Dmitry Pashchenko
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Dmitry Pashchenko has a total of 36 co-authors. Here are the top co-authors by number of shared publications:
- Maxim Nikitin
Guangdong Technion–Israel Institute of Technology
5 shared publications - Viacheslav Papkov
Faculty of Mechanical Engineering, Technion—Israel Institute of Technology, Technion City 1 , Haifa 3200003
5 shared publications Igor Karpilov
4 shared publications- Igor Karpilov
Department of Industrial Engineering, Faculty of Thermal Engineering, Samara State Technical University, Samara, Russia
4 shared publications - Ravil Mustafin
Samara State Technical University
4 shared publications - H. M. Quinn
Department of Research and Development, the Wrangler Group LLC, 40 Nottinghill Rd. 1 , Boston, Massachusetts 02135
3 shared publications
Latest Publications
- Open Access
- 17 October 2026
- Published by Elsevier in Energy Conversion and Management
- Vol. 372
Combined cycle power plant with chemically recuperated high-temperature gas turbine: Thermal efficiency, energy and material balance via comparative analysis
- 17 October 2026
- Published by Elsevier in Energy Conversion and Management
- Vol. 372
Open AccessCombined cycle power plant with chemically recuperated high-temperature gas turbine: Thermal efficiency, energy and material balance via comparative analysis
- Open Access
- 24 September 2026
- Published by Elsevier in Progress in Energy and Combustion Science
- Vol. 118
Pre-combustion fuel reforming in gas turbines: Hydrocarbon and carbon-neutral fuel pathways
- 24 September 2026
- Published by Elsevier in Progress in Energy and Combustion Science
- Vol. 118
Open AccessPre-combustion fuel reforming in gas turbines: Hydrocarbon and carbon-neutral fuel pathways
- Open Access
Thermochemical pre-combustion fuel transformation as “exergy pump”: a case of ammonia for power generation
- 17 March 2026
- Published by American Physical Society (APS) in Physical Review Fluids
- Vol. 11 (3)
Residual-driven sensitivity analysis for pressure drop prediction in packed beds of spherical particles
- 17 March 2026
- Published by American Physical Society (APS) in Physical Review Fluids
- Vol. 11 (3)
Residual-driven sensitivity analysis for pressure drop prediction in packed beds of spherical particles
- Open Access
- 1 March 2026
- Published by AIP Publishing in Physics of Fluids
- Vol. 38 (3)
Influence of surface dimpling on pressure drop in a monolayer sphere configuration under confined flow conditions
This study investigates the influence of surface dimpling on pressure drop in a confined monolayer of spheres under low diameter-ratio conditions (Dtube/dsphere≈1.17). An integrated experimental and computational fluid dynamics approach is employed to analyze the hydraulic performance of smooth and dimpled spheres arranged in a single row within a horizontal pipe, across a range of inter-particle spacing ratios (δ/Dp=1.0–2.0) and superficial velocities (Us=2–16 m/s). Experimental results reveal that dimpled spheres consistently exhibit higher pressure drops than smooth spheres, with the relative increase quantified by the ratio Ψ=(ΔP/L)dimpled/(ΔP/L)smooth. This ratio shows a non-monotonic dependence on Us, reaching a minimum of approximately 1.02 near Us=9–10 m/s, and is systematically reduced by increasing δ/Dp. Normalization of pressure drop per particle (ΔP/Np) collapses data onto single power-law trends for each surface type, indicating that individual particle contributions are largely independent of packing density. The increased resistance for dimpled spheres is attributed to enhanced surface area, promoted flow separation, and earlier boundary layer transition. These findings demonstrate that surface texture significantly alters flow resistance in confined arrays, where wall effects and particle proximity dominate, offering insights for applications in filtration, catalytic beds, and narrow-channel flows.
