Anwar Faizd Osman
Anwar Faizd Osman has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
- Aduwati Sali
Department of Computer and Communication Systems Engineering, Faculty of Engineering, WiPNET Research Centre, Universiti Putra Malaysia (UPM), Serdang, Selangor, Malaysia
2 shared publications - Imran Mohd Ibrahim
Universiti Teknikal Malaysia Melaka (UTeM)
2 shared publications - Noor Azwan Shairi
Universiti Teknikal Malaysia Melaka
2 shared publications - Sangin Qahtan Wali
Department of Computer and Communication Systems Engineering, WiPNET Research Centre, Faculty of Engineering, Universiti Putra Malaysia (UPM), Serdang, Selangor, Malaysia
2 shared publications - Zahriladha Zakaria
Faculty of Electronic and Computer Technology and Engineering, Universiti Teknikal Malaysia Melaka (UTeM), Durian Tunggal, Malaysia
2 shared publications - Abdulmajeed Al-Jumaily
Department of Signal Theory and Communications (DTSC) Madrid Leganes Department of Signal Theory and Communications (DTSC), Charles III University of Madrid, UC3M, Leganes
1 shared publication
Latest Publications
- Open Access
- 1 April 2024
- Published by Institute of Advanced Engineering and Science in Bulletin of Electrical Engineering and Informatics
- Vol. 13 (2) , 955-962
Microstrip antenna with reflector and air gap for short range communication in 900 MHz band
This paper proposes a microstrip antenna that was made of a microstrip fed slot with a complimentary stub on a single dielectric medium. This antenna was integrated with a reflector and air gap for the application of short range communication (SRC) in a 900 MHz band. Analyses were made on the dimension of the reflector and the height of the air gap towards the antenna performance. Besides, an antenna field test was done for the propagation distance of the proposed antenna. As a result, with the antenna size of 13,770 mm2 , the measured return loss was -10.79 dB and the directivity gain was 7.44 dBi. Besides, with the effective isotropic radiated power (EIRP) of 7.44 dBm, it was predicted that at 100 m, the received signal would be around 60 to 70 dBm. Therefore, a high gain was produced by using a reflector with air gap and a compact size was achieved if compared to conventional high gain antenna designs such as Yagi Uda. Thus, it is suitable for a communication device such as the SRC application.
- 1 April 2024
- Published by Institute of Advanced Engineering and Science in Bulletin of Electrical Engineering and Informatics
- Vol. 13 (2) , 955-962
Open AccessMicrostrip antenna with reflector and air gap for short range communication in 900 MHz band
This paper proposes a microstrip antenna that was made of a microstrip fed slot with a complimentary stub on a single dielectric medium. This antenna was integrated with a reflector and air gap for the application of short range communication (SRC) in a 900 MHz band. Analyses were made on the dimension of the reflector and the height of the air gap towards the antenna performance. Besides, an antenna field test was done for the propagation distance of the proposed antenna. As a result, with the antenna size of 13,770 mm2 , the measured return loss was -10.79 dB and the directivity gain was 7.44 dBi. Besides, with the effective isotropic radiated power (EIRP) of 7.44 dBm, it was predicted that at 100 m, the received signal would be around 60 to 70 dBm. Therefore, a high gain was produced by using a reflector with air gap and a compact size was achieved if compared to conventional high gain antenna designs such as Yagi Uda. Thus, it is suitable for a communication device such as the SRC application.
- Open Access
- 10 April 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 11, 79648-79658
Machine Learning Modeling for Radiofrequency Electromagnetic Fields (RF-EMF) Signals From mmWave 5G Signals
5G is the next-generation mobile communication technology expected to deliver more excellent data rates than Long Term Evolution (LTE). It offers ultra-low latency and ultra-high dependability, allowing revolutionary services across sectors. 5G mm-Wave base stations may emit harmful radiofrequency electromagnetic fields (RF-EMF). However, RF-EMF concern raises health and safety. From our research, the RF-EMF prediction model lacks papers or publications. This study uses IEEE and ICNIRP standards for assessment and exposure limits. The measuring campaign analyses one sector of a 5G base station (5G-BS) operation on 29.5 GHz in Cyberjaya, Malaysia. This study proposes two prediction models. The first model predicts signal beam RF-EMF, and the second predicts base station RF-EMF. Each model contains three neural network techniques to forecast RF-EMF values: Approximate-RBFNN, Exact-RBFNN, and GRNN. The results are analysed and compared with the measured data, observing which algorithm is more accurate by calculating the RMSE of each algorithm. As a result, it can observe that the Exact-RBFNN algorithm is the best algorithm to predict the RF-EMF because it shows a good agreement with the measured value. Besides that, in 1-min duration, the difference between predicted and measured values reached 0.2 less channels. However, in 6-min and 30-min, it can observe more accurate results since the differences between values reached 0.1in the situations. In addition, the ICNIRP standard was used and compared with the result and validation value of the algorithms.
- 10 April 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 11, 79648-79658
Open AccessMachine Learning Modeling for Radiofrequency Electromagnetic Fields (RF-EMF) Signals From mmWave 5G Signals
5G is the next-generation mobile communication technology expected to deliver more excellent data rates than Long Term Evolution (LTE). It offers ultra-low latency and ultra-high dependability, allowing revolutionary services across sectors. 5G mm-Wave base stations may emit harmful radiofrequency electromagnetic fields (RF-EMF). However, RF-EMF concern raises health and safety. From our research, the RF-EMF prediction model lacks papers or publications. This study uses IEEE and ICNIRP standards for assessment and exposure limits. The measuring campaign analyses one sector of a 5G base station (5G-BS) operation on 29.5 GHz in Cyberjaya, Malaysia. This study proposes two prediction models. The first model predicts signal beam RF-EMF, and the second predicts base station RF-EMF. Each model contains three neural network techniques to forecast RF-EMF values: Approximate-RBFNN, Exact-RBFNN, and GRNN. The results are analysed and compared with the measured data, observing which algorithm is more accurate by calculating the RMSE of each algorithm. As a result, it can observe that the Exact-RBFNN algorithm is the best algorithm to predict the RF-EMF because it shows a good agreement with the measured value. Besides that, in 1-min duration, the difference between predicted and measured values reached 0.2 less channels. However, in 6-min and 30-min, it can observe more accurate results since the differences between values reached 0.1in the situations. In addition, the ICNIRP standard was used and compared with the result and validation value of the algorithms.
