Chil-Hoon Doh
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Chil-Hoon Doh has a total of 98 co-authors. Here are the top co-authors by number of shared publications:
Seong-In Moon
Korea Electrotechnology Research Institute, Changwon 641 600, Republic of Korea
7 shared publicationsAdnan Yaqub
Korea Electro-Technology Research Institute (KERI)
5 shared publicationsBong-Soo Jin
Korea Electrotechnology Research Institute, Changwon 641 600, Republic of Korea
5 shared publicationsDoohun Kim
Korea Electro-Technology Research Institute (KERI)
5 shared publications- Jeong-Hee Choi
Battery Research Division Korea Electrotechnology Research Institute (KERI) Changwon‐si Gyeongsangnam‐do Republic of Korea
5 shared publications Mun-Soo Yun
5 shared publications
Latest Publications
- 16 October 2024
- Published by Elsevier in eTransportation
- Vol. 22
Microstructure-based digital twin thermo-electrochemical modeling of LIBs at the cell-to-module scale
- 16 October 2024
- Published by Elsevier in eTransportation
- Vol. 22
Microstructure-based digital twin thermo-electrochemical modeling of LIBs at the cell-to-module scale
- Open Access
- 31 August 2022
- Published by The Korean Electrochemical Society - English Journal in Journal of Electrochemical Science and Technology
- Vol. 13 (3) , 323-338
Experiment and Electro-Thermo-Chemical Modeling on Rapid Resistive Discharge of Large-Capacity Lithium Ion Battery
- 31 August 2022
- Published by The Korean Electrochemical Society - English Journal in Journal of Electrochemical Science and Technology
- Vol. 13 (3) , 323-338
Open AccessExperiment and Electro-Thermo-Chemical Modeling on Rapid Resistive Discharge of Large-Capacity Lithium Ion Battery
- Open Access
Design of an Effective State of Charge Estimation Method for a Lithium-Ion Battery Pack Using Extended Kalman Filter and Artificial Neural Network
Currently, Lithium-ion batteries (LiB) are widely applied in energy storage devices in smart grids and electric vehicles. The state of charge (SOC) is an indication of the available battery capacity, and is one of the most important factors that should be monitored to optimize LiB’s performance and improve its lifetime. However, because the SOC relies on many nonlinear factors, it is difficult to estimate accurately. This paper presented the design of an effective SOC estimation method for a LiB pack Battery Management System (BMS) based on Kalman Filter (KF) and Artificial Neural Network (ANN). First, considering the configuration and specifications of the BMS and LiB pack, an ANN was constructed for the SOC estimation, and then the ANN was trained and tested using the Google TensorFlow open-source library. An SOC estimation model based on the extended KF (EKF) and a Thevenin battery model was developed. Then, we proposed a combined mode EKF-ANN that integrates the estimation of the EKF into the ANN. Both methods were evaluated through experiments conducted on a real LiB pack. As a result, the ANN and KF methods showed maximum errors of 2.6% and 2.8%, but the EKF-ANN method showed better performance with less than 1% error.
Open AccessDesign of an Effective State of Charge Estimation Method for a Lithium-Ion Battery Pack Using Extended Kalman Filter and Artificial Neural Network
Currently, Lithium-ion batteries (LiB) are widely applied in energy storage devices in smart grids and electric vehicles. The state of charge (SOC) is an indication of the available battery capacity, and is one of the most important factors that should be monitored to optimize LiB’s performance and improve its lifetime. However, because the SOC relies on many nonlinear factors, it is difficult to estimate accurately. This paper presented the design of an effective SOC estimation method for a LiB pack Battery Management System (BMS) based on Kalman Filter (KF) and Artificial Neural Network (ANN). First, considering the configuration and specifications of the BMS and LiB pack, an ANN was constructed for the SOC estimation, and then the ANN was trained and tested using the Google TensorFlow open-source library. An SOC estimation model based on the extended KF (EKF) and a Thevenin battery model was developed. Then, we proposed a combined mode EKF-ANN that integrates the estimation of the EKF into the ANN. Both methods were evaluated through experiments conducted on a real LiB pack. As a result, the ANN and KF methods showed maximum errors of 2.6% and 2.8%, but the EKF-ANN method showed better performance with less than 1% error.
- 19 August 2014
- Published by Korean Physical Society in Journal of the Korean Physical Society
- Vol. 65 (3) , 317-324
Effect of copper content in the new conductive material Cu-SPB used in low-temperature Li-ion batteries
A new conductive material, copper/Super-P carbon black composite (Cu-SPB), is prepared via an efficient ion reducing method for use in low-temperature lithium-ion batteries (LIBs). The present study investigated the effects of copper content on the low-temperature performance of LIBs. Electrodes prepared with a high-copper-content conductive material (Cu = 18.54%) showed remarkably improved performance in terms of capacity retention (around 40%), cycling stability, and columbic efficiency. The electrochemical impedance spectroscopy (EIS) analysis revealed that the presence of higher Cu contents could reduce the cell’s impedance. The results were also confirmed by using a coin-type full cell’s improved capacity retention, which indicated the significance of Cu particles in enhancing the low-temperature performance of LIBs.
