Xiaolin Liu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Xiaolin Liu has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Dejian Li
State Key Laboratory for GeoMechanics and Deep Underground Engineering, China University of Mining and Technology, Beijing, China
6 shared publications Chao Han
State Key Laboratory for Geomechanics and Deep Underground Engineering, China University of Mining and Technology (Beijing), Beijing, China
5 shared publicationsYiming Shao
State Key Laboratory for Geomechanics and Deep Underground Engineering, China University of Mining and Technology (Beijing), Beijing, China
4 shared publicationsChunxiao Li
State Key Laboratory for GeoMechanics and Deep Underground Engineering, China University of Mining and Technology, Beijing, China
3 shared publicationsDejian Li
State Key Laboratory for Geomechanics and Deep Underground Engineering, China University of Mining and Technology (Beijing), Beijing, China
3 shared publicationsJin Zhang
State Key Laboratory for Geomechanics and Deep Underground Engineering, China University of Mining and Technology (Beijing), Beijing, China
2 shared publications
Latest Publications
- 3 August 2023
- Published by Springer Nature in Bulletin of Engineering Geology and the Environment
- Vol. 82 (9) , 1-17
Experimental study on the influence of intermediate principal stress on failure characteristics of strain rock burst for granite
- 3 August 2023
- Published by Springer Nature in Bulletin of Engineering Geology and the Environment
- Vol. 82 (9) , 1-17
Experimental study on the influence of intermediate principal stress on failure characteristics of strain rock burst for granite
- 21 July 2023
- Published by Springer Nature in Mechanics of Time-Dependent Materials
- Vol. 28 (4) , 2309-2331
Characterization and modeling of the compressive behavior of a granite experiencing thermal damage
- 21 July 2023
- Published by Springer Nature in Mechanics of Time-Dependent Materials
- Vol. 28 (4) , 2309-2331
Characterization and modeling of the compressive behavior of a granite experiencing thermal damage
- 27 May 2022
- Published by Springer Nature in Arabian Journal of Geosciences
- Vol. 15 (11) , 1-9
A novel variable-order fractional damage creep model for sandstone
- 27 May 2022
- Published by Springer Nature in Arabian Journal of Geosciences
- Vol. 15 (11) , 1-9
A novel variable-order fractional damage creep model for sandstone
- 19 January 2022
- Published by Springer Nature in Arabian Journal of Geosciences
- Vol. 15 (2) , 1-10
Error calibration for kinetic energy of rock burst ejected fragments based on the binocular high-speed photography system
- 19 January 2022
- Published by Springer Nature in Arabian Journal of Geosciences
- Vol. 15 (2) , 1-10
Error calibration for kinetic energy of rock burst ejected fragments based on the binocular high-speed photography system
- 7 January 2022
- Published by Springer Nature in Arabian Journal of Geosciences
- Vol. 15 (1) , 1-15
Investigation on failure characteristic and instability mechanism of red sandstone including serrated joints under variable angle shear
- 7 January 2022
- Published by Springer Nature in Arabian Journal of Geosciences
- Vol. 15 (1) , 1-15
Investigation on failure characteristic and instability mechanism of red sandstone including serrated joints under variable angle shear
- 14 October 2021
- Published by Springer Nature in Mechanics of Time-Dependent Materials
- Vol. 26 (4) , 909-922
A Caputo fractional damage creep model and its experimental validation
- 14 October 2021
- Published by Springer Nature in Mechanics of Time-Dependent Materials
- Vol. 26 (4) , 909-922
A Caputo fractional damage creep model and its experimental validation
- Open Access
- 1 September 2021
- Published by AIP Publishing in AIP Advances
- Vol. 11 (9) , 095317
Investigation of mechanical and energy evolution characteristics for sandstone after high temperature damage under cyclic loading
During the production of underground engineering, investigating the mechanical behaviors of rock materials after high temperature damage is of great importance for controlling the stability of the underground structure. In this paper, for revealing the deformation and energy evolution laws of rock materials after high temperature damage under cyclic loading, a series of uniaxial compressive and cyclic loading experiments were conducted on sandstone after various high temperature damages, i.e., 200, 300, 400, 500, 600, 700, 800, and 900°C, to study the effect of high temperature on primary wave velocity, microstructure, deformation, strength, energy, etc. It can be observed that the primary wave velocity and microstructure weakened seriously with the development of high temperature damage and the uniaxial compressive strength of samples increases toward the maximum value with a high temperature damage of 300°C and then decreases gradually. The energy proportion index was established to characterize the influence of high temperature damage and cyclic stress levels on energy evolution laws of samples. With an increase in temperature, compared with input energy, elastic strain energy proportion decreases and dissipated energy proportion rises up, which indicate that the property of samples transforms from elasticity to plasticity. Finally, the variation laws between the burst tendency of the sample and high temperature damage were well described by presenting the average elastic energy index, which provides references for studying failure characteristics of rock materials.
