P. Duraipandy
P. Duraipandy has a total of 27 co-authors. Here are the top co-authors by number of shared publications:
- A V Prabhu
Department of Electronics and Communication Engineering, Koneru Lakshmaiah Education Foundation, Guntur, India
1 shared publication - Abdullah Mohamed
Research Centre, Future University in Egypt, New Cairo, Cairo 11745, Egypt
1 shared publication - Aseela Sweatha
Annamalai University
1 shared publication - Ashit Kumar Dutta
Department of Computer Science and Information Systems, College of Applied Sciences, AlMaarefa University, Riyadh, Saudi Arabia
1 shared publication - Balasubramanian Baskaran
Annamalai University
1 shared publication - C Sundar Ganesh
Department of Electrical and Electronics Engineering, Karpagam College of Engineering, Coimbatore, Tamil Nadu 641032, India
1 shared publication
Latest Publications
- 23 January 2024
- Published by Springer Nature
- p. 99-110
Performance Analysis of IPM and SPM-Based BLDC Motor Using JMAG Software
- 23 January 2024
- Published by Springer Nature
- p. 99-110
Performance Analysis of IPM and SPM-Based BLDC Motor Using JMAG Software
- Open Access
- 1 December 2023
- Published by Institute of Advanced Engineering and Science in International Journal of Applied Power Engineering (IJAPE)
- Vol. 12 (4) , 416-428
A novel voltage lifting technique of switched-inductor cell based modified LUO converter topology for water pumping system
The persistent exhaustion of traditional energy sources with their impacts on the environment has been initiating a significant interest in a selection of renewable-energy sources (RES) based water-pumping system. Among several renewable sources, solar-PV is the most promising and practical source for water-pumping applications that can be easily installed on a building's roof. The available solar-PV energy is integrated to AC electric motor through front-end DC-DC boost converter topology. Among the various DC-DC converter topologies, a novel switched-inductor type modified LUO converter has been proposed for solar-PV powered water pumping system. The proposed switched-inductor type modified LUO (SI-MLUO) converter have simple structure which delivers high voltage gain with low leakage currents, low current ripples, reduced voltage spikes, low dv/dt stress and high efficiency over the several conventional DC-DC converters. The operating modes and performance of proposed SI-MLUO converter topology is verified by using MATLAB/Simulink tool, simulation results are validated with conventional topologies.
- 1 December 2023
- Published by Institute of Advanced Engineering and Science in International Journal of Applied Power Engineering (IJAPE)
- Vol. 12 (4) , 416-428
Open AccessA novel voltage lifting technique of switched-inductor cell based modified LUO converter topology for water pumping system
The persistent exhaustion of traditional energy sources with their impacts on the environment has been initiating a significant interest in a selection of renewable-energy sources (RES) based water-pumping system. Among several renewable sources, solar-PV is the most promising and practical source for water-pumping applications that can be easily installed on a building's roof. The available solar-PV energy is integrated to AC electric motor through front-end DC-DC boost converter topology. Among the various DC-DC converter topologies, a novel switched-inductor type modified LUO converter has been proposed for solar-PV powered water pumping system. The proposed switched-inductor type modified LUO (SI-MLUO) converter have simple structure which delivers high voltage gain with low leakage currents, low current ripples, reduced voltage spikes, low dv/dt stress and high efficiency over the several conventional DC-DC converters. The operating modes and performance of proposed SI-MLUO converter topology is verified by using MATLAB/Simulink tool, simulation results are validated with conventional topologies.
- Open Access
- 21 November 2022
- Published by MDPI AG in Preprints.org
A Novel Energy Optimization System for Renewable Demand using Heuristics, Distributed Systems, and Machine Learning in a Smart City
Transportation, environmental conditions, quality of human life within smart cities, and system infrastructure have all needed practical and dependable smart solutions as urbanization has accelerated in recent years. In addition, the emerging Internet of Things (IoT) provides access to a plethora of cutting-edge, all-encompassing apps for smart cities, all of which contribute significantly to lowering energy consumption and other negative environmental impacts. For smart cities to meet the challenge of using less energy, the authors of this research article suggest planning and implementing an integrated power and heat architecture that puts renewable energy infrastructure and energy-storage infrastructure at the top of the list. To address these issues, we describe a smart proposed NEOSRD architecture that uses a distributed smart area domain to optimize renewable demand energy in a smart city across a wide area network. The energy requirements of desalination procedures are negligible when compared to the total local energy consumption and transportation, a feat accomplished by the proposed NEOSRD system. Here, the computational model shows how the established system is a valuable response to our problems and a cost-effective strategy for creating smarter structural elements that cut down on overall smart cities' energy costs.
