RWRuidong Wu

Ruidong Wu

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Ruidong Wu has a total of 21 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Case Study of Dynamic Stratified Production Allocation and Remaining Oil Evaluation in Offshore Multilayer Commingled Reservoirs with Strong Aquifers

    by Fang Ding, Gangxiang Song, Ruidong Wu, Yan Jin, Peng Zhou, Xiukun Wang

    After prolonged development, offshore edge- and bottom-water reservoirs have entered an ultra-high water-cut stage. Under long-time multilayer commingled production conditions, accurate dynamic quantification of layer-wise production remains technically challenging, and conventional production allocation approaches often lack the accuracy required for fine-scale reservoir management. To address these challenges, this study proposes a production allocation method that integrates static reservoir properties, dynamic production performance, and pressure-based correction. The resulting layer-wise allocation provides a quantitative basis for evaluating remaining oil utilization and delineating the distribution of remaining oil across individual layers. The method is formulated on the basis of a pseudo-steady-state productivity model that incorporates wellbore imperfection effects. The initial production rate of each layer is calculated by combining reservoir transmissibility with production pressure drawdown. To account for unequal pressure responses among layers under commingled production—resulting from pressure imbalance, limited edge- and bottom-water energy support, and interlayer interference—a correction factor is introduced to adjust the effective production contribution of low-pressure layers. Compared with the PLT test results, the average error of the conventional KH method was 16.7%, whereas the average error of the proposed method was reduced to 6.1%. The average error was reduced from 16.7% to 6.1%, corresponding to a 63.5% reduction in prediction error, indicating that the proposed approach can provide a more reliable estimation of layered production contribution. The proposed method enables continuous and dynamic production allocation for commingled wells without the need for frequent surveys, offering a practical tool for identifying multilayer production imbalance, evaluating remaining potential, and supporting development optimization in offshore oilfields.

  • Open Access

    Mechanistic Insights into Brine Domain Assembly Regulated by Natural Potential Field: A Molecular Dynamics Exploration in Porous Media

    by Xiaoman Leng, Yajun Wang, Yueying Wang, Zhixue Sun, Shuangyan Kou, Ruidong Wu, Yifan Xu, Yufeng Jiang

    The behavior of brine solution in the porous media of the strata is of great significance for geological environment regulation. In this study, a molecular dynamics model with silicon dioxide walls was constructed to reveal the regulatory mechanism of the natural potential of the electric field on cluster aggregation. It was found that the critical electric field intensity was 7 V/m. When the electric field intensity was lower than this value, the aggregation rate was only increased by 0.73 times due to thermal motion; when it was higher than this value, the rate increased sharply by 3.2 times due to the dominant effect of electric field force. The microscopic structure analysis indicated that the strong electric field induced the transformation of clusters from fractal structure into an amorphous structure (the index of the order degree increased by 58%). The directional regulation experiments confirmed that the axial electric field led to anisotropic growth (the index of uniformity increased by 0.58 ± 0.04), and the rotational electric field could achieve a three-dimensional uniform distribution (the index of uniformity increased by 42%). This study provides theoretical support for the regulation of brine behavior and the optimization of geological energy storage.

  • Open Access

    Integrating Stochastic Geological Modeling and Injection–Production Optimization in Aquifer Underground Gas Storage: A Case Study of the Qianjiang Basin

    by Yifan Xu, Zhixue Sun, Wei Chen, Beibei Yu, Jiqin Liu, Zhongxin Ren, Yueying Wang, Chenyao Guo, Ruidong Wu, Yufeng Jiang

    Addressing the critical challenges of sealing integrity and operational optimization in aquifer gas storage (AGS), this study focuses on a block within the Qianjiang Basin to systematically investigate geological modeling and injection–production strategies. Utilizing 3D seismic interpretation, drilling, and logging data, a stochastic geological modeling approach was employed to construct a high-resolution 3D reservoir model, elucidating the distribution of reservoir properties and trap configurations. Numerical simulations optimized the gas storage parameters, yielding an injection rate of 160 MMSCF/day (40 MMSCF/well/day) over 6-month-long hot seasons and a production rate of 175 MMSCF/day during 5-month-long cold seasons. Interval theory was innovatively applied to assess fault stability under parameter uncertainty, determining a maximum safe operating pressure of 23.5 MPa—12.3% lower than conventional deterministic results. The non-probabilistic reliability analysis of caprock integrity showed a maximum 11.1% deviation from Monte Carlo simulations, validating the method’s robustness. These findings establish a quantitative framework for site selection, sealing system evaluation, and operational parameter design in AGS projects, offering critical insights to ensure safe and efficient gas storage operations. This work bridges theoretical modeling with practical engineering applications, providing actionable guidelines for large-scale AGS deployment.


  • Open Access

    Study on Calculation Method for Wellbore Pressure in Gas Wells with Large Liquid Production

    by Yang Cheng, Ruidong Wu, Ruiquan Liao, Zilong Liu

    In order to solve the inaccuracy in the calculation of the wellbore pressure distribution caused by large liquid production in the Donghai gas field, the gas–liquid production conditions of the Donghai gas field were simulated with indoor experiments, and the flow patterns for different pipe diameters, different inclinations, and different flow patterns were systematically analyzed using a flow pattern discrimination method, liquid holdup calculation method, and pressure drop calculation method. Using the experimental data, the division methods for different flow patterns were screened. Finally, based on the fact that the change trend for the flow patterns was consistent, the Kaya–Sarica–Brill method was selected to establish the flow pattern discrimination formula. According to the calculation method for the Mukherjee and Brill (M–B) liquid holdup, the M–B model was re-established according to a 75 mm pipe diameter and 60 mm pipe diameter using the instantaneous liquid holdup measured in the laboratory. Through the comparison and analysis of the measured data and the calculated data for the Beggs and Brill (B–B_ pressure drop model under the same working conditions, it was found that when the B–B model was applied to different angles and different gas–liquid ratios, the error decreased with an increase in the angle and increased with a decrease in the gas–liquid ratio. After verifying the correlation of different dimensionless numbers that can characterize the gas–liquid ratio, it was considered that the introduction of the Reynolds number into the original model could greatly improve the accuracy of the calculation, so a new pressure drop calculation model was established. The new pressure drop calculation model takes into account the two parameters of the well deviation angle and gas–liquid ratio. The accuracy was greatly improved, as verified by field measurements in four wells.