Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Thamer Abdulrahman H Alghamdi has a total of 125 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Optimization of solar water pumping systems through a combined approach based on MPPT-Bat and DTC

    by Abdelilah Hilali, Mouncef El Marghichi, Mohamed Makhad, Azeddine Loulijat, Najib el Ouanjli, Mahmoud A. Mossa, Mishari Metab Almalki, Thamer A. H. Alghamdi

    This paper investigates enhancing the efficiency of solar water pumping systems (SWPS) by implementing a Maximum Power Point Tracking technique based on the Bat Metaheuristic Optimizer (MPPT-bat) for the photovoltaic generator (PVG) side, coupled with Direct Torque Control (DTC) for the induction motor powering the pump. Unlike traditional techniques, which make no compromise between tracking speed, oscillation and robustness. The integration of the MPPT-bat represents a significant advance, making it possible to improve PVG performance whatever the weather conditions. The main objective remains to improve the energy efficiency of this type of application by maximizing the electrical power allocated to the SWPS. At the same time, a DTC controller applied to the pump motor aims to optimize the use of the energy generated by the MPPT-bat. This intelligent approach adjusts the motor power according to the power extracted from the PVG, thus avoiding inappropriate profiles for the pumping system. The study confirms that optimizing SWPS using this approach based on MPPT-bat and DTC, significantly improves overall performances in terms of tracking error, oscillations, tracking speed and robustness, promotes more efficient pump rotation and, consequently, increases the flow rate of pumped water, and that these improvements persist under different climate conditions.


  • Open Access

    DRL-PSO Powered Optimization for Efficiency Enhancement and Reliability Improvement in Smart Grids

    by Mohamed A.Wahab Ali, Thamer A. H. Alghamdi, Mohamed Alenezi, Mohammed Hatatah

    The increasing complexity of modern power systems, driven by the integration of renewable energy sources and growing electricity demand, has led to a need for optimizing smart grids. Traditional grid management approaches are often insufficient in addressing the challenges of efficiency, reliability, and minimizing losses. In this paper, we propose a novel AI-based optimization framework for smart grids, designed to reduce transmission and distribution losses, enhance system efficiency, and improve grid reliability. We conduct a comparative analysis of traditional optimization techniques and state-of-the-art AI algorithms and demonstrate the superiority of the proposed method using the IEEE 33-bus benchmark system. Results show a significant reduction in power losses and an improvement in voltage profile, leading to a more efficient and reliable grid.

  • Open Access

    Research Insights on Recent Power Converter Topologies and Control Strategies for Wireless EV Chargers: A Comprehensive Study

    by Venugopal Ramadoss, Balaji Chandrasekar, M.M.R. Ahmed, Dominic Savio A, Narayanamoorthi Rajamanickam, Thamer A. H. Alghamdi

    Electric vehicles (EVs) penetrating the transportation sector are accelerated through environmental concerns, low prices, and increased power density. At the same time, the technologies for wireless charging of EVs are advancing due to their convenience, cost-effectiveness, and reliability as charging solutions. The crucial part of Wireless EV (W-EV) chargers, apart from charging pads and compensation, is the power electronics converters. These converters are essential for converting electrical energy into an appropriate form for efficient transmission and reception. This article provides a comprehensive review of the recent advancements in power converter topologies and their control methods used in W-EV chargers. Depending on the specific requirements of the W-EV charger, these converters can be classified into DC-DC, DC-AC, AC-AC, and AC-DC converters. In addition, the article explores specialized converters such as multiple-stage, multiple-phase, multiple transmitter and multiple receiver-based converters, discussing their technical details, merits and limitations. The control techniques for the power electronics converters utilised in W-EV chargers such as transmitter-side control, receiver-side control and dual controls are presented along with various technical comparative analyses. Challenges and future research directions in advanced power converter topologies for W-EV chargers are outlined at last. This article assists researchers in gaining insights into the recent technological advancements and developments aimed at enhancing the performance of the W-EV charger.


