RKRyo Koma

Ryo Koma

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Ryo Koma has a total of 11 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Fast QoT Estimation Based on Probability Density Calculation of Electric Field Waveform

    by Ryo Igarashi, Ryo Koma, Kazutaka Hara, Jun-Ichi Kani, Tomoaki Yoshida, Tatsuya Shimada

    For dynamic optical path provisioning in optical networks, real-time path design based on fast quality-of-transmission (QoT) estimation is highly desirable. We propose an electric field feature propagation based QoT estimation technique using a new feature extraction method. The proposed feature extraction method can reduce the calculation load by a factor of 10000 compared with the conventional approach, enabling comprehensive datasets for various networks to be created in realistic time. This study confirms that the proposed QoT estimation method can accurately estimate the bit error rate (BER) for different combinations of input power, span length, and received optical power.

  • Fiber Parameter-Independent Zero-Dispersion Wavelength Estimation Method and Its Feasibility With Reduced Quantization Bits and Sampling Rates

    by Yasunari Tanaka, Kazutaka Hara, Ryo Koma, Jun-Ichi Kani, Tatsuya Shimada, Tomoaki Yoshida

    We propose a method for estimating the zero-dispersion wavelength (ZDW) of an optical fiber independently of fiber parameters and for tuning the emission wavelength for the ZDW to suppress waveform distortion in high-speed intensity modulation and direct detection (IM-DD) systems. By using two emission wavelengths and unique notch frequencies caused by chromatic dispersion (CD) calculated from the frequency spectra (FSs) of each received signal, the proposed method can estimate the ZDW independent of fiber parameters such as fiber length and dispersion slope. The ZDW can be estimated by using the emission wavelength on either the shorter-wavelength side or the longer-wavelength side of the ZDW. To evaluate the feasibility of the method, we estimate the ZDW of 60-km fiber using 50-Gbps pseudorandom binary sequence 211−1 PAM4 signals at 1300-nm and 1305-nm emission wavelengths. The obtained estimation accuracy of −0.78 nm is sufficiently good when using an 8-bit analogue-to-digital converter operating at a sampling rate of 200 GS/s. We also demonstrate that results similar to the estimated ZDW are obtained even when the number of quantization bits is reduced from 8 to 4 and the sampling rate is reduced from 200 to 50 GS/s. These results show that the functions of the proposed method can be implemented in optical transceivers. On the basis of this configuration, we also achieve penalty-free and equalizer-free transmission by using an emission wavelength tuned to the estimated ZDW. Furthermore, we discuss the challenges associated with implementing the method in practical applications. We show that the BtB FSs required for estimating the ZDW can be replaced with simulated data instead of experimental data, that the method can be applied even at the minimum receiver sensitivity, and that there is no CD penalty when the notch frequency does not appear below the baud rate. Finally, we modify the procedure of the method to be applicable when the notch frequency does not appear within the value of the baud rate. Since this method can suppress waveform distortion due to CD independently of baud rate, it is applicable to higher speed transmission systems with a larger capacity of 100 Gbps or more.


  • Burst-Mode Multi-Level-CPFSK Signal Detection Using DD-LMS Based Adaptive Equalizer for High-Speed TDM-PON Upstream

    by Ryo Koma, Kazutaka Hara, Jun-Ichi Kani, Tomoaki Yoshida

    This paper evaluates the link budget for burst-mode single wavelength 50-Gbps 4-level continuous phase frequency shift keying (CPFSK) signal reception in time domain multiplexing (TDM) based digital coherent optical access networks. The key advances of the burst-mode CPFSK transmitter and receiver are as follows; simple EA-DFB-SOA based transmitter that suppresses the intensity modulation component generated by direct modulation of the DFB-LD, a burst-mode DSP that reduces convergence time of the adaptive finite impulse response (FIR) filter-based equalizer by using the tap coefficient handover method with simple decision-directed least mean square (DD-LMS) algorithm. The results of burst-mode experiments show the proposal offers high link budget of 40.7 dB with 32.8 ns short preamble. In addition, we calculate and compare the BER characteristics for higher baud rate 4-level CPFSK signals (37.5 Gbaud, and 50 Gbaud) and higher level CPFSK signals (8- and 16- level CPFSK signals) detection as a feasibility study for beyond 50-Gbps optical access networks.


  • Open Access

    Novel Wide-Range Frequency Offset Estimation and Compensation for Burst-mode CPFSK Upstream Signaling in TDM-Based Digital Coherent PON

    by Takuya Kanai, Ryo Koma, Masamichi Fujiwara, Jun-Ichi Kani, Tomoaki Yoshida

    The burst-mode continuous phase frequency shift-keying (CPFSK) transmitter that combines a directly modulated laser diode, an electro absorption modulator and a semiconductor optical amplifier is attractive as a cost-effective transmitter for phase modulation formats for digital signal processing (DSP)-based coherent passive optical network (PON) upstream signaling. However, since highly accurate wavelength controllers for the transmitters in optical network units (ONUs) create excessive cost burdens, large carrier frequency offsets (CFOs) must be expected. Thus, a CFO compensation method with wide compensation range is required. This paper proposes a novel CFO estimation and compensation method for burst-mode CPFSK signals in upstream PON signaling. The proposed method is based on a simple blind algorithm and does not require any training symbols. We demonstrate wide CFO compensation range, from −12 to 14 GHz, with high receiver sensitivity, less than −42.5 dBm for 10 Gbit/s binary CPFSK signals. This range far exceeds that of the conventional CFO compensation method using a blind algorithm. Moreover, the proposed method can enhance the convergence of finite impulse response (FIR) filters. The feasibility of the proposed CFO compensation technique is successfully demonstrated for burst-mode CPFSK signals.


