Sharifah Masniah Wan Masra
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Sharifah Masniah Wan Masra has a total of 31 co-authors. Here are the top co-authors by number of shared publications:
- Yanuar Zulardiansyah Arief
Department of Electrical and Electronic Engineering, Faculty of Engineering, Universiti Malaysia Sarawak, Kota Samarahan, Malaysia
3 shared publications - Nur Sabrina Suhaimi
Department of Electrical and Electronic Engineering, Faculty of Engineering and Built Environment, Universiti Sains Islam Malaysia, Nilai, Negeri Sembilan, Malaysia
2 shared publications S. K. Sahari
Department of Electrical and Electronic Engineering, Faculty of Engineering, Universiti Malaysia Sarawak, Kota Samarahan, Malaysia
2 shared publications- Shamsiah Suhaili
Universiti Malaysia Sarawak
2 shared publications A. Lit
Department of Electrical and Electronic Engineering, Faculty of Engineering, Universiti Malaysia Sarawak, Kota Samarahan, Malaysia
1 shared publicationA. R. H. Rigit
Department of Mechanical Engineering, Faculty of Engineering, Universiti Malaysia Sarawak, Kota Samarahan, Malaysia
1 shared publication
Latest Publications
- 18 April 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Dielectrics and Electrical Insulation
- Vol. 33 (2) , 1352-1359
Dissolved Gas Analysis on POME-Based Nanofluids
This paper investigates the dissolved gas analysis (DGA) of aged palm oil methyl ester (POME)-based nanofluids. Thermal stress is applied to nanofluids with various concentrations of TiO2 and MWCNT nanoparticles. The experiments are conducted on a laboratory scale, with the POME-based nanofluids thermally aged at 130 oC in the absence of solid insulating materials. The study aims to compare the gases generated in both nanofluids. Four different diagnosis methods are employed: Rogers Ratio, IEC Gas Ratio, Duval Triangle, and Duval Pentagon. The experimental results reveal nearly identical gassing behaviors between the two nanofluids after thermal ageing. These findings contribute to expanding investigations into transformer fault diagnosis, particularly in cases where various natural ester oils, including POME-based nanofluids, are used in power transformer. This helps diversify the growing body of research on DGA for natural ester oils, which has largely focused on commercially dominant types.
- 18 April 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Dielectrics and Electrical Insulation
- Vol. 33 (2) , 1352-1359
Dissolved Gas Analysis on POME-Based Nanofluids
This paper investigates the dissolved gas analysis (DGA) of aged palm oil methyl ester (POME)-based nanofluids. Thermal stress is applied to nanofluids with various concentrations of TiO2 and MWCNT nanoparticles. The experiments are conducted on a laboratory scale, with the POME-based nanofluids thermally aged at 130 oC in the absence of solid insulating materials. The study aims to compare the gases generated in both nanofluids. Four different diagnosis methods are employed: Rogers Ratio, IEC Gas Ratio, Duval Triangle, and Duval Pentagon. The experimental results reveal nearly identical gassing behaviors between the two nanofluids after thermal ageing. These findings contribute to expanding investigations into transformer fault diagnosis, particularly in cases where various natural ester oils, including POME-based nanofluids, are used in power transformer. This helps diversify the growing body of research on DGA for natural ester oils, which has largely focused on commercially dominant types.
- 31 March 2024
- Published by Springer Nature
- p. 101-107
Exploring the Impact of Accelerated Thermal Aging on POME-Based MWCNT Nanofluid
- 31 March 2024
- Published by Springer Nature
- p. 101-107
Exploring the Impact of Accelerated Thermal Aging on POME-Based MWCNT Nanofluid
- 22 September 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Dielectrics and Electrical Insulation
- Vol. 30 (6) , 2522-2531
Thermal Aging Effects on the Electrical Breakdown Voltage of TiO and MWCNT Nanofluids Based on POME
In this work, the aging behavior of liquid insulation in transformers using chemically modified refined, bleached, and deodorized palm oil (RBDPO) olein is investigated. The transesterification process is used to modify RBDPO olein to produce palm oil methyl ester (POME), which is used as a base fluid for nanofluid (NF) preparation. The performance of POME with the dispersion of semiconducting titanium oxide (TiO 2 ) and conducting multi-walled carbon nanotube (MWCNT) nanoparticles (NPs) at different concentrations on the AC breakdown voltage (AC BDV) as insulation in transformers is evaluated for their aging behavior. The accelerated aging was conducted under sealed conditions at a temperature of 130°C for 1000 hours. The results show that incorporating TiO 2 and MWCNT NPs into POME did not have an adverse effect on the BDV, regardless of the doping concentrations. Notably, POME-based TiO 2 NFs exhibited the highest AC BDV after thermal aging, specifically at a concentration of 0.05 g/L. Anderson-Darling goodness-of-fit statistics were performed on the experimental data to verify their agreement with the Normal and Weibull distributions.
