THTakeshi Hasegawa

Takeshi Hasegawa

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Takeshi Hasegawa has a total of 320 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Analysis of transition dipole moments of band-progression peaks of fluorocarbons: Fundamentals and application to orientation analysis of fluoropolymers

    by Taisuke Araki, Nobutaka Shioya, Shun Konno, Tomoya Oonuki, Takeshi Hasegawa

    Perfluoroalkyl chains give infrared spectra involving a dominant absorption peak corresponding to the CF2 symmetric stretching vibration mode. The direction of the transition dipole moment of this mode is approximately perpendicular to the chain axis, that is, the vibrational motion belongs to the E1 symmetry species. Accordingly, the band progressions of this mode have also been considered to have the same property. In the present study, we have investigated the properties of the band progressions in detail using the p-polarized multiple-angle incidence resolution spectrometry on an oriented n-C20F42 monolayer. We found that the surface selection rule of band progressions is the same as that of the CF3 symmetric stretching vibrational mode with the aid of quantum chemical calculations. This indicates that the transition dipole moment of the band progressions does not correspond to the E1 mode but is instead oriented predominantly parallel to the chain axis. We also show that this distinction is important for determining the orientation of perfluoroalkyl chains.

  • Open Access

    Solvent‐Desorption‐Induced Formation of a Long‐Period Polymorph Yielding a High‐Performance Porphyrin‐Based Organic Semiconductor

    by Kazuya Miyazaki, Keitaro Yamamoto, Mitsuaki Yamauchi, Yoshiyuki Mizuhata, Hiroshi Matsuda, Nobutaka Shioya, Takeshi Hasegawa, Hiroko Yamada

    Polymorphism is common in organic semiconductors, yet experimentally accessible crystal structures are often limited to thermodynamically favored phases formed under equilibrium crystallization conditions. Here, we report a structural transformation in single crystals of 5,15‐bisphenyl‐tetrabenzoporphyrin ( Ph‐BP ) triggered by the removal of intercalated o ‐dichlorobenzene. This transformation induces a 90° rotation of the π‐stacking direction between adjacent layers, giving rise to a previously unobserved long‐period polymorph characterized by the periodic alternation of two distinct herringbone packing motifs. The solvent‐desorption‐induced transformed phase can also be formed on Si/SiO 2 substrates and affords single‐crystal organic field‐effect transistors exhibiting hole mobilities higher than those of devices based on the previously reported Ph‐BP polymorph. These findings suggest that solvent‐desorption‐induced structural transformations provide a viable strategy for accessing hidden polymorphs with enhanced semiconductor performance.

  • Open Access

    Understanding the Structure–Performance Relationship for Organic Thin-Film Transistors Using Liquid-Crystalline Organic Semiconductors

    by Takayuki Oka, Nobutaka Shioya, Hiroki Nakano, Hiroaki Iino, Takeshi Hasegawa

    Liquid-crystalline organic semiconductors are rapidly gaining attention as next-generation materials for organic field-effect transistors (OFETs) due to their high charge mobility and thermal durability. However, thermal treatment at temperatures exceeding the transition point of the liquid-crystalline phase degrades device performance, and the relationship between structure and performance remains unclear. In the present study, we investigate 2-decyl-7-phenyl-[1]benzothieno[3,2-b][1]benzothiophene, which exhibits outstanding charge-carrier transport properties among liquid-crystalline organic semiconductors. The aggregation structure in thin films is analyzed by combining X-ray diffraction, infrared spectroscopy, and atomic force microscopy, depending on the heating conditions. Meanwhile, the OFET mobility is measured in comparison with this structure. A comparative analysis identifies crystallographic and conformational disorders responsible for the degradation in OFET performance. This is due to the fact that, even after cooling to room temperature, flipped molecules resulting from the liquid-crystalline phase transition partially remain in the polycrystalline film. In other words, the OFET mobility of liquid-crystalline organic semiconductors is governed by the film crystallinity, for which the conformational ordering of the alkyl side chains is a prerequisite but not a sufficient condition. The results demonstrate a clear structure–performance relationship in liquid-crystalline organic semiconductors, thus facilitating the fabrication of high-mobility OFET devices.