  • Novel Data-Aided Carrier Frequency Offset Compensation Methods Using Asymmetric-Shape Constellations for Burst-Mode Coherent Reception

    by Ryo Koma, Masamichi Fujiwara, Ryo Igarashi, Kazutaka Hara, Jun-Ichi Kani, Tomoaki Yoshida

    This paper introduces a novel data-aided carrier frequency offset (CFO) estimation and compensation method for m-array phase shift keying (m-PSK) signals in burst-mode digital coherent reception. Its key advances are as follows; the use of newly designed training symbols (TS) that exhibit asymmetric distributed constellations after differential decoding and a vector summation based feed-forward CFO estimation algorithm. These offer short response time and strong robustness to training symbols (TS) timing detection error with wide CFO estimation range of ±B/2, where B is signal baudrate. We evaluate the feasibility of the proposal by simulations of and experiments on 12.5-Gbaud SP-QPSK signals that target optical budget enhancement of 25-Gbps/λ-class PONs to realize long-reach and high splitting ratio optical access. The 100-km burst-mode transmission experiments confirm the proposal offers high sensitivity detection of better than −43 dBm with much wider CFO range of above ±10 GHz.


  • Fast Feed-Forward Optical and Electrical Gain Control to Extend the Dynamic Range of the Burst-Mode Digital Coherent Receiver for High-Speed TDM-PON Systems

    by Ryo Koma, Masamichi Fujiwara, Jun-Ichi Kani, Tomoaki Yoshida

    This paper introduces a new burst-mode coherent receiver configuration that drastically widens the receiver input dynamic range. Its key advance is a fast feed forward gain control scheme for both a semiconductor optical amplifier (SOA) used as a preamplifier and trans-impedance amplifiers (TIAs) set at the coherent receiver. The two-stage optical and electrical gain control greatly decreases the received burst signal's power variations and increases the receiver dynamic range which attenuates the quantization errors in analogue-to-digital conversion (ADC). To elucidate the receiver sensitivity characteristics, bit error rate (BER) calculations are conducted on 10 Gbit/s single polarization quadrature phase shift keying (SP-QPSK) signal coherent reception. The calculations focus on two significant parameters that greatly impact the quantization noise; ADC vertical resolution and received signal's state of polarization (SOP). The calculation results confirm that the proposed configuration achieves high sensitivity, better than −44 dBm, and wide dynamic range of 30 dB in the worst SOP condition, even when 5-bit ADC is used. Transmission experiments verify the calculated sensitivities and extremely high loss budget of 48.6 dB is achieved in 40-km single mode fiber (SMF) transmission. These results show that the proposal has the potential to realize 10 Gbit/s class long-reach and high splitting ratio PONs; the extremely wide dynamic range yields 40 km reach PON systems with 512- or 1024-way splits with no change in receiver configuration.


  • Open Access

    Network Design for Bus-Type Optical Access Using Distributed Raman Amplification With Asymmetric Power Splitter

    by Ryo Igarashi, Kazutaka Hara, Ryo Koma, Masamichi Fujiwara, Takuya Kanai, Jun-Ichi Kani, Tomoaki Yoshida

    This paper proposes loss budget improvement of the bus-type optical access network (NW) with cost-effective non-repeater configuration. To achieve drastic improvements, we propose two approaches; (i) application of a low noise distributed Raman amplification (DRA) technique to upstream signal transmission (ii) utilization of asymmetric power splitters at each drop point to enhance Raman gain and to suppress transmission loss of far branches. We optimize the asymmetric power splitter drop ratio to maximize the number of accommodated users. Then, we clarify the number of accommodated users and improvements based on DRA through calculations that examine the inter-drop distance and total branch number. Experiments evaluate the bit error rate performance of the proposal. We confirm that measured values correspond to the simulation results. Based on the simulation and the experiment, we clarify the optimal network configuration for the user distribution. It is found that bus-type NWs support more accommodated users with shorter total fiber length than star-type NWs for user range examined. The potential advantage of bus-type NWs is revealed.


  • Compact bi-directional EDFAs to support extended power budget class of TWDM-PON

    by Masamichi Fujiwara, Ryo Koma, Ken-Ichi Suzuki, Akihiro Otaka

    Proposed bi-directional EDFAs reuse, in an L-band EDF, the pump light power unused in a very short length C-band EDF. Device size is effectively reduced while meeting the E2 class power budget required for TWDM-PON OLT.