Davide Rotta
Davide Rotta has a total of 26 co-authors. Here are the top co-authors by number of shared publications:
- Aina Serrano Rodrigo
Inphotec, Inphotec Foundation, Pisa, Pisa, Italy
1 shared publication - Alessandra Bigongiari
Ericsson Research, Ericsson, Pisa, Italy
1 shared publication - Chiara Barri
Istituto di Fotonica e Nanotecnologie, Consiglio Nazionale delle Ricerche, Piazza Leonardo da Vinci 32, I-20133 Milan, Italy
1 shared publication - Costantino Agnesi
Università degli Studi di Padova
1 shared publication - Enrico Prati
Department of Physics Aldo Pontremoli Università degli Studi di Milano Via Celoria 16 20133 Milano Italy
1 shared publication - Erfan Mafakheri
Istituto di Fotonica e Nanotecnologie, Consiglio Nazionale delle Ricerche, Piazza Leonardo da Vinci 32, I-20133 Milan, Italy
1 shared publication
Latest Publications
- Open Access
Fully Integrated Silicon Photonic Erbium-Doped Nanodiode for Few Photon Emission at Telecom Wavelengths
Recent advancements in quantum key distribution (QKD) protocols opened the chance to exploit nonlaser sources for their implementation. A possible solution might consist in erbium-doped light emitting diodes (LEDs), which are able to produce photons in the third communication window, with a wavelength around 1550 nm. Here, we present silicon LEDs based on the electroluminescence of Er:O complexes in Si. Such sources are fabricated with a fully-compatible CMOS process on a 220 nm-thick silicon-on-insulator (SOI) wafer, the common standard in silicon photonics. The implantation depth is tuned to match the center of the silicon layer. The erbium and oxygen co-doping ratio is tuned to optimize the electroluminescence signal. We fabricate a batch of Er:O diodes with surface areas ranging from 1 µm × 1 µm to 50 µm × 50 µm emitting 1550 nm photons at room temperature. We demonstrate emission rates around 5 × 10 photons/s for a 1 µm × 1 µm device at room temperature using superconducting nanowire detectors cooled at 0.8 K. The demonstration of Er:O diodes integrated in the 220 nm SOI platform paves the way towards the creation of integrated silicon photon sources suitable for arbitrary-statistic-tolerant QKD protocols.Open AccessFully Integrated Silicon Photonic Erbium-Doped Nanodiode for Few Photon Emission at Telecom Wavelengths
Recent advancements in quantum key distribution (QKD) protocols opened the chance to exploit nonlaser sources for their implementation. A possible solution might consist in erbium-doped light emitting diodes (LEDs), which are able to produce photons in the third communication window, with a wavelength around 1550 nm. Here, we present silicon LEDs based on the electroluminescence of Er:O complexes in Si. Such sources are fabricated with a fully-compatible CMOS process on a 220 nm-thick silicon-on-insulator (SOI) wafer, the common standard in silicon photonics. The implantation depth is tuned to match the center of the silicon layer. The erbium and oxygen co-doping ratio is tuned to optimize the electroluminescence signal. We fabricate a batch of Er:O diodes with surface areas ranging from 1 µm × 1 µm to 50 µm × 50 µm emitting 1550 nm photons at room temperature. We demonstrate emission rates around 5 × 10 photons/s for a 1 µm × 1 µm device at room temperature using superconducting nanowire detectors cooled at 0.8 K. The demonstration of Er:O diodes integrated in the 220 nm SOI platform paves the way towards the creation of integrated silicon photon sources suitable for arbitrary-statistic-tolerant QKD protocols. - 10 September 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 40 (2) , 519-526
Integrated Remote Laser Source for 6G Advanced Antenna Systems
Future generations of mobile communications promise near unlimited access to information and data sharing with ubiquitous wireless connectivity for any kind of device and application that may benefit from being connected. This poses new design challenges and requires a renewal of the hardware platforms to meet the increased demand of capacity and reliability of the network. Next generation Radio Access Network (RAN) will evolve towards an increase of the radio bandwidth, with carrier frequency extended to the millimeter waves (mmW) range. Other technologies that will be extensively used to increase the RAN capacity will be beamforming and spatial multiplexing with advanced antenna systems (AAS) comprising hundreds of antenna elements. Optical technologies are the natural candidates to support the traffic increase, by providing high-capacity interconnection within the radio unit and towards the base band unit (BBU). However, the higher level of integration of AAS will cause an increase of the temperature to values >100C, due to power dissipation of RF power amplifiers (PA), digital front-end (DFE) and baseband processing Application Specific Circuits (ASIC). This makes the AAS an inhospitable environment for optical transceivers that include lasers, typically operating at temperatures <85C. A promising approach to solve this issue is to place the laser outside the transceiver as a remote laser source (RLS) in a less harsh environment or in a thermally controlled environment e.g. in the same cabinet of the BBU. In this article we demonstrate a fully integrated RLS enabling a reduction of power consumption and packaging cost.
- 10 September 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 40 (2) , 519-526
Integrated Remote Laser Source for 6G Advanced Antenna Systems
Future generations of mobile communications promise near unlimited access to information and data sharing with ubiquitous wireless connectivity for any kind of device and application that may benefit from being connected. This poses new design challenges and requires a renewal of the hardware platforms to meet the increased demand of capacity and reliability of the network. Next generation Radio Access Network (RAN) will evolve towards an increase of the radio bandwidth, with carrier frequency extended to the millimeter waves (mmW) range. Other technologies that will be extensively used to increase the RAN capacity will be beamforming and spatial multiplexing with advanced antenna systems (AAS) comprising hundreds of antenna elements. Optical technologies are the natural candidates to support the traffic increase, by providing high-capacity interconnection within the radio unit and towards the base band unit (BBU). However, the higher level of integration of AAS will cause an increase of the temperature to values >100C, due to power dissipation of RF power amplifiers (PA), digital front-end (DFE) and baseband processing Application Specific Circuits (ASIC). This makes the AAS an inhospitable environment for optical transceivers that include lasers, typically operating at temperatures <85C. A promising approach to solve this issue is to place the laser outside the transceiver as a remote laser source (RLS) in a less harsh environment or in a thermally controlled environment e.g. in the same cabinet of the BBU. In this article we demonstrate a fully integrated RLS enabling a reduction of power consumption and packaging cost.