David A. Katzmarek
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
David A. Katzmarek has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Francesca Iacopi
School of Electrical and Data Engineering, Faculty of Engineering and Information Technology, University of Technology Sydney 1 , Sydney, New South Wales 2007, Australia
3 shared publications - Richard W. Ziolkowski
Department of Electrical and Computer Engineering, University of Arizona, Tucson, AZ, USA
2 shared publications - Aiswarya Pradeepkumar
Faculty of Engineering and IT, University of Technology Sydney, Sydney, New South Wales 2007, Australia
1 shared publication - Andrea Mancini
Centre for Nano Science and Technology, Fondazione Istituto Italiano di Tecnologia, Milano, Italy
1 shared publication - Kourosh Kalantar-Zadeh
University of Sydney
1 shared publication - Mohammad Bagher Ghasemian
School of Chemical and Biomolecular Engineering University of Sydney Sydney NSW 2006 Australia
1 shared publication
Latest Publications
- Open Access
- 19 July 2023
- Published by IOP Publishing in Nanotechnology
- Vol. 34 (40) , 405302
Direct synthesis of nanopatterned epitaxial graphene on silicon carbide
This article introduces a straightforward approach for the direct synthesis of transfer-free, nanopatterned epitaxial graphene on silicon carbide on silicon substrates. A catalytic alloy tailored to optimal SiC graphitization is pre-patterned with common lithography and lift-off techniques to form planar graphene structures on top of an unpatterned SiC layer. This method is compatible with both electron-beam lithography and UV-lithography, and graphene gratings down to at least ∼100 nm width/space can be realized at the wafer scale. The minimum pitch is limited by the flow of the metal catalyst during the liquid-phase graphitization process. We expect that the current pitch resolution could be further improved by optimizing the metal deposition method and lift-off process.
- 19 July 2023
- Published by IOP Publishing in Nanotechnology
- Vol. 34 (40) , 405302
Open AccessDirect synthesis of nanopatterned epitaxial graphene on silicon carbide
This article introduces a straightforward approach for the direct synthesis of transfer-free, nanopatterned epitaxial graphene on silicon carbide on silicon substrates. A catalytic alloy tailored to optimal SiC graphitization is pre-patterned with common lithography and lift-off techniques to form planar graphene structures on top of an unpatterned SiC layer. This method is compatible with both electron-beam lithography and UV-lithography, and graphene gratings down to at least ∼100 nm width/space can be realized at the wafer scale. The minimum pitch is limited by the flow of the metal catalyst during the liquid-phase graphitization process. We expect that the current pitch resolution could be further improved by optimizing the metal deposition method and lift-off process.
- Open Access
- 19 December 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 44 (2) , 297-300
Characteristics of Epitaxial Graphene on SiC/Si Substrates in the Radio Frequency Spectrum
Graphene is expected to bring substantial benefits for high-frequency applications, however, most of the studies in this area are based on theory. Here, the properties of epitaxial graphene grown on intrinsic silicon carbide on silicon substrates are investigated for potential radio frequency (RF) applications. Metal coplanar waveguides (CPWs) are fabricated that employ graphene as a shunt between the signal and ground planes. The CPWs are used for characterizing the frequency-dependent behavior of the sheet resistance of the graphene shunt from 10 MHz to 10 GHz. The process involves evaluating the CPW’s RLCG transmission line parameters and comparing them to a reference un-shunted CPW to extract the sheet resistance. We find that the quality of the metal contact with graphene is one key parameter to observe adequate current injection in the 2D material in the RF spectrum. A mild argon plasma treatment was applied to reach an adequate contact quality. Furthermore, we observe a monotonic decrease of the sheet resistance of the epitaxial graphene for frequencies roughly above 100 MHz. We attribute this behavior to the progressively smaller influence of small-scale discontinuities, such as grain sizes, at those higher frequencies.
- 19 December 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 44 (2) , 297-300
Open AccessCharacteristics of Epitaxial Graphene on SiC/Si Substrates in the Radio Frequency Spectrum
Graphene is expected to bring substantial benefits for high-frequency applications, however, most of the studies in this area are based on theory. Here, the properties of epitaxial graphene grown on intrinsic silicon carbide on silicon substrates are investigated for potential radio frequency (RF) applications. Metal coplanar waveguides (CPWs) are fabricated that employ graphene as a shunt between the signal and ground planes. The CPWs are used for characterizing the frequency-dependent behavior of the sheet resistance of the graphene shunt from 10 MHz to 10 GHz. The process involves evaluating the CPW’s RLCG transmission line parameters and comparing them to a reference un-shunted CPW to extract the sheet resistance. We find that the quality of the metal contact with graphene is one key parameter to observe adequate current injection in the 2D material in the RF spectrum. A mild argon plasma treatment was applied to reach an adequate contact quality. Furthermore, we observe a monotonic decrease of the sheet resistance of the epitaxial graphene for frequencies roughly above 100 MHz. We attribute this behavior to the progressively smaller influence of small-scale discontinuities, such as grain sizes, at those higher frequencies.
- 17 March 2022
- Published by IOP Publishing in 2D Materials
- Vol. 9 (2) , 022002
Review of graphene for the generation, manipulation, and detection of electromagnetic fields from microwave to terahertz
Graphene has attracted considerable attention ever since the discovery of its unprecedented properties, including its extraordinary and tunable electronic and optical properties. In particular, applications within the microwave to terahertz frequency spectrum can benefit from graphene’s high electrical conductivity, mechanical flexibility and robustness, transparency, support of surface-plasmon-polaritons, and the possibility of dynamic tunability with direct current to light sources. This review aims to provide an in-depth analysis of current trends, challenges, and prospects within the research areas of generating, manipulating, and detecting electromagnetic fields using graphene-based devices that operate from microwave to terahertz frequencies. The properties of and models describing graphene are reviewed first, notably those of importance to electromagnetic applications. State-of-the-art graphene-based antennas, such as resonant and leaky-wave antennas, are discussed next. A critical evaluation of the performance and limitations within each particular technology is given. Graphene-based metasurfaces and devices used to manipulate electromagnetic fields, e.g. wavefront engineering, are then examined. Lastly, the state-of-the-art of detecting electromagnetic fields using graphene-based devices is discussed.
- 17 March 2022
- Published by IOP Publishing in 2D Materials
- Vol. 9 (2) , 022002
Review of graphene for the generation, manipulation, and detection of electromagnetic fields from microwave to terahertz
Graphene has attracted considerable attention ever since the discovery of its unprecedented properties, including its extraordinary and tunable electronic and optical properties. In particular, applications within the microwave to terahertz frequency spectrum can benefit from graphene’s high electrical conductivity, mechanical flexibility and robustness, transparency, support of surface-plasmon-polaritons, and the possibility of dynamic tunability with direct current to light sources. This review aims to provide an in-depth analysis of current trends, challenges, and prospects within the research areas of generating, manipulating, and detecting electromagnetic fields using graphene-based devices that operate from microwave to terahertz frequencies. The properties of and models describing graphene are reviewed first, notably those of importance to electromagnetic applications. State-of-the-art graphene-based antennas, such as resonant and leaky-wave antennas, are discussed next. A critical evaluation of the performance and limitations within each particular technology is given. Graphene-based metasurfaces and devices used to manipulate electromagnetic fields, e.g. wavefront engineering, are then examined. Lastly, the state-of-the-art of detecting electromagnetic fields using graphene-based devices is discussed.