Martina N. Rogers
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Martina N. Rogers has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
- Timothy H. Bertram
University of Wisconsin–Madison (Madison, United States of America)
5 shared publications - Christopher M. Jernigan
Department of Chemistry, University of Wisconsin-Madison, Madison, WI 53706, USA
2 shared publications Delaney B. Kilgour
Department of Chemistry, University of Wisconsin-Madison, Madison, WI 53706, USA
2 shared publications- Elisabeth N. Kray
Department of Chemistry, University of Wisconsin-Madison, Madison, WI 53706, USA
2 shared publications - Michael P. Vermeuel
Department of Earth, Atmospheric, and Planetary Sciences, Purdue University, West Lafayette, IN, 47907, USA
2 shared publications - Subi Thakali
Department of Chemistry University of Wisconsin‐Madison Madison WI USA
2 shared publications
Latest Publications
- Open Access
- 24 September 2026
- Published by Copernicus GmbH in EGUsphere
- Vol. 2026, 1-22
Simultaneous, in situ detection of gas-phase carbon disulfide (CS 2 ) and carbonyl sulfide (OCS) via O 2 + chemical ionization mass spectrometry
Carbonyl sulfide (OCS) is the largest gas-phase sulfur reservoir in the troposphere. OCS is both directly emitted to the atmosphere and formed chemically in the atmosphere following the oxidation of reduced sulfur species such as carbon disulfide (CS2) and dimethyl sulfide (C2H6S, DMS). OCS is the largest continuous contributor to stratospheric sulfate aerosol and a key diagnostic for the photosynthetic uptake of carbon dioxide (CO2). Despite its importance to the OCS budget, in situ measurements of CS2 are extremely limited. Here, we describe a new technique for the simultaneous measurement of CS2, OCS, and DMS utilizing O2+ chemical ionization time-of-flight mass spectrometry (O2+ CI-ToFMS). We highlight the utility of the measurement through the reanalysis of three distinct data sets taken in remote marine, remote continental, and urban environments. We report mean CS2 mixing ratios for the Eastern North Atlantic (2.2 ppt) and Downtown Chicago, IL (9.5 ppt), while CS2 was not detected in Northern Wisconsin. In the Eastern North Atlantic, CS2 showed limited temporal variability during the summer. In Chicago, CS2 was highly variable, with episodic large enhancements (>85 ppt) suggesting local, anthropogenic sources. Results of laboratory measurements and success in the quantification of field measurements suggest that primary and secondary O2+ CI-ToFMS is suitable for simultaneous, in situ detection of CS2 and OCS.
- 24 September 2026
- Published by Copernicus GmbH in EGUsphere
- Vol. 2026, 1-22
Open AccessSimultaneous, in situ detection of gas-phase carbon disulfide (CS 2 ) and carbonyl sulfide (OCS) via O 2 + chemical ionization mass spectrometry
Carbonyl sulfide (OCS) is the largest gas-phase sulfur reservoir in the troposphere. OCS is both directly emitted to the atmosphere and formed chemically in the atmosphere following the oxidation of reduced sulfur species such as carbon disulfide (CS2) and dimethyl sulfide (C2H6S, DMS). OCS is the largest continuous contributor to stratospheric sulfate aerosol and a key diagnostic for the photosynthetic uptake of carbon dioxide (CO2). Despite its importance to the OCS budget, in situ measurements of CS2 are extremely limited. Here, we describe a new technique for the simultaneous measurement of CS2, OCS, and DMS utilizing O2+ chemical ionization time-of-flight mass spectrometry (O2+ CI-ToFMS). We highlight the utility of the measurement through the reanalysis of three distinct data sets taken in remote marine, remote continental, and urban environments. We report mean CS2 mixing ratios for the Eastern North Atlantic (2.2 ppt) and Downtown Chicago, IL (9.5 ppt), while CS2 was not detected in Northern Wisconsin. In the Eastern North Atlantic, CS2 showed limited temporal variability during the summer. In Chicago, CS2 was highly variable, with episodic large enhancements (>85 ppt) suggesting local, anthropogenic sources. Results of laboratory measurements and success in the quantification of field measurements suggest that primary and secondary O2+ CI-ToFMS is suitable for simultaneous, in situ detection of CS2 and OCS.
- Open Access
- 14 November 2025
- Published by American Chemical Society (ACS) in ACS ES&T Air
- Vol. 2 (12) , 2838-2849
Balancing Discrete Indoor Air Quality Metrics: A Chemical Modeling Study of the Response of Indoor Air Quality to Airborne Pathogen Control Strategies
- 14 November 2025
- Published by American Chemical Society (ACS) in ACS ES&T Air
- Vol. 2 (12) , 2838-2849
Open AccessBalancing Discrete Indoor Air Quality Metrics: A Chemical Modeling Study of the Response of Indoor Air Quality to Airborne Pathogen Control Strategies
- Open Access
- 5 July 2025
- Published by Wiley in Limnology and Oceanography Letters
- Vol. 10 (5) , 602-618
The role of surface water waves on cyanobacterial blooms in lakes
The biophysical processes by which wind‐driven surface waves influence cyanobacterial bloom formation, transport, aerosolization, and termination in lakes represent a major knowledge gap in our understanding of bloom dynamics. We synthesized the literature that examined how waves interact with cyanobacterial bloom processes including: cyanobacterial recruitment to inoculate blooms, sediment nutrient resuspension, the transport, aggregation, and disaggregation of bloom biomass by various wave‐driven physical processes (e.g., Stokes drift, Langmuir circulation), and the aerosolization of bloom biomass and cyanotoxins. Using this synthesis, we present a set of testable hypotheses and concepts that can be used to direct future research to better understand the mechanisms that may regulate wave and bloom interactions. Further, we highlight the differences in spatial and temporal scales that these processes act upon, and argue that mechanistic research into wave and bloom interactions must be applicable to whole ecosystems to be relevant in improving bloom management strategies.