- 1 September 2021
- Published by AIP Publishing in AIP Advances
- Vol. 11 (9) , 095317
Open AccessInvestigation of mechanical and energy evolution characteristics for sandstone after high temperature damage under cyclic loading
During the production of underground engineering, investigating the mechanical behaviors of rock materials after high temperature damage is of great importance for controlling the stability of the underground structure. In this paper, for revealing the deformation and energy evolution laws of rock materials after high temperature damage under cyclic loading, a series of uniaxial compressive and cyclic loading experiments were conducted on sandstone after various high temperature damages, i.e., 200, 300, 400, 500, 600, 700, 800, and 900°C, to study the effect of high temperature on primary wave velocity, microstructure, deformation, strength, energy, etc. It can be observed that the primary wave velocity and microstructure weakened seriously with the development of high temperature damage and the uniaxial compressive strength of samples increases toward the maximum value with a high temperature damage of 300°C and then decreases gradually. The energy proportion index was established to characterize the influence of high temperature damage and cyclic stress levels on energy evolution laws of samples. With an increase in temperature, compared with input energy, elastic strain energy proportion decreases and dissipated energy proportion rises up, which indicate that the property of samples transforms from elasticity to plasticity. Finally, the variation laws between the burst tendency of the sample and high temperature damage were well described by presenting the average elastic energy index, which provides references for studying failure characteristics of rock materials.
- 22 April 2021
- Published by Springer Nature in Mechanics of Time-Dependent Materials
- Vol. 26 (2) , 485-498
Constitutive modeling of rock materials based on variable-order fractional theory
- 22 April 2021
- Published by Springer Nature in Mechanics of Time-Dependent Materials
- Vol. 26 (2) , 485-498
Constitutive modeling of rock materials based on variable-order fractional theory
- Open Access
- 11 March 2021
- Published by Springer Nature in Research Square
Experimental and theoretical study of compressive mechanical behavior of red sandstone after heating-cooling treatment
In order to investigate compressive mechanical behaviors of rock materials after different heating-cooling treatments, in this paper, a series of uniaxial compressive experiments are carried out on red sandstone samples after various heating temperature (from 25℃ to 1000℃) and water cooling treatments (10℃) to obtain evolution laws of mechanical property. The evolution laws of peak strength, elastic modulus, primary wave velocity and micro-structure are analyzed in details. And for better reflecting compressive stress-strain behaviors of red sandstone after heating-cooling treatments, based on Caputo variable-order fractional calculus, considering strain correlation and constant strain loading rate, we propose a novel variable-order fractional constitutive model to describe stress-strain behaviors of red sandstone samples after heating-cooling treatments. The validation of proposed model is well verified and a comparative study between proposed variable-order fractional constitutive model and constant-order fractional constitutive model is performed to highlight the advantage of proposed model. The evolutions of mechanical characteristics are revealed by presented varying-order function related to strain and the influence of fitting parameters on stress-strain behaviors are also discussed for deeply comprehending compressive mechanical mechanism of red sandstone after heating-cooling treatments.
- 11 March 2021
- Published by Springer Nature in Research Square
Open AccessExperimental and theoretical study of compressive mechanical behavior of red sandstone after heating-cooling treatment
In order to investigate compressive mechanical behaviors of rock materials after different heating-cooling treatments, in this paper, a series of uniaxial compressive experiments are carried out on red sandstone samples after various heating temperature (from 25℃ to 1000℃) and water cooling treatments (10℃) to obtain evolution laws of mechanical property. The evolution laws of peak strength, elastic modulus, primary wave velocity and micro-structure are analyzed in details. And for better reflecting compressive stress-strain behaviors of red sandstone after heating-cooling treatments, based on Caputo variable-order fractional calculus, considering strain correlation and constant strain loading rate, we propose a novel variable-order fractional constitutive model to describe stress-strain behaviors of red sandstone samples after heating-cooling treatments. The validation of proposed model is well verified and a comparative study between proposed variable-order fractional constitutive model and constant-order fractional constitutive model is performed to highlight the advantage of proposed model. The evolutions of mechanical characteristics are revealed by presented varying-order function related to strain and the influence of fitting parameters on stress-strain behaviors are also discussed for deeply comprehending compressive mechanical mechanism of red sandstone after heating-cooling treatments.