ZZZhiyun Zhang

Zhiyun Zhang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Zhiyun Zhang has a total of 44 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Dual‐Polarization Reconfigurable Metasurface With High Isolation for Simultaneous Multi‐Mode OAM Generation

    by Yijun Zou, Min Huang, Ruichen Li, Ruikai Hu, Zhiyun Zhang, Deng Wei, Bin Zheng

    Dual‐polarization reconfigurable metasurfaces with two independent polarization modulation channels offer new opportunities for multifunctional and multitasking applications. However, most previous dual‐polarization metasurfaces can only operate in certain single polarization modes separately at a time, unable to concurrently and in parallel work in dual‐polarization modes. Moreover, they typically provide only limited 2D 1‐ or 2‐bit phase modulation capabilities, which fail to meet the requirements for real‐time fine‐tuning and independent control in complicated and parallel dual‐polarization electromagnetic (EM) systems. In this work, we propose a high‐isolation dual‐polarization reconfigurable metasurface to achieve decoupled and continuous EM manipulation of two orthogonal polarizations in the 2D direction. As a demonstration, we show the simultaneous generation of x‐polarization ( x‐pol .) and y‐polarization ( y‐pol .) vortex beams with different orbital angular momentum (OAM) modes on this reconfigurable metasurface under 45° linear‐polarized wave incidence. Both simulation and experimental results demonstrate that the dual‐polarization reconfigurable metasurface can operate simultaneously and independently for two orthogonal polarizations, and the fine‐tuning EM response enables the generation of vortex beams with high‐purity OAM modes and lower background noise. Our work could advance reconfigurable metasurfaces a step closer to real‐world applications in polarization‐assisted dynamic multiplexed holographic imaging and encryption.

  • Open Access

    Low-Profile Metasurface Antenna for Broadband RCS Reduction and Omnidirectional Radiation

    by Liqiu Hu, Sijia Li, Kefeng Ji, Yuhao Wu, Zhiyun Zhang

    A low-profile, low radar cross-section (RCS) omnidirectional metasurface antenna is investigated and proposed in this letter. The antenna consists of a top circular patch, a three-layer dielectric substrate, a full metal ground, a multi-layer polarization conversion metasurface, and four short vias for connecting the top patch to the ground. Wideband impedance matching is achieved by modifying an F-shaped feeding structure. The broadband RCS reduction is realized by loading the antenna with the polarization conversion metasurface (PCM) in an appropriate array configuration. The antenna prototype has been fabricated and measured in an anechoic chamber. Experimental results illuminated that the antenna features a low profile of 0.051λ0 (λ0 is the wavelength at 2.35 GHz) and a 10 dB impedance bandwidth of 2.11–2.62 GHz (a fractional bandwidth of 21.56%). Significantly broadband RCS reduction is achieved from 7.05 to 16.96 GHz, with a maximum reduction of –28 dB and an average reduction of –12.51 dB.


  • High-Fidelity Microwave Holography Using a Programmable Transmissive Metasurface With Enhanced Phase Modulation

    by Zhiyun Zhang, Yulong Zhou, Sijia Li, Min Huang, Bin Zheng, Jianghao Tian, Huanhuan Yang, Liqiu Hu, Jiwei Zhao, Xiangyu Cao

    To overcome limitations in imaging quality and dynamic control, a high-fidelity microwave holography system using a programmable transmissive metasurface with enhanced phase modulation is presented in this letter. Initially, through rigorous analyses and optimizations of electrical periodicity and phase resolution of the unit cell, the imaging performance is enhanced significantly. A novel cascaded structure is designed to achieve 3-bit transmissive phase modulation with a large phase coverage of up to 318°. Consequently, high-fidelity greyscale images across 9.8–10.6 GHz are realized. Based on frequency multiplexing combined with CMYK color decomposition, false full-color holographic image reconstruction is achieved, and information transmission capacity is increased. Measurements of the unit and array prototype demonstrated precise control over transmissive phase and effective dynamic hologram reconstruction. The proposed approach provides a promising solution for high-fidelity meta-hologram reconstruction, with potential applications in data storage, secure transmission, and holographic communication.


  • Complex‐Amplitude Programmable Transmissive Metasurface Empowering High‐Fidelity Holographic Imaging

    by Zhiyun Zhang, Yulong Zhou, Sijia Li, Bin Zheng, Min Huang, Tong Li, Jianghao Tian, Zexu Guo, Xiangyu Cao

    To generate the high‐fidelity holographic images in real‐time, a design strategy for a programmable complex‐amplitude metasurface (MS) is proposed in this paper. Inspired by orthogonal polarization grids, the innovative unit cell independently and simultaneously controls the amplitude and phase of the cross‐polarized component. Topology optimization is achieved through analysis of the current distribution, proportion of metallic patches, and parameter sweep, so that the resonant cavity‐like microstructure ensures a broad transmissive amplitude modulation range of 0.15 to 0.8. Besides, a wideband 2π phase coverage is achieved ranging from 7 to 10 GHz. The metasurface demonstrates remarkable capability in achieving arbitrary and high‐fidelity holographic imaging, achieving an average signal‐to‐noise ratio (SNR) of 14.3 dB and an imaging efficiency exceeding 60%. Moreover, it is demonstrated that the programmable MS is capable of reconstructing 3D images and certain information encryption. Experimental results align well with simulated data, validating its feasibility to customize arbitrary holographic images. The design strategy provides a versatile platform for near‐field manipulation, showcasing potential applications in holographic communication, smart imaging systems, and secure data transfer and encryption in the 6G era.


  • High-Scanning-Rate Circularly Polarized Dual-Beam Frequency-Scanning Antenna Based on Orthogonal Cosine-Type SSPP

    by Kefeng Ji, Yulong Zhou, Huanhuan Yang, Tong Li, Sijia Li, Zhiyun Zhang, Jing Zou, Xiangyu Cao

    In this letter, a circularly polarized (CP) dual-beam frequency scanning antenna with high scanning rate is designed, which is constructed by a double-layer orthogonal Spoof Surface Plasmon Polariton (SSPP) transmission line after cosine modulation. The double-layer orthogonal SSPP element has strong dispersion characteristics and dispersion separation, which is helpful to realize dual-beam continuous scanning with high scanning rate and large scanning range. By adopting cosine modulation on the SSPP transmission line, the surface wave in the form of slow wave can be disturbed to form leaky wave radiation. Finally, the orthogonal cosine-type SSPP structures of the upper and lower layers are shifted by about a quarter wavelength to achieve circular polarization. The experimental results show that the 3dB axial ratio (AR) bandwidth of the circularly polarized dual-beam frequency scanning antenna is 5.14-5.41 GHz, the relative bandwidth is 5.12%, the continuous scanning range is 33°, and the scanning rate can reach 6.45°/%. The average radiation gain is 8.18dBi, and the maximum gain is 8.79dBi. The overall radiation efficiency is more than 50%, and the average radiation efficiency is 61.1%, which has a good circular polarization radiation performance. The design in this letter greatly improves the scanning rate of the circular polarization frequency scanning antennas, and has broad application prospects in modern communication systems requiring fast response.


  • Dual-Beam Frequency-Scanning Antenna Based on SSPP for Full-Space Continuous Scanning

    by Kefeng Ji, Yulong Zhou, Huanhuan Yang, Zhiyun Zhang, Tong Li, Sijia Li, Xiangyu Cao

    In this paper, a dual-beam frequency scanning antenna based on spoof surface plasmon polariton (SSPP) is designed for continuous scanning in full space. The antenna is composed of a double-layer composite single-sided (DL-CSS) SSPP transmission line and asymmetric radiation patches. The DL-CSS SSPP element has stronger dispersion characteristics and well-separated dispersion curves, facilitating designing the frequency scanning antenna with dual-beam, ultra-wide angle, and high scanning rate. The asymmetric radiation patches consist of an elliptic patch array and a rectangular patch array with different modulation periods, effectively improve the open-stopband effect through beam synthesis. Simulation and measurement results show that the dual-beam frequency scanning antenna can realize 360° full coverage scanning in the whole space without a dead angle. The operating frequency band is 6.79-8.69GHz, the relative bandwidth is 24.5%, and the scanning rate is 7.35°/%. The average gain is 9.98dBi and the maximum gain is 12.38dBi. Furthermore, the overall radiation efficiency is more than 50%, and the average radiation efficiency is 68.99%. Thus, the designed antenna not only greatly broadens the scanning range, and raises the scanning rate, but also improves the open-stopband effect of broadside radiation. Meanwhile, its full-space continuous scanning capability has a broad application prospect in autonomous vehicles and intelligent transportation systems, radar systems, wireless communication network optimization, radio signal intelligence, spectrum monitoring and management, disaster recovery and emergency communications, radio astronomy, and so on.


  • Optically Transparent Complex-Amplitude Metasurface for Full-Space Manipulation of Frequency-Multiplexed Holographic Imaging

    by Zhiyun Zhang, Yulong Zhou, Sijia Li, Jianghao Tian, Lili Cong, Huanhuan Yang, Xiangyu Cao

    Restricted by the physical properties of materials, most traditional metasurfaces (MSs) cannot achieve transparent stealth in the visible spectrum. Although some metasurfaces for holography have been designed, there is no standard method for evaluating the advancement of wavefront manipulation under different design algorithms. Here, a complex-amplitude metasurface with optical transparency (OT) and full-space manipulation is presented in the millimeterwave band. Through frequency multiplexing, two holographic images "HOLO" and "GRAM" with high quality are designed, achieving the signal-to-noise ratios of 14.6 and 14.4 dB, respectively. The 64 × 64 bilayered metasurface consists of glass and poly(ethylene terephthalate) (PET) substrates and three metallic mesh layers. By change of the opening size and oriented angle of split rings, phase and amplitude modulations are independently realized. Besides, a new method is provided to assess the superiority of the metasurface holography system for near-field energy regulation. The prototype was fabricated using micro-nano-technology and tested. Two holographic images were experimentally demonstrated and show good agreement with theoretical calculations and simulated results. With the advantages of OT and full-space complex-amplitude customization, the proposed metasurface holograms for frequency-multiplexed may find prospective application aspects in target perception, multichannel data storage and encryption, and many other related fields.


  • 4-bit millimeter-wave Janus metasurface enabled polarization-spatial multiplexing holography

    by Zhiyun Zhang, Sijia Li, Yulong Zhou, Tong Li, Lili Cong, Qiang Feng, Xilai Zhao, Xiangyu Cao

    Metasurface holography has become a surging and revolutionized field due to its flexible manipulation of amplitude and/or phase, which enhances the quality and capacity of holographic images. However, the current meta-holograms primarily focus on half-space manipulation, posing a challenge in developing simplified meta-hologram structures for spatial multiplexing. To address this situation, what we believe to be a novel 4-bit “Janus” metasurface combined with the weighted Gerchberg-Saxton (WGS) algorithm is proposed to record and reconstruct two distinct images in millimeter wave band. By meticulously designing the single-layer units, the 4-bit Janus metasurface achieves independent amplitude and phase responses in two orthogonal information channels. Moreover, the imaging ability of the proposed metasurface is investigated under different amplitude and phase dispersion. Comparative analysis also highlights several notable advantages of our work, including a low-profile design, polarization-frequency multiplexing, and enhanced imaging efficiency. The proposed method is verified through theoretical calculations, simulations, and experiments, and promises a versatile platform for applications in data storage, encryption, and auxiliary sensing.


  • A Mesh-Type Ultrawideband Low-RCS Transmitarray Antenna Based on Spoof Surface Plasmon Polariton

    by Kefeng Ji, Yulong Zhou, Huanhuan Yang, Zhiyun Zhang, Zexu Guo, Tong Li, Xiaobin Liu, Xiangyu Cao

    In this letter, an ultra-wideband low radar cross section (RCS) transmitarray antenna is designed, which is composed of a microstrip antenna array and a transmissive metasurface based on Spoof Surface Plasmon Polariton (SSPP). The mesh-type transmissive metasurface, which consists of 4×4 double-cross SSPP elements, can achieve transmitting electromagnetic waves in the X-band and reduce RCS on both sides of the passband. In addition, the reflection phase difference between two adjacent elements can be regulated by the height of the SSPP structure. Thus, by means of a checkerboard array, the transmissive metasurface can scatter normal incident waves to achieve RCS reduction. Moreover, when the transmissive metasurface fed by the microstrip antenna array, good radiation performance can be achieved in the X-band. The experimental results show that the maximum gain of the transmitarray antenna is 18.6 dBi and the 3 dB gain bandwidth is 9.7-10.7 GHz. Compared with the original microstrip antenna array, the transmitarray antenna achieves RCS reduction in the ultra-wideband of 4.7-12.2 GHz, with a maximum reduction of 11.98 dB and a relative bandwidth of 88.8%. Meanwhile, RCS reduction performance is still good under oblique incidence.