Misha Zvekic
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Misha Zvekic has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Erik T. Krogh
Vancouver Island University
5 shared publications - Angelina Jaeger
Vancouver Island University
2 shared publications Christine C. Tong
Applied Environmental Research Laboratories (AERL), Department of Chemistry, Vancouver Island University, Nanaimo, British Columbia, V9R 5S5, Canada
2 shared publications- Heather Wiebe
Vancouver Island University
2 shared publications - Joseph Monaghan
Vancouver Island University
2 shared publications - Chris Gill
Department of Chemistry University of Victoria Victoria British Columbia Canada
1 shared publication
Latest Publications
- 10 July 2025
- Published by Royal Society of Chemistry (RSC) in Environmental Science: Processes & Impacts
- Vol. 27 (8) , 2550-2563
Physicochemical properties of tire-derived para-phenylenediamine quinones – a comparison of experimental and computational approaches
We report experimental water solubilities and test the accuracy of predictive models for 6PPDQ and its analogs, aiding in risk assessment and the search for safer tire additives through improved fate and distribution models.
- 10 July 2025
- Published by Royal Society of Chemistry (RSC) in Environmental Science: Processes & Impacts
- Vol. 27 (8) , 2550-2563
Physicochemical properties of tire-derived para-phenylenediamine quinones – a comparison of experimental and computational approaches
We report experimental water solubilities and test the accuracy of predictive models for 6PPDQ and its analogs, aiding in risk assessment and the search for safer tire additives through improved fate and distribution models.
- Open Access
- 7 July 2025
- Published by American Chemical Society (ACS) in ChemRxiv
Physicochemical properties of tire-derived para-phenylenediamine quinones - A comparison of experimental and computational approaches
Para-phenylenediamine (PPD) compounds are added to tire rubber at percent levels to sacrificially react with oxidants for prolonged service life. Recently, the PPD transformation product N-(1,3-dimethylbutyl)-N’-phenyl-p-phenylenediamine quinone (6PPDQ) has been identified in roadway runoff as a potent toxicant for coho salmon (Oncorhynchus kisutch). As 6PPD may be phased out in favour of alternative PPDs, understanding the physicochemical properties of their corresponding quinones is important for predicting their environmental fate, distribution, and toxicity. Here, we present an experimentally determined log KOW for 6PPDQ (4.0 ± 0.2) as well as water solubility values for 6PPDQ and five structural analogues (3.2 – 170 µg/L). The water solubilities were several orders of magnitude lower than those predicted by EPI Suite and OPERA, popular Quantitative Structure Activity Relationship (QSAR) programs. We also report octanol-water and air-water partition ratios for PPDQs using Density Functional Theory (DFT) and QSAR approaches. Both methods provided similar rank ordering of compounds. We found that DFT tends to underestimate log KOW values, while QSAR models provide a better agreement with experimental results. Conversely, QSAR models provided poorer predictions of log KAW values than DFT. We discuss the strengths and limitations of both computational approaches, the need for more experimentally derived values, and caution researchers interpreting predicted physicochemical properties, particularly for emerging contaminants for which QSARs may be insufficiently parameterized.
- 7 July 2025
- Published by American Chemical Society (ACS) in ChemRxiv
Open AccessPhysicochemical properties of tire-derived para-phenylenediamine quinones - A comparison of experimental and computational approaches
Para-phenylenediamine (PPD) compounds are added to tire rubber at percent levels to sacrificially react with oxidants for prolonged service life. Recently, the PPD transformation product N-(1,3-dimethylbutyl)-N’-phenyl-p-phenylenediamine quinone (6PPDQ) has been identified in roadway runoff as a potent toxicant for coho salmon (Oncorhynchus kisutch). As 6PPD may be phased out in favour of alternative PPDs, understanding the physicochemical properties of their corresponding quinones is important for predicting their environmental fate, distribution, and toxicity. Here, we present an experimentally determined log KOW for 6PPDQ (4.0 ± 0.2) as well as water solubility values for 6PPDQ and five structural analogues (3.2 – 170 µg/L). The water solubilities were several orders of magnitude lower than those predicted by EPI Suite and OPERA, popular Quantitative Structure Activity Relationship (QSAR) programs. We also report octanol-water and air-water partition ratios for PPDQs using Density Functional Theory (DFT) and QSAR approaches. Both methods provided similar rank ordering of compounds. We found that DFT tends to underestimate log KOW values, while QSAR models provide a better agreement with experimental results. Conversely, QSAR models provided poorer predictions of log KAW values than DFT. We discuss the strengths and limitations of both computational approaches, the need for more experimentally derived values, and caution researchers interpreting predicted physicochemical properties, particularly for emerging contaminants for which QSARs may be insufficiently parameterized.
