien-Han Chen
Institute of Physics, Academia Sinica, Taipei City 115201, Taiwan
3 shared publications - Ching-Fang Chen
Department of Physics, National Central University, Taoyuan City 320317, Taiwan
3 shared publications
Latest Publications
- Open Access
- 30 March 2026
- Published by American Physical Society (APS) in Physical Review D
- Vol. 113 (5)
Dark photon dark matter constraints at the Taiwan Axion Search Experiment with Haloscope
The dark photon is a well motivated candidate for the dark matter that comprises most of the mass of our visible Universe, leading to worldwide experimental and observational efforts toward its discovery. A primary tool in this search is the cavity haloscope, which facilitates resonantly enhanced conversion to photons from both dark photons and axions. In this context, limits from axion search experiments are often directly converted into dark photon constraints, without re-analyzing the original data. However, this rescaling may not fully capture all of the relevant physics due to various reasons. By reexamining data taken by the Taiwan Axion Search Experiment with Haloscope experiment, we derive a world-leading constraint on the dark photon parameter space, excluding | ε | ≳ 2 × 10 − 14 in the 19.46 – 19.84 μ eV mass range, which exceeds the naïve “rescaling limit” by roughly a factor of two. We emphasize that accounting for the scanning timing information is crucial for deriving limits for the polarized dark photon case. In the data, we also analyze a tentative signal excess with a local significance of 4.7 σ ( m X ≃ 19.5 μ eV ) that persists in the absence of a magnetic field. While this excess mimics the behavior of a dark photon signal, it has been excluded by recent results from the HAYSTAC and ORGAN-Q experiments. This case study, nevertheless, highlights the risk of discarding valid dark photon signals when relying on axion-specific magnetic field vetoes.
- 30 March 2026
- Published by American Physical Society (APS) in Physical Review D
- Vol. 113 (5)
Open AccessDark photon dark matter constraints at the Taiwan Axion Search Experiment with Haloscope
The dark photon is a well motivated candidate for the dark matter that comprises most of the mass of our visible Universe, leading to worldwide experimental and observational efforts toward its discovery. A primary tool in this search is the cavity haloscope, which facilitates resonantly enhanced conversion to photons from both dark photons and axions. In this context, limits from axion search experiments are often directly converted into dark photon constraints, without re-analyzing the original data. However, this rescaling may not fully capture all of the relevant physics due to various reasons. By reexamining data taken by the Taiwan Axion Search Experiment with Haloscope experiment, we derive a world-leading constraint on the dark photon parameter space, excluding | ε | ≳ 2 × 10 − 14 in the 19.46 – 19.84 μ eV mass range, which exceeds the naïve “rescaling limit” by roughly a factor of two. We emphasize that accounting for the scanning timing information is crucial for deriving limits for the polarized dark photon case. In the data, we also analyze a tentative signal excess with a local significance of 4.7 σ ( m X ≃ 19.5 μ eV ) that persists in the absence of a magnetic field. While this excess mimics the behavior of a dark photon signal, it has been excluded by recent results from the HAYSTAC and ORGAN-Q experiments. This case study, nevertheless, highlights the risk of discarding valid dark photon signals when relying on axion-specific magnetic field vetoes.
- 1 January 2025
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 96 (1)
Direct calibration of microwave amplification chain on an axion cavity haloscope
In an axion haloscope, the weak photon signal, theoretically converted from axions, is captured by a detection cavity. The signal from the cavity is too weak to be acquired by a signal receiver. The amplification chain assists the signal acquisition by amplifying the signal and requires accurate gain calibration. Typically, the readout line is calibrated using the Y-factor method, involving a switch that directs either the detection line or the calibration line to the amplification chain. The detection and calibration lines may have different transmissions, which leads to the calibration results being less accurate. In response, we propose a calibration method that eliminates the need for a switch. In this approach, the cavity temperature is decoupled from its incoming noise source and can be controlled, resulting in excess or deficiency of the noise spectrum near its resonance frequency. The experimental result shows that the gain of the amplification chain can be calibrated directly using the temperature-varied cavity radiation.