  • Open Access

    A hybrid residue based sequential encoding mechanism with XGBoost improved ensemble model for identifying 5-hydroxymethylcytosine modifications

    by Islam Uddin, Hamid Hussain Awan, Majdi Khalid, Salman Khan, Shahid Akbar, Mahidur R. Sarker, Maher G. M. Abdolrasol, Thamer A. H. Alghamdi

    RNA modifications play an important role in actively controlling recently created formation in cellular regulation mechanisms, which link them to gene expression and protein. The RNA modifications have numerous alterations, presenting broad glimpses of RNA’s operations and character. The modification process by the TET enzyme oxidation is the crucial change associated with cytosine hydroxymethylation. The effect of CR is an alteration in specific biochemical ways of the organism, such as gene expression and epigenetic alterations. Traditional laboratory systems that identify 5-hydroxymethylcytosine (5hmC) samples are expensive and time-consuming compared to other methods. To address this challenge, the paper proposed XGB5hmC, a machine learning algorithm based on a robust gradient boosting algorithm (XGBoost), with different residue based formulation methods to identify 5hmC samples. Their results were amalgamated, and six different frequency residue based encoding features were fused to form a hybrid vector in order to enhance model discrimination capabilities. In addition, the proposed model incorporates SHAP (Shapley Additive Explanations) based feature selection to demonstrate model interpretability by highlighting the high contributory features. Among the applied machine learning algorithms, the XGBoost ensemble model using the tenfold cross-validation test achieved improved results than existing state-of-the-art models. Our model reported an accuracy of 89.97%, sensitivity of 87.78%, specificity of 94.45%, F1-score of 0.8934%, and MCC of 0.8764%. This study highlights the potential to provide valuable insights for enhancing medical assessment and treatment protocols, representing a significant advancement in RNA modification analysis.


  • Open Access

    Multi-objective resistance-capacitance optimization algorithm: An effective multi-objective algorithm for engineering design problems

    by Sowmya Ravichandran, Premkumar Manoharan, Deepak Kumar Sinha, Pradeep Jangir, Laith Abualigah, Thamer A.H. Alghamdi


  • Open Access

    A Fractional Order-Kepler Optimization Algorithm (FO-KOA) for single and double-diode parameters PV cell extraction

    by Sultan Hassan Hakmi, Hashim Alnami, Ahmed Ginidi, Abdullah Shaheen, Thamer A.H. Alghamdi


  • Open Access

    Impact of mustard biodiesel and clove oil additives on particulate matter emission and carbon deposition in diesel engines

    by Sajjad Bhangwar, Muhammad Ramzan Luhur, Gordhan Das Walasai, Thamer A. H. Alghamdi

    Recent studies suggest that the world is facing an energy crisis due to the depletion of fossil fuel reserves. To combat this issue, researchers have turned to biodiesel, a renewable bioenergy source made from vegetable oils, microalgae, and animal fats. A recent study analysed engine parts’ particulate matter emissions and carbon deposition during the long-term use of mustard biodiesel and clove oil as antioxidants in a compression ignition engine. Three samples of fuels: DF (diesel fuel), B30 (30% mustard biodiesel and 70% DF), and biodiesel blended fuel with 3000 PPM in a single-cylinder CI engine. The use of 30% biodiesel in diesel fuel (B30) for the endurance test was based on a good mix. The engine was run for 100 h to investigate the particulate matter emissions and carbon deposition. The particulate matter emission data was collected every 25 h, and for carbon deposition, the engine’s fuel injector was turned off after 100 h of engine running. The results showed a reduction in particulate matter emissions of about 9.97%, 13.367%, 7.24%, 14.64%, 5.3%, 12.32%, 1.88%, and 7.99% for PM1, PM2.5, PM7, and PM10 in biodiesel blended fuel and biodiesel blended fuel with clove oil, respectively. The deposition of clove oil added to biodiesel blended fuel in the fuel injector has been reduced compared with the other fuels. Carbon deposition of the fuel injector was analysed through SEM and EDX tests, and the results showed that the carbon content in biodiesel blended fuel was lower than in diesel fuel. The deposition of clove oil added to biodiesel blended fuel in the fuel injector has been reduced compared with biodiesel blended fuel.