- 22 September 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Dielectrics and Electrical Insulation
- Vol. 30 (6) , 2522-2531
Thermal Aging Effects on the Electrical Breakdown Voltage of TiO and MWCNT Nanofluids Based on POME
In this work, the aging behavior of liquid insulation in transformers using chemically modified refined, bleached, and deodorized palm oil (RBDPO) olein is investigated. The transesterification process is used to modify RBDPO olein to produce palm oil methyl ester (POME), which is used as a base fluid for nanofluid (NF) preparation. The performance of POME with the dispersion of semiconducting titanium oxide (TiO 2 ) and conducting multi-walled carbon nanotube (MWCNT) nanoparticles (NPs) at different concentrations on the AC breakdown voltage (AC BDV) as insulation in transformers is evaluated for their aging behavior. The accelerated aging was conducted under sealed conditions at a temperature of 130°C for 1000 hours. The results show that incorporating TiO 2 and MWCNT NPs into POME did not have an adverse effect on the BDV, regardless of the doping concentrations. Notably, POME-based TiO 2 NFs exhibited the highest AC BDV after thermal aging, specifically at a concentration of 0.05 g/L. Anderson-Darling goodness-of-fit statistics were performed on the experimental data to verify their agreement with the Normal and Weibull distributions.
- 1 August 2022
- Published by Malaysian Palm Oil Board in Journal of Oil Palm Research
- Vol. 35 (1) , 33-44
ASSESSING ELECTRICAL AND PHYSICOCHEMICAL PERFORMANCE OF CHEMICALLY MODIFIED PALM OIL AS AN ALTERNATIVE TRANSFORMER LIQUID
- 1 August 2022
- Published by Malaysian Palm Oil Board in Journal of Oil Palm Research
- Vol. 35 (1) , 33-44
ASSESSING ELECTRICAL AND PHYSICOCHEMICAL PERFORMANCE OF CHEMICALLY MODIFIED PALM OIL AS AN ALTERNATIVE TRANSFORMER LIQUID
- 30 June 2022
- Published by Penerbit UMT, Universiti Malaysia Terengganu in Journal of Sustainability Science and Management
- Vol. 17 (6) , 159-171
ADAPTIVE ENERGY MANAGEMENT STRATEGY FOR SUSTAINABLE OPERATION OF HYBRID ELECTRIC VEHICLE
Hybrid electric vehicles (HEVs) in the transportation sector is spearheading the industry towards embracing green technology to ensure the sustainability of the environment. HEVs offer significant reduction of exhaust emissions while retaining vehicle performance achieved via a revolutionary energy management strategy (EMS) which reforms the management of power flow from the dual energy sources of a HEV. However, researchers are faced with challenges to extract the maximum performance out of HEVs due to the contradicting nature between its main objectives, namely vehicle performance, fuel consumption and cost. In this study, an investigation focusing on the fuel-saving potential of a power-split type HEV using a fuzzy logic-based EMS is conducted. The purpose of this research is to explore methods to improve fuel efficiency of a HEV through a smart and adaptive EMS. The power flow in the proposed model is decided based on its current vehicle speed and the global discharge rate value derived from the real-time battery state-of-charge and remaining trip distance. From simulations over standard drive cycles, the proposed controller is able to outperform a rule-based EMS by an improvement of up to 65.4% in terms of fuel consumption which subsequently reduces the volume of pollutants released to the atmosphere.
- 30 June 2022
- Published by Penerbit UMT, Universiti Malaysia Terengganu in Journal of Sustainability Science and Management
- Vol. 17 (6) , 159-171
ADAPTIVE ENERGY MANAGEMENT STRATEGY FOR SUSTAINABLE OPERATION OF HYBRID ELECTRIC VEHICLE
Hybrid electric vehicles (HEVs) in the transportation sector is spearheading the industry towards embracing green technology to ensure the sustainability of the environment. HEVs offer significant reduction of exhaust emissions while retaining vehicle performance achieved via a revolutionary energy management strategy (EMS) which reforms the management of power flow from the dual energy sources of a HEV. However, researchers are faced with challenges to extract the maximum performance out of HEVs due to the contradicting nature between its main objectives, namely vehicle performance, fuel consumption and cost. In this study, an investigation focusing on the fuel-saving potential of a power-split type HEV using a fuzzy logic-based EMS is conducted. The purpose of this research is to explore methods to improve fuel efficiency of a HEV through a smart and adaptive EMS. The power flow in the proposed model is decided based on its current vehicle speed and the global discharge rate value derived from the real-time battery state-of-charge and remaining trip distance. From simulations over standard drive cycles, the proposed controller is able to outperform a rule-based EMS by an improvement of up to 65.4% in terms of fuel consumption which subsequently reduces the volume of pollutants released to the atmosphere.