- 19 August 2014
- Published by Korean Physical Society in Journal of the Korean Physical Society
- Vol. 65 (3) , 317-324
Effect of copper content in the new conductive material Cu-SPB used in low-temperature Li-ion batteries
A new conductive material, copper/Super-P carbon black composite (Cu-SPB), is prepared via an efficient ion reducing method for use in low-temperature lithium-ion batteries (LIBs). The present study investigated the effects of copper content on the low-temperature performance of LIBs. Electrodes prepared with a high-copper-content conductive material (Cu = 18.54%) showed remarkably improved performance in terms of capacity retention (around 40%), cycling stability, and columbic efficiency. The electrochemical impedance spectroscopy (EIS) analysis revealed that the presence of higher Cu contents could reduce the cell’s impedance. The results were also confirmed by using a coin-type full cell’s improved capacity retention, which indicated the significance of Cu particles in enhancing the low-temperature performance of LIBs.
- 11 August 2014
- Published by Wiley in Physica Status Solidi (a)
- Vol. 211 (11) , 2625-2630
Effects of electrode loading on low temperature performances of Li-ion batteries
- 11 August 2014
- Published by Wiley in Physica Status Solidi (a)
- Vol. 211 (11) , 2625-2630
Effects of electrode loading on low temperature performances of Li-ion batteries
- 2 August 2014
- Published by Springer Nature in Journal of Materials Science
- Vol. 49 (22) , 7707-7714
Low temperature performance of graphite and LiNi0.6Co0.2Mn0.2O2 electrodes in Li-ion batteries
- 2 August 2014
- Published by Springer Nature in Journal of Materials Science
- Vol. 49 (22) , 7707-7714
Low temperature performance of graphite and LiNi0.6Co0.2Mn0.2O2 electrodes in Li-ion batteries
- 11 March 2014
- Published by Wiley in Physica Status Solidi (a)
- Vol. 211 (8) , 1889-1894
Crystalline iron oxide nanotube arrays with high aspect ratio as binder free anode for Li-ion batteries
- 11 March 2014
- Published by Wiley in Physica Status Solidi (a)
- Vol. 211 (8) , 1889-1894
Crystalline iron oxide nanotube arrays with high aspect ratio as binder free anode for Li-ion batteries
- 23 November 2013
- Published by Korean Physical Society in Journal of the Korean Physical Society
- Vol. 63 (9) , 1809-1814
Improved performance of Ag-nanoparticle-decorated TiO2 nanotube arrays in Li-ion batteries
The present work investigates the electrochemical response of silver nanoparticle (Ag-NP)-decorated TiO2 nanotube (NT) layers as an anode material for a lithium-ion battery. Self-organized nanotube layers with a thickness of approximately 1 µm and a diameter of approximately 100 nm were grown by anodization of Ti in a fluoride-containing aqueous electrolyte. Ag NPs (average particle size of ∼10 nm) were deposited both inside and outside the nanotube geometry in a well-distributed manner through a simple and efficient photocatalytic reduction process. The morphology and the chemical composition of the resulting materials were characterized by using field-emission scanning electron microscopy (FE-SEM), X-ray diffraction (XRD) and energy dispersive X-ray spectroscopy (EDX). Our results show that the TiO2 NT layers decorated with Ag NPs had a superior electrochemical response in terms of charge/discharge capacity, rate capability, cyclic performance and columbic efficiency. The enhanced performance is attributed to the improved electronic and ionic conductivity, obtained by providing highly conductive paths to electrons flowing through a well-distributed Ag NPs deposition on the walls of the highly-oriented NTs.
- 23 November 2013
- Published by Korean Physical Society in Journal of the Korean Physical Society
- Vol. 63 (9) , 1809-1814
Improved performance of Ag-nanoparticle-decorated TiO2 nanotube arrays in Li-ion batteries
The present work investigates the electrochemical response of silver nanoparticle (Ag-NP)-decorated TiO2 nanotube (NT) layers as an anode material for a lithium-ion battery. Self-organized nanotube layers with a thickness of approximately 1 µm and a diameter of approximately 100 nm were grown by anodization of Ti in a fluoride-containing aqueous electrolyte. Ag NPs (average particle size of ∼10 nm) were deposited both inside and outside the nanotube geometry in a well-distributed manner through a simple and efficient photocatalytic reduction process. The morphology and the chemical composition of the resulting materials were characterized by using field-emission scanning electron microscopy (FE-SEM), X-ray diffraction (XRD) and energy dispersive X-ray spectroscopy (EDX). Our results show that the TiO2 NT layers decorated with Ag NPs had a superior electrochemical response in terms of charge/discharge capacity, rate capability, cyclic performance and columbic efficiency. The enhanced performance is attributed to the improved electronic and ionic conductivity, obtained by providing highly conductive paths to electrons flowing through a well-distributed Ag NPs deposition on the walls of the highly-oriented NTs.