HHHuarui Hu

Huarui Hu

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Huarui Hu has a total of 20 co-authors. Here are the top co-authors by number of shared publications:

  • Zepeng Wang

    State Key Laboratory Cultivation Base for Gas Geology and Gas Control, Henan Polytechnic University 2 , Jiaozuo 454000

    3 shared publications
  • Chenguang Liu

    State Key Laboratory Cultivation Base for Gas Geology and Gas Control, Henan Polytechnic University 2 , Jiaozuo 454000

    2 shared publications
  • Haowen Chen

    State Key Laboratory Cultivation Base for Gas Geology and Gas Control, Henan Polytechnic University 2 , Jiaozuo 454000

    2 shared publications
  • Mengru Zeng

    Department of Civil, Environmental and Ocean Engineering, Stevens Institute of Technology 4 , Hoboken, New Jersey 07030

    2 shared publications
  • Mengting Wang

    School of Resources and Safety Engineering, Chongqing University 3 , Chongqing 400044

    2 shared publications
  • Cancan Chen

    School of Water Conservancy and Transportation, Zhengzhou University, Zhengzhou, China

    1 shared publication

Latest Publications

  • Open Access

    Distribution and flow of methane and water in kaolinite nanoslits

    by Yafei Luo, Zhangkai Zheng, Huarui Hu, Qiangwei Lin, Fei Huang, Pengfei Wang

    Inorganic mineral pores in coal are highly effective conduits for the transport of methane and water but are primary sites for water blocking. Current research on methane/water two-phase flow in coal focuses on pores in organic matter, and few studies have been performed on inorganic mineral pores. Inorganic materials are typically hydrophilic, making it essential to investigate the distribution and transport of two-phase flow in inorganic mineral nanofluidic channels. In this study, a nanoscale kaolinite slit model was constructed using results from scanning electron microscopy and energy dispersive spectroscopy Molecular dynamics simulations were conducted on methane and water in the model. The influence of water saturation, pressure differential, and pore size on two-phase flow was systematically analyzed. Water molecules preferentially adsorb onto the surface of kaolinite channels. With increasing water saturation, the water molecules order into various structures, such as films, bridges, and locks. The presence of water substantially reduces the space available for methane flow. As the water saturation increases, for methane, the peak density near the channel walls decreases, the distribution gradually becomes parabolic, and the flow rate decreases considerably (particularly for 0–45% water saturation). At 45% water saturation, the methane flow rate is 69.46% lower than that for single-phase methane flow. Both the water and methane flow rates increase with the pore size, but the effect is stronger for water than for methane. These findings provide valuable insights into the underlying mechanisms of water blockage and could make production performance prediction more accurate.

  • Effects of different water-based fracturing fluids on mechanical properties and energy evolution of deep coal under true triaxial loading

    by Huarui Hu, Zepeng Wang, Mengting Wang, Mengru Zeng, Chenguang Liu, Haowen Chen

    In order to investigate the impact of fracturing fluid invasion on the mechanical degradation of deep coal, coal samples treated with five promising fracturing fluids were used for true triaxial compression tests in deep conditions. Due to water–rock reactions, lubrication, and the water wedge effect, the compressive strength of coal samples decreased. The decrease was most significant for coal samples treated with hydrofluoric (HF). The total energy and elastic strain energy of the coal samples first increased and then decreased. In contrast, the dissipation energy increased gradually, and the energy dissipation ratio exhibited a U-shape, decreasing initially and then increasing, with a turning point at the peak strain. However, the inflection point was delayed to varying degrees following treatment with viscoelastic surfactant fracturing fluid (VESFF) and acidic fracturing fluid (AFF), with the delay being more pronounced for AFF. The coal samples treated with anionic VESFF and hydrochloric acid exhibited the highest peaks of total energy and elastic strain energy, along with the fastest growth rate of dissipated energy and the most rapid decrease in the energy dissipation ratio, whereas the coal samples treated with HF exhibited the opposite behavior. All coal samples primarily exhibited shear damage, with a small number of tensile cracks appearing near the shear surface in the VESFF-treated coal samples. The coal samples treated with two types of AFF exhibited shear-tensile composite damage, while the HF-treated coal samples displayed X-shaped cracks. In summary, VESFF holds significant potential for future applications in the development of deep ECBM.


  • Effects of physical modification on permeability evolution of coal under CO2–water

    by Jingwei Zheng, Huarui Hu, Cancan Chen, Xiang Zhang, Chengtian Li

    The deep coal seam is the ideal place for CO2 geological storage, and its permeability is the key index to evaluate the geological storage ability. In this study, permeability tests on coal samples under triaxial stress were conducted. Combined with nuclear magnetic resonance and x-ray diffraction tests, the physical modification mechanism of coal sample under the action of water–CO2 and its effect on permeability were discussed. The results indicate that, due to effective stress and adsorption expansion, the internal pores of the coal samples are compressed and closed, resulting in narrower seepage channels. Under varying effective stress conditions, the permeability of coal samples with different moisture contents decreases before CO2 adsorption, after CO2 adsorption, and after CO2 desorption, as moisture content increases. However, due to competitive adsorption between water and CO2, the permeability of coal samples after CO2 injection is lower than that before injection. Under the combined effects of water and CO2, the coal matrix experiences complex interactions leading to mineral dissolution, precipitation accumulation, and changes in the composition and pore structure of the coal samples. After CO2 desorption, the permeability of coal samples exhibits an “M”-shaped change with increasing moisture content. The permeability of samples with 5.6% moisture content was lower than that before CO2 injection, whereas the permeability of other samples increased. The sample with moisture content of 2.8% showed the highest permeability, with the largest proportion of mesopores and macropores providing seepage channels. In contrast, the sample with moisture content of 5.6% had a reduced macropore volume proportion, making macropores the dominant factor in permeability. Based on these findings, a permeability model for coal samples was derived and its accuracy verified. The study reveals the influence mechanism of adsorption expansion, effective stress, and moisture content on the permeability of coal samples.