- 1 January 2025
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 96 (1)
Direct calibration of microwave amplification chain on an axion cavity haloscope
In an axion haloscope, the weak photon signal, theoretically converted from axions, is captured by a detection cavity. The signal from the cavity is too weak to be acquired by a signal receiver. The amplification chain assists the signal acquisition by amplifying the signal and requires accurate gain calibration. Typically, the readout line is calibrated using the Y-factor method, involving a switch that directs either the detection line or the calibration line to the amplification chain. The detection and calibration lines may have different transmissions, which leads to the calibration results being less accurate. In response, we propose a calibration method that eliminates the need for a switch. In this approach, the cavity temperature is decoupled from its incoming noise source and can be controlled, resulting in excess or deficiency of the noise spectrum near its resonance frequency. The experimental result shows that the gain of the amplification chain can be calibrated directly using the temperature-varied cavity radiation.
- Open Access
- 6 September 2022
- Published by American Physical Society (APS) in Physical Review D
- Vol. 106 (5) , 052002
Taiwan Axion Search Experiment with Haloscope: CD102 analysis details
This paper presents the analysis of the data acquired during the first physics run of the Taiwan Axion Search Experiment with Haloscope (TASEH), a search for axions using a microwave cavity at frequencies between 4.70750 and 4.79815 GHz. The data were collected from October 13, 2021 to November 15, 2021, and are referred to as the CD102 data. The analysis of the TASEH CD102 data excludes models with the axion-two-photon coupling , a factor of 11 above the benchmark Kim-Shifman-Vainshtein-Zakharov model for the mass range .- 6 September 2022
- Published by American Physical Society (APS) in Physical Review D
- Vol. 106 (5) , 052002
Open AccessTaiwan Axion Search Experiment with Haloscope: CD102 analysis details
This paper presents the analysis of the data acquired during the first physics run of the Taiwan Axion Search Experiment with Haloscope (TASEH), a search for axions using a microwave cavity at frequencies between 4.70750 and 4.79815 GHz. The data were collected from October 13, 2021 to November 15, 2021, and are referred to as the CD102 data. The analysis of the TASEH CD102 data excludes models with the axion-two-photon coupling , a factor of 11 above the benchmark Kim-Shifman-Vainshtein-Zakharov model for the mass range . - Open Access
- 6 September 2022
- Published by American Physical Society (APS) in Physical Review Letters
- Vol. 129 (11) , 111802
First Results from the Taiwan Axion Search Experiment with a Haloscope atThis Letter reports on the first results from the Taiwan Axion Search Experiment with a Haloscope, a search for axions using a microwave cavity at frequencies between 4.707 50 and 4.798 15 GHz. Apart from the nonaxion signals, no candidates with a significance of more than 3.355 were found. The experiment excludes models with the axion-two-photon coupling , a factor of eleven above the benchmark Kim-Shifman-Vainshtein-Zakharov model, in the mass range . It is also the first time that a haloscope experiment places constraints on in the mass region of , reaching a sensitivity 3 orders of magnitude better than the limits obtained by nonhaloscope experiments.- 6 September 2022
- Published by American Physical Society (APS) in Physical Review Letters
- Vol. 129 (11) , 111802
Open AccessFirst Results from the Taiwan Axion Search Experiment with a Haloscope atThis Letter reports on the first results from the Taiwan Axion Search Experiment with a Haloscope, a search for axions using a microwave cavity at frequencies between 4.707 50 and 4.798 15 GHz. Apart from the nonaxion signals, no candidates with a significance of more than 3.355 were found. The experiment excludes models with the axion-two-photon coupling , a factor of eleven above the benchmark Kim-Shifman-Vainshtein-Zakharov model, in the mass range . It is also the first time that a haloscope experiment places constraints on in the mass region of , reaching a sensitivity 3 orders of magnitude better than the limits obtained by nonhaloscope experiments. - 1 August 2022
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 93 (8) , 084501
Taiwan axion search experiment with haloscope: Designs and operations
We report on a holoscope axion search experiment near 19.6 µeV from the Taiwan Axion Search Experiment with Haloscope collaboration. This experiment is carried out via a frequency-tunable cavity detector with a volume V = 0.234 liter in a magnetic field B0 = 8 T. With a signal receiver that has a system noise temperature Tsys ≅ 2.2 K and an experiment time of about one month, the search excludes values of the axion–photon coupling constant gaγγ ≳ 8.1 × 10−14 GeV−1, a factor of 11 above the Kim–Shifman–Vainshtein–Zakharov benchmark model, at the 95% confidence level in the mass range of 19.4687–19.8436 µeV. We present the experimental setup and procedures to accomplish this search.
