Atiqul Islam
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Atiqul Islam has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- Besma Smida
Department of Electrical and Computer Engineering University of Illinois Chicago USA
4 shared publications - George C. Alexandropoulos
National and Kapodistrian University of Athens
3 shared publications - Konstantin Muranov
Department of Electrical and Computer Engineering, University of Illinois at Chicago, Chicago, IL, USA
1 shared publication - Natasha Devroye
Department of Electrical and Computer Engineering, University of Illinois at Chicago, Chicago, IL, USA
1 shared publication
Latest Publications
- 31 October 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Vehicular Technology Magazine
- Vol. 17 (4) , 83-91
Full-Duplex Massive Multiple-Input, Multiple-Output Architectures: Recent Advances, Applications, and Future Directions
The increasingly demanding objectives for next-generation wireless communications have spurred recent research activities on multiantenna transceiver hardware architectures and relevant intelligent communication schemes. Among them belong full-duplex (FD) multiple-input, multiple-output (MIMO) architectures, which offer the potential for simultaneous uplink (UL) and downlink (DL) operations in the entire frequency band. However, as the number of antenna elements increases, the interference signal leaking from the transmitter (Tx) of the FD radio to its receiver (Rx) becomes more severe. In this article, we present a unified FD massive MIMO architecture comprising analog and digital transmit and receive beamforming (BF) as well as analog and digital self-interference (SI) cancellation, which can be jointly optimized for various performance objectives and complexity requirements. The performance evaluation results for applications of the proposed architecture to fully digital and hybrid analog and digital-BF operations using recent algorithmic designs as well as simultaneous communication of data and control (SCDC) signals are presented. It is shown that the proposed architecture, for both small and large numbers of antennas, enables improved spectral-efficient FD communications with fewer analog-cancellation elements compared to various benchmark schemes. The article concludes with a list of open challenges and research directions for future FD massive MIMO communication systems and their promising applications.
- 31 October 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Vehicular Technology Magazine
- Vol. 17 (4) , 83-91
Full-Duplex Massive Multiple-Input, Multiple-Output Architectures: Recent Advances, Applications, and Future Directions
The increasingly demanding objectives for next-generation wireless communications have spurred recent research activities on multiantenna transceiver hardware architectures and relevant intelligent communication schemes. Among them belong full-duplex (FD) multiple-input, multiple-output (MIMO) architectures, which offer the potential for simultaneous uplink (UL) and downlink (DL) operations in the entire frequency band. However, as the number of antenna elements increases, the interference signal leaking from the transmitter (Tx) of the FD radio to its receiver (Rx) becomes more severe. In this article, we present a unified FD massive MIMO architecture comprising analog and digital transmit and receive beamforming (BF) as well as analog and digital self-interference (SI) cancellation, which can be jointly optimized for various performance objectives and complexity requirements. The performance evaluation results for applications of the proposed architecture to fully digital and hybrid analog and digital-BF operations using recent algorithmic designs as well as simultaneous communication of data and control (SCDC) signals are presented. It is shown that the proposed architecture, for both small and large numbers of antennas, enables improved spectral-efficient FD communications with fewer analog-cancellation elements compared to various benchmark schemes. The article concludes with a list of open challenges and research directions for future FD massive MIMO communication systems and their promising applications.
- Open Access
- 7 June 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Wireless Communications
- Vol. 21 (11) , 9729-9743
Joint Analog and Digital Transceiver Design for Wideband Full Duplex MIMO Systems
In this paper, we propose a wideband Full Duplex (FD) Multiple-Input Multiple-Output (MIMO) communication system comprising of an FD MIMO node simultaneously communicating with two multi-antenna UpLink (UL) and DownLink (DL) nodes utilizing the same time and frequency resources. To suppress the strong Self-Interference (SI) signal due to simultaneous transmission and reception in FD MIMO systems, we propose a joint design of Analog and Digital (A/D) cancellation as well as transmit and receive beamforming capitalizing on baseband Orthogonal Frequency-Division Multiplexing (OFDM) signal modeling. Considering practical transmitter impairments, we present a multi-tap wideband analog canceller architecture whose number of taps does not scale with the number of transceiver antennas and multipath SI components. We also propose a novel adaptive digital cancellation based on truncated singular value decomposition that reduces the residual SI signal estimation parameters. To maximize the FD sum rate, a joint optimization framework is presented for A/D cancellation and digital beamforming. Finally, our extensive waveform simulation results demonstrate that the proposed wideband FD MIMO design exhibits higher SI cancellation capability with reduced complexity compared to existing cancellation techniques, resulting in improved achievable rate performance.
- 7 June 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Wireless Communications
- Vol. 21 (11) , 9729-9743
Open AccessJoint Analog and Digital Transceiver Design for Wideband Full Duplex MIMO Systems
In this paper, we propose a wideband Full Duplex (FD) Multiple-Input Multiple-Output (MIMO) communication system comprising of an FD MIMO node simultaneously communicating with two multi-antenna UpLink (UL) and DownLink (DL) nodes utilizing the same time and frequency resources. To suppress the strong Self-Interference (SI) signal due to simultaneous transmission and reception in FD MIMO systems, we propose a joint design of Analog and Digital (A/D) cancellation as well as transmit and receive beamforming capitalizing on baseband Orthogonal Frequency-Division Multiplexing (OFDM) signal modeling. Considering practical transmitter impairments, we present a multi-tap wideband analog canceller architecture whose number of taps does not scale with the number of transceiver antennas and multipath SI components. We also propose a novel adaptive digital cancellation based on truncated singular value decomposition that reduces the residual SI signal estimation parameters. To maximize the FD sum rate, a joint optimization framework is presented for A/D cancellation and digital beamforming. Finally, our extensive waveform simulation results demonstrate that the proposed wideband FD MIMO design exhibits higher SI cancellation capability with reduced complexity compared to existing cancellation techniques, resulting in improved achievable rate performance.
- 29 September 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Wireless Communications Letters
- Vol. 10 (12) , 2762-2766
On Deep Learning Assisted Self-Interference Estimation in a Full-Duplex Relay Link
We propose and evaluate two new methods for digital mitigation of the non-linear Self-Interference (SI) signal in the context of a Full-Duplex (FD) relay link. The proposed methods utilize Deep Neural Networks (DNN) for the reconstruction of the non-linear SI components. Existing DNN-based SI mitigation techniques require a large number of on-line training samples, which takes resources away from actual data communication. The proposed methods allow a significant reduction in or complete elimination of on-line training by utilizing transfer learning and decoupling the reconstruction of non-linear transmitted SI signal from the estimation of the SI propagation channel, respectively. We utilize link-level simulation to demonstrate the SI cancellation performance of the proposed approaches compared to the existing state-of-the-art DNN-based solutions. The simulation results confirm that the proposed SI mitigation techniques achieve robust Bit Error Rate (BER) performance for Signal-to-Interference-Ratio (SIR) levels as low as −20dB. We derive an upper bound and an approximation for the probability of generalization error that is caused by an insufficient training set size.
- 29 September 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Wireless Communications Letters
- Vol. 10 (12) , 2762-2766
On Deep Learning Assisted Self-Interference Estimation in a Full-Duplex Relay Link
We propose and evaluate two new methods for digital mitigation of the non-linear Self-Interference (SI) signal in the context of a Full-Duplex (FD) relay link. The proposed methods utilize Deep Neural Networks (DNN) for the reconstruction of the non-linear SI components. Existing DNN-based SI mitigation techniques require a large number of on-line training samples, which takes resources away from actual data communication. The proposed methods allow a significant reduction in or complete elimination of on-line training by utilizing transfer learning and decoupling the reconstruction of non-linear transmitted SI signal from the estimation of the SI propagation channel, respectively. We utilize link-level simulation to demonstrate the SI cancellation performance of the proposed approaches compared to the existing state-of-the-art DNN-based solutions. The simulation results confirm that the proposed SI mitigation techniques achieve robust Bit Error Rate (BER) performance for Signal-to-Interference-Ratio (SIR) levels as low as −20dB. We derive an upper bound and an approximation for the probability of generalization error that is caused by an insufficient training set size.
- Open Access
- 1 May 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-5
Full Duplex Hybrid A/D Beamforming with Reduced Complexity Multi-Tap Analog Cancellation
Although the hardware complexity of the analog self-interference canceller in full duplex Multiple Input Multiple Output (MIMO) designs does not necessarily scale with the number of transceiver antennas, exploiting the benefits of analog cancellation in massive MIMO systems with hundreds of antenna elements is still quite impractical. Hybrid Analog and Digital (A/D) beamforming architectures have been lately considered as a candidate technology for realizing massive MIMO transceivers with very large number of antenna elements, but with much fewer numbers of Radio Frequency (RF) chains. In this paper, we present a novel architecture for full duplex hybrid A/D beamforming transceivers including multi-tap analog cancellation with reduced number of taps and simple multiplexers for efficient signal routing among the transceiver RF chains. Capitalizing on the proposed transceiver architecture, we present a joint design of analog cancellation and A/D beamforming with the objective to maximize the achievable full duplex rate performance. Representative millimeter wave simulation results demonstrate the effectiveness of the proposed architecture and algorithmic framework for enabling simultaneous uplink and downlink communications with reduced complexity analog self-interference cancellation.
- 1 May 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-5
Open AccessFull Duplex Hybrid A/D Beamforming with Reduced Complexity Multi-Tap Analog Cancellation
Although the hardware complexity of the analog self-interference canceller in full duplex Multiple Input Multiple Output (MIMO) designs does not necessarily scale with the number of transceiver antennas, exploiting the benefits of analog cancellation in massive MIMO systems with hundreds of antenna elements is still quite impractical. Hybrid Analog and Digital (A/D) beamforming architectures have been lately considered as a candidate technology for realizing massive MIMO transceivers with very large number of antenna elements, but with much fewer numbers of Radio Frequency (RF) chains. In this paper, we present a novel architecture for full duplex hybrid A/D beamforming transceivers including multi-tap analog cancellation with reduced number of taps and simple multiplexers for efficient signal routing among the transceiver RF chains. Capitalizing on the proposed transceiver architecture, we present a joint design of analog cancellation and A/D beamforming with the objective to maximize the achievable full duplex rate performance. Representative millimeter wave simulation results demonstrate the effectiveness of the proposed architecture and algorithmic framework for enabling simultaneous uplink and downlink communications with reduced complexity analog self-interference cancellation.