- 31 January 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Dielectrics and Electrical Insulation
- Vol. 29 (1) , 302-318
A Systematic Review on Promising Development of Palm Oil and Its Nanofluid as a Biodegradable Oil Insulation Alternative
This review is conducted following a systematic approach by adopting the Preferred Reporting Items for Systematic Reviews and Meta-Analyses (PRISMA) guideline and using reliable and trustworthy databases, namely, IEEE Xplore , Science Direct, and Scopus, with Google Scholar as an additional database. This review has divided into three subsections. The first subsection shows the major publications searching for palm oil (PO)-based as an alternative to biodegradable oil insulation. The second subsection discusses the research trends on PO replacing mineral oil. Finally, the third subsection discusses the development and progress of PO-based nanofluid (NF) as a future substitute for biodegradable oil insulation and the types of analyzes conducted in the studies. This part contains 11 subsubsections, namely: 1) types of PO used; 2) tests of PO as an insulating liquid; 3) properties of PO as an insulating liquid; 4) thermal aging; 5) water content; 6) dissolved gas analysis; 7) selection of nanoparticles; 8) preparation of PO-based NFs; 9) characterization and stability of PO-based NFs; 10) analysis of electrical, physical, and chemical properties; and 11) current status of PO-based insulating liquid in Malaysia. This article highlights PO’s development, trends, and status and its NF as a liquid insulating alternative in transformers. The properties and performance of the liquid are also reported in this article. The promising results, shortcomings, and imbalances between PO and other types of natural ester oils are discussed, and suggestions are made for future work worth exploring.
- 31 January 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Dielectrics and Electrical Insulation
- Vol. 29 (1) , 302-318
A Systematic Review on Promising Development of Palm Oil and Its Nanofluid as a Biodegradable Oil Insulation Alternative
This review is conducted following a systematic approach by adopting the Preferred Reporting Items for Systematic Reviews and Meta-Analyses (PRISMA) guideline and using reliable and trustworthy databases, namely, IEEE Xplore , Science Direct, and Scopus, with Google Scholar as an additional database. This review has divided into three subsections. The first subsection shows the major publications searching for palm oil (PO)-based as an alternative to biodegradable oil insulation. The second subsection discusses the research trends on PO replacing mineral oil. Finally, the third subsection discusses the development and progress of PO-based nanofluid (NF) as a future substitute for biodegradable oil insulation and the types of analyzes conducted in the studies. This part contains 11 subsubsections, namely: 1) types of PO used; 2) tests of PO as an insulating liquid; 3) properties of PO as an insulating liquid; 4) thermal aging; 5) water content; 6) dissolved gas analysis; 7) selection of nanoparticles; 8) preparation of PO-based NFs; 9) characterization and stability of PO-based NFs; 10) analysis of electrical, physical, and chemical properties; and 11) current status of PO-based insulating liquid in Malaysia. This article highlights PO’s development, trends, and status and its NF as a liquid insulating alternative in transformers. The properties and performance of the liquid are also reported in this article. The promising results, shortcomings, and imbalances between PO and other types of natural ester oils are discussed, and suggestions are made for future work worth exploring.
- Open Access
- 1 June 2011
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 266, 154-159
DNA words based on an enhanced algorithm of multi-objective particle swarm optimization in a continuous search space
In this paper, particle swarm optimization algorithm in a continuous search space is implemented to generate a set of DNA words. A single swarm with 20 particles is used to find the best solution (gbest). Here, each particle has a number of sub-particles which is referred as the number of sequences to be designed. Overall, the particle which has the optimum fitness value is considered as the best solution. Fitness value of a particle is computed from the average value of all the applied objective functions. The solution obtained from this algorithm is found to be better as compared with other approaches. Furthermore, it has a fast convergence towards the optimum fitness value.
- 1 June 2011
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 266, 154-159
Open AccessDNA words based on an enhanced algorithm of multi-objective particle swarm optimization in a continuous search space
In this paper, particle swarm optimization algorithm in a continuous search space is implemented to generate a set of DNA words. A single swarm with 20 particles is used to find the best solution (gbest). Here, each particle has a number of sub-particles which is referred as the number of sequences to be designed. Overall, the particle which has the optimum fitness value is considered as the best solution. Fitness value of a particle is computed from the average value of all the applied objective functions. The solution obtained from this algorithm is found to be better as compared with other approaches. Furthermore, it has a fast convergence towards the optimum fitness value.