Tsuyoshi Yokoyama
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Tsuyoshi Yokoyama has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
- Tokihiro Nishihara
Taiyo Yuden Co., LTD., Akashi, Hyogo 674-8555, Japan
3 shared publications Masanori Ueda
Taiyo Yuden Co. Ltd., Japan
2 shared publications- Akira Nagakubo
Graduate School of Engineering, Tohoku University 2 , 6-6-02 Aramaki Aza Aoba, Aoba-ku, Sendai, Miyagi 980-8579
1 shared publication H. Yamada
Faculty of Science, Shinshu University, Matsumoto, 390-8621, Japan
1 shared publication- Hidekazu Saito
Spintronics Research Center, National Institute of Advanced Industrial Science and Technology, Central 2, Umezono 1-1-1, Tsukuba, Tsukuba, Ibaraki, 305-8568, JAPAN
1 shared publication - Hirokazu Ishida
The University of Tokyo
1 shared publication
Latest Publications
- Open Access
- 7 July 2015
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 118 (1) , 014307
Temperature behavior of sound velocity of fluorine-doped vitreous silica thin films studied by picosecond ultrasonics
- 7 July 2015
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 118 (1) , 014307
Open AccessTemperature behavior of sound velocity of fluorine-doped vitreous silica thin films studied by picosecond ultrasonics
- 11 June 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control
- Vol. 62 (6) , 1007-1015
Highly piezoelectric co-doped AlN thin films for wideband FBAR applications
We report piezoelectric materials composed of charge-compensated co-doped (Mg, β) x Al 1-x N (β = Zr or Hf) thin films. The effect of the dopant element into AlN on the crystal structure, and piezoelectric properties of co-doped AlN was determined on the basis of a first-principles calculation, and the theoretical piezoelectric properties were confirmed by experimentally depositing thin films of magnesium (Mg) and zirconium (Zr) co-doped AlN (Mg-Zr-doped AlN). The Mg-Zrdoped AlN thin films were prepared on Si (100) substrates by using a triple-radio-frequency magnetron reactive co-sputtering system. The crystal structures and piezoelectric coefficients (d 33 ) were investigated as a function of the concentrations, which were measured by X-ray diffraction and a piezometer. The results show that the d 33 of Mg-Zr-doped AlN at total Mg and Zr concentrations (both expressed as x) of 0.35 was 280% larger than that of pure AlN. The experimentally measured parameter of the crystal structure and d 33 of Mg-Zr-doped AlN (plotted as functions of total Mg and Zr concentrations) were in very close agreement with the corresponding values obtained by the first-principle calculations. Thin film bulk acoustic wave resonators (FBAR) employing (Mg,Zr) 0.13 Al 0.87 N and (Mg, Hf) 0.13 Al 0.87 N as a piezoelectric thin film were fabricated, and their resonant characteristics were evaluated. The measured electromechanical coupling coefficient increased from 7.1% for pure AlN to 8.5% for Mg-Zr-doped AlN and 10.0% for MgHf-doped AlN. These results indicate that co-doped (Mg, β) x Al 1-x N (β = Zr or Hf) films have potential as piezoelectric thin films for wideband RF applications.
- 11 June 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control
- Vol. 62 (6) , 1007-1015
Highly piezoelectric co-doped AlN thin films for wideband FBAR applications
We report piezoelectric materials composed of charge-compensated co-doped (Mg, β) x Al 1-x N (β = Zr or Hf) thin films. The effect of the dopant element into AlN on the crystal structure, and piezoelectric properties of co-doped AlN was determined on the basis of a first-principles calculation, and the theoretical piezoelectric properties were confirmed by experimentally depositing thin films of magnesium (Mg) and zirconium (Zr) co-doped AlN (Mg-Zr-doped AlN). The Mg-Zrdoped AlN thin films were prepared on Si (100) substrates by using a triple-radio-frequency magnetron reactive co-sputtering system. The crystal structures and piezoelectric coefficients (d 33 ) were investigated as a function of the concentrations, which were measured by X-ray diffraction and a piezometer. The results show that the d 33 of Mg-Zr-doped AlN at total Mg and Zr concentrations (both expressed as x) of 0.35 was 280% larger than that of pure AlN. The experimentally measured parameter of the crystal structure and d 33 of Mg-Zr-doped AlN (plotted as functions of total Mg and Zr concentrations) were in very close agreement with the corresponding values obtained by the first-principle calculations. Thin film bulk acoustic wave resonators (FBAR) employing (Mg,Zr) 0.13 Al 0.87 N and (Mg, Hf) 0.13 Al 0.87 N as a piezoelectric thin film were fabricated, and their resonant characteristics were evaluated. The measured electromechanical coupling coefficient increased from 7.1% for pure AlN to 8.5% for Mg-Zr-doped AlN and 10.0% for MgHf-doped AlN. These results indicate that co-doped (Mg, β) x Al 1-x N (β = Zr or Hf) films have potential as piezoelectric thin films for wideband RF applications.