- Open Access
- 10 May 2024
- Published by Elsevier in Chemosphere
- Vol. 359, 142315
Unique hepatic maternal transfer pattern of trace metals and perfluoroalkyl substances (PFAS) in a bluntnose sixgill shark (Hexanchus griseus)
- 10 May 2024
- Published by Elsevier in Chemosphere
- Vol. 359, 142315
Open AccessUnique hepatic maternal transfer pattern of trace metals and perfluoroalkyl substances (PFAS) in a bluntnose sixgill shark (Hexanchus griseus)
- 13 June 2023
- Published by Royal Society of Chemistry (RSC) in Environmental Science: Processes & Impacts
- Vol. 25 (7) , 1169-1180
Monitoring microplastic–contaminant sorption processes in real-time using membrane introduction mass spectrometry
Microplastics are environmentally ubiquitous and their role in the fate and distribution of trace contaminants is of emerging concern. We report the first use of membrane introduction mass spectrometry to directly monitor the rate and extent of microplastic–contaminant sorption. Target contaminant (naphthalene, anthracene, pyrene, and nonylphenol) sorption behaviours were examined at nanomolar concentrations with four plastic types: low density polyethylene (LDPE), high density polyethylene (HDPE), polypropylene (PP), and polystyrene (PS). Under the conditions employed here, short-term sorption kinetics were assessed using on-line mass spectrometry for up to one hour. Subsequent sorption was followed by periodically measuring contaminant concentrations for up to three weeks. Short-term sorption followed first order kinetics with rate constants that scaled with hydrophobicity for the homologous series of polycyclic aromatic hydrocarbons (PAHs). Sorption rate constants on LDPE for equimolar solutions of naphthalene, anthracene, and pyrene were 0.5, 2.0, and 2.2 h−1, respectively, while nonylphenol did not sorb to pristine plastics over this time period. Similar trends among contaminants were observed for other pristine plastics with 4- to 10-fold faster sorption rates associated with LDPE when compared to PS and PP. Sorption was largely complete after three weeks, with the percent analyte sorbed ranging from 40–100% across various microplastic–contaminant combinations. Photo-oxidative ageing of LDPE had little effect on PAH sorption. However, a marked increase in nonylphenol sorption was consistent with increased hydrogen-bonding interactions. This work provides kinetic insights into surface interactions and describes a powerful experimental platform to directly observe contaminant sorption behaviours in complex samples under a variety of environmentally relevant conditions.
- 13 June 2023
- Published by Royal Society of Chemistry (RSC) in Environmental Science: Processes & Impacts
- Vol. 25 (7) , 1169-1180
Monitoring microplastic–contaminant sorption processes in real-time using membrane introduction mass spectrometry
Microplastics are environmentally ubiquitous and their role in the fate and distribution of trace contaminants is of emerging concern. We report the first use of membrane introduction mass spectrometry to directly monitor the rate and extent of microplastic–contaminant sorption. Target contaminant (naphthalene, anthracene, pyrene, and nonylphenol) sorption behaviours were examined at nanomolar concentrations with four plastic types: low density polyethylene (LDPE), high density polyethylene (HDPE), polypropylene (PP), and polystyrene (PS). Under the conditions employed here, short-term sorption kinetics were assessed using on-line mass spectrometry for up to one hour. Subsequent sorption was followed by periodically measuring contaminant concentrations for up to three weeks. Short-term sorption followed first order kinetics with rate constants that scaled with hydrophobicity for the homologous series of polycyclic aromatic hydrocarbons (PAHs). Sorption rate constants on LDPE for equimolar solutions of naphthalene, anthracene, and pyrene were 0.5, 2.0, and 2.2 h−1, respectively, while nonylphenol did not sorb to pristine plastics over this time period. Similar trends among contaminants were observed for other pristine plastics with 4- to 10-fold faster sorption rates associated with LDPE when compared to PS and PP. Sorption was largely complete after three weeks, with the percent analyte sorbed ranging from 40–100% across various microplastic–contaminant combinations. Photo-oxidative ageing of LDPE had little effect on PAH sorption. However, a marked increase in nonylphenol sorption was consistent with increased hydrogen-bonding interactions. This work provides kinetic insights into surface interactions and describes a powerful experimental platform to directly observe contaminant sorption behaviours in complex samples under a variety of environmentally relevant conditions.