  • A Three-Phase Distribution Method for Quantifying the Intermolecular Interactions

    by Shun Konno, Taisuke Araki, Tomoya Oonuki, Takeshi Hasegawa

    The octanol/water partition coefficient, log P, is a standard descriptor of hydrophobicity; however, it compresses the hydrogen bonding, dispersion, and orientation forces onto a single axis and fails for per- and polyfluoroalkyl substances (PFAS), where the orientation forces dominate and a stable octanol/water equilibrium rarely forms─hence, PFAS have long been mischaracterized as “extremely hydrophobic” through log P values. Here, we propose the three-phase distribution method as a new experimental tool that extends log P by partitioning a neutral solute among water, cyclohexane, and perfluorononane─three mutually immiscible phases, each selectively dominated by one of those interactions─hence, each solute is mapped onto a ternary diagram by the percentage shares of three forces. The present paper is a theoretical proposal of this new experimental method, with first-principles COSMO-RS calculations as a consistency check. The results confirm that the method subsumes log P, extends the analysis to PFAS that lie outside the scope of conventional log P, and resolves compounds that are indistinguishable on the log P axis by decomposing their intermolecular-force contributions─capabilities that establish the three-phase distribution method as a general-purpose analytical tool applicable across diverse fields of physical chemistry.


  • Surface Morphology Analysis of Thin Films of Perfluoroalkanes Using Atomic Force Microscopy–Infrared (AFMIR) with Respect to Surface Phonon–Polariton Modes

    by Takayuki Oka, Nobutaka Shioya, Takeshi Hasegawa

    Although atomic force microscopy–infrared (AFM–IR) spectroscopy enables nanoscale infrared characterization, the dielectric origin of its spectral contrast, particularly the role of collective vibrational modes, remains incompletely understood. Here, we investigate the correlation between nanoscale infrared spectra and surface morphology using thin films of perfluorotetracosane (C 2 4 F 5 0 ). By comparing low-temperature vapor-deposited films and their aged counterparts, we track aging-induced morphological evolution from lying-oriented sub-micrometer aggregates to standing-oriented crystalline grains. For discussing fine features in the nano-scale spectrum, infrared p-polarized multiple-angle incidence resolution spectroscopy (pMAIRS) is also employed as a macroscopic reference in advance. The pMAIRS analysis reveals pronounced longitudinal–transverse optical (LO–TO) splitting, which increases upon aging due to an enhanced Berreman-type longitudinal field contribution associated with surface flattening and improved crystallinity. Nanoscale AFM–IR measurements in a resonance-enhanced-mode with top-down illumination configuration demonstrate that the local spectral response is predominantly governed by the transverse optical (TO) dielectric function, while surface phonon–polariton (SPP) modes are strongly enhanced, reflecting localized electromagnetic field confinement at crystalline grains. Through rigorous cross-scale comparisons of macroscopic and nanoscale spectroscopy, this study has experimentally established the dominant TO-controlled contrast mechanism in top-down AFM–IR and revealed the characteristics of SPP-driven nanoscale spectra. These results demonstrate that AFM–IR is a powerful probe for investigating both the chemical identity of surface-active organic materials and nanoscale surface morphology.

  • Optimized Infrared Reflection–Absorption Spectroscopy Using Indium Tin Oxide as Thin-Film Supporting Substrates

    by Hiroshi Matsuda, Nobutaka Shioya, Minh Anh Truong, Atsushi Wakamiya, Takeshi Hasegawa

    Optimal experimental conditions of indium tin oxide (ITO) as a thin-film supporting substrate for spectroscopically reliable infrared reflection–absorption (IR-RA) measurements are studied experimentally by the use of ITO substrates having a wide range of thickness from 50 to 500 nm. When the thickness is 300 nm or more, the reflectivity of ITO is close to that of a metallic substrate, but this is not solely due to the dielectric properties of ITO. This is an apparent reflectivity partly due to the RA-specific large angle-of-incidence. In fact, the observed RA spectra are quantitatively out of expectations significantly at 2000 cm –1 or higher, which means that the surface selection rules (SSRs) of RA spectrometry in the high wavenumber region are lost. With the optimized experimental conditions, an ITO substrate is employed for an actual application study of hole-collecting layer deposited on ITO. The IR-RA spectrum is beautifully obtained as if it were on a metallic substrate, and the SSR is also recognized properly.