- 1 January 2015
- Published by Japan Society of Mechanical Engineers in The Proceedings of the Symposium on Micro-Nano Science and Technology
- Vol. 2015.7, _29pm3-_29pm3-PN-
29pm3-PN-37 Cantilever based energy harvesters using Mg-Zr-codoped aluminum nitride with high piezoelectricity
We report (Mg,Zr)AlN-based micro-energy harvester. Doping Mg and Zr into AlN crystal, (Mg,Zr)AlN shows high piezoelectric coefficient, leading to high power figure of merit (FOM = e_^2/(ε_0ε)). The 13 at.%-(Mg,Zr)AlN had the experimental FOM of up to 16.7 GPa. The micromachining harvester provided the high normalized power density of 3.72 mW.g^<-2>.cm^<-3>. This achievement was 1.5-fold increase compared to state of the art.
- 1 January 2015
- Published by Japan Society of Mechanical Engineers in The Proceedings of the Symposium on Micro-Nano Science and Technology
- Vol. 2015.7, _29pm3-_29pm3-PN-
29pm3-PN-37 Cantilever based energy harvesters using Mg-Zr-codoped aluminum nitride with high piezoelectricity
We report (Mg,Zr)AlN-based micro-energy harvester. Doping Mg and Zr into AlN crystal, (Mg,Zr)AlN shows high piezoelectric coefficient, leading to high power figure of merit (FOM = e_^2/(ε_0ε)). The 13 at.%-(Mg,Zr)AlN had the experimental FOM of up to 16.7 GPa. The micromachining harvester provided the high normalized power density of 3.72 mW.g^<-2>.cm^<-3>. This achievement was 1.5-fold increase compared to state of the art.
- 28 August 2001
- Published by American Physical Society (APS) in Physical Review B
- Vol. 64 (13) , 134401
Magnetic phase diagrams of itinerant-electron metamagnetic and Ga) Laves-phase compoundsDetailed magnetization measurements of and Ga) Laves-phase compounds with a high quality of homogeneity in composition have been carried out. A first-order ferromagnetic transition at the Curie temperature has been confirmed in with and 0.095. For these compounds, in addition, a metamagnetic transition from the paramagnetic to the ferromagnetic state above is induced by applying external magnetic field. The critical temperature from the first- to the second-order metamagnetic transition was estimated to be 42 K for The concentration dependence of of is not so remarkable. In the higher concentration of x, the ferromagnetic transition is of the second-order-type. The magnetic transitions in are quite similar to those in In contrast with previous experimental results, the established magnetic phase diagrams in the vicinity of the onset of ferromagnetism for are in good agreement with the theoretical phase diagram.- 28 August 2001
- Published by American Physical Society (APS) in Physical Review B
- Vol. 64 (13) , 134401
Magnetic phase diagrams of itinerant-electron metamagnetic and Ga) Laves-phase compoundsDetailed magnetization measurements of and Ga) Laves-phase compounds with a high quality of homogeneity in composition have been carried out. A first-order ferromagnetic transition at the Curie temperature has been confirmed in with and 0.095. For these compounds, in addition, a metamagnetic transition from the paramagnetic to the ferromagnetic state above is induced by applying external magnetic field. The critical temperature from the first- to the second-order metamagnetic transition was estimated to be 42 K for The concentration dependence of of is not so remarkable. In the higher concentration of x, the ferromagnetic transition is of the second-order-type. The magnetic transitions in are quite similar to those in In contrast with previous experimental results, the established magnetic phase diagrams in the vicinity of the onset of ferromagnetism for are in good agreement with the theoretical phase diagram.- 1 May 1990
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 11 (5) , 197-199
Se-doped AlGaAs/GaAs HEMTs for stable low-temperature operation
The fabrication of Se-doped AlGaAs/GaAs high electron mobility transistors (HEMTs) is discussed. Because the DX center concentration in Se-doped AlGaAs layers is lower than in Si-doped layers, the drain-current collapses much less at 77 K. The Se-doped HEMTs are therefore suitable for application in low-temperature LSI.<>
- 1 May 1990
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 11 (5) , 197-199
Se-doped AlGaAs/GaAs HEMTs for stable low-temperature operation
The fabrication of Se-doped AlGaAs/GaAs high electron mobility transistors (HEMTs) is discussed. Because the DX center concentration in Se-doped AlGaAs layers is lower than in Si-doped layers, the drain-current collapses much less at 77 K. The Se-doped HEMTs are therefore suitable for application in low-temperature LSI.<>