- 5 July 2025
- Published by Wiley in Limnology and Oceanography Letters
- Vol. 10 (5) , 602-618
Open AccessThe role of surface water waves on cyanobacterial blooms in lakes
The biophysical processes by which wind‐driven surface waves influence cyanobacterial bloom formation, transport, aerosolization, and termination in lakes represent a major knowledge gap in our understanding of bloom dynamics. We synthesized the literature that examined how waves interact with cyanobacterial bloom processes including: cyanobacterial recruitment to inoculate blooms, sediment nutrient resuspension, the transport, aggregation, and disaggregation of bloom biomass by various wave‐driven physical processes (e.g., Stokes drift, Langmuir circulation), and the aerosolization of bloom biomass and cyanotoxins. Using this synthesis, we present a set of testable hypotheses and concepts that can be used to direct future research to better understand the mechanisms that may regulate wave and bloom interactions. Further, we highlight the differences in spatial and temporal scales that these processes act upon, and argue that mechanistic research into wave and bloom interactions must be applicable to whole ecosystems to be relevant in improving bloom management strategies.
- Open Access
- 10 June 2025
- Published by American Chemical Society (ACS) in ChemRxiv
Balancing discrete indoor air quality metrics: A chemical modeling study of the response of indoor air quality to airborne pathogen control strategies
The impact of airborne pathogen mitigation strategies on indoor air quality (IAQ) depends on the concentration of outdoor air pollutants, the emission and generation of indoor pollutants, and baseline ventilation conditions. Typical engineering solutions to reduce airborne pathogens include enhanced ventilation, in-room filtration, and germicidal UV radiation. Predicting the response of IAQ to these reduction strategies is challenging due to the wide variability in outdoor and indoor air pollutants and numerous configurations for engineered solutions. We use an existing, observationally constrained, open-access photochemical model to assess the response of IAQ metrics to actionable risk reduction strategies in mechanically ventilated buildings. We confirm two commonly held priors: 1) in-room filtration universally reduces PM2.5, while enhancing ventilation rates can increase PM2.5 depending on the quality of the HVAC intake filter and the concentration and size distribution of outdoor aerosol and 2) enhanced ventilation is the only strategy that reduces the indoor concentration of CO2 and indoor sourced VOC, but often at the expense of O3 and PM2.5. Uniquely, the model predicts the balance of O3, and aerosol production driven by the infiltration of outdoor air and photochemically driven indoor air chemistry, where chemical processes are less intuitive. We show that the response of commonly measured proxies for IAQ (e.g., CO2) do not always coincide with an overall improvement in indoor air quality.
- 10 June 2025
- Published by American Chemical Society (ACS) in ChemRxiv
Open AccessBalancing discrete indoor air quality metrics: A chemical modeling study of the response of indoor air quality to airborne pathogen control strategies
The impact of airborne pathogen mitigation strategies on indoor air quality (IAQ) depends on the concentration of outdoor air pollutants, the emission and generation of indoor pollutants, and baseline ventilation conditions. Typical engineering solutions to reduce airborne pathogens include enhanced ventilation, in-room filtration, and germicidal UV radiation. Predicting the response of IAQ to these reduction strategies is challenging due to the wide variability in outdoor and indoor air pollutants and numerous configurations for engineered solutions. We use an existing, observationally constrained, open-access photochemical model to assess the response of IAQ metrics to actionable risk reduction strategies in mechanically ventilated buildings. We confirm two commonly held priors: 1) in-room filtration universally reduces PM2.5, while enhancing ventilation rates can increase PM2.5 depending on the quality of the HVAC intake filter and the concentration and size distribution of outdoor aerosol and 2) enhanced ventilation is the only strategy that reduces the indoor concentration of CO2 and indoor sourced VOC, but often at the expense of O3 and PM2.5. Uniquely, the model predicts the balance of O3, and aerosol production driven by the infiltration of outdoor air and photochemically driven indoor air chemistry, where chemical processes are less intuitive. We show that the response of commonly measured proxies for IAQ (e.g., CO2) do not always coincide with an overall improvement in indoor air quality.
- 17 March 2022
- Published by Springer Nature in Biogeochemistry
- Vol. 159 (1) , 87-102
Temporal patterns in sediment, carbon, and nutrient burial in ponds associated with changing agricultural tillage
- 17 March 2022
- Published by Springer Nature in Biogeochemistry
- Vol. 159 (1) , 87-102
Temporal patterns in sediment, carbon, and nutrient burial in ponds associated with changing agricultural tillage