Debanik Das
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Debanik Das has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
- L. R. Ram-Mohan
Department of Physics Worcester Polytechnic Institute 01609 Worcester MA
3 shared publications - Robert Bedford
Air Force Research Laboratory
3 shared publications - Heather J. Haugan
Air Force Research Lab. (United States)
2 shared publications K. G. Eyink
Air Force Research Laboratory, Materials and Manufacturing Directorate, Wright-Patterson Air Force Base 1 , Ohio 45433, USA
2 shared publicationsK. Mahalingam
Air Force Research Laboratory, Materials and Manufacturing Directorate, Wright-Patterson Air Force Base 1 , Ohio 45433, USA
2 shared publications- Chandriker Kavir Dass
Department of Physics and Center for Complex Quantum Systems, University of Texas at Austin, Austin, Texas 78712, USA
1 shared publication
Latest Publications
- Open Access
- 3 February 2023
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 133 (5)
Tapered resonator-based phononic crystal: Avoided level crossings, robust self-collimation, and bi-refringence
In search of novel phononic crystals to effectively control the propagation of elastic waves, we propose a new single-material phononic crystal (PnC) with unit cells containing tapered resonators (TRs). The thickness of the circular taper radially decreases outward from the center. The device modulates dispersion of the wave by a local resonance mechanism and by slowly varying the group velocity of elastic waves. The TRs are layered on the top of a conventional PnC slab with a square arrangement of air holes. The band structure of the PnC is theoretically studied and a comparison is drawn between the avoided level crossings and the symmetry-protected ordinary degeneracies. In the absence of a bandgap, the zero group velocity at the band maximum restricts the waves from propagating. Moreover, the design shows anomalous dispersion phenomena such as self-collimation and bi-refringence, which are rare in conventional PnCs. We trace the origins of these phenomena by analyzing equifrequency contours associated with relevant frequencies. We show that the self-collimation effect persists even with a small variation in the angle of incidence and a perturbative hole at the center of each of the TRs. Within the classical limit, the scale invariance of the elastic wave equation makes the device useful in both the low frequency ultrasonic and the high frequency phononic regime.
- 3 February 2023
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 133 (5)
Open AccessTapered resonator-based phononic crystal: Avoided level crossings, robust self-collimation, and bi-refringence
In search of novel phononic crystals to effectively control the propagation of elastic waves, we propose a new single-material phononic crystal (PnC) with unit cells containing tapered resonators (TRs). The thickness of the circular taper radially decreases outward from the center. The device modulates dispersion of the wave by a local resonance mechanism and by slowly varying the group velocity of elastic waves. The TRs are layered on the top of a conventional PnC slab with a square arrangement of air holes. The band structure of the PnC is theoretically studied and a comparison is drawn between the avoided level crossings and the symmetry-protected ordinary degeneracies. In the absence of a bandgap, the zero group velocity at the band maximum restricts the waves from propagating. Moreover, the design shows anomalous dispersion phenomena such as self-collimation and bi-refringence, which are rare in conventional PnCs. We trace the origins of these phenomena by analyzing equifrequency contours associated with relevant frequencies. We show that the self-collimation effect persists even with a small variation in the angle of incidence and a perturbative hole at the center of each of the TRs. Within the classical limit, the scale invariance of the elastic wave equation makes the device useful in both the low frequency ultrasonic and the high frequency phononic regime.
- Open Access
- 10 January 2023
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 133 (2)
Study of bulk carrier properties in largely hybridized InAsSb/GaSb superlattice materials
The prospect of implementing quantum device architectures with technologically mature III–V semiconductors requires precisely controlled topologically protected edge states and bulk insulation. However, experimentally reaching this regime with III–V heterostructure epitaxy has been difficult due to charged bulk defects. Charged defects prevent bulk insulation and disturb the stability of edge states. Hence, we study carrier properties in a hybridized III–V InAs0.9Sb0.1/GaSb superlattice (SL) structure. We realize that an electron density (mobility) is limited to approximately 1012 cm−2 (104 cm2/V s). In order to understand these limits, the authors investigate the in-plane mobility of hybridized SLs as a function of current-carrying layer thickness, L, to determine scattering mechanisms that restrict carrier mobility. Although theory predicts the in-plane mobility is proportional to L6 dominated by interface roughness scattering (IRS) at low temperatures, we report that mobility follows the fourth power dependence, which is a weaker than expected from IRS theory. We attribute the discrepancy between experiment and the model to interface intermixing and wave function penetration into barrier regions. We use this understanding to develop a strategy for realizing high-performance topological materials.