- 1 August 2022
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 93 (8) , 084501
Taiwan axion search experiment with haloscope: Designs and operations
We report on a holoscope axion search experiment near 19.6 µeV from the Taiwan Axion Search Experiment with Haloscope collaboration. This experiment is carried out via a frequency-tunable cavity detector with a volume V = 0.234 liter in a magnetic field B0 = 8 T. With a signal receiver that has a system noise temperature Tsys ≅ 2.2 K and an experiment time of about one month, the search excludes values of the axion–photon coupling constant gaγγ ≳ 8.1 × 10−14 GeV−1, a factor of 11 above the Kim–Shifman–Vainshtein–Zakharov benchmark model, at the 95% confidence level in the mass range of 19.4687–19.8436 µeV. We present the experimental setup and procedures to accomplish this search.
- Open Access
- 14 January 2022
- Published by MDPI AG in Applied Sciences
- Vol. 12 (2) , 825
Deep Learning-Based Water Crystal Classification
Much of the earth’s surface is covered by water. As was pointed out in the 2020 edition of the World Water Development Report, climate change challenges the sustainability of global water resources, so it is important to monitor the quality of water to preserve sustainable water resources. Quality of water can be related to the structure of water crystal, the solid-state of water, so methods to understand water crystals can help to improve water quality. As a first step, a water crystal exploratory analysis has been initiated with the cooperation with the Emoto Peace Project (EPP). The 5K EPP dataset has been created as the first world-wide small dataset of water crystals. Our research focused on reducing the inherent limitations when fitting machine learning models to the 5K EPP dataset. One major result is the classification of water crystals and how to split our small dataset into several related groups. Using the 5K EPP dataset of human observations and past research on snow crystal classification, we created a simple set of visual labels to identify water crystal shapes, in 13 categories. A deep learning-based method has been used to automatically do the classification task with a subset of the label dataset. The classification achieved high accuracy when using a fine-tuning technique.
- 14 January 2022
- Published by MDPI AG in Applied Sciences
- Vol. 12 (2) , 825
Open AccessDeep Learning-Based Water Crystal Classification
Much of the earth’s surface is covered by water. As was pointed out in the 2020 edition of the World Water Development Report, climate change challenges the sustainability of global water resources, so it is important to monitor the quality of water to preserve sustainable water resources. Quality of water can be related to the structure of water crystal, the solid-state of water, so methods to understand water crystals can help to improve water quality. As a first step, a water crystal exploratory analysis has been initiated with the cooperation with the Emoto Peace Project (EPP). The 5K EPP dataset has been created as the first world-wide small dataset of water crystals. Our research focused on reducing the inherent limitations when fitting machine learning models to the 5K EPP dataset. One major result is the classification of water crystals and how to split our small dataset into several related groups. Using the 5K EPP dataset of human observations and past research on snow crystal classification, we created a simple set of visual labels to identify water crystal shapes, in 13 categories. A deep learning-based method has been used to automatically do the classification task with a subset of the label dataset. The classification achieved high accuracy when using a fine-tuning technique.