Gia M. Carignan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Gia M. Carignan has a total of 39 co-authors. Here are the top co-authors by number of shared publications:
- Jing Li
Department of Chemistry and Chemical Biology, Rutgers University, Piscataway, New Jersey 08854, USA
6 shared publications Andrew Wu
School of Natural Sciences and Mathematics, Stockton University, Galloway, USA
2 shared publicationsLe Hong Nguyen
Department of Chemistry and Chemical Biology, Rutgers University, Piscataway, New Jersey 08854, USA
2 shared publicationsMatthias Zeller
Department of Chemistry, Purdue University, West Lafayette, Indiana, 47907, USA
2 shared publications- Patrick C. Hillesheim
Illinois State University
2 shared publications - Simon J. Teat
Advanced Light Source, Lawrence Berkeley National Laboratory, Berkeley, CA, 94720, USA
2 shared publications
Latest Publications
- Open Access
- 22 October 2026
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry C
- Vol. 14 (40) , 19404-19413
Scaled synthesis, thin-film fabrication and photophysical characterization of a highly luminescent green-emitting hybrid Cu( i ) iodide
A strongly luminescent all-in-one (AIO) type hybrid copper ( i ) iodide has been thoroughly characterized and studied for possible use as phosphor and solution-processable green-emissive material.
- 22 October 2026
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry C
- Vol. 14 (40) , 19404-19413
Open AccessScaled synthesis, thin-film fabrication and photophysical characterization of a highly luminescent green-emitting hybrid Cu( i ) iodide
A strongly luminescent all-in-one (AIO) type hybrid copper ( i ) iodide has been thoroughly characterized and studied for possible use as phosphor and solution-processable green-emissive material.
- Open Access
- 9 September 2025
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry C
- Vol. 13 (40) , 20580-20588
Maximizing sunlight absorption in narrow bandgap semiconducting copper( i ) iodides for enhanced photocatalytic dye degradation
Utilizing their photocatalytic activity and strong sunlight absorption capability, narrow band gap CuI-based hybrid semiconductors are highly efficient in breaking down dyes and pigments into safer, simpler molecules.
- 9 September 2025
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry C
- Vol. 13 (40) , 20580-20588
Open AccessMaximizing sunlight absorption in narrow bandgap semiconducting copper( i ) iodides for enhanced photocatalytic dye degradation
Utilizing their photocatalytic activity and strong sunlight absorption capability, narrow band gap CuI-based hybrid semiconductors are highly efficient in breaking down dyes and pigments into safer, simpler molecules.
- 4 June 2025
- Published by Royal Society of Chemistry (RSC) in Chemical Communications
- Vol. 61 (55) , 10170-10173
Aggregation-induced emission-active indium complex as fluorescent turn-off chemosensor for perfluoroalkyl substances
AIE-active indium (iii) chloride complex was developed as a selective fluorescent turn-off chemosensor for detecting perfluoroalkyl substances (PFAS).
- 4 June 2025
- Published by Royal Society of Chemistry (RSC) in Chemical Communications
- Vol. 61 (55) , 10170-10173
Aggregation-induced emission-active indium complex as fluorescent turn-off chemosensor for perfluoroalkyl substances
AIE-active indium (iii) chloride complex was developed as a selective fluorescent turn-off chemosensor for detecting perfluoroalkyl substances (PFAS).
- 13 November 2024
- Published by American Chemical Society (ACS) in Chemistry of Materials
- Vol. 36 (22) , 11139-11149
Narrow Band Gap Hybrid Copper(I)Iodides: Designer Materials for Optoelectronic Applications
- 13 November 2024
- Published by American Chemical Society (ACS) in Chemistry of Materials
- Vol. 36 (22) , 11139-11149
Narrow Band Gap Hybrid Copper(I)Iodides: Designer Materials for Optoelectronic Applications
- Open Access
- 28 May 2024
- Published by American Chemical Society (ACS) in ChemRxiv
Nanospike Nickel-Iron Oxalate as an Efficient Electrocatalyst for the Oxygen Evolution Reaction
Obtaining hydrogen as a renewable fuel through water splitting is severely hindered by the energy-intensive oxygen evolution reaction (OER). Transition metal oxides based on low-cost and earth-abundant elements have been shown to provide high OER rivaling that of commercial IrO2, with nickel iron oxide/oxyhydroxide systems exhibiting some of the lowest reported overpotentials. Here, we report a nickel-iron oxalate material with a nanospike morphology synthesized via a simple and novel hydrothermal method, in which oxalate is generated in situ during material preparation under mild conditions. The as-synthesized nanostructured material displays high catalytic activity for OER, requiring a low overpotential of only 284 mV at a current density of 10 mA·cm−2, lower than that of its amorphous counterpart and commercial IrO2 (326 and 308 mV, respectively). This material also exhibits excellent long-term stability with retention of the nanospike morphology after several hours under OER conditions.
