VPVan-Duyen Pham

Van-Duyen Pham

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Van-Duyen Pham has a total of 14 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Numerical Investigation of Cavitation-induced Noise and Hydrodynamic Instability Around a Two-dimensional Hydrofoil

    by Minh Duc Nguyen, Ngoc Tu Tran, Van Duyen Pham

    In this numerical study, physical characteristics of cavitating flow around a two-dimensional hydrofoil was investigated using a Large Eddy Simulation (LES) framework. To capture the phase change, the Schnerr–Sauer cavitation model was applied to the simulation. First, the numerical results were carefully validated with current experimental study to ensure the accuracy of the numerical scheme. Then, systematic analysis of cavity evolution around the hydrofoil, velocity fields and streamline behaviors, and pressure distribution on the surface of the hydrofoil under two different flow conditions (σ = 2.57 and 4.95) were carried out. The results indicated that cavitation numbers have significant effects on the formation of the cavity as well as stability of the cavity dynamics. In particular, at high cavitation number, no cavity was observed on the suction side of the hydrofoil. However, as the cavitation number decreases to 2.57, the local pressure dropped significantly, leading to cavity formation. In addition, the acoustic analysis showed that cavitation substantially increased the sound pressure level (SPL) over a wide range of the frequencies. Moreover, formation of cavities on the suction side of the hydrofoil significantly induced instability of the hydrodynamic forces. Findings from this numerical study demonstrate unexpected influences of the cavitating flow on the hydrofoil. This provides valuable insight into the design and optimization of the hydrofoil geometry to reduce cavitation effects.

  • Influence of a deflector on ventilated supercavity development and stability

    by Van-Duyen Pham, Byoung-Kwon Ahn

    This study numerically investigated the effects of a deflector structure installed behind a disk-type cavitator on the development and hydrodynamic stability of a ventilated supercavitating flow. A multiphase volume-of-fluid model coupled with a large eddy simulation framework was employed. Numerical simulations were performed on test models with and without a deflector structure under conditions of identical Froude numbers and angles of attack of the cavitator. The results showed that the presence of the deflector structure accelerated supercavity development, thereby increasing the maximum cavity length by approximately 25%. Without a deflector structure, the supercavity exhibited strong unsteadiness and large-scale shedding, whereas the presence of the deflector structure stabilized the air–water interface and suppressed large-scale shedding by breaking it down into smaller vortical structures. The total drag acting on the model with the deflector structure was slightly lower than that acting on the model without a deflector structure, with a maximum drag reduction of approximately 2%. Under a nonzero angle of attack of the cavitator, the supercavity became increasingly asymmetric; however, the cavity length for the model with the deflector structure remained consistently greater. This study provides a systematic investigation of the role of deflector structures in supercavitating flows, offering new numerical insights into the underlying physical mechanisms and practical guidance for the hydrodynamic design of high-speed underwater vehicles.


  • Effects of leading-edge protuberances on cavitation, induced noise and hydrodynamic performances of three-dimensional hydrofoils

    by Rafat Ivan Ahamed Simanto, Ji-Woo Hong, Van-Duyen Pham, Young-Jin Kim, Byoung-Kwon Ahn

    By incorporating leading-edge (L-E) protuberances inspired by humpback whale flippers, this study enhances hydrodynamic performance, mitigates cavitation effects and develops efficient models to minimise noise emissions in aquatic systems. Experimental and numerical simulations are conducted on four semi-elliptical NACA 16020 three-dimensional (3-D) hydrofoils, including a baseline hydrofoil and three modified versions featuring sinusoidal L-E alterations. These alterations encompass amplitudes of 2 %, wavelengths of 8.33 % and 4.1667 % of the mean chord length (C), and wavenumbers of 12 and 6. Experimental analysis encompassing both cavitational and non-cavitational regimes at varying attack angles revealed significant relationships between the hydrodynamic performance and partial sheet cavitation. Hydrodynamic force analysis shows that hydrofoils with L-E protuberances generate elevated lift at moderate and high angles of attack (AOA) in cavitating and non-cavitating conditions. Under lower-severity cavitating conditions, models with L-E protuberances exhibit no significant reduction in sound pressure level. In contrast, at higher severity, the presence of L-E protuberances effectively reduces the flow-induced noise, with partial cavities covering 30 %–50 % of the chord. Numerical simulations were conducted to investigate the turbulent kinetic energy (TKE) distribution and the presence of counter-rotating vortices on each protuberance. The results reveal a significantly enhanced TKE around the trough area and the presence of counter-rotating vortices at each protuberance peak. The more realistic asymmetric design performed better than the other modifications regarding hydrodynamic force, whereas the symmetric model with wavelengths of 8.33 % excelled at cavitation and noise suppression. Therefore, this study offers promising avenues for advancing hydrofoil design in diverse engineering domains.


