Ang Hu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Ang Hu has a total of 60 co-authors. Here are the top co-authors by number of shared publications:
- Dongsheng Liu
School of Integrated Circuits, Huazhong University of Science and Technology, Wuhan, China
12 shared publications Dongsheng Liu
6 shared publicationsZirui Jin
6 shared publications- Hao Li
School of Integrated Circuits, Huazhong University of Science and Technology, Wuhan, China
5 shared publications Chengcheng Zhang
Huazhong Univ Sci & Technol, Sch Integrated Circuits, Wuhan 430074, Peoples R China
4 shared publications- Jiahao Lu
School of Integrated Circuit, Huazhong University of Science and Technology, Wuhan, China
4 shared publications
Latest Publications
- 1 November 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 73 (11) , 1119-1123
A 20-Gb/s Digital CDR With Complementary Phase Interpolator Control for Low-Jitter Transfer
- 1 November 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 73 (11) , 1119-1123
A 20-Gb/s Digital CDR With Complementary Phase Interpolator Control for Low-Jitter Transfer
- 20 July 2026
- Published by Elsevier in Microelectronics Journal
- Vol. 176
A 2 × 5-Gb/s inductorless optical receiver with shared Ring-PLL clock generation and PI-based clock recovery
- 20 July 2026
- Published by Elsevier in Microelectronics Journal
- Vol. 176
A 2 × 5-Gb/s inductorless optical receiver with shared Ring-PLL clock generation and PI-based clock recovery
- 1 July 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 73 (7) , 4016-4022
A 4.19-M Pixels Colloidal Quantum Dot-Based SWIR Image Sensor With High-Linearity Multistep Single-Slope ADCs
- 1 July 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 73 (7) , 4016-4022
A 4.19-M Pixels Colloidal Quantum Dot-Based SWIR Image Sensor With High-Linearity Multistep Single-Slope ADCs
- 26 March 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 73 (5) , 518-522
A Phase Switching Fractional Output Divider With Split-DTC-Based Nonlinear Calibration
This brief presents a fractional output divider (FOD) utilizing phase-switching and split-DTC technique. The split-DTC based background calibration technique is used to mitigate the gain mismatch and nonlinearity of the DTC chain. By using the phase switching technique, the divider division step is reduced from 1 to 0.25. Moreover, the DTC dynamic range is decreased to 1/4 quadrature signal period, leading to the optimized noise performance and power consumption of the DTC chain. The prototype chip was designed and fabricated using 40nm CMOS process, occupying a core area of 0.055mm2 and consuming 5.4mW at a 1.2V supply. The fractional spur is reduced from -44.01dBc to -74.48dBc when the calibration technique turning on and the worst spur level across the fractional-N division range is -70dBc.
- 26 March 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 73 (5) , 518-522
A Phase Switching Fractional Output Divider With Split-DTC-Based Nonlinear Calibration
This brief presents a fractional output divider (FOD) utilizing phase-switching and split-DTC technique. The split-DTC based background calibration technique is used to mitigate the gain mismatch and nonlinearity of the DTC chain. By using the phase switching technique, the divider division step is reduced from 1 to 0.25. Moreover, the DTC dynamic range is decreased to 1/4 quadrature signal period, leading to the optimized noise performance and power consumption of the DTC chain. The prototype chip was designed and fabricated using 40nm CMOS process, occupying a core area of 0.055mm2 and consuming 5.4mW at a 1.2V supply. The fractional spur is reduced from -44.01dBc to -74.48dBc when the calibration technique turning on and the worst spur level across the fractional-N division range is -70dBc.
- 26 November 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 73 (5) , 3153-3165
A 240 × 180 Event-Based Vision Sensor ROIC With Global Threshold Voltage Calibration Technology
This paper presents a $240\times 180$ event-based vision sensor (EVS) readout integrated circuit (ROIC) that incorporates global threshold voltage calibration technology. Conventional EVS suffer from error events and intra-array mismatch. This paper delves into four types of error events and presents effective solutions for them. This paper proposes a global threshold voltage calibration (GTVC) technique to minimize the impact of mismatch in the pixel array. The pixel size measures $10\times 10~\mu $ m ${}^{\mathbf {2}}$ , using 40 nm CMOS technology. The analog pixel circuits work with supply voltages of 2.5 V and 1.1 V, while the power consumption of this chip is 12.16 mW. By using the global threshold voltage calibration technology, which incorporates eight reference pixels for determining the input voltage of event comparators, the error in the detection result is reduced to 2.84 mV. The maximum event rate reaches 360 Meps with a 40 MHz system clock, boasting a dynamic range of 97.3 dB. Further, the event power efficiency stands at 29.6 Ge/W.
- 26 November 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 73 (5) , 3153-3165
A 240 × 180 Event-Based Vision Sensor ROIC With Global Threshold Voltage Calibration Technology
This paper presents a $240\times 180$ event-based vision sensor (EVS) readout integrated circuit (ROIC) that incorporates global threshold voltage calibration technology. Conventional EVS suffer from error events and intra-array mismatch. This paper delves into four types of error events and presents effective solutions for them. This paper proposes a global threshold voltage calibration (GTVC) technique to minimize the impact of mismatch in the pixel array. The pixel size measures $10\times 10~\mu $ m ${}^{\mathbf {2}}$ , using 40 nm CMOS technology. The analog pixel circuits work with supply voltages of 2.5 V and 1.1 V, while the power consumption of this chip is 12.16 mW. By using the global threshold voltage calibration technology, which incorporates eight reference pixels for determining the input voltage of event comparators, the error in the detection result is reduced to 2.84 mV. The maximum event rate reaches 360 Meps with a 40 MHz system clock, boasting a dynamic range of 97.3 dB. Further, the event power efficiency stands at 29.6 Ge/W.
- 28 April 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Technology Letters
- Vol. 35 (7) , 1085-1088
A 11-pA/Hz 5-Gb/s Inductorless Optical Receiver for High-Density Parallel Interface Application
This letter presents a 5-Gb/s inductorless optical receiver (ORX) used for high-density parallel interface application. In order to reduce the active area of single channel and mitigate the magnetic coupling effect, the on-chip inductor is limit-used. By adopting a regulated cascode (RGC) transimpedance amplifier (TIA) and an on-chip low dropout (LDO) regulator, the high-frequency noise and off-chip noise are reduced. A limiting amplifier (LA) utilizing the second-order amplifier cells with active feedback is employed, which can perform peaking characteristics at high frequencies and increase the gain-bandwidth (GBW) product. Implemented in 0.18- $\mu $ m CMOS process, the ORX achieves a measured transimpedance gain of 74 dB $\Omega $ , a −3-dB bandwidth of 3.65 GHz, and an average input-referred current noise density of 11 pA/ $\sqrt {\mathrm {Hz}} $ . The total area occupied by the ORX is 2.686 mm2, with a power consumption of 112.9 mW.
- 28 April 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Technology Letters
- Vol. 35 (7) , 1085-1088
A 11-pA/Hz 5-Gb/s Inductorless Optical Receiver for High-Density Parallel Interface Application
This letter presents a 5-Gb/s inductorless optical receiver (ORX) used for high-density parallel interface application. In order to reduce the active area of single channel and mitigate the magnetic coupling effect, the on-chip inductor is limit-used. By adopting a regulated cascode (RGC) transimpedance amplifier (TIA) and an on-chip low dropout (LDO) regulator, the high-frequency noise and off-chip noise are reduced. A limiting amplifier (LA) utilizing the second-order amplifier cells with active feedback is employed, which can perform peaking characteristics at high frequencies and increase the gain-bandwidth (GBW) product. Implemented in 0.18- $\mu $ m CMOS process, the ORX achieves a measured transimpedance gain of 74 dB $\Omega $ , a −3-dB bandwidth of 3.65 GHz, and an average input-referred current noise density of 11 pA/ $\sqrt {\mathrm {Hz}} $ . The total area occupied by the ORX is 2.686 mm2, with a power consumption of 112.9 mW.
- 7 May 2024
- Published by Elsevier in Microelectronics Journal
- Vol. 149
A 206.4 dBc/Hz FoMT Class-F23 VCO using nonlinear-capacitance-transforming technique
- 7 May 2024
- Published by Elsevier in Microelectronics Journal
- Vol. 149
A 206.4 dBc/Hz FoMT Class-F23 VCO using nonlinear-capacitance-transforming technique
- 7 May 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 59 (9) , 2774-2787
A Low-Phase-Noise Wide-Tuning-Range Mode-Switching Oscillator Using Multi-Magnetic-Coupling and Active-Source-Degenerating Techniques
In this article, a mode-switching oscillator using multi-magnetic-coupling and active-source-degenerating techniques is proposed to achieve wide frequency tuning and low phase noise. The multi-magnetic coupled resonator can realize two switchable resonant frequencies and perform active source degeneration. Two main coils are developed to switch between the two resonant modes, thereby doubling the frequency tuning range (TR) without degrading the phase noise performance. The effective noise power from the active device is suppressed by an additional coupling between the primary and secondary coils via active source degeneration. Moreover, the strong coupling between the primary and secondary coils can boost the equivalent quality factor of the inductance part of the tank at both switchable modes. Thus, both the reduction of phase noise and the extension of the TR are achieved. Fabricated in a 40-nm CMOS process, the proposed oscillator exhibits frequency tuning from 2.88 to 5.87 GHz while consuming 20.5 to 27.9 mW power dissipation. The phase noise at 2.88 GHz oscillation frequency is -135.8 dBc/Hz at 1-MHz offset, corresponding to a figure-of-merit (FoM) of 191.5 dBc/Hz and FoMT of 208.2 dBc/Hz. The 1/ $\mathbf {f}^{3}$ phase noise corner is 68–234 kHz over the 68.3% TR.
- 7 May 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 59 (9) , 2774-2787
A Low-Phase-Noise Wide-Tuning-Range Mode-Switching Oscillator Using Multi-Magnetic-Coupling and Active-Source-Degenerating Techniques
In this article, a mode-switching oscillator using multi-magnetic-coupling and active-source-degenerating techniques is proposed to achieve wide frequency tuning and low phase noise. The multi-magnetic coupled resonator can realize two switchable resonant frequencies and perform active source degeneration. Two main coils are developed to switch between the two resonant modes, thereby doubling the frequency tuning range (TR) without degrading the phase noise performance. The effective noise power from the active device is suppressed by an additional coupling between the primary and secondary coils via active source degeneration. Moreover, the strong coupling between the primary and secondary coils can boost the equivalent quality factor of the inductance part of the tank at both switchable modes. Thus, both the reduction of phase noise and the extension of the TR are achieved. Fabricated in a 40-nm CMOS process, the proposed oscillator exhibits frequency tuning from 2.88 to 5.87 GHz while consuming 20.5 to 27.9 mW power dissipation. The phase noise at 2.88 GHz oscillation frequency is -135.8 dBc/Hz at 1-MHz offset, corresponding to a figure-of-merit (FoM) of 191.5 dBc/Hz and FoMT of 208.2 dBc/Hz. The 1/ $\mathbf {f}^{3}$ phase noise corner is 68–234 kHz over the 68.3% TR.
- 31 March 2024
- Published by Elsevier in Microelectronics Journal
- Vol. 147
A TDC-assisted SAR ADC with high-speed sampling switches and fine-tuned delay cells
- 31 March 2024
- Published by Elsevier in Microelectronics Journal
- Vol. 147
A TDC-assisted SAR ADC with high-speed sampling switches and fine-tuned delay cells