- 28 May 2024
- Published by American Chemical Society (ACS) in ChemRxiv
Open AccessNanospike Nickel-Iron Oxalate as an Efficient Electrocatalyst for the Oxygen Evolution Reaction
Obtaining hydrogen as a renewable fuel through water splitting is severely hindered by the energy-intensive oxygen evolution reaction (OER). Transition metal oxides based on low-cost and earth-abundant elements have been shown to provide high OER rivaling that of commercial IrO2, with nickel iron oxide/oxyhydroxide systems exhibiting some of the lowest reported overpotentials. Here, we report a nickel-iron oxalate material with a nanospike morphology synthesized via a simple and novel hydrothermal method, in which oxalate is generated in situ during material preparation under mild conditions. The as-synthesized nanostructured material displays high catalytic activity for OER, requiring a low overpotential of only 284 mV at a current density of 10 mA·cm−2, lower than that of its amorphous counterpart and commercial IrO2 (326 and 308 mV, respectively). This material also exhibits excellent long-term stability with retention of the nanospike morphology after several hours under OER conditions.
- 28 March 2024
- Published by Royal Society of Chemistry (RSC) in Dalton Transactions
- Vol. 53 (16) , 6932-6940
New type of tin(iv) complex based turn-on fluorescent chemosensor for fluoride ion recognition: elucidating the effect of molecular structure on sensing property
A new type of turn-on fluorescent chemosensor for F− based on tin(iv) complexes was investigated to understand the effect of molecular structure on sensing properties.
- 28 March 2024
- Published by Royal Society of Chemistry (RSC) in Dalton Transactions
- Vol. 53 (16) , 6932-6940
New type of tin(iv) complex based turn-on fluorescent chemosensor for fluoride ion recognition: elucidating the effect of molecular structure on sensing property
A new type of turn-on fluorescent chemosensor for F− based on tin(iv) complexes was investigated to understand the effect of molecular structure on sensing properties.
- 26 August 2023
- Published by Royal Society of Chemistry (RSC) in Chemical Communications
- Vol. 59 (76) , 11413-11416
Fast and reversible solvent-vapor-induced 1D to 2D transformation in emissive Ag( i )-organic networks
Unprecedently fast and reversible solvent-vapour-induced 1D to 2D transformation of Ag( i )-organic frameworks is reported. The interconvertible frameworks exhibit an outstandingly bright cyan and blue room temperature phosphorescence.
- 26 August 2023
- Published by Royal Society of Chemistry (RSC) in Chemical Communications
- Vol. 59 (76) , 11413-11416
Fast and reversible solvent-vapor-induced 1D to 2D transformation in emissive Ag( i )-organic networks
Unprecedently fast and reversible solvent-vapour-induced 1D to 2D transformation of Ag( i )-organic frameworks is reported. The interconvertible frameworks exhibit an outstandingly bright cyan and blue room temperature phosphorescence.
- 1 February 2022
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 169 (2) , 020571
Operando Synchrotron Studies of Inhomogeneity during Anode-Free Plating of Li Metal in Pouch Cell Batteries
Operando synchrotron X-ray diffraction (XRD) studies have not previously been used to directly characterize Li metal in standard batteries due to the extremely weak scattering from Li atoms. In this work, it is demonstrated the stripping and plating of Li metal can be effectively quantified during battery cycling in appropriately designed synchrotron XRD experiments that utilize an anode-free battery configuration in which a Li-containing cathode material of LiNi 0.6 Mn 0.2 Co 0.2 O 2 (NMC622) is paired with a bare anode current collector consisting of either Cu metal (Cu/NMC) or Mo metal (Mo/NMC). In this configuration, it is possible to probe local variations in the deposition and stripping of Li metal with sufficient spatial sensitivity to map the inhomogeneity in pouch cells and to follow these processes with sufficient time resolution to track state-of-charge-dependent variations in the rate of Li usage at a single point. For the Cu/NMC and Mo/NMC batteries, it was observed that the initial plating of Li occurred in a very homogeneous manner but that severe macroscopic inhomogeneity arose on a mm-scale during the subsequent stripping of Li, contrasting with the conventional wisdom that the greatest challenges in Li metal batteries are associated with Li deposition.
- 1 February 2022
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 169 (2) , 020571
Operando Synchrotron Studies of Inhomogeneity during Anode-Free Plating of Li Metal in Pouch Cell Batteries
Operando synchrotron X-ray diffraction (XRD) studies have not previously been used to directly characterize Li metal in standard batteries due to the extremely weak scattering from Li atoms. In this work, it is demonstrated the stripping and plating of Li metal can be effectively quantified during battery cycling in appropriately designed synchrotron XRD experiments that utilize an anode-free battery configuration in which a Li-containing cathode material of LiNi 0.6 Mn 0.2 Co 0.2 O 2 (NMC622) is paired with a bare anode current collector consisting of either Cu metal (Cu/NMC) or Mo metal (Mo/NMC). In this configuration, it is possible to probe local variations in the deposition and stripping of Li metal with sufficient spatial sensitivity to map the inhomogeneity in pouch cells and to follow these processes with sufficient time resolution to track state-of-charge-dependent variations in the rate of Li usage at a single point. For the Cu/NMC and Mo/NMC batteries, it was observed that the initial plating of Li occurred in a very homogeneous manner but that severe macroscopic inhomogeneity arose on a mm-scale during the subsequent stripping of Li, contrasting with the conventional wisdom that the greatest challenges in Li metal batteries are associated with Li deposition.