  • Study on ventilated supercavitation in vertical and lateral gust flows

    by Van-Duyen Pham, Byoung-Kwon Ahn

    In realistic operational settings, underwater vehicles often encounter unsteady incoming flows; however, the implications of such disturbances on ventilated supercavitation remain insufficiently understood. This study addresses this gap by analyzing the effects of vertical and lateral gust flows on the physical characteristics of a ventilated supercavity—knowledge that is critical for enhancing control mechanisms in supercavitating vehicles. The simulations utilize the volume of fluid method with the realizable k–ε turbulence model, incorporating periodic inlet disturbances via a superimposed cosine function. Following validation against experimental benchmarks, gust flows are modeled at frequencies of 10, 15, and 20 Hz across three Froude numbers: 15.25, 20.33, and 25.41. The results indicate that gust flows significantly modify cavity morphology, inducing pinch-off events and promoting a shift from twin-vortex to re-entrant jet closure modes. At fixed Froude numbers, increasing gust frequency leads to a progressive reduction in total cavity length, with vertical gusts inducing more substantial reductions than lateral gusts. Conversely, the maximum cavity diameter remains largely unaffected by gust frequency. Additionally, both gust directions reduce ventilation air concentration and static pressure within the cavity, resulting in elevated local cavitation numbers. These flow disturbances also introduce pronounced unsteadiness in the hydrodynamic forces: The streamwise and vertical components of the hydrodynamic force are primarily affected by vertical gusts, whereas the lateral component is influenced by later gusts.


  • Large eddy simulation investigation on the effects of the forebody shape of a supercavitating torpedo

    by Van-Duyen Pham, Byoung-Kwon Ahn

    The forebody length of a supercavitating vehicle requires careful consideration during the design process. Variations in this dimension have the potential to profoundly influence the supercavitation characteristics. In this numerical study, we qualitatively and quantitatively explore the characteristics of natural and ventilated supercavitating flow under various forebody lengths. We use the multiphase volume-of-fluid method and the large-eddy simulation framework coupled with the Schnerr–Sauer cavitation model. Three forebody lengths (LF = 10dc, 15dc, and 20dc, where dc is the diameter of the cavitator) are applied to the test model. The numerical simulations effectively predict variations in supercavity geometry, hydrodynamic force, and supercavitating internal flow under the influence of the forebody length. The results indicate that the time required to generate a clear supercavity for the model with a 10dc forebody length is ∼6% and 9% less than for the 15dc and 20dc forebody length models, respectively. Additionally, the 10dc forebody length model experiences about 5% smaller total drag force compared to the longer models. The variations in forebody length significantly influence the supercavitating internal flow and pressure distribution inside the supercavity. Specifically, the ventilation air is distributed as an outer layer of the supercavity for the 10dc forebody length model, whereas it moves along the surface of the models with 15dc and 20dc forebody lengths. In terms of pressure distribution, the 10dc forebody length model exhibits the highest local pressure compared to the models with longer forebody lengths. These observations provide insights into the physical mechanisms underlying the effects of forebody length on supercavity characteristics.


  • Open Access

    Experimental and numerical analysis of the physical characteristics of natural and ventilated supercavitating flows

    by Van-Duyen Pham, Ji-Woo Hong, Byoung-Kwon Ahn

    In this experimental and numerical study, we investigate the physical characteristics of a supercavitating flow generated behind a disk-shaped cavitator under both natural and ventilated conditions, an area of research that has not been thoroughly examined. Initially, the experiment is conducted within a cavitation tunnel employing a forward-facing model, complemented by high-speed visualization techniques. Subsequently, an unsteady Reynolds-averaged Navier–Stokes approach is adopted to conduct numerical simulations along with the k–ε turbulent model and Ffowcs Williams–Hawkings (FW–H) methods. The outcomes of the study demonstrate that when considering fixed cavitation numbers, the profiles of natural and ventilated cavities are consistent. Under constant flow conditions, the introduction of ventilating air leads to a discernible reduction in hydroacoustic characteristics in the high-frequency spectrum and has the potential to improve flow stability behind the cavitator. The numerical results offer insight into the behaviors of the water, vapor, and ventilation air. In the foamy cavity stage, all the considered phases (water, vapor, and ventilation air) coexist inside the cavity. Upon the formation of a transparent supercavity, the ventilation air primarily gathers around the ventilation holes and the surrounding gas-leakage region. Meanwhile, the vaporous gas is dominant and is concentrated predominantly in the central region of the supercavity. The findings extracted from this study represent a significant advancement in our understanding of the intricacies of supercavities under ventilated and vaporous conditions. These insights hold the potential to drive groundbreaking innovations in the design and control of supercavitating vehicles.