- 1 March 2026
- Published by AIP Publishing in Physics of Fluids
- Vol. 38 (3)
Open AccessInfluence of surface dimpling on pressure drop in a monolayer sphere configuration under confined flow conditions
This study investigates the influence of surface dimpling on pressure drop in a confined monolayer of spheres under low diameter-ratio conditions (Dtube/dsphere≈1.17). An integrated experimental and computational fluid dynamics approach is employed to analyze the hydraulic performance of smooth and dimpled spheres arranged in a single row within a horizontal pipe, across a range of inter-particle spacing ratios (δ/Dp=1.0–2.0) and superficial velocities (Us=2–16 m/s). Experimental results reveal that dimpled spheres consistently exhibit higher pressure drops than smooth spheres, with the relative increase quantified by the ratio Ψ=(ΔP/L)dimpled/(ΔP/L)smooth. This ratio shows a non-monotonic dependence on Us, reaching a minimum of approximately 1.02 near Us=9–10 m/s, and is systematically reduced by increasing δ/Dp. Normalization of pressure drop per particle (ΔP/Np) collapses data onto single power-law trends for each surface type, indicating that individual particle contributions are largely independent of packing density. The increased resistance for dimpled spheres is attributed to enhanced surface area, promoted flow separation, and earlier boundary layer transition. These findings demonstrate that surface texture significantly alters flow resistance in confined arrays, where wall effects and particle proximity dominate, offering insights for applications in filtration, catalytic beds, and narrow-channel flows.
- Open Access
- 1 January 2026
- Published by AIP Publishing in Physics of Fluids
- Vol. 38 (1)
A new semi-empirical model for pressure drop prediction in a packed bed of smooth and rough particles: Derivation and verification
The accurate prediction of pressure drop in packed beds is fundamental to numerous chemical, mechanical, and environmental engineering applications. While traditional models such as the Ergun equation and Reynolds number-based correlations have been widely employed, they suffer from inherent limitations and lack a unified framework bridging packed beds and empty conduits. This paper presents a comprehensive derivation of the Quinn Fluid Flow Model (QFFM), a novel theoretical framework developed from first principles. The QFFM establishes a universal linear relationship between the normalized dimensionless pressure gradient (PQ) and the fluid current (CQ), expressed as PQ=k1+k2CQ. A key innovation is the conceptualization of any closed conduit as a “packed conduit” via the Hypothetical Q-Channel (HQC) and the wall normalization coefficient (λ), which inherently incorporates the effects of tortuosity, viscous boundary layers, and surface roughness. By unifying the description of flow through packed beds, the new semi-empirical model offers a robust, physics-based alternative to conventional semi-empirical correlations, validated across diverse flow regimes and particle morphologies.
- 1 January 2026
- Published by AIP Publishing in Physics of Fluids
- Vol. 38 (1)
Open AccessA new semi-empirical model for pressure drop prediction in a packed bed of smooth and rough particles: Derivation and verification
The accurate prediction of pressure drop in packed beds is fundamental to numerous chemical, mechanical, and environmental engineering applications. While traditional models such as the Ergun equation and Reynolds number-based correlations have been widely employed, they suffer from inherent limitations and lack a unified framework bridging packed beds and empty conduits. This paper presents a comprehensive derivation of the Quinn Fluid Flow Model (QFFM), a novel theoretical framework developed from first principles. The QFFM establishes a universal linear relationship between the normalized dimensionless pressure gradient (PQ) and the fluid current (CQ), expressed as PQ=k1+k2CQ. A key innovation is the conceptualization of any closed conduit as a “packed conduit” via the Hypothetical Q-Channel (HQC) and the wall normalization coefficient (λ), which inherently incorporates the effects of tortuosity, viscous boundary layers, and surface roughness. By unifying the description of flow through packed beds, the new semi-empirical model offers a robust, physics-based alternative to conventional semi-empirical correlations, validated across diverse flow regimes and particle morphologies.
- Open Access
- 4 November 2025
- Published by Elsevier in International Communications in Heat and Mass Transfer
- Vol. 170
A numerical study of intra-catalyst diffusion limitations in small-scale ammonia plate reformer
- 4 November 2025
- Published by Elsevier in International Communications in Heat and Mass Transfer
- Vol. 170
Open AccessA numerical study of intra-catalyst diffusion limitations in small-scale ammonia plate reformer