  • Open Access

    An artificial gorilla troops optimizer for stochastic unit commitment problem solution incorporating solar, wind, and load uncertainties

    by Mahmoud Rihan, Aml Sayed, Adel Bedair Abdel-Rahman, Mohamed Ebeed, Thamer A. H. Alghamdi, Hossam S. Salama

    The unit commitment (UC) optimization issue is a vital issue in the operation and management of power systems. In recent years, the significant inroads of renewable energy (RE) resources, especially wind power and solar energy generation systems, into power systems have led to a huge increment in levels of uncertainty in power systems. Consequently, solution the UC is being more complicated. In this work, the UC problem solution is addressed using the Artificial Gorilla Troops Optimizer (GTO) for three cases including solving the UC at deterministic state, solving the UC under uncertainties of system and sources with and without RE sources. The uncertainty modelling of the load and RE sources (wind power and solar energy) are made through representing each uncertain variable with a suitable probability density function (PDF) and then the Monte Carlo Simulation (MCS) method is employed to generate a large number of scenarios then a scenario reduction technique known as backward reduction algorithm (BRA) is applied to establish a meaningful overall interpretation of the results. The results show that the overall cost per day is reduced from 0.2181% to 3.7528% at the deterministic state. In addition to that the overall cost reduction per day is 19.23% with integration of the RE resources. According to the results analysis, the main findings from this work are that the GTO is a powerful optimizer in addressing the deterministic UC problem with better cost and faster convergence curve and that RE resources help greatly in running cost saving. Also uncertainty consideration makes the system more reliable and realistic.


  • Open Access

    Sustainable Strategies for Crystalline Solar Cell Recycling: A Review on Recycling Techniques, Companies, and Environmental Impact Analysis

    by Mina Akhter, Ahmed Al Mansur, Imamul Islam, M. S. Hossain Lipu, Tahia F. Karim, Maher G. M. Abdolrasol, Thamer A. H. Alghamdi

    Solar PV is gaining increasing importance in the worldwide energy industry. Consequently, the global expansion of crystalline photovoltaic power plants has resulted in a rise in PV waste generation. However, disposing of PV waste is challenging and can pose harmful chemical effects on the environment. Therefore, developing technologies for recycling crystalline silicon solar modules is imperative to improve process efficiency, economics, recovery, and recycling rates. This review offers a comprehensive analysis of PV waste management, specifically focusing on crystalline solar cell recycling. The classification of PV recycling companies based on various components, including solar panels, PV glass, aluminum frames, silicon solar cells, junction boxes, plastic, back sheets, and cables, is explored. Additionally, the survey includes an in-depth literature review concentrating on chemical treatment for crystalline solar cell recycling. Furthermore, this study provides constructive suggestions for PV power plants on how to promote solar cell recycling at the end of their life cycles, thereby reducing their environmental impact. Moreover, the techno-economic and environmental dimensions of solar cell recycling techniques are investigated in detail. Overall, this review offers valuable insights into the challenges and opportunities associated with crystalline solar cell recycling, emphasizing the importance of economically feasible and environmentally sustainable PV waste management solutions in the constantly evolving solar energy market.


  • Open Access

    Decentralized Community Energy Management: Enhancing Demand Response Through Smart Contracts in a Blockchain Network

    by Abdullah Umar, Deepak Kumar, Tirthadip Ghose, Thamer A. H. Alghamdi, Almoataz Y. Abdelaziz

    The integration of distributed energy resources (DERs) and digital technologies has accelerated the transition to decentralized energy systems. Among these technologies, blockchain stands out for its ability to facilitate peer-to-peer (P2P) energy trading efficiently and securely. This paper explores the concept of P2P energy trading within community microgrid systems, leveraging blockchain-based smart contracts. The proposed system integrates an incentive-driven demand response program directly into the smart contract framework, offering real-time rewards for load-balancing contributions. By incorporating the microgrid’s Energy Management System (EMS) and transparently recording all transactions on the blockchain, the proposed platform provides detailed data and immediate reward distribution. At the core of our system lies the Supply to Demand Ratio (SDR), ensuring fair energy exchange within the community. Dynamic pricing, enabled by blockchain and Tether (USDT) cryptocurrency, adjusts to real-time market conditions, enhancing transparency and responsiveness in energy trading. This adaptive pricing model fosters a more equitable and efficient trading environment compared to static approaches. Moreover, this system is tailored for community microgrids, emphasizing a community-centric approach. Local prosumers serve as validators in the blockchain network, aligning energy management decisions with community needs and dynamics. This localized engagement promotes efficiency and participation, fostering resilient, sustainable, and user-centric energy landscapes. Through rigorous analysis, we demonstrate the system’s effectiveness in optimizing economic efficiency, reducing operational costs, and increasing compliance rates. By combining blockchain technology with community-focused design principles, the proposed platform represents a significant advancement towards self-sufficiency and resilience in local energy systems.