- 8 December 2021
- Published by Royal Society of Chemistry (RSC) in Environmental Science: Processes & Impacts
- Vol. 24 (1) , 52-61
Characterizing photochemical ageing processes of microplastic materials using multivariate analysis of infrared spectra
Microplastics in the environment are an emerging concern due to impacts on human and environmental health. In addition to direct effects on biota, microplastics influence the fate and distribution of trace organic contaminants through sorption and transport. Environmental weathering may influence the rate and extent of chemical sorption. Changes in the surface characteristics of four common plastics including low-density polyethylene (LDPE), high-density polyethylene (HDPE), polypropylene (PP), and polystyrene (PS) were followed under the influence of both artificial light (UV-B) and natural sunlight for up to six months. Attenuated total reflectance Fourier transform infrared (ATR-FTIR) spectra were collected at regular intervals. Principal component analysis (PCA) of the full dataset of UV-B weathered samples (n >500 spectra) simultaneously discriminated plastic type and extent of photochemical weathering. The magnitude of PCA scores correlated with exposure time and the loadings were consistent with surface chemistry changes including photooxidation. Projecting sunlight and UV-C exposed samples onto this PCA model demonstrated that similar chemical changes occurred, albeit at different rates. The results were compared to the carbonyl index (CI) with similar weathering trends indicating PP weathered at a faster initial rate than LDPE and HDPE. We propose that a multivariate approach is more widely applicable than CI as illustrated by PS, which lacked a stable reference peak. Kinetic analysis of the time series indicated that outdoor weathering occurred 5–12 times slower than the artificial exposure used here, depending on the plastic and the light source employed. The results provide unique insights into weathering processes and the photochemical age of naturally weathered plastics.
- 8 December 2021
- Published by Royal Society of Chemistry (RSC) in Environmental Science: Processes & Impacts
- Vol. 24 (1) , 52-61
Characterizing photochemical ageing processes of microplastic materials using multivariate analysis of infrared spectra
Microplastics in the environment are an emerging concern due to impacts on human and environmental health. In addition to direct effects on biota, microplastics influence the fate and distribution of trace organic contaminants through sorption and transport. Environmental weathering may influence the rate and extent of chemical sorption. Changes in the surface characteristics of four common plastics including low-density polyethylene (LDPE), high-density polyethylene (HDPE), polypropylene (PP), and polystyrene (PS) were followed under the influence of both artificial light (UV-B) and natural sunlight for up to six months. Attenuated total reflectance Fourier transform infrared (ATR-FTIR) spectra were collected at regular intervals. Principal component analysis (PCA) of the full dataset of UV-B weathered samples (n >500 spectra) simultaneously discriminated plastic type and extent of photochemical weathering. The magnitude of PCA scores correlated with exposure time and the loadings were consistent with surface chemistry changes including photooxidation. Projecting sunlight and UV-C exposed samples onto this PCA model demonstrated that similar chemical changes occurred, albeit at different rates. The results were compared to the carbonyl index (CI) with similar weathering trends indicating PP weathered at a faster initial rate than LDPE and HDPE. We propose that a multivariate approach is more widely applicable than CI as illustrated by PS, which lacked a stable reference peak. Kinetic analysis of the time series indicated that outdoor weathering occurred 5–12 times slower than the artificial exposure used here, depending on the plastic and the light source employed. The results provide unique insights into weathering processes and the photochemical age of naturally weathered plastics.