Eckhard Karden
Eckhard Karden has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Rik W. De Doncker
Institute for Power Generation and Storage Systems, E.ON Energy Research Center, RWTH Aachen University, Aachen, Germany
2 shared publications - Abderrezak Hammouche
Institute for Power Electronics and Electrical Drives, Aachen University of Technology, Jägerstrasse 17-19, D-52066 Aachen, Germany
1 shared publication - Begüm Bozkaya
Fraunhofer R&D Center Electromobility Fraunhofer Institute for Silicate Research ISC 97082 Würzburg Germany
1 shared publication - Guinevere A. Giffin
Fraunhofer Institute for Silicate Research ISC Neunerplatz 2 97082 Würzburg Germany
1 shared publication - Jochen Settelein
Fraunhofer Institute for Silicate Research ISC, Neunerplatz 2, 97082 Würzburg, Germany
1 shared publication - Julia Kowal
Electrical Energy Storage Technology, Technische Universität Berlin, Einsteinufer 11, 10587 Berlin, Germany
1 shared publication
Latest Publications
- Open Access
- 25 January 2022
- Published by Wiley in Energy Technology
- Vol. 10 (4)
Comparison of Dynamic Charge Acceptance Tests on Lead–Acid Cells for Carbon Additive Screening
Including a certain amount of carbon in the negative active material is currently the state‐of‐the‐art method to improve the dynamic charge acceptance (DCA) of lead–acid batteries. The DCA is a key parameter of batteries used in microhybrid cars where brake energy recuperation is implemented. To find the optimal carbon additive, it is essential to test the carbon both in short‐term and long‐term tests. This work investigates the long‐term and short‐term DCA of 2 V, 2.5 Ah lead–acid cells and correlates the results with the external surface area of the carbon. Five different carbons with tailored particle size (27–633 nm) and external surface area (7.1–159.3 m2 g−1) are employed as additives in the negative electrodes. The charge acceptance of cells according to the charge acceptance test 2 (SBA), the DCA (EN) test, and the run‐in DCA test (Ford) is increased via an increase in the carbon external surface area. A correlation between the short‐term tests and the first week of the run‐in DCA test is established for the carbon impact. After several weeks of run‐in DCA test, the carbon effect is diminished and only a differentiation between high and low DCA cells is possible.
- 25 January 2022
- Published by Wiley in Energy Technology
- Vol. 10 (4)
Open AccessComparison of Dynamic Charge Acceptance Tests on Lead–Acid Cells for Carbon Additive Screening
Including a certain amount of carbon in the negative active material is currently the state‐of‐the‐art method to improve the dynamic charge acceptance (DCA) of lead–acid batteries. The DCA is a key parameter of batteries used in microhybrid cars where brake energy recuperation is implemented. To find the optimal carbon additive, it is essential to test the carbon both in short‐term and long‐term tests. This work investigates the long‐term and short‐term DCA of 2 V, 2.5 Ah lead–acid cells and correlates the results with the external surface area of the carbon. Five different carbons with tailored particle size (27–633 nm) and external surface area (7.1–159.3 m2 g−1) are employed as additives in the negative electrodes. The charge acceptance of cells according to the charge acceptance test 2 (SBA), the DCA (EN) test, and the run‐in DCA test (Ford) is increased via an increase in the carbon external surface area. A correlation between the short‐term tests and the first week of the run‐in DCA test is established for the carbon impact. After several weeks of run‐in DCA test, the carbon effect is diminished and only a differentiation between high and low DCA cells is possible.
- 14 March 2005
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Industry Applications Magazine
- Vol. 11 (2) , 62-67
Supercapacitors and lithium-ion batteries for power electronic applications
This article employs the method of electrochemical impedance spectroscopy (EIS) to extend the physics-based, nonlinear equivalent circuit models of supercapacitors (SCs) to describe lithium-ion batteries (Li-ion). The following section briefly introduces the method of electrochemical impedance spectroscopy and presents measured impedance spectra. From these spectra, appropriate equivalent-circuit models are deduced. After this, the MATLAB/Simulink implementation of the new simulation models is discussed, and simulation results, as well as verification measurements, are provided. Finally, conclusions are drawn, and future perspectives of the new impedance-based modeling approach are outlined.
- 14 March 2005
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Industry Applications Magazine
- Vol. 11 (2) , 62-67
Supercapacitors and lithium-ion batteries for power electronic applications
This article employs the method of electrochemical impedance spectroscopy (EIS) to extend the physics-based, nonlinear equivalent circuit models of supercapacitors (SCs) to describe lithium-ion batteries (Li-ion). The following section briefly introduces the method of electrochemical impedance spectroscopy and presents measured impedance spectra. From these spectra, appropriate equivalent-circuit models are deduced. After this, the MATLAB/Simulink implementation of the new simulation models is discussed, and simulation results, as well as verification measurements, are provided. Finally, conclusions are drawn, and future perspectives of the new impedance-based modeling approach are outlined.
- 1 June 2001
- Published by Elsevier in Journal of Power Sources
- Vol. 96 (1) , 106-112
On the impedance of the gassing reactions in lead-acid batteries
- 1 June 2001
- Published by Elsevier in Journal of Power Sources
- Vol. 96 (1) , 106-112
On the impedance of the gassing reactions in lead-acid batteries