Agung Iswandi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Agung Iswandi has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Basori Basori
Universitas Nasional, Indonesia
1 shared publication - Ferry Budhi Susetyo
Universitas Negeri Jakarta, Indonesia
1 shared publication - Gadang Priyotomo
National Research and Innovation Agency
1 shared publication - Joanne S. Porter
International Centre for Island Technology, Heriot-Watt University, Stromness, UK
1 shared publication - Leuserina Garniati
International Centre for Island Technology, Heriot-Watt University, Orkney Campus, Stromness KW16 3AN, UK
1 shared publication - Maman Kartaman Ajiriyanto
Research Center for Nuclear Material and Radioactive Waste Technology – National Research and Innovation Agency
1 shared publication
Latest Publications
- Open Access
- 19 March 2023
- Published by International Association of Physical Chemists (IAPC) in Journal of Electrochemical Science and Engineering
- Vol. 13 (3) , 451-467
Effect of KOH concentration on corrosion behavior and surface morphology of stainless steel 316L for HHO generator application
Hydrogen production could be enhanced by increasing the potassium hydroxide (KOH) concentration, but higher KOH concentrations result in higher corrosion rates. Therefore, a deep investigation of the electrochemical behavior of stainless steel (SS 316L) in the KOH solution is needed. This study investigates the influence of KOH concentrations on the electrochemical behavior, surface morphology, structure, and sample phases of SS 316L. The investigations were conducted by some electrochemical techniques, UV-vis, scanning electron microscopy-energy dispersive spectroscopy (SEM-EDS), and X-ray diffraction (XRD). The corrosion rate was found to increase, and solution resistance to decrease with increasing KOH concentration. Samples tested in 5, 30, and 50 g l-1 of KOH showed corrosion rates of 0.457, 2.362, and 5.613 µm year-1, respectively. A wide passive region and the noblest pitting potential were noticed for the sample with 5 g l-1 of KOH. Moreover, Mott-Schottky plots and characteristic wavelengths of UV-Vis suggest the formation of iron and chromium oxides by the passivation of samples. The SEM analysis showed a dynamic change of surface morphology from the lowest to the highest concentration with the intergranular corrosion found at the grain boundaries area. In conclusion, concentrations < 50 g l-1 KOH could be recommended since they would support the optimum remaining life of SS 316 L plates in HHO generators.
- 19 March 2023
- Published by International Association of Physical Chemists (IAPC) in Journal of Electrochemical Science and Engineering
- Vol. 13 (3) , 451-467
Open AccessEffect of KOH concentration on corrosion behavior and surface morphology of stainless steel 316L for HHO generator application
Hydrogen production could be enhanced by increasing the potassium hydroxide (KOH) concentration, but higher KOH concentrations result in higher corrosion rates. Therefore, a deep investigation of the electrochemical behavior of stainless steel (SS 316L) in the KOH solution is needed. This study investigates the influence of KOH concentrations on the electrochemical behavior, surface morphology, structure, and sample phases of SS 316L. The investigations were conducted by some electrochemical techniques, UV-vis, scanning electron microscopy-energy dispersive spectroscopy (SEM-EDS), and X-ray diffraction (XRD). The corrosion rate was found to increase, and solution resistance to decrease with increasing KOH concentration. Samples tested in 5, 30, and 50 g l-1 of KOH showed corrosion rates of 0.457, 2.362, and 5.613 µm year-1, respectively. A wide passive region and the noblest pitting potential were noticed for the sample with 5 g l-1 of KOH. Moreover, Mott-Schottky plots and characteristic wavelengths of UV-Vis suggest the formation of iron and chromium oxides by the passivation of samples. The SEM analysis showed a dynamic change of surface morphology from the lowest to the highest concentration with the intergranular corrosion found at the grain boundaries area. In conclusion, concentrations < 50 g l-1 KOH could be recommended since they would support the optimum remaining life of SS 316 L plates in HHO generators.
- Open Access
- 8 March 2022
- Published by MDPI AG in Journal of Marine Science and Engineering
- Vol. 10 (3) , 384
Establishing an Agenda for Biofouling Research for the Development of the Marine Renewable Energy Industry in Indonesia
Marine renewable energy holds strategic potential in Indonesia, not only to meet the target of renewable energy share in the national energy mix but also to provide equal access to clean energy throughout the archipelago. Marine energy in Indonesia is still in the early phase of development, which mainly focusses on resources assessment and power generation through technology prototype testing. Based on a review of available literature, it is found that specific research on the effects of biofouling on material durability of marine energy infrastructure in Indonesia has yet to be addressed. In this study, a matrix that identifies and predicts key fouling organisms and their possible risks on marine renewable energy infrastructure in tropical waters of Indonesia is developed by analysing previous findings in temperate and subtropical waters. Based on the matrix developed, calcareous polychaetes (Serpulidae), barnacles (Amphibalanus spp.), and bivalves (Perna viridis) are among possible key fouling organisms that might pose risks to marine energy infrastructure in Indonesia, such as by adding weight and drag and causing corrosion. Further studies and detailed and statistically robust analysis of the biofouling and its impacts are needed to support the development of the technological performance of marine renewable energy in Indonesia.
- 8 March 2022
- Published by MDPI AG in Journal of Marine Science and Engineering
- Vol. 10 (3) , 384
Open AccessEstablishing an Agenda for Biofouling Research for the Development of the Marine Renewable Energy Industry in Indonesia
Marine renewable energy holds strategic potential in Indonesia, not only to meet the target of renewable energy share in the national energy mix but also to provide equal access to clean energy throughout the archipelago. Marine energy in Indonesia is still in the early phase of development, which mainly focusses on resources assessment and power generation through technology prototype testing. Based on a review of available literature, it is found that specific research on the effects of biofouling on material durability of marine energy infrastructure in Indonesia has yet to be addressed. In this study, a matrix that identifies and predicts key fouling organisms and their possible risks on marine renewable energy infrastructure in tropical waters of Indonesia is developed by analysing previous findings in temperate and subtropical waters. Based on the matrix developed, calcareous polychaetes (Serpulidae), barnacles (Amphibalanus spp.), and bivalves (Perna viridis) are among possible key fouling organisms that might pose risks to marine energy infrastructure in Indonesia, such as by adding weight and drag and causing corrosion. Further studies and detailed and statistically robust analysis of the biofouling and its impacts are needed to support the development of the technological performance of marine renewable energy in Indonesia.