YHYujun Hao

Yujun Hao

*This is an algorithmically generated author record based on publicly available information.

Yujun Hao has a total of 9 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    The Dynamic Prediction Method for Aircraft Cabin Temperatures Based on Flight Test Data

    by He Li, Jianjun Zhang, Liangxu Cai, Minwei Li, Yun Fu, Yujun Hao

    For advanced aircraft, the temperature environment inside the cabin is very severe due to the high flight speed and the compact concentration of the electronic equipment in the cabin. Accurately predicting the temperature environment induced inside the cabin during the flight of the aircraft can determine the temperature environment requirements of the onboard equipment inside the cabin and provide an accurate input for the thermal design optimization and test verification of the equipment. The temperature environment of the whole aircraft is divided into zones by the cluster analysis method; the heat transfer mechanism of the aircraft cabin is analyzed for the target area; and the influence of internal and external factors on the thermal environment is considered to establish the temperature environment prediction model of the target cabin. The coefficients of the equations in the model are parameterized to extract the long-term stable terms and trend change terms; with the help of the measured data of the flight state, the model coefficients are determined by a stepwise regression method; and the temperature value inside the aircraft cabin is the output by inputting parameters such as flight altitude, flight speed, and external temperature. The model validation results show that the established temperature environment prediction model can accurately predict the change curve of the cabin temperature during the flight of the aircraft, and the model has a good follow-up performance, which reduces the prediction error caused by the temperature hysteresis effect. For an aircraft, the estimated error is 2.8 °C at a confidence level of 95%. Engineering cases show that the application of this method can increase the thermal design requirements of the airborne equipment by 15 °C, increase the low-temperature test conditions by 17 °C, and avoid the problems caused by an insufficient design and over-testing. This method can accurately predict the internal temperature distribution of the cabin during the flight state of the aircraft, help designers determine the thermal design requirements of the airborne equipment, modify the thermal design and temperature test profile, and improve the environmental worth of the equipment.


  • Open Access

    Temperature and Moisture Dependent Dielectric and Thermal Properties of Walnut Components Associated with Radio Frequency and Microwave Pasteurization

    by Yuxiao Mao, Yujun Hao, Xiangyu Guan, Penghao Wang, Shaojin Wang

    To provide necessary information for further pasteurization experiments and computer simulations based on radio frequency (RF) and microwave (MW) energy, dielectric and thermal properties of walnut components were measured at frequencies between 10 and 3000 MHz, temperatures between 20 and 80 °C, and moisture contents of whole walnuts between 8.04% and 20.01% on a dry basis (d.b.). Results demonstrated that dielectric constants and loss factors of walnut kernels and shells decreased dramatically with raised frequency within the RF range from 10 to 300 MHz, but then reduced slightly within the MW range from 300 to 3000 MHz. Dielectric constant, loss factor, specific heat capacity, and thermal conductivity increased with raised temperature and moisture content. Dielectric loss factors of kernels were greater than those of shells, leading to a higher RF or MW heating rate. Penetration depth of electromagnetic waves in walnut components was found to be greater at lower frequencies, temperatures, and moisture contents. The established regression models with experimental results could predict both dielectric and thermal properties with large coefficients of determination (R2 > 0.966). Therefore, this study offered essential data and effective guidance in developing and optimizing RF and MW pasteurization techniques for walnuts using both experiments and mathematical simulations.