- 10 January 2023
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 133 (2)
Open AccessStudy of bulk carrier properties in largely hybridized InAsSb/GaSb superlattice materials
The prospect of implementing quantum device architectures with technologically mature III–V semiconductors requires precisely controlled topologically protected edge states and bulk insulation. However, experimentally reaching this regime with III–V heterostructure epitaxy has been difficult due to charged bulk defects. Charged defects prevent bulk insulation and disturb the stability of edge states. Hence, we study carrier properties in a hybridized III–V InAs0.9Sb0.1/GaSb superlattice (SL) structure. We realize that an electron density (mobility) is limited to approximately 1012 cm−2 (104 cm2/V s). In order to understand these limits, the authors investigate the in-plane mobility of hybridized SLs as a function of current-carrying layer thickness, L, to determine scattering mechanisms that restrict carrier mobility. Although theory predicts the in-plane mobility is proportional to L6 dominated by interface roughness scattering (IRS) at low temperatures, we report that mobility follows the fourth power dependence, which is a weaker than expected from IRS theory. We attribute the discrepancy between experiment and the model to interface intermixing and wave function penetration into barrier regions. We use this understanding to develop a strategy for realizing high-performance topological materials.
- Open Access
- 8 August 2022
- Published by AIP Publishing in Applied Physics Letters
- Vol. 121 (6)
Optimization of hybridized InAsSb/InGaSb semiconductor topological materials
Generating large topologically protected surface currents using conventional III–V infrared materials such as InAsSb/InGaSbAs quantum wells (QWs) and superlattices (SLs) has been important. In such materials, topological states can be formed at the edge by hybridizing ordinary electronic band structures. However, achieving large surface currents out of these materials is still difficult due to low emission currents and high carrier defects. In this work, we present two hybridized topological structures: one for the 6.22 Å metamorphic QWs and the other for the 6.10 Å pseudomorphic SLs. Both structures are tailored for the same hybridization gap (Δ) of ∼60 meV and optimized for the minimum crystal defects. While the QW grown on metamorphic buffers generates a significant amount of mismatch-related crystal defects, the SL grown on lattice-matched buffers produces an excellent crystalline-quality. Quasiparticle interference mapping and calculations on a SL sample show good agreement of the band structure.
- 8 August 2022
- Published by AIP Publishing in Applied Physics Letters
- Vol. 121 (6)
Open AccessOptimization of hybridized InAsSb/InGaSb semiconductor topological materials
Generating large topologically protected surface currents using conventional III–V infrared materials such as InAsSb/InGaSbAs quantum wells (QWs) and superlattices (SLs) has been important. In such materials, topological states can be formed at the edge by hybridizing ordinary electronic band structures. However, achieving large surface currents out of these materials is still difficult due to low emission currents and high carrier defects. In this work, we present two hybridized topological structures: one for the 6.22 Å metamorphic QWs and the other for the 6.10 Å pseudomorphic SLs. Both structures are tailored for the same hybridization gap (Δ) of ∼60 meV and optimized for the minimum crystal defects. While the QW grown on metamorphic buffers generates a significant amount of mismatch-related crystal defects, the SL grown on lattice-matched buffers produces an excellent crystalline-quality. Quasiparticle interference mapping and calculations on a SL sample show good agreement of the band structure.
- 6 April 2022
- Published by Elsevier in Micro and Nanostructures
- Vol. 166
Larger hybridization bandgaps and topological phase transitions in the Sb-based topological insulator superlattices
- 6 April 2022
- Published by Elsevier in Micro and Nanostructures
- Vol. 166
Larger hybridization bandgaps and topological phase transitions in the Sb-based topological insulator superlattices