  • Top Cited Papers

    Homogenized Optoelectronic Properties in Perovskites: Achieving High-Efficiency Solar Cells with Common Chloride Additives

    by Junke Wang, Shuaifeng Hu, Xinyu Gu, Minh Anh Truong, Yi Yang, Cheng Liu, Gunnar Kusch, Zhongcheng Yuan, Manuel Kober-Czerny, Zuhong Zhang, et al.

    Improving the bulk quality of perovskite films is critical for achieving higher-performance photovoltaic devices. Chloride-containing additives, including lead chloride (PbCl2) and methylammonium chloride (MACl)─standard additives widely adopted in perovskite photovoltaics─are effective for controlling crystallization kinetics and grain morphology. However, the distinct impacts of different forms of chloride additives on nanoscale phase uniformity and luminescence homogeneity remain underexplored. Here, we provide new insights into how the choice and combination of chloride additives influence phase transitions and spatially uniform carrier dynamics within perovskite films. We demonstrate that strategically combining MACl and PbCl2 improves crystallinity and optoelectronic uniformity across dimensions spanning micrometers to millimeters. Leveraging these findings, we fabricated inverted (p-i-n) perovskite solar cells achieving certified quasi-steady-state efficiencies of 26.4% and 24.5% at device areas of 0.05 and 1 cm2, respectively. Furthermore, these devices exhibit robust operational stability, retaining 88% of their initial performance after 1200 h of continuous maximum power point tracking at elevated temperatures (65 °C) under simulated AM1.5G illumination. Our results elucidate the mechanistic differences between chloride additive forms, providing a viable strategy for advancing large-area, high-efficiency, and thermally stable perovskite photovoltaics.


  • Open Access

    From Monolayer to Bulk: Thin-Film-Specific Polymorphic Transitions of a Molecular Semiconductor

    by Nobutaka Shioya, Fabian Gasser, Nina Strasser, Egbert Zojer, Roland Resel, Josef Simbrunner, Takeshi Hasegawa

    Organic compounds have the potential to form distinct crystal structures on a substrate surface. These are typically referred to as thin-film and monolayer phases. The properties of these phases are often key for developing high-performance devices. Nevertheless, many thin-film-specific phases remain unidentified, and the known bulk phase is instead used as a structural model to discuss structure–property relationships also in thin films. For example, the polymorphism of dinaphtho­[2,3-b:2’,3′-f]­thieno­[3,2-b]­thiophene (DNTT) has long been overlooked, even though this compound is widely used as a benchmark material for organic thin-film transistors. For a comprehensive understanding of polymorphic transitions in organic semiconductors, the present study investigates the thickness-dependent structural changes in DNTT vapor-deposited films using high-resolution infrared Brewster-angle transmission spectroscopy, grazing incidence X-ray diffraction, and density functional theory calculations. This multimodal approach identifies three different crystal structures depending on the film thickness: the monolayer phase, the thin-film phase, and the bulk phase. Furthermore, the structure solutions of the monolayer phase and candidate structures of the thin-film phase are obtained. This study not only provides an overall model for the thin-film growth of organic semiconductors but also discusses a powerful combination of analytical and modeling techniques for identifying unknown thin-film phases of organic materials.


  • Fabrication of tetrabenzoporphyrin thin-film transistors with hydrogen-bonding networks via a thermal precursor approach and effect of the amide-group position

    by So Ueno, Mitsuaki Yamauchi, Hiroshi Matsuda, Nobutaka Shioya, Keitaro Yamamoto, Yoshiyuki Mizuhata, Takeshi Hasegawa, Hiroko Yamada

    New hydrogen-bonded tetrabenzoporphyrin thin films were fabricated by a thermal precursor approach and exhibited p-type organic field-effect transistor properties.


  • In Situ Study of Liquid Crystal Phase Mediated Crystal Growth in Vacuum-Deposited Thin Films of an Alkyl Perylene Diimide

    by Yusuke Takagawa, Riku Miura, Miki Shimizu, Ren Abe, Shuhei Tanaka, Shingo Maruyama, Tetsuhiko Miyadera, Tomoyuki Koganezawa, Nobutaka Shioya, Takafumi Shimoaka, et al.