- Open Access
- 1 November 2022
- Published by Institute of Advanced Engineering and Science in Indonesian Journal of Electrical Engineering and Computer Science
- Vol. 28 (2) , 820-829
Reconfigurable bandstop to allpass filter using defected ground structure in K-band for millimeter-wave communications
In this paper, a reconfigurable bandstop to allpass filters using Defected Ground Structure (DGS) in K-Band for millimeter-wave communications is proposed. Mathematical analysis of the DGS is discussed in this paper for the bandstop and allpass responses. The reconfigurable filter is performed by using an ideal switch with open circuit and short circuit conditions on DGS at several locations. Hence, two filter designs with different DGS are investigated for their performance in both simulation and measurement. As a result, the ideal switch at location S3 gives the best performance for both DGSs with a narrowband bandstop response and a wideband allpass response with insertion loss of less than 1 dB and return loss of more than 10 dB at the 26 GHz band. Hence, the proposed reconfigurable filter is suitable for millimeter-wave front-end communications.
- 1 November 2022
- Published by Institute of Advanced Engineering and Science in Indonesian Journal of Electrical Engineering and Computer Science
- Vol. 28 (2) , 820-829
Open AccessReconfigurable bandstop to allpass filter using defected ground structure in K-band for millimeter-wave communications
In this paper, a reconfigurable bandstop to allpass filters using Defected Ground Structure (DGS) in K-Band for millimeter-wave communications is proposed. Mathematical analysis of the DGS is discussed in this paper for the bandstop and allpass responses. The reconfigurable filter is performed by using an ideal switch with open circuit and short circuit conditions on DGS at several locations. Hence, two filter designs with different DGS are investigated for their performance in both simulation and measurement. As a result, the ideal switch at location S3 gives the best performance for both DGSs with a narrowband bandstop response and a wideband allpass response with insertion loss of less than 1 dB and return loss of more than 10 dB at the 26 GHz band. Hence, the proposed reconfigurable filter is suitable for millimeter-wave front-end communications.
- Open Access
- 14 January 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 10, 9048-9058
RF-EMF Exposure Measurement for 5G Over Mm-Wave Base Station With MIMO Antenna
The fifth-generation (5G) technology offers more capacity and data rates than the previous generations. It provides ultra-low latency and ultra-high dependability, allowing for efficient services in many industries. Using radiofrequency electromagnetic fields (RF-EMF) above 6 GHz in 5G millimeter Wave(mm-Wave) base stations has concerned many people due to the potential health risks caused by EMF exposure. This study aims to measure the maximum exposure emitted by a 5G mm-Wave base station by utilizing international standards in both its assessment methodology and exposure limits. In this study, the R&S Ⓡ TSMA6 scanner, R&S Ⓡ ROMES4 software, and R&S Ⓡ TSME30DC down converter have been used for the measurement campaign; in addition to the user equipment device (UE), GPS, and an omnidirectional antenna. The investigation is based on a code selective method due to the radiated power fluctuations over time with data traffic. To conduct the measurement, six tests are taken based on three different time frames, antenna directions, and user equipment device (UE) to investigate the RF-EMF exposure. The maximum and average exposure from the 5G mm-Wave base station are calculated and compared with the ICNIRP standard. The maximum exposure from the 29.5 GHz base station is found to be 5.71 V/m, and the highest amount of average exposure is 2.02V/m. In this study, it was found that the maximum and average exposure (RF-EMF) produced from a single 5G mm-Wave base station are well within the allowed RF-EMF standard limit.
- 14 January 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 10, 9048-9058
Open AccessRF-EMF Exposure Measurement for 5G Over Mm-Wave Base Station With MIMO Antenna
The fifth-generation (5G) technology offers more capacity and data rates than the previous generations. It provides ultra-low latency and ultra-high dependability, allowing for efficient services in many industries. Using radiofrequency electromagnetic fields (RF-EMF) above 6 GHz in 5G millimeter Wave(mm-Wave) base stations has concerned many people due to the potential health risks caused by EMF exposure. This study aims to measure the maximum exposure emitted by a 5G mm-Wave base station by utilizing international standards in both its assessment methodology and exposure limits. In this study, the R&S Ⓡ TSMA6 scanner, R&S Ⓡ ROMES4 software, and R&S Ⓡ TSME30DC down converter have been used for the measurement campaign; in addition to the user equipment device (UE), GPS, and an omnidirectional antenna. The investigation is based on a code selective method due to the radiated power fluctuations over time with data traffic. To conduct the measurement, six tests are taken based on three different time frames, antenna directions, and user equipment device (UE) to investigate the RF-EMF exposure. The maximum and average exposure from the 5G mm-Wave base station are calculated and compared with the ICNIRP standard. The maximum exposure from the 29.5 GHz base station is found to be 5.71 V/m, and the highest amount of average exposure is 2.02V/m. In this study, it was found that the maximum and average exposure (RF-EMF) produced from a single 5G mm-Wave base station are well within the allowed RF-EMF standard limit.