Gary A. Glass
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Gary A. Glass has a total of 26 co-authors. Here are the top co-authors by number of shared publications:
- Bibhudutta Rout
Department of Physics University of North Texas Denton Texas USA
7 shared publications - Todd A. Byers
Department of Physics University of North Texas Denton Texas USA
7 shared publications - Charles T. Bowen
Ion Beam Laboratory Department of Physics University of North Texas 210 Ave A Denton TX 76203 USA
6 shared publications - Darshpreet Kaur Saini
Department of Physics University of North Texas Denton Texas USA
6 shared publications - Mritunjaya Parashar
Ion Beam Laboratory, Department of Physics, University of North Texas , Denton, Texas 76203
4 shared publications Mohin Sharma
3 shared publications
Latest Publications
Unraveling Various Sources of Particulates Matter in Air‐Dust Samples Collected from North India Through Elemental Mapping and Concentration Correlation Using Micro‐Particle‐Induced X‐Ray Emission Spectroscopy
Particulate matter (PM) found in the air is one of the major sources of pollution and air‐borne diseases. Therefore, it is imperative to examine the elemental concentration distribution of the PM to identify the pollutant sources. In this study, it has demonstrated the capabilities of micro‐particle‐induced X‐ray emission (micro‐PIXE) spectroscopy in quantitative analysis of air samples collected from the Old Delhi outdoor market and indoor locations in the Panjab University hostel in the winter months. A 2‐million electronvolts energetic scanning proton micro‐beam (diameter ≈1 µm 2 ) is used in micro‐PIXE experiments generating high‐resolution elemental maps of different regions of interest (ROI). Micro‐PIXE along with the GeoPIXE analysis provides a non‐destructive, standard‐less, and ng/mg level‐sensitive tool for the investigation of elemental distributions and highlighting pixels, which correlates to specific concentration ratios between elements at ROIs, thereby enabling a comprehensive understanding of the source of each elemental particulate. Si, Ca, and K detected in indoor PM suggest the source to soil erosion and crop burning, while high S levels in outdoor PM are primarily associated with coal power plants. Additionally, Sc, Ti, Cr, Mn, and Zn are found in outdoor samples, while indoor locations also contained trace amounts of V, Co, and Cu.
Unraveling Various Sources of Particulates Matter in Air‐Dust Samples Collected from North India Through Elemental Mapping and Concentration Correlation Using Micro‐Particle‐Induced X‐Ray Emission Spectroscopy
Particulate matter (PM) found in the air is one of the major sources of pollution and air‐borne diseases. Therefore, it is imperative to examine the elemental concentration distribution of the PM to identify the pollutant sources. In this study, it has demonstrated the capabilities of micro‐particle‐induced X‐ray emission (micro‐PIXE) spectroscopy in quantitative analysis of air samples collected from the Old Delhi outdoor market and indoor locations in the Panjab University hostel in the winter months. A 2‐million electronvolts energetic scanning proton micro‐beam (diameter ≈1 µm 2 ) is used in micro‐PIXE experiments generating high‐resolution elemental maps of different regions of interest (ROI). Micro‐PIXE along with the GeoPIXE analysis provides a non‐destructive, standard‐less, and ng/mg level‐sensitive tool for the investigation of elemental distributions and highlighting pixels, which correlates to specific concentration ratios between elements at ROIs, thereby enabling a comprehensive understanding of the source of each elemental particulate. Si, Ca, and K detected in indoor PM suggest the source to soil erosion and crop burning, while high S levels in outdoor PM are primarily associated with coal power plants. Additionally, Sc, Ti, Cr, Mn, and Zn are found in outdoor samples, while indoor locations also contained trace amounts of V, Co, and Cu.
- 1 August 2018
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 89 (8) , 086103
Note: Performance of a novel electrostatic quadrupole doublet for nuclear microprobe application
The newly designed and constructed electrostatic quadrupole doublet (EQD) at the University of North Texas (UNT) has achieved mass independent focusing of MeV particles to a spot size of 3.3 × 3.5 μm. The EQD is compared to the Louisiana magnetic doublet which is also in use at UNT. Characteristics such as demagnification and sensitivity to aberrations are simulated by the matrix raytracing software, propagation of rays and aberrations by matrices and compared for each focusing system. Particle induced x-ray emission (PIXE) maps of a 2000 mesh Cu grid are compared and show that both doublets produce suitable spot sizes for microprobe analysis. A coarser, 200 mesh grid and incident beams of 2 MeV H+ and O+ show the EQD to be stigmatic given common aperture sizes and lens potentials.
- 1 August 2018
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 89 (8) , 086103
Note: Performance of a novel electrostatic quadrupole doublet for nuclear microprobe application
The newly designed and constructed electrostatic quadrupole doublet (EQD) at the University of North Texas (UNT) has achieved mass independent focusing of MeV particles to a spot size of 3.3 × 3.5 μm. The EQD is compared to the Louisiana magnetic doublet which is also in use at UNT. Characteristics such as demagnification and sensitivity to aberrations are simulated by the matrix raytracing software, propagation of rays and aberrations by matrices and compared for each focusing system. Particle induced x-ray emission (PIXE) maps of a 2000 mesh Cu grid are compared and show that both doublets produce suitable spot sizes for microprobe analysis. A coarser, 200 mesh grid and incident beams of 2 MeV H+ and O+ show the EQD to be stigmatic given common aperture sizes and lens potentials.
- 1 January 1999
- Published by Springer Nature in MRS Proceedings
- Vol. 560
Survey of Recent Research Results for New Fluor Materials
There is worldwide interest in the use of fluor materials that emit visible light when exposed to ionizing radiation. Typically, fluors are used as components in high performance electromagnetic calorimeters, down-hole oil well loggers, temperature sensors for equipment with high speed moving parts, and beam positioning systems for large particle accelerators. A candidate fluor should have a large fluorescence efficiency, small reduction in output as a function of exposure, intense visible fluorescence spectrum, large material density, and small prompt fluorescence decay time.Over the last few years, new fluor materials have been located by organizations such as Oak Ridge National Laboratory, Lawrence Berkeley National Laboratory, and the Department of Defense. These new fluors, such as YAIO3:Ce, YSiO5:Ce, GdSiO5:Ce, Y2O2S doped with Tb, Pr, and Eu, and Gd2O0S doped with Th, Pr, and Eu, show a great deal of promise for use in the applications listed above.This paper will present a summary of fluor research completed by the authors over the last ten years. These results will be used to establish a fluor characterization program at the Acadiana Research Laboratory (ARL) that will move it to the front of this developing technology.
- 1 January 1999
- Published by Springer Nature in MRS Proceedings
- Vol. 560
Survey of Recent Research Results for New Fluor Materials
There is worldwide interest in the use of fluor materials that emit visible light when exposed to ionizing radiation. Typically, fluors are used as components in high performance electromagnetic calorimeters, down-hole oil well loggers, temperature sensors for equipment with high speed moving parts, and beam positioning systems for large particle accelerators. A candidate fluor should have a large fluorescence efficiency, small reduction in output as a function of exposure, intense visible fluorescence spectrum, large material density, and small prompt fluorescence decay time.Over the last few years, new fluor materials have been located by organizations such as Oak Ridge National Laboratory, Lawrence Berkeley National Laboratory, and the Department of Defense. These new fluors, such as YAIO3:Ce, YSiO5:Ce, GdSiO5:Ce, Y2O2S doped with Tb, Pr, and Eu, and Gd2O0S doped with Th, Pr, and Eu, show a great deal of promise for use in the applications listed above.This paper will present a summary of fluor research completed by the authors over the last ten years. These results will be used to establish a fluor characterization program at the Acadiana Research Laboratory (ARL) that will move it to the front of this developing technology.
- 1 January 1995
- Published by Springer Nature in MRS Proceedings
- Vol. 407
Electrochemical Oscillations, Surface Morphology and Corrosion of Selected Thermal Sprayed Alloys.
- 1 January 1995
- Published by Springer Nature in MRS Proceedings
- Vol. 407
Electrochemical Oscillations, Surface Morphology and Corrosion of Selected Thermal Sprayed Alloys.