YDYudong Dang

Yudong Dang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Yudong Dang has a total of 12 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Rheology-Driven Quantification and Mechanistic Insight into Binder-Filler Interactions in Asphalt Mastics Incorporating Raw and Calcined Oyster Shell Powders

    by Ruihai Wang, Xiang Liu, Yudong Dang, Xiaolong Li, Jie Chen

    Waste oyster shell powder (OP) and calcined oyster shell powder (COP) were used as bio-fillers in asphalt mastics. Limestone powder (LP) served as the control. This study employed rheological theory to quantify filler–asphalt interactions. Dynamic shear rheometry (DSR), Black diagrams, and master curves were analyzed to determine critical volume fraction (φcrit), interaction parameter (C), and complex viscosity increment (∆η*). Results indicate that OP mastics exhibit the lowest φcrit (0.510) and highest C value (1.133), demonstrating the strongest interfacial interaction. COP shows intermediate interaction strength (φcrit = 0.542), yet both OP and COP outperform LP (φcrit = 0.617) in high-temperature deformation resistance within the 0.23–0.53 filler volume fraction range, evidenced by superior complex shear modulus (G*) master curves and pronounced ∆η* increases. Grey relational analysis identifies specific surface area and CaCO3 content as governing factors. Optical microscopy and FTIR confirm that filler–asphalt interactions are dominated by physical adsorption without chemical bond formation. These findings elucidate the performance advantages of both raw and calcined oyster shell powders and provide a theoretical basis for their application as sustainable high-performance bio-fillers in asphalt pavements.

  • Open Access

    An Experimental Investigation on the Effects of Limestone Fines in Manufactured Sands on the Performance of Magnesia Ammonium Phosphate Mortar

    by Wenting Mao, Chunpeng Cao, Xincheng Li, Jueshi Qian, Yudong Dang

    Magnesium ammonium phosphate cement (MAPC) prepared with ammonium dihydrogen phosphate (NH4H2PO4, ADP) and dead-burned Magnesium oxide (MgO) is a new type of rapid patch repair material for concrete structures. In order to reduce the material costs of MAPC mortar, manufactured limestone sands, being a more widely-available resource with lower cost, was investigated in this study as an alternative to quartz sands for the preparation of MAPC mortar. The limestone fines in manufactured sands were found to be the key factor that influences properties of MAPC mortar by causing bubbling and volume expansion before hardening. As a result, the mechanical strength of MAPC mortar decreased with the increasing content of limestone fines due to increased porosity. According to microstructure analysis, the mechanism of these negative effects can be inferred as the reaction between limestone fines and ADP with the gas generation of CO2 and NH3. This reaction mainly occurred during a short period before setting while most limestone fines remained unreactive in the hardened MAPC mortar. Based on the above detailed experimental findings on the effects of limestone fines in manufactured sand on the properties of MAPC mortar, this paper pointed out that effective defoaming methods for inhibiting bubbling was the key to the utilization of manufactured sands in preparation of high performance MAPC mortar.