- 21 November 2022
- Published by MDPI AG in Preprints.org
Open AccessA Novel Energy Optimization System for Renewable Demand using Heuristics, Distributed Systems, and Machine Learning in a Smart City
Transportation, environmental conditions, quality of human life within smart cities, and system infrastructure have all needed practical and dependable smart solutions as urbanization has accelerated in recent years. In addition, the emerging Internet of Things (IoT) provides access to a plethora of cutting-edge, all-encompassing apps for smart cities, all of which contribute significantly to lowering energy consumption and other negative environmental impacts. For smart cities to meet the challenge of using less energy, the authors of this research article suggest planning and implementing an integrated power and heat architecture that puts renewable energy infrastructure and energy-storage infrastructure at the top of the list. To address these issues, we describe a smart proposed NEOSRD architecture that uses a distributed smart area domain to optimize renewable demand energy in a smart city across a wide area network. The energy requirements of desalination procedures are negligible when compared to the total local energy consumption and transportation, a feat accomplished by the proposed NEOSRD system. Here, the computational model shows how the established system is a valuable response to our problems and a cost-effective strategy for creating smarter structural elements that cut down on overall smart cities' energy costs.
- Open Access
- 3 April 2022
- Published by MDPI AG in Healthcare
- Vol. 10 (4) , 677
Intelligent Deep-Learning-Enabled Decision-Making Medical System for Pancreatic Tumor Classification on CT Images
Decision-making medical systems (DMS) refer to the design of decision techniques in the healthcare sector. They involve a procedure of employing ideas and decisions related to certain processes such as data acquisition, processing, judgment, and conclusion. Pancreatic cancer is a lethal type of cancer, and its prediction is ineffective with current techniques. Automated detection and classification of pancreatic tumors can be provided by the computer-aided diagnosis (CAD) model using radiological images such as computed tomography (CT) and magnetic resonance imaging (MRI). The recently developed machine learning (ML) and deep learning (DL) models can be utilized for the automated and timely detection of pancreatic cancer. In light of this, this article introduces an intelligent deep-learning-enabled decision-making medical system for pancreatic tumor classification (IDLDMS-PTC) using CT images. The major intention of the IDLDMS-PTC technique is to examine the CT images for the existence of pancreatic tumors. The IDLDMS-PTC model derives an emperor penguin optimizer (EPO) with multilevel thresholding (EPO-MLT) technique for pancreatic tumor segmentation. Additionally, the MobileNet model is applied as a feature extractor with optimal auto encoder (AE) for pancreatic tumor classification. In order to optimally adjust the weight and bias values of the AE technique, the multileader optimization (MLO) technique is utilized. The design of the EPO algorithm for optimal threshold selection and the MLO algorithm for parameter tuning shows the novelty. A wide range of simulations was executed on benchmark datasets, and the outcomes reported the promising performance of the IDLDMS-PTC model on the existing methods.
- 3 April 2022
- Published by MDPI AG in Healthcare
- Vol. 10 (4) , 677
Open AccessIntelligent Deep-Learning-Enabled Decision-Making Medical System for Pancreatic Tumor Classification on CT Images
Decision-making medical systems (DMS) refer to the design of decision techniques in the healthcare sector. They involve a procedure of employing ideas and decisions related to certain processes such as data acquisition, processing, judgment, and conclusion. Pancreatic cancer is a lethal type of cancer, and its prediction is ineffective with current techniques. Automated detection and classification of pancreatic tumors can be provided by the computer-aided diagnosis (CAD) model using radiological images such as computed tomography (CT) and magnetic resonance imaging (MRI). The recently developed machine learning (ML) and deep learning (DL) models can be utilized for the automated and timely detection of pancreatic cancer. In light of this, this article introduces an intelligent deep-learning-enabled decision-making medical system for pancreatic tumor classification (IDLDMS-PTC) using CT images. The major intention of the IDLDMS-PTC technique is to examine the CT images for the existence of pancreatic tumors. The IDLDMS-PTC model derives an emperor penguin optimizer (EPO) with multilevel thresholding (EPO-MLT) technique for pancreatic tumor segmentation. Additionally, the MobileNet model is applied as a feature extractor with optimal auto encoder (AE) for pancreatic tumor classification. In order to optimally adjust the weight and bias values of the AE technique, the multileader optimization (MLO) technique is utilized. The design of the EPO algorithm for optimal threshold selection and the MLO algorithm for parameter tuning shows the novelty. A wide range of simulations was executed on benchmark datasets, and the outcomes reported the promising performance of the IDLDMS-PTC model on the existing methods.
- Open Access
- 1 January 2021
- Published by International Journal of Renewable Energy Research in International Journal of Renewable Energy Research
- Vol. 14 (v11i2) , 101-110
Optimized Controller Design for Renewable Energy Systems by using Deep Reinforcement Learning Technique
Optimized Controller Design for Renewable Energy Systems by using Deep Reinforcement Learning Technique
- 1 January 2021
- Published by International Journal of Renewable Energy Research in International Journal of Renewable Energy Research
- Vol. 14 (v11i2) , 101-110
Open AccessOptimized Controller Design for Renewable Energy Systems by using Deep Reinforcement Learning Technique
Optimized Controller Design for Renewable Energy Systems by using Deep Reinforcement Learning Technique