Fuyang Liu
Fuyang Liu has a total of 17 co-authors. Here are the top co-authors by number of shared publications:
- Bin Yang
Center for High Pressure Science and Technology Advanced Research 3 , Beijing 100094
1 shared publication Bing Li
Ctr High Pressure Sci & Technol Adv Res, Changchun 130012, Peoples R China
1 shared publication- Dong Han
State Key Laboratory of Luminescence and Applications, Changchun Institute of Optics, Fine Mechanics and Physics, Chinese Academy of Sciences, Changchun 130033, China
1 shared publication - Dongzhou Zhang
Center for Advanced Radiation Sources The University of Chicago Chicago IL USA
1 shared publication - Haozhe Liu
Center for High Pressure Science and Technology Advanced Research
1 shared publication Kai Hu
School of Physics and Electronics, Hunan University, Changsha 410082, China
1 shared publication
Latest Publications
- 11 January 2023
- Published by Elsevier in Journal of Rare Earths
- Vol. 41 (12) , 1990-1995
Ferroelectricity induced by non-symmetry of A-site cations in hexagonal antiferromagnetic In1–Yb FeO3 (x = 0.1, 0.2, 0.3) perovskites
- 11 January 2023
- Published by Elsevier in Journal of Rare Earths
- Vol. 41 (12) , 1990-1995
Ferroelectricity induced by non-symmetry of A-site cations in hexagonal antiferromagnetic In1–Yb FeO3 (x = 0.1, 0.2, 0.3) perovskites
- Open Access
- 1 February 2022
- Published by International Union of Crystallography (IUCr) in IUCrJ
- Vol. 9 (2) , 253-260
Negative linear compressibility in Se at ultra-high pressure above 120 GPa
A series of in situ synchrotron X-ray diffraction (XRD) measurements were carried out, combined with first-principles calculations, to study structural phase transitions of selenium at high pressures and room temperature. Several phase transitions were observed, among which an isostructural phase transition was found at around 120 GPa for the first time. Evolved from the rhombohedral (space group R 3 m) structure (Se-V), the new phase (Se-V′) exhibited an interesting increase of lattice parameter a at pressures from 120 to 148 GPa, known as negative linear compressibility (NLC). The discovery of NLC behavior observed in this work is mainly attributed to the accuracy and fine steps controlled by the membrane system for in situ XRD data collected with an exposure time of 0.5 s. After 140 GPa, a body-centered cubic (b.c.c.) structure Se-VI (space group Im 3 m) was formed, which remains stable up to 210 GPa, the highest pressure achieved in this study. The bulk moduli of phases Se-V, Se-V′ and Se-VI were estimated to be 83 ± 2, 321 ± 2 and 266 ± 7 GPa, respectively, according to the P–V curve fit by the third-order Birch–Murnaghan equation of state. The Se-V′ phase shows a bulk modulus almost 4 times larger than that of the Se-V phase, which is mainly due to the effect of its NLC. NLC in a higher pressure range is always more significant in terms of fundamental mechanism and new materials discovery, yet it has barely been reported at pressures above 100 GPa. This will hopefully inspire future studies on potential NLC behaviors in other materials at ultra-high pressure.
- 1 February 2022
- Published by International Union of Crystallography (IUCr) in IUCrJ
- Vol. 9 (2) , 253-260
Open AccessNegative linear compressibility in Se at ultra-high pressure above 120 GPa
A series of in situ synchrotron X-ray diffraction (XRD) measurements were carried out, combined with first-principles calculations, to study structural phase transitions of selenium at high pressures and room temperature. Several phase transitions were observed, among which an isostructural phase transition was found at around 120 GPa for the first time. Evolved from the rhombohedral (space group R 3 m) structure (Se-V), the new phase (Se-V′) exhibited an interesting increase of lattice parameter a at pressures from 120 to 148 GPa, known as negative linear compressibility (NLC). The discovery of NLC behavior observed in this work is mainly attributed to the accuracy and fine steps controlled by the membrane system for in situ XRD data collected with an exposure time of 0.5 s. After 140 GPa, a body-centered cubic (b.c.c.) structure Se-VI (space group Im 3 m) was formed, which remains stable up to 210 GPa, the highest pressure achieved in this study. The bulk moduli of phases Se-V, Se-V′ and Se-VI were estimated to be 83 ± 2, 321 ± 2 and 266 ± 7 GPa, respectively, according to the P–V curve fit by the third-order Birch–Murnaghan equation of state. The Se-V′ phase shows a bulk modulus almost 4 times larger than that of the Se-V phase, which is mainly due to the effect of its NLC. NLC in a higher pressure range is always more significant in terms of fundamental mechanism and new materials discovery, yet it has barely been reported at pressures above 100 GPa. This will hopefully inspire future studies on potential NLC behaviors in other materials at ultra-high pressure.
- 23 September 2021
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry Letters
- Vol. 12 (39) , 9422-9428
From Two-, One-, to Zero-Dimensional Vacancies: A Densification Pattern for a Typcial Transition-Metal Dichalcogenide of TiSe2
In the areas of condensed matter physics, geoscience, material science, and inorganic chemistry, how the crystal structures evolve under an external field such as high-pressure is a fundamental question. By taking TiSe2 as the case, we investigate the phase transformations of the layered transition-metal dichalcogenides (TMDs) under high-pressure. The ambient 6-fold P-3m1 TiSe2 undergoes a transformation into the monoclinic 8-fold coordinated C2/m phase at 15 GPa and then into the hexagonal 9-fold Fe2P-type structure at 34 GPa. The above phase transitions can be unitedly described as the evolution of the vacancies: from a layered structure with two-dimensional (2D) vacancies to the structure with one-dimensional (1D) and zero-dimensional (0D) vacancies. The proposed densification model of TiSe2 reveals the processes how the symmetry breaking phase of spatial chemical bonding restores the symmetry under the isotropic external pressure.
- 23 September 2021
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry Letters
- Vol. 12 (39) , 9422-9428
From Two-, One-, to Zero-Dimensional Vacancies: A Densification Pattern for a Typcial Transition-Metal Dichalcogenide of TiSe2
In the areas of condensed matter physics, geoscience, material science, and inorganic chemistry, how the crystal structures evolve under an external field such as high-pressure is a fundamental question. By taking TiSe2 as the case, we investigate the phase transformations of the layered transition-metal dichalcogenides (TMDs) under high-pressure. The ambient 6-fold P-3m1 TiSe2 undergoes a transformation into the monoclinic 8-fold coordinated C2/m phase at 15 GPa and then into the hexagonal 9-fold Fe2P-type structure at 34 GPa. The above phase transitions can be unitedly described as the evolution of the vacancies: from a layered structure with two-dimensional (2D) vacancies to the structure with one-dimensional (1D) and zero-dimensional (0D) vacancies. The proposed densification model of TiSe2 reveals the processes how the symmetry breaking phase of spatial chemical bonding restores the symmetry under the isotropic external pressure.