Drona Dahal
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Drona Dahal has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Björn Lüssem
Institute for Microsensors, Actuators and Systems, University of Bremen, 28359 Bremen, Germany
4 shared publications - Pushpa Raj Paudel
Department of Physics Kent State University Kent OH 44242 USA
3 shared publications - Raj Kishen Radha Krishnan
Department of Physics, Kent State University, Kent, Ohio 44240, United States
3 shared publications Vikash Kaphle
Department of Physics, Kent State University 1 , Kent, Ohio 44240, USA
2 shared publications- Antal Jákli
Kent State University
1 shared publication - Chathuranga Prageeth Hemantha Rajapaksha
Department of Physics, Kent State University 1 , Kent, Ohio 44240, USA
1 shared publication
Latest Publications
- 18 August 2022
- Published by Elsevier in Computational Materials Science
- Vol. 214
Accurate and reproducible mobility estimation enables high-throughput analysis of organic field-effect transistors
- 18 August 2022
- Published by Elsevier in Computational Materials Science
- Vol. 214
Accurate and reproducible mobility estimation enables high-throughput analysis of organic field-effect transistors
- Open Access
- 1 April 2022
- Published by AIP Publishing in AIP Advances
- Vol. 12 (4) , 045310
Top-contact organic electrochemical transistors
Organic electrochemical transistors (OECTs) transduce ionic into electric signals, which makes them a promising candidate for a wide range of bio-electronic applications. However, despite their promise, the influence of their device geometry on performance is still not fully understood. Here, two different device geometries—top contact and bottom contact OECTs—are compared in terms of their contact resistance, reproducibility, and switching speed. It is shown that bottom contact devices have faster switching times, while their top-contact counterparts are superior in terms of slightly reduced contact-resistance and increased reproducibility. The origin of this trade-off between speed and reproducibility is discussed, which provides optimization guidelines for a particular application.
- 1 April 2022
- Published by AIP Publishing in AIP Advances
- Vol. 12 (4) , 045310
Open AccessTop-contact organic electrochemical transistors
Organic electrochemical transistors (OECTs) transduce ionic into electric signals, which makes them a promising candidate for a wide range of bio-electronic applications. However, despite their promise, the influence of their device geometry on performance is still not fully understood. Here, two different device geometries—top contact and bottom contact OECTs—are compared in terms of their contact resistance, reproducibility, and switching speed. It is shown that bottom contact devices have faster switching times, while their top-contact counterparts are superior in terms of slightly reduced contact-resistance and increased reproducibility. The origin of this trade-off between speed and reproducibility is discussed, which provides optimization guidelines for a particular application.
- 3 February 2022
- Published by AIP Publishing in Applied Physics Reviews
- Vol. 9 (1) , 011415
Ionic liquid crystal elastomers-based flexible organic electrochemical transistors: Effect of director alignment of the solid electrolyte
Organic electrochemical transistors (OECTs) have attracted great attention since their discovery in 1984 due to their flexibility and biocompatibility. Although an intense focus has been put on the design of new organic semiconductors, fewer efforts are directed toward the development of optimized electrolytes. However, the electrolyte is an integral part of OECTs and strongly influences the transient responses of these devices. Also, best performing OECTs currently use liquid electrolytes, but there is a growing need for solid electrolytes, as they can be easily integrated into wearable devices. In this paper, we demonstrate that ionic liquid crystal elastomers (iLCEs) can be used as solid electrolytes of flexible, substrate-free organic electrochemical transistors. We introduce the alignment of the director of the liquid crystal elastomers as a new parameter to tune and improve both steady state and transient responses. The normalized maximum transconductance gm/w of the most sensitive iLCE was found to be the highest (7 Sm−1) among all solid state-based OECTs.
- 3 February 2022
- Published by AIP Publishing in Applied Physics Reviews
- Vol. 9 (1) , 011415
Ionic liquid crystal elastomers-based flexible organic electrochemical transistors: Effect of director alignment of the solid electrolyte
Organic electrochemical transistors (OECTs) have attracted great attention since their discovery in 1984 due to their flexibility and biocompatibility. Although an intense focus has been put on the design of new organic semiconductors, fewer efforts are directed toward the development of optimized electrolytes. However, the electrolyte is an integral part of OECTs and strongly influences the transient responses of these devices. Also, best performing OECTs currently use liquid electrolytes, but there is a growing need for solid electrolytes, as they can be easily integrated into wearable devices. In this paper, we demonstrate that ionic liquid crystal elastomers (iLCEs) can be used as solid electrolytes of flexible, substrate-free organic electrochemical transistors. We introduce the alignment of the director of the liquid crystal elastomers as a new parameter to tune and improve both steady state and transient responses. The normalized maximum transconductance gm/w of the most sensitive iLCE was found to be the highest (7 Sm−1) among all solid state-based OECTs.
- 25 January 2022
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 14 (5) , 7063-7072
Influence of Injection Barrier on Vertical Organic Field Effect Transistors
Organic field-effect transistors (OFETs) have shown great potential for applications that require low temperature deposition on large and flexible substrates. To increase their performance, in particular a high transconductance and transit frequency, the transistor channel length has to be scaled into the submicrometer regime, which can be easily achieved in vertical organic field effect transistors (VOFETs). However, despite high performance observed in VOFETs, these transistors usually suffer from short channel effects like weak saturation of the drain current and direct source-drain leakage resulting in large off currents. Here, we study the influence of the injection barrier at the source electrode on the OFF currents, on/off ratio, and transconductance of vertical OFETs. We use two semiconducting materials, 2,6-diphenyl anthracene (DPA), and C60 to vary the injection barrier at the source electrode and are able to show that increasing the Schottky barrier at the source electrode can decrease the direct source/drain leakage by 3 orders of magnitude. However, the increased injection barrier at the source electrode comes at the expense of an increased contact resistance, which in turn will decrease its transconductance and transit frequency. With the help of a 2D drift-diffusion simulation we show that the trade-off between low off currents and high transconductance is inherent to the current VOFET device setup and that new approaches have to be found to design VOFETs that combine good switching properties with high performance.
- 25 January 2022
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 14 (5) , 7063-7072
Influence of Injection Barrier on Vertical Organic Field Effect Transistors
Organic field-effect transistors (OFETs) have shown great potential for applications that require low temperature deposition on large and flexible substrates. To increase their performance, in particular a high transconductance and transit frequency, the transistor channel length has to be scaled into the submicrometer regime, which can be easily achieved in vertical organic field effect transistors (VOFETs). However, despite high performance observed in VOFETs, these transistors usually suffer from short channel effects like weak saturation of the drain current and direct source-drain leakage resulting in large off currents. Here, we study the influence of the injection barrier at the source electrode on the OFF currents, on/off ratio, and transconductance of vertical OFETs. We use two semiconducting materials, 2,6-diphenyl anthracene (DPA), and C60 to vary the injection barrier at the source electrode and are able to show that increasing the Schottky barrier at the source electrode can decrease the direct source/drain leakage by 3 orders of magnitude. However, the increased injection barrier at the source electrode comes at the expense of an increased contact resistance, which in turn will decrease its transconductance and transit frequency. With the help of a 2D drift-diffusion simulation we show that the trade-off between low off currents and high transconductance is inherent to the current VOFET device setup and that new approaches have to be found to design VOFETs that combine good switching properties with high performance.