Yunzhou Li
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Yunzhou Li has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
- Shidong Zhou
Department of Electronic Engineering, Tsinghua University, Beijing, China
2 shared publications - Bin Cai
Shanghai Key Lab of Modern Optical System, Ministry of Education, University of Shanghai for Science and Technology, Shanghai, China
1 shared publication - Feifei Gao
Tsinghua University
1 shared publication - Fengchao Zhu
Rocket Force University of Engineering, Xian, China
1 shared publication - Hongru Sun
Tsinghua University, 12442 Beijing, Beijing China 100084
1 shared publication Hongxin Wei
State Key Laboratory on Microwave and Digital Communications, Tsinghua National Laboratory Information Science and Technology, Department of Electronic Engineering, Tsinghua University, Beijing 100084, China
1 shared publication
Latest Publications
- 14 November 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in China Communications
- Vol. 14 (10) , 142-150
Energy-efficient resource allocation for small-cell networks: A stable queue perspective
The small-cell technology is promising for spectral-efficiency enhancement. However, it usually requires a huge amount of energy consumption. In this paper, queue state information and channel state information are jointly utilized to minimize the time average of overall energy consumption for a multi-carrier small-cell network, where the inter-cell interference is an intractable problem. Based on the Lyapunov optimization theory, the problem could be solved by dynamically optimizing the problem of user assignment, carrier allocation and power allocation in each time slot. As the optimization problem is NP-hard, we propose a heuristic iteration algorithm to solve it. Numerical results verify that the heuristic algorithm offers an approximate performance as the brute-force algorithm. Moreover, it could bring down the overall energy consumption to different degrees according to the variation of traffic load. Meanwhile, it could achieve the same sum rate as the algorithm which focuses on maximizing system sum rate.
- 14 November 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in China Communications
- Vol. 14 (10) , 142-150
Energy-efficient resource allocation for small-cell networks: A stable queue perspective
The small-cell technology is promising for spectral-efficiency enhancement. However, it usually requires a huge amount of energy consumption. In this paper, queue state information and channel state information are jointly utilized to minimize the time average of overall energy consumption for a multi-carrier small-cell network, where the inter-cell interference is an intractable problem. Based on the Lyapunov optimization theory, the problem could be solved by dynamically optimizing the problem of user assignment, carrier allocation and power allocation in each time slot. As the optimization problem is NP-hard, we propose a heuristic iteration algorithm to solve it. Numerical results verify that the heuristic algorithm offers an approximate performance as the brute-force algorithm. Moreover, it could bring down the overall energy consumption to different degrees according to the variation of traffic load. Meanwhile, it could achieve the same sum rate as the algorithm which focuses on maximizing system sum rate.
- 1 October 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Inductor design of magnetic resonance coupled circuits for secured wireless power transfer
Magnetic resonance coupling (MRC) has been utilized in wireless power transfer (WPT) systems to achieve mid-range contactless power supply. For many cases, power security is an important issue, say when power transfer to certain users is unintended and therefore needs to be restricted. Moreover, manufacturing costs and physical dimensions are also important issues for mass production. In this paper, we investigate an MRC-WPT system with multiple transmitters, one intended receiver and one unintended receiver. We formulate the problem of maximizing power of intended receiver by designing coil winding numbers of inductors in MRC circuits. Meanwhile, the proposed design should satisfy the total power and manufacturing cost constraints, as well as the power security demands. Although the problem is non-convex, the global optimal solution can still be efficiently obtained via semidefinite programming approach. Simulation results are provided to show the performance of the proposed design.
- 1 October 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Inductor design of magnetic resonance coupled circuits for secured wireless power transfer
Magnetic resonance coupling (MRC) has been utilized in wireless power transfer (WPT) systems to achieve mid-range contactless power supply. For many cases, power security is an important issue, say when power transfer to certain users is unintended and therefore needs to be restricted. Moreover, manufacturing costs and physical dimensions are also important issues for mass production. In this paper, we investigate an MRC-WPT system with multiple transmitters, one intended receiver and one unintended receiver. We formulate the problem of maximizing power of intended receiver by designing coil winding numbers of inductors in MRC circuits. Meanwhile, the proposed design should satisfy the total power and manufacturing cost constraints, as well as the power security demands. Although the problem is non-convex, the global optimal solution can still be efficiently obtained via semidefinite programming approach. Simulation results are provided to show the performance of the proposed design.
- 8 June 2015
- Published by AIP Publishing in Applied Physics Letters
- Vol. 106 (23) , 231107
High refractive index composite for broadband antireflection in terahertz frequency range
In this study, titania–polymer composites with a very high refractive-index tenability and high transparency in the terahertz region were prepared. By controlling the blending ratio of the titania particle, a broad refractive-index tuning range from 1.5 to 3.1 was realized. Then, the composites were used to fabricate antireflective (AR) layers of high-resistivity silicon (HR-Si). By utilizing the thermoplasticity of the titania–polymer composite, a graded-index structure was fabricated via a hot-embossing method. Because of the good refractive-index matching between the composite and the HR-Si substrate, a broadband (0.2–1.6 THz, 7% reflection) AR layer was fabricated.
- 8 June 2015
- Published by AIP Publishing in Applied Physics Letters
- Vol. 106 (23) , 231107
High refractive index composite for broadband antireflection in terahertz frequency range
In this study, titania–polymer composites with a very high refractive-index tenability and high transparency in the terahertz region were prepared. By controlling the blending ratio of the titania particle, a broad refractive-index tuning range from 1.5 to 3.1 was realized. Then, the composites were used to fabricate antireflective (AR) layers of high-resistivity silicon (HR-Si). By utilizing the thermoplasticity of the titania–polymer composite, a graded-index structure was fabricated via a hot-embossing method. Because of the good refractive-index matching between the composite and the HR-Si substrate, a broadband (0.2–1.6 THz, 7% reflection) AR layer was fabricated.
- 1 May 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-7
Energy efficiency analysis of energy harvesting relay-aided cooperative networks
Cooperative relaying is a promising technology which can improve the energy efficiency of cellular networks. However, the relays' static power consumption may cancel out the energy saved by the deployed relays. Energy harvesting (EH) technique is introduced for relay nodes in cellular networks in order to deploy flexibility and reduce the energy charge. Due to the EH property, relay nodes cannot maintain a stable energy flow and keep active with a certain probability, which would degrade the benefit from relay-aided cooperative transmission. In this paper, an analytical model is proposed to investigate the energy efficiency of cellular networks aided by EH relay nodes. Meanwhile, the closed-form expressions of coverage probabilities and mean achievable rates for different links are derived. Numerical results show that EH relays bring more improvement on energy efficiency compared with non-EH relayed transmission. The influence of the density and transmit power of stations is also given through numerical simulation.
- 1 May 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-7
Energy efficiency analysis of energy harvesting relay-aided cooperative networks
Cooperative relaying is a promising technology which can improve the energy efficiency of cellular networks. However, the relays' static power consumption may cancel out the energy saved by the deployed relays. Energy harvesting (EH) technique is introduced for relay nodes in cellular networks in order to deploy flexibility and reduce the energy charge. Due to the EH property, relay nodes cannot maintain a stable energy flow and keep active with a certain probability, which would degrade the benefit from relay-aided cooperative transmission. In this paper, an analytical model is proposed to investigate the energy efficiency of cellular networks aided by EH relay nodes. Meanwhile, the closed-form expressions of coverage probabilities and mean achievable rates for different links are derived. Numerical results show that EH relays bring more improvement on energy efficiency compared with non-EH relayed transmission. The influence of the density and transmit power of stations is also given through numerical simulation.
- 27 November 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Communications Letters
- Vol. 11 (10) , 802-804
Joint Space-Frequency Iterative Interference Suppression in Multiuser MIMO-OFDM Systems
In uplink multiuser multiple-input multiple-output (MIMO) orthogonal frequency-division multiplexing (OFDM) systems, inter-user interference includes co-channel interference (CCI) due to spatial multiplexing and inter-carrier interference (ICI) due to carrier-frequency offset (CFO). In this letter, a space-frequency joint processing scheme is proposed to suppress the two-dimensional interference alternatively and iteratively. Moreover, by the studies of convergence behavior of iterations, a sufficient condition for convergence is presented. The theoretical analysis and simulation results both show that this iterative scheme can effectively suppress inter-user interference with low complexity.
- 27 November 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Communications Letters
- Vol. 11 (10) , 802-804
Joint Space-Frequency Iterative Interference Suppression in Multiuser MIMO-OFDM Systems
In uplink multiuser multiple-input multiple-output (MIMO) orthogonal frequency-division multiplexing (OFDM) systems, inter-user interference includes co-channel interference (CCI) due to spatial multiplexing and inter-carrier interference (ICI) due to carrier-frequency offset (CFO). In this letter, a space-frequency joint processing scheme is proposed to suppress the two-dimensional interference alternatively and iteratively. Moreover, by the studies of convergence behavior of iterations, a sufficient condition for convergence is presented. The theoretical analysis and simulation results both show that this iterative scheme can effectively suppress